Boat

Have Boat Questions? Ask a Boat Repair Expert.

Connect one-on-one with {0} who will answer your question

Related Boat Questions
2000 DF 70 Suzuki: Had old fuel. Replaced both filters,
2000 DF 70 Suzuki: Had old fuel. Replaced both filters, vaper separator, plugs. Have pressure at injectors and seam to have good pattern. Blead air from fuel system. Fresh non ethanal gas. Problem is … read more
Jason
Jason
Marine Mechanic
19,966 satisfied customers
On my 70hp Suzuki outboard a hose on my IAC Valve Silencer
on my 70hp Suzuki outboard a hose on my IAC Valve Silencer is loose and I don't know where it goes. the diagram show one end going to the intake manifold but the other end is loose. it is drawing a va… read more
Jason
Jason
Marine Mechanic
19,966 satisfied customers
I have a 2007 Mercury 90hp 4 stroke. Yesterday it gave me
I have a 2007 Mercury 90hp 4 stroke. Yesterday it gave me two brief alarms when backing off of the throttle. Today, after cruising at 3000 rpm for about half an hour, I idled about for several minutes… read more
Charles
Charles
Certified Mercury Tech
5,519 satisfied customers
Just bought a boat w/2012 df 175 cranks runs fine @ low rpm
Just bought a boat w/2012 df 175 cranks runs fine @ low rpm but when I give throttle it surges bad… read more
Jason
Jason
Marine Mechanic
19,966 satisfied customers
2008 75 HP 4 stroke EFI. Hesitation when throttle up between
2008 75 HP 4 stroke EFI. Hesitation when throttle up between 1000 and 2000 RPM, only when sitting for week. Idles and starts fine. after several hesitations, runs fine at 4-5000 Rpm. Gas or electric p… read more
Charles
Charles
Certified Mercury Tech
5,519 satisfied customers
I have a 2007 Suzuki DF 150. Wont reach max RPM.. stalls @
I have a 2007 Suzuki DF 150. Won't reach max RPM.. stalls @ 3500-4000 RPM. When i pull the kill switch it will make about 5000 RPM for a few seconds and then slow down to the same. Already changed my … read more
Jason
Jason
Marine Mechanic
19,966 satisfied customers
Hi, I have a 2006 Suzuki DF70 4 stroke Outboard on a 5.75
Hi, I have a 2006 Suzuki DF70 4 stroke Outboard on a 5.75 metre aluminium boat, reasonable narrow beam 2070mm so reasonably efficient hull. I was wondering what RPM I should cruise at and what RPM is … read more
Whitecap36
Whitecap36
Service Manager/Technician
Vocational, Technical or Trade Scho
1,556 satisfied customers
I have a 1994 suzuki 225 dt two stroke, it starts up fine but
I have a 1994 suzuki 225 dt two stroke, it starts up fine but when I try to drive it will only reach 2000 rpms... seems to be an engine problem as i have run it on an external tank with th same result… read more
Noel Schembri
Noel Schembri
Marine mechanic
Diploma
1,804 satisfied customers
My 70 hp outboard runs OK up to 2500 rpm and then if you try
My 70 hp outboard runs OK up to 2500 rpm and then if you try to push it over that it sputters at 3000 and then will run up to 4500 for a second or two and then back down to 3000. If you back off to 25… read more
Jason
Jason
Marine Mechanic
19,966 satisfied customers
I have a Suzuki DF(NNN) NNN-NNNNand I just changed the spark plugs
I have a Suzuki DF(NNN) NNN-NNNNand I just changed the spark plugs and fuel filter. My question is this, when I ran it up in my yard ,hooked up to the water hose, I t ran fine all the way to 5000 rpm … read more
James
James
Certified Marine Mechanic
Vocational, Technical or Trade Scho
4,094 satisfied customers
I have a 2003 suzuki df 140 outboard. It overheated yesterday
I have a 2003 suzuki df 140 outboard. It overheated yesterday and dropped my rpm to a max of 2000,I was trying to outrun a thunderstorm in very rough seas for a few miles. I never har rpm"s above 5500… read more
Jeremy R.
Jeremy R.
5,362 satisfied customers
WE HAVE A 2005 RINKER FIESTA VEE 342 WITH TWO VOLVO PENTA 5.7
WE HAVE A 2005 RINKER FIESTA VEE 342 WITH TWO VOLVO PENTA 5.7 OSXI-DF MOTORS. THE PORT MOTOR WILL ONLY TO GO 4000 RPM, BUT THE STERN MOTOR GOES TO 5000 RPM. WE ARE MIFFED.… read more
Jeremy R.
Jeremy R.
5,362 satisfied customers
I have a1998 Suzuki 70DT that surges at 4000 rpm. Ajusting
I have a1998 Suzuki 70DT that surges at 4000 rpm. Ajusting the tilt will increase the rpm to 4500 however it has a prop gear ratio that normally allows the engine to run at 5600 rpm. I have checked th… read more
Jason
Jason
Associate Degree
210 satisfied customers
I have a 70hp suzuki 4stroke 2002 and it has been dieing while
I have a 70hp suzuki 4stroke 2002 and it has been dieing while underway. It runs fine if you continue to pump the fuel bulb. This was happening at about 4000rpm. Sometimes it slows down and somtimes i… read more
Jason
Jason
Associate Degree
210 satisfied customers
I have an 1986 4cyl chev starts fine, idle at 900-1000 shifts
I have an 1986 4cyl chev starts fine, idle at(NNN) NNN-NNNNshifts no growl cruises purring at 3000 max 4000 (at least that is where I shut it back) BUT from nutral to forward shift if I push full gas … read more
capt ron 1959
capt ron 1959
Owner/Marine Mechanic
Vocational, Technical or Trade Scho
348 satisfied customers
Suzuki DT70 Year 2000 Outboard will not go over 1500 rpm when
Suzuki DT70 Year 2000 Outboard will not go over 1500 rpm when under load. Revs up fine out of the water. Has less than 200 hours on it. I've checked the fuel lines and they are all clean. I have the o… read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,406 satisfied customers
Hi, I have a 2004 Mercury 115hp 4-stroke EFI outboard, when
Hi, I have a 2004 Mercury 115hp 4-stroke EFI outboard, when i rev the engine on neutral sounds fine and will rev up till rev limiter, but in gear or under load, it will start bogging past 3500 rpm and… read more
TOM
TOM
Vocational, Technical or Trade Scho
196 satisfied customers
power issue with 2002 mercury outboard 90 hp 4 stroke.
power issue with 2002 mercury outboard 90 hp 4 stroke. history: boat used to run @ 40 mph @ 4000 rpm. now it cuts back after @ 7 mins. at anything over 3000 rpm. if taken to nuetral, the same will re … read more
BC Boat Guy
BC Boat Guy
Lecturer/Instructor
Vocational, Technical or Trade Scho
56 satisfied customers
Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

JustAnswer in the News:

Ask-a-doc Web sites: If you've got a quick question, you can try to get an answer from sites that say they have various specialists on hand to give quick answers... Justanswer.com.
JustAnswer.com...has seen a spike since October in legal questions from readers about layoffs, unemployment and severance.
Web sites like justanswer.com/legal
...leave nothing to chance.
Traffic on JustAnswer rose 14 percent...and had nearly 400,000 page views in 30 days...inquiries related to stress, high blood pressure, drinking and heart pain jumped 33 percent.
Tory Johnson, GMA Workplace Contributor, discusses work-from-home jobs, such as JustAnswer in which verified Experts answer people’s questions.
I will tell you that...the things you have to go through to be an Expert are quite rigorous.

What Customers are Saying:

Wonderful service, prompt, efficient, and accurate. Couldn't have asked for more. I cannot thank you enough for your help.

Mary C.Freshfield, Liverpool, UK

This expert is wonderful. They truly know what they are talking about, and they actually care about you. They really helped put my nerves at ease. Thank you so much!!!!

AlexLos Angeles, CA

Thank you for all your help. It is nice to know that this service is here for people like myself, who need answers fast and are not sure who to consult.

GPHesperia, CA

I couldn't be more satisfied! This is the site I will always come to when I need a second opinion.

JustinKernersville, NC

Just let me say that this encounter has been entirely professional and most helpful. I liked that I could ask additional questions and get answered in a very short turn around.

EstherWoodstock, NY

Thank you so much for taking your time and knowledge to support my concerns. Not only did you answer my questions, you even took it a step further with replying with more pertinent information I needed to know.

RobinElkton, Maryland

He answered my question promptly and gave me accurate, detailed information. If all of your experts are half as good, you have a great thing going here.

DianeDallas, TX

< Previous | Next >

Meet the Experts:

Ted G.

Ted G.

Rigger, Diagnostician

1,242 satisfied customers

40 years boating, Safe boating instruct., Offshore Race promoter, Failure Analysis, Expert Witness

Dominick

Dominick

Marine Mechanic

1,009 satisfied customers

25 Years Experience as Mechanic, 20 Yrs Boat Yard Owner/Mechanic, Factory Certified

John White

John White

Marine Mechanic

306 satisfied customers

11 years experience working on outboards, inboards, sterndrives & pwcs

Jason

Jason

Marine Mechanic

19,966 satisfied customers

Degree in Marine Technology. Gas and diesel marine mechanic.

Tan

Tan

MerCruiser Certified Technician

11,406 satisfied customers

40 yrs. experience with complete engine repairs both inboard/outboard and MerCruiser Certified Technician.

Jeff G.

Jeff G.

Marine Mechanic

4,730 satisfied customers

42 years experience, Certified Master Technician, All Major Outboards, Sterndrives, Hi-Performance

Captain Dave

Captain Dave

Marine Mechanic

2,672 satisfied customers

USCG Licensed Captain, 20+ Years Boating, Fishing, Maintenance and Repair Experience

< Previous | Next >

Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

Show MoreShow Less

Ask Your Question

x