Boat

Have Boat Questions? Ask a Boat Repair Expert.

Connect one-on-one with {0} who will answer your question

Related Boat Questions
2005 2-stroke 90 hp mercury outboard with recently rebuilt
2005 2-stroke 90 hp mercury outboard with recently rebuilt carbs. 1st time out on water after rebuild had good top rpm (5800) and good idle. After 20 minutes of cruising @ 3000 rpm, powered down to ch… read more
Charles
Charles
Certified Mercury Tech
5,752 satisfied customers
1988 mercruiser 5.7 4 barrel carb. Won't idles down and
1988 mercruiser 5.7 4 barrel carb. Won't idles down and surges from 1000 to 1800 rpm. Up and down, I can see parts on the carb moving as it surges...carb need rebuilt?… read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,409 satisfied customers
I have a 2004 200 hpdi yamaha idles at 700 rpm when i put in
I have a 2004 200 hpdi yamaha idles at 700 rpm when i put in gear it will jump how can i slow it down in gear it is at 700 rpm 2004 zx200 skeeter… read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade School
22,043 satisfied customers
90 hp Yamaha outboard starts easily, runs well at idle and
90 hp Yamaha outboard starts easily, runs well at idle and runs its full rpms 4000-4100 when in reverse gear but will only reach around 2000rpm in forward. A neighbor was "helping" me get the boat rea… read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade School
22,043 satisfied customers
i have a 2008 50 hp yamaha outboard and i need to dissassemble
i have a 2008 50 hp yamaha outboard and i need to dissassemble and clean the carbs. the bottom jet is not pushing any gas through. i can get the two top carbs off but i cant figure out how to get the … read more
Joe
Joe
Owner Kingsland Auto & Marine Services
Vocational, Technical or Trade Scho
1,396 satisfied customers
350 cid marine gas engine stalls at idle when under load. Generally
350 cid marine gas engine stalls at idle when under load. Generally ok above 1000 rpm w/ load although significant power losses and stall have occured from 3300 rpm cruise. I have changed inline fuel … read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade School
22,043 satisfied customers
yamaha 130 2 stroke 2002 starts cold ok idle 700 rpm 10k run
yamaha 130 2 stroke 2002 starts cold ok idle 700 rpm 10k run return to idle 500 rpm. 15 minuits later need choke to start idle 500 rpm miss fires and stalls do again put into gear ok until power down … read more
Noel Schembri
Noel Schembri
Marine mechanic
Diploma
2,659 satisfied customers
I RECENTLY PERCHASED A 17FOOT FISHING BOAT WITH A 90 HP MERCURY
I RECENTLY PERCHASED A 17FOOT FISHING BOAT WITH A 90 HP MERCURY 3 CYLENDER ENGINE. IT STARTS GREAT AND WILL REV UP TO5000 RPMS IN NUTRIAL. SLOW IT DOWN TO A SLOW IDAL AND ENGAGE THE DRIVE BUT IT WILL … read more
Jeremy R.
Jeremy R.
5,362 satisfied customers
boat has been to 3 marinas, carbs rebuilt, compression great,
boat has been to 3 marinas, carbs rebuilt, compression great, full tune up twice,new impeller,temp good, always had fresh full tank of gas. Its an 89 40 hp mariner runs great at the shop & in the driv… read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade School
22,043 satisfied customers
LOOKING FOR A QUITE OUT BOARD 30 - 50 HP. FOR A PONTOON BOOT,
LOOKING FOR A QUITE OUT BOARD 30 - 50 HP. FOR A PONTOON BOOT, I HAVE A ENENINROOD AND IT IS LOUD.… read more
Jeff G.
Jeff G.
Marine Mechanic
Vocational, Technical or Trade Scho
4,730 satisfied customers
2001 waverunner xlt yamaha 1200 is for sale. Owner states
2001 waverunner xlt yamaha 1200 is for sale. Owner states this has 118 hrs and "IT IS IN GOOD PHYSICAL CONDITION WITH ONLY NORMAL DOCK MARKS LOST COMPRESSION IN REAR CYLINDER OTHER TWO CYLINDERS ARE F… read more
Jeremy R.
Jeremy R.
5,362 satisfied customers
I have a 50 hp Honda 4-stroke on 21 foot pontoon boat. First
I have a 50 hp Honda 4-stroke on 21 foot pontoon boat. First time run this summer. Idles and revs up at the dock with no load to 5000 rpms, but when I take it out and give it gas, it bogs down and cut… read more
Jeff G.
Jeff G.
Marine Mechanic
Vocational, Technical or Trade Scho
4,730 satisfied customers
1988 90 hp Yamaha outboard engine looses power after 4,000
1988 90 hp Yamaha outboard engine looses power after 4,000 rpm - drop down to 3,800 runs ok. fuel problem? ck filter, appears clean , but cloudy when mixed with new gas. what do you recommend Also eng… read more
Jeff G.
Jeff G.
Marine Mechanic
Vocational, Technical or Trade Scho
4,730 satisfied customers
I have a Yamaha four-stroke 50hp boat engine. The past two
I have a Yamaha four-stroke 50hp boat engine. The past two years I have had problems after summer storage in Florida. Carbs clogged and costly repair bills. I had the carbs cleaned this year at a cost… read more
Jeff G.
Jeff G.
Marine Mechanic
Vocational, Technical or Trade Scho
4,730 satisfied customers
have a 91 40 HP mercuy 4 cylinder classic. Seems to run fine
have a 91 40 HP mercuy 4 cylinder classic. Seems to run fine up to 4400 RPM. Taken it to the mech twice. Put in new fuel pump and plugs. Both times he said water in gas. I know this is not the case. H… read more
Captain Dave
Captain Dave
Marine Mechanic
Master's Degree
2,672 satisfied customers
I have a 2007 yamaha 50 hp TLR. that coughs sputters and dies
I have a 2007 yamaha 50 hp TLR. that coughs sputters and dies while in gear but will run at full rpm with the idle lever… read more
davesoutboard
davesoutboard
owner
Associate Degree
1,570 satisfied customers
I have a mercury outboard, its a 50 hp. 4 stroke engine, sitting
I have a mercury outboard, it's a 50 hp. 4 stroke engine, sitting at idle the engine will attain 6000 rpms. but when I go out and put aload on it, it will only attain about 3500 to 3800 rpms and thats… read more
Larry B.
Larry B.
Marine Service Tech
High School or GED
574 satisfied customers
I have a 2 stroke Yamaha 90 outboard. The motor starts ...
I have a 2 stroke Yamaha 90 outboard. The motor starts just fine and runs up to 2,000 rpm with no problems. When I give it more throttle the motor goes faster then sputters, then goes fast, then sputt… read more
Larry B.
Larry B.
Marine Service Tech
High School or GED
574 satisfied customers
Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

JustAnswer in the News:

Ask-a-doc Web sites: If you've got a quick question, you can try to get an answer from sites that say they have various specialists on hand to give quick answers... Justanswer.com.
JustAnswer.com...has seen a spike since October in legal questions from readers about layoffs, unemployment and severance.
Web sites like justanswer.com/legal
...leave nothing to chance.
Traffic on JustAnswer rose 14 percent...and had nearly 400,000 page views in 30 days...inquiries related to stress, high blood pressure, drinking and heart pain jumped 33 percent.
Tory Johnson, GMA Workplace Contributor, discusses work-from-home jobs, such as JustAnswer in which verified Experts answer people’s questions.
I will tell you that...the things you have to go through to be an Expert are quite rigorous.

What Customers are Saying:

Wonderful service, prompt, efficient, and accurate. Couldn't have asked for more. I cannot thank you enough for your help.

Mary C.Freshfield, Liverpool, UK

This expert is wonderful. They truly know what they are talking about, and they actually care about you. They really helped put my nerves at ease. Thank you so much!!!!

AlexLos Angeles, CA

Thank you for all your help. It is nice to know that this service is here for people like myself, who need answers fast and are not sure who to consult.

GPHesperia, CA

I couldn't be more satisfied! This is the site I will always come to when I need a second opinion.

JustinKernersville, NC

Just let me say that this encounter has been entirely professional and most helpful. I liked that I could ask additional questions and get answered in a very short turn around.

EstherWoodstock, NY

Thank you so much for taking your time and knowledge to support my concerns. Not only did you answer my questions, you even took it a step further with replying with more pertinent information I needed to know.

RobinElkton, Maryland

He answered my question promptly and gave me accurate, detailed information. If all of your experts are half as good, you have a great thing going here.

DianeDallas, TX

< Previous | Next >

Meet the Experts:

Ted G.

Ted G.

Rigger, Diagnostician

2,678 satisfied customers

40 years boating, Safe boating instruct., Offshore Race promoter, Failure Analysis, Expert Witness

Dominick

Dominick

Marine Mechanic

1,009 satisfied customers

25 Years Experience as Mechanic, 20 Yrs Boat Yard Owner/Mechanic, Factory Certified

John White

John White

Marine Mechanic

306 satisfied customers

11 years experience working on outboards, inboards, sterndrives & pwcs

Jason

Jason

Marine Mechanic

22,043 satisfied customers

Degree in Marine Technology. Gas and diesel marine mechanic.

Tan

Tan

MerCruiser Certified Technician

11,409 satisfied customers

40 yrs. experience with complete engine repairs both inboard/outboard and MerCruiser Certified Technician.

Jeff G.

Jeff G.

Marine Mechanic

4,730 satisfied customers

42 years experience, Certified Master Technician, All Major Outboards, Sterndrives, Hi-Performance

Captain Dave

Captain Dave

Marine Mechanic

2,672 satisfied customers

USCG Licensed Captain, 20+ Years Boating, Fishing, Maintenance and Repair Experience

< Previous | Next >

Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

Show MoreShow Less

Ask Your Question

x