Boat

Have Boat Questions? Ask a Boat Repair Expert.

Ask an Expert,
Get an Answer ASAP!

Related Boat Questions
Took the boat out and it ran then cut off so I started
Took the boat out and it ran then cut off so I started checking everything and oil smelled like gas so we drained the oil and put a used fuel pump on it . The boat started and ran back to the landing … read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,264 satisfied customers
I have a 1986 mercruiser 3.0 that has a rattle behind the
I have a 1986 mercruiser 3.0 that has a rattle behind the timing cover. The engine runs great. Has 40 psi oil pressure, and a full dips tick. Could the problem be timing gears?… read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,264 satisfied customers
Hi All, in desperate need of help…. My problem is as follows,
Hi All, in desperate need of help…. My problem is as follows, I have a Mercruiser 7.4L MPI on a 28ft Bayliner Ciera, starts in one, low end works great, when throttle is applied it will get up to abou… read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade Scho
18,489 satisfied customers
Have 2005 5.0 MPI Mercruiser that starts and runs fine at low
Have 2005 5.0 MPI Mercruiser that starts and runs fine at low RPM's going out of the channel. When I get out onto the bay and increase speed it runs well for about 5 minutes then bogs and hesitates. W… read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,264 satisfied customers
I have a 1990 7.4 mercruiser in my Bayliner 2655. I am having
I have a 1990 7.4 mercruiser in my Bayliner 2655. I am having an issue with the Boat falling on it's face snd shutting down at 3K RPM's. It will normally start right back up. We had an overheating iss… read more
Captain Dave
Captain Dave
Marine Mechanic
Master's Degree
2,672 satisfied customers
I have a bayliner with a 3.0 mercruiser and today it started
I have a bayliner with a 3.0 mercruiser and today it started fine then started running rough at idle. It ran okay at higher rpms but when the throttle was pulled back to idle it would hardly run. When… read more
MarineService8
MarineService8
34 satisfied customers
I have a 21 ft. Bayliner Trophy without an engine. it is rigged
I have a 21 ft. Bayliner Trophy without an engine. it is rigged for a V8. I have the option to buy a 1989 Rinker deckboat that has a 5.0 L Mercruiser/outdrive. Would the engine/outdrive from the Rinke… read more
James
James
Certified Marine Mechanic
Vocational, Technical or Trade Scho
4,094 satisfied customers
I have a 1999 Bayliner Capri with a 3.0 Mercruiser. This weekend
I have a 1999 Bayliner Capri with a 3.0 Mercruiser. This weekend I had the boat out and was running about 1/2 to 3/4 throttle. The engine started to lose power and stalled out. I was able to get it re… read more
K. Kergan
K. Kergan
Inboard/Outboard Mechanic
Vocational, Technical or Trade Scho
1,031 satisfied customers
I have a 1995 Malibu ski boat with a Mercruiser 350 Mag EFI
I have a 1995 Malibu ski boat with a Mercruiser 350 Mag EFI Tournament ski engine. I am getting a clicking sound that increases with the throttle. It stops once I stabalized the throttle. Changed plug… read more
James
James
Certified Marine Mechanic
Vocational, Technical or Trade Scho
4,094 satisfied customers
I have a 08 Bayliner 192 cuddy with a 3.0 tks Mecury/Mercruiser.
I have a 08 Bayliner 192 cuddy with a 3.0 tks Mecury/Mercruiser. Just before putting it up for the winter, the engine started to hesitate when taking off and well as cutting off at times. Well I winte… read more
Captain Dave
Captain Dave
Marine Mechanic
Master's Degree
2,672 satisfied customers
I have a 2006 Sea Ray 270 Sundeck with a 496 Mag Mercruiser....as
I have a 2006 Sea Ray 270 Sundeck with a 496 Mag Mercruiser....as you begin to accelerate their is a whistling sound coming from engine...mechanics have determined it is behind the flame arrestor in t… read more
Dominick
Dominick
Marine Mechanic
Vocational, Technical or Trade Scho
1,009 satisfied customers
I have a 2007 Bayliner with a 3.0 MerCruiser 135hp engine.
I have a 2007 Bayliner with a 3.0 MerCruiser 135hp engine. From day 1 it will idle rough/quit while trying to dock Also when at fishing destination and trying to re-start or going from the start posit… read more
mercmastertech
mercmastertech
Service Manager, Master technician
Technical School
249 satisfied customers
I have a 1989 4.3litre Mercruiser engine. Starts fine, idles
I have a 1989 4.3litre Mercruiser engine. Starts fine, idles a little rough and under zero load, will rev up to 5000 rpm without a hiccup. It 'barks' pretty good. BUT....as soon as I place it in gear … read more
Captain Dave
Captain Dave
Marine Mechanic
Master's Degree
2,672 satisfied customers
I have a 1993 3.0 Mercruiser I/O, and it idles too slow, sometimes
I have a 1993 3.0 Mercruiser I/O, and it idles too slow, sometimes to the point of stopping when I don't want it to. How do I adjust the idle on the engine to make it go just a bit faster? Thanks,… read more
Captain Dave
Captain Dave
Marine Mechanic
Master's Degree
2,672 satisfied customers
I have a 1978 Johnson 70hp that has a what seems to be a misfire
I have a 1978 Johnson 70hp that has a what seems to be a misfire under load and will not rev over 2500-2600 rpms. It runs fine on the muffs but not during water test. The carbs were rebuilt, the compr… read more
Dr. Joe
Dr. Joe
Bachelor's Degree
198 satisfied customers
I have a 1995 bayliner 2050 with a 5.0 mercruiser. I have had
I have a 1995 bayliner 2050 with a 5.0 mercruiser. I have had the boat for 2 years. It runs great on smooth water. Yesterday I was running about 4000 rpms and hit another boats wake, suddenly the moto… read more
ROCKET
ROCKET
MASTER CERTIFIED TECH
Vocational, Technical or Trade Scho
426 satisfied customers
hi,i bought a 1988 bayliner trophy 21 ft. it had a 4.3 from
hi,i bought a 1988 bayliner trophy 21 ft. it had a 4.3 from fact. a 5.7 was put in 2004, the leg had to be rebuilt in 2006, was this from to much torque from the 5.7 or is it the same leg as the 4.3?… read more
Dominick
Dominick
Marine Mechanic
Vocational, Technical or Trade Scho
1,009 satisfied customers
I HAVE A 3.0 L MERCRUISER I/0 IN A 1996 SEA PRO D/C .WHEN ...
I HAVE A 3.0 L MERCRUISER I/0 IN A 1996 SEA PRO D/C .WHEN THE ENGINE GETS TO 2800 RPM THE MOTOR BOGS DOWN AND WILL NOT ACCELERATE.ANYTHING UNDER THE 2800 RPM,S IT WILL START AND RUN WELL… read more
Infiniti Nissan Specialist
Infiniti Nissan Specialist
Master Technician
Vocational, Technical or Trade Scho
915 satisfied customers
Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

JustAnswer in the News:

Ask-a-doc Web sites: If you've got a quick question, you can try to get an answer from sites that say they have various specialists on hand to give quick answers... Justanswer.com.
JustAnswer.com...has seen a spike since October in legal questions from readers about layoffs, unemployment and severance.
Web sites like justanswer.com/legal
...leave nothing to chance.
Traffic on JustAnswer rose 14 percent...and had nearly 400,000 page views in 30 days...inquiries related to stress, high blood pressure, drinking and heart pain jumped 33 percent.
Tory Johnson, GMA Workplace Contributor, discusses work-from-home jobs, such as JustAnswer in which verified Experts answer people’s questions.
I will tell you that...the things you have to go through to be an Expert are quite rigorous.

What Customers are Saying:

Wonderful service, prompt, efficient, and accurate. Couldn't have asked for more. I cannot thank you enough for your help.

Mary C.Freshfield, Liverpool, UK

This expert is wonderful. They truly know what they are talking about, and they actually care about you. They really helped put my nerves at ease. Thank you so much!!!!

AlexLos Angeles, CA

Thank you for all your help. It is nice to know that this service is here for people like myself, who need answers fast and are not sure who to consult.

GPHesperia, CA

I couldn't be more satisfied! This is the site I will always come to when I need a second opinion.

JustinKernersville, NC

Just let me say that this encounter has been entirely professional and most helpful. I liked that I could ask additional questions and get answered in a very short turn around.

EstherWoodstock, NY

Thank you so much for taking your time and knowledge to support my concerns. Not only did you answer my questions, you even took it a step further with replying with more pertinent information I needed to know.

RobinElkton, Maryland

He answered my question promptly and gave me accurate, detailed information. If all of your experts are half as good, you have a great thing going here.

DianeDallas, TX

< Previous | Next >

Meet the Experts:

Dominick

Dominick

Marine Mechanic

1,009 satisfied customers

25 Years Experience as Mechanic, 20 Yrs Boat Yard Owner/Mechanic, Factory Certified

Ted G.

Ted G.

Rigger, Diagnostician

704 satisfied customers

40 years boating, Safe boating instruct., Offshore Race promoter, Failure Analysis, Expert Witness

John White

John White

Marine Mechanic

306 satisfied customers

11 years experience working on outboards, inboards, sterndrives & pwcs

Jason

Jason

Marine Mechanic

18,489 satisfied customers

Degree in Marine Technology. Gas and diesel marine mechanic.

Tan

Tan

MerCruiser Certified Technician

11,264 satisfied customers

40 yrs. experience with complete engine repairs both inboard/outboard and MerCruiser Certified Technician.

Jeff G.

Jeff G.

Marine Mechanic

4,729 satisfied customers

42 years experience, Certified Master Technician, All Major Outboards, Sterndrives, Hi-Performance

Captain Dave

Captain Dave

Marine Mechanic

2,672 satisfied customers

USCG Licensed Captain, 20+ Years Boating, Fishing, Maintenance and Repair Experience

< Previous | Next >

Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

Show MoreShow Less

Ask Your Question

x