Boat

Have Boat Questions? Ask a Boat Repair Expert.

Connect one-on-one with {0} who will answer your question

Related Boat Questions
I have a 1995 Sea Ray 135hp inboard/outboard of the "195"
I have a 1995 Sea Ray 135hp inboard/outboard of the "195" series. The switch that elevates/lowers the drive unit appears to need replacing. I contacted Sea Ray and they say the controls were from Merc… read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade School
22,883 satisfied customers
Engine will not go down; stuck in the up position. when I
engine will not go down; stuck in the up position. when I press the down trim button on the throttle, it makes the usual noise but nothing happens. I put my hand on the Hydraulic motor and its turning… read more
Yachtwork
Yachtwork
Owner Team Yachtwork
Technical or Trade School
1,903 satisfied customers
I have a 1991 sea ray sundancer. my question is about the
I have a 1991 sea ray sundancer. my question is about the out drive (bravo 3). the last time I was in the water I was not comfortable with the engine temperature. and I notice that when I put the gear… read more
Ted G.
Ted G.
Rigger, Diagnostician
Vocational, Technical or Trade Scho
2,678 satisfied customers
The leg on our 240 Sea Ray won't go down, When i press the
When i press the button downward on the throttle to lower the leg nothing happens. The leg is currently raised to it's highest point. When I press the switch to move the leg downward typically I hear some sound, but right now no sound either. … read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade School
22,883 satisfied customers
I have a 1991 mercruiser Alfa 1 and have a issue with the trim.
I have a 1991 mercruiser Alfa 1 and have a issue with the trim. When I raise the leg its fine but when I lower the leg my oil becomes all milky with air. I had a seeping cylinder so I replaced the cyl… read more
Ted G.
Ted G.
Rigger, Diagnostician
Vocational, Technical or Trade Scho
2,678 satisfied customers
I have a 1993 Sea Ray 190 "ski ray" outboard, 175 Merc Outboard.
I have a 1993 Sea Ray 190 "ski ray" outboard, 175 Merc Outboard. The steering is "jerky" over 15-20 MPH, lots of play in the steering wheel. I called the marine mechanic, who asked me if my steering w… read more
Noel Schembri
Noel Schembri
Marine mechanic
Diploma
2,638 satisfied customers
My Yamaha outboard hydraullic lift/trim device (small -- for
My Yamaha outboard hydraullic lift/trim device (small -- for a 15 HP Yamaha 4-stroke makes a 'straining' noise and now often hesitates before raising or lowering the engine. It can be encouraged to do… read more
Jason Forsberg
Jason Forsberg
Outboard Marine Mechanic
Vocational, Technical or Trade Scho
531 satisfied customers
I have an inboard outboard Mericruise 130 3 litre and over
I have an inboard outboard Mericruise 130 3 litre and over the Winter hydolic fluid formed at the back of the boat under the lower end which was raised. What might be the caude of that? Regards, David… read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,409 satisfied customers
I have a 1999 mercury opti max 200hp. there is hydraulic fluid
I have a 1999 mercury opti max 200hp. there is hydraulic fluid leaking from the lower right pivot point when I try to raise the engine. I see no fluid on the main cylinder and was told by other mercur… read more
Shane Creekmore
Shane Creekmore
Certified Mercury Marine technician
High School or GED
531 satisfied customers
I need to manually raise the outdrive on my 1986 Sea Ray Sundancer
I need to manually raise the outdrive on my 1986 Sea Ray Sundancer with an OMC cobra 800? It is out of the water on a trailer and the power lift is not working.… read more
shane j forrest
shane j forrest
Vocational, Technical or Trade Scho
270 satisfied customers
I have a Yanmar 240 hp turbo diesel linked to a Bravo II on
I have a Yanmar 240 hp turbo diesel linked to a Bravo II on my bayliner 2855. I have had a recent series of events in which the engine stops soon after departure from berth. yesterday we ran a sea tri… read more
Rick Gay
Rick Gay
High School or GED
106 satisfied customers
I have a outboard 2-stroke Evinrude 88 spl with power tilt.
I have a outboard 2-stroke Evinrude 88 spl with power tilt. The tilt motor worked and then stopped working. This is what I mean: The electric motor spins up, but it was taking a few seconds for the hy… read more
Master Tech
Master Tech
Service Manager/Technician
Vocational, Technical or Trade Scho
1,167 satisfied customers
Hi, i have a Mercrusier 5 lt with a Alpha one leg, this has
Hi, i have a Mercrusier 5 lt with a Alpha one leg, this has Hydraulic steering which is juddering in the centre portion of its travel. At low speed you can feel the boat (sea ray 200 cc 1999) wobble o… read more
The Man on the Dock
The Man on the Dock
Marina Owner, Operator
Vocational, Technical or Trade Scho
74 satisfied customers
I have a Mercruiser Bravo 111 350 hp motor cruiser the current
I have a Mercruiser Bravo 111 350 hp motor cruiser the current problem I'm having is the leg will not raise , have detected small oil leak on water could this be due to perished hydraulic hose or hose… read more
mercmastertech
mercmastertech
Service Manager, Master technician
Technical School
249 satisfied customers
if the power tilt and trim cylinder is leaking fluid....do
if the power tilt and trim cylinder is leaking fluid....do you have to replace the o ring....and if so....how… read more
FieldServiceTech
FieldServiceTech
Vocational, Technical or Trade Scho
146 satisfied customers
We cannot raise and lower moter (its currently in the trailer
We cannot raise and lower moter (it's currently in the trailer position). The hydrolic pump works (we hot wired it), but it doesn't work from the trottle control. It appears to be electrical. Any sugg… read more
mercmastertech
mercmastertech
Service Manager, Master technician
Technical School
249 satisfied customers
I have a 1987 Sea Ray Seville with a OMC 4.3 engine. There
I have a 1987 Sea Ray Seville with a OMC 4.3 engine. There is a part on the back of the engine that is leaking water. This part is connected to the power steering unit and is a 8 inch long cylinder wi… read more
gearheadII
gearheadII
Bachelor's Degree
138 satisfied customers
I have just purchased a bass boat with a 1989 Evinrude model
I have just purchased a bass boat with a 1989 Evinrude model E50TLCEC 50 HP outboard. The problem is that the tilt/trim does not work properly. The t/t motor makes noise up and down from either pair o… read more
The Man on the Dock
The Man on the Dock
Marina Owner, Operator
Vocational, Technical or Trade Scho
74 satisfied customers
Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

JustAnswer in the News:

Ask-a-doc Web sites: If you've got a quick question, you can try to get an answer from sites that say they have various specialists on hand to give quick answers... Justanswer.com.
JustAnswer.com...has seen a spike since October in legal questions from readers about layoffs, unemployment and severance.
Web sites like justanswer.com/legal
...leave nothing to chance.
Traffic on JustAnswer rose 14 percent...and had nearly 400,000 page views in 30 days...inquiries related to stress, high blood pressure, drinking and heart pain jumped 33 percent.
Tory Johnson, GMA Workplace Contributor, discusses work-from-home jobs, such as JustAnswer in which verified Experts answer people’s questions.
I will tell you that...the things you have to go through to be an Expert are quite rigorous.

What Customers are Saying:

Wonderful service, prompt, efficient, and accurate. Couldn't have asked for more. I cannot thank you enough for your help.

Mary C.Freshfield, Liverpool, UK

This expert is wonderful. They truly know what they are talking about, and they actually care about you. They really helped put my nerves at ease. Thank you so much!!!!

AlexLos Angeles, CA

Thank you for all your help. It is nice to know that this service is here for people like myself, who need answers fast and are not sure who to consult.

GPHesperia, CA

I couldn't be more satisfied! This is the site I will always come to when I need a second opinion.

JustinKernersville, NC

Just let me say that this encounter has been entirely professional and most helpful. I liked that I could ask additional questions and get answered in a very short turn around.

EstherWoodstock, NY

Thank you so much for taking your time and knowledge to support my concerns. Not only did you answer my questions, you even took it a step further with replying with more pertinent information I needed to know.

RobinElkton, Maryland

He answered my question promptly and gave me accurate, detailed information. If all of your experts are half as good, you have a great thing going here.

DianeDallas, TX

< Previous | Next >

Meet the Experts:

Ted G.

Ted G.

Rigger, Diagnostician

2,678 satisfied customers

40 years boating, Safe boating instruct., Offshore Race promoter, Failure Analysis, Expert Witness

Dominick

Dominick

Marine Mechanic

1,009 satisfied customers

25 Years Experience as Mechanic, 20 Yrs Boat Yard Owner/Mechanic, Factory Certified

John White

John White

Marine Mechanic

306 satisfied customers

11 years experience working on outboards, inboards, sterndrives & pwcs

Jason

Jason

Marine Mechanic

22,883 satisfied customers

Degree in Marine Technology. Gas and diesel marine mechanic.

Tan

Tan

MerCruiser Certified Technician

11,409 satisfied customers

40 yrs. experience with complete engine repairs both inboard/outboard and MerCruiser Certified Technician.

Jeff G.

Jeff G.

Marine Mechanic

4,730 satisfied customers

42 years experience, Certified Master Technician, All Major Outboards, Sterndrives, Hi-Performance

Captain Dave

Captain Dave

Marine Mechanic

2,672 satisfied customers

USCG Licensed Captain, 20+ Years Boating, Fishing, Maintenance and Repair Experience

< Previous | Next >

Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

Show MoreShow Less

Ask Your Question

x