Boat

Have Boat Questions? Ask a Boat Repair Expert.

Connect one-on-one with {0} who will answer your question

Related Boat Questions
I have a 1998 fastrike 175 hp motor. Bowls on the carbs are
I have a 1998 johnson fastrike 175 hp motor. Bowls on the carbs are warped slightly, the fuel primer bulb will not stay firm after I stop. It has a hard time going on plane. When it does get on plane … read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade School
19,289 satisfied customers
78 outboard motor will start run for a few minutes then will
78 Johnson outboard motor will start run for a few minutes then will peter out. New fuel bulb, fuel line, and fuel. … read more
Charles
Charles
Certified Mercury Tech
5,361 satisfied customers
I am rebuilding my carbs on my 1996 112spl, when I removed
I am rebuilding my carbs on my 1996 Johnson 112spl , when I removed the float chambers I noticed one chamber had the 2 #25 orifices installed while the other did not, are these not supposed to be inde… read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,399 satisfied customers
I have a 1983 85 hp outboard. Very rough idle. It seems to
I have a 1983 Johnson 85 hp outboard . Very rough idle . It seems to run fine above 1300 rpms and up . And most times I have to start it 1/3 throttle in gear to go . After I get it moving I can back i… read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,399 satisfied customers
I have a 2000 150hp runs perfect 1st thing but if you run
I have a 2000 150hp Johnson runs perfect 1st thing but if you run say 1/2 hour then stop to swim or fish it will not throttle up on restart, primer bulb flat has to be continually pumped to keep it id… read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,399 satisfied customers
I have a 1999 115 outboard. the motor runs on just the two
i have a 1999 115 johnson outboard. the motor runs on just the two cyls on the port side. all four spark plugs are getting a good blue spark. the temps on the starboard cyl head is not getting hot. i … read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,399 satisfied customers
1993 175 hp -60degree v6--rebuilt power head with no hours
1993 Johnson 175 hp -60degree v6--rebuilt power head with no hours on it yet because I can not stop the starboard side lowest carburetor from leaking on the inside and running out the front . I have r… read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade School
19,289 satisfied customers
I have a 2001 FourWinns horizon 180 with the 4.3 liter Volvo
Hello , I have a 2001 FourWinns horizon 180 with the 4.3 liter Volvo Penta engine with a 2 Barrel Halley Carb. The fuel pump went out when I was out on the water. Then I replaced the pump and fuel was… read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,399 satisfied customers
1992 150 (J150EXENC) just rebuilt cabs because of fuel
1992 Johnson 150 (J150EXENC) just rebuilt cabs because of fuel leaking all over, now 5 out of the 6 of them are still leaking from the bowl gasket. wondering if there is a remedy for this. also the mo… read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,399 satisfied customers
I have a 1984 Johnson VRO 70 hp. What kind or type of
I have a 1984 Johnson VRO 70 hp. What kind or type of carburetor is on this motor. There are three of them. There is a number stamped on the top of them. It's 326929.… read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,399 satisfied customers
i have a 1998 evinruder 175 intruder carb. engine. the motor
i have a 1998 evinruder 175 intruder carb. engine. the motor will run on cups great and take gas in neutral, but in the lake when put into gear it dies. it is now making a noise around the starter mot… read more
Master Tech
Master Tech
Service Manager/Technician
Vocational, Technical or Trade Scho
1,167 satisfied customers
I have a 1990 Johnson225hp j225txess.When I trim up the motor
I have a 1990 Johnson225hp j225txess.When I trim up the motor gas spills from the small hole in the middle of the carb body next to the float bowl.What would cause this.Motor runs fine. Thanks John… read more
Evinrude/Johnson
Evinrude/Johnson
Evinrude/Johnson marine technician
Vocational, Technical or Trade Scho
41 satisfied customers
I have a 2000 115 hp Johnson, model J115PLSSB Elec. Start,
I have a 2000 115 hp Johnson, model J115PLSSB Elec. Start, TNT, 20 In. Shaft. After sitting for a few months, I pulled it out to run in yard. Started fine, but RPM would drop off sharply and then reco… read more
Jeff G.
Jeff G.
Marine Mechanic
Vocational, Technical or Trade Scho
4,730 satisfied customers
I replaced the float in a 1956 10hp Johnson outboard motor
I replaced the float in a 1956 10hp Johnson outboard motor with OMC#0396514. This float is a bit thicker than the old cork float that was in the carb. I'm not sure if there is enough room in the bowl … read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,399 satisfied customers
hi mate i have a 70 hp 3cyl two stroke johnson 1999/2000 model.
hi mate i have a 70 hp 3cyl two stroke johnson 1999/2000 model. What it is doing is when your travelling at 4000 to 4500 revs - it cuts back to 2800 when it warms up. It is like it is running on 2 cyl… read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,399 satisfied customers
1074, 70 hp johnson outboard. We have run about 4 gallons
1074, 70 hp johnson outboard. We have run about 4 gallons of fuel with seafoam through it so far. Has been sitting for a couple of years or more. Starts fine and idles. Smokes alot. Runs OK to about 2… read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,399 satisfied customers
I have a 6 hp Johnson Sailmaster motor. I have been told that
I have a 6 hp Johnson Sailmaster motor. I have been told that I have a primer pump rather than a choke on my motor. What is the correct position of this "black handle" when starting and when running? … read more
Master Tech
Master Tech
Service Manager/Technician
Vocational, Technical or Trade Scho
1,167 satisfied customers
i have a 1972 evinrude 70 hp, that has been giving me carb
i have a 1972 evinrude 70 hp, that has been giving me carb troubles all year. now it is chokeing out of fuel, the carbs were rebuilt last year and it used to flood out and i adjusted the floats to be … read more
davesoutboard
davesoutboard
owner
Associate Degree
1,570 satisfied customers
Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

JustAnswer in the News:

Ask-a-doc Web sites: If you've got a quick question, you can try to get an answer from sites that say they have various specialists on hand to give quick answers... Justanswer.com.
JustAnswer.com...has seen a spike since October in legal questions from readers about layoffs, unemployment and severance.
Web sites like justanswer.com/legal
...leave nothing to chance.
Traffic on JustAnswer rose 14 percent...and had nearly 400,000 page views in 30 days...inquiries related to stress, high blood pressure, drinking and heart pain jumped 33 percent.
Tory Johnson, GMA Workplace Contributor, discusses work-from-home jobs, such as JustAnswer in which verified Experts answer people’s questions.
I will tell you that...the things you have to go through to be an Expert are quite rigorous.

What Customers are Saying:

Wonderful service, prompt, efficient, and accurate. Couldn't have asked for more. I cannot thank you enough for your help.

Mary C.Freshfield, Liverpool, UK

This expert is wonderful. They truly know what they are talking about, and they actually care about you. They really helped put my nerves at ease. Thank you so much!!!!

AlexLos Angeles, CA

Thank you for all your help. It is nice to know that this service is here for people like myself, who need answers fast and are not sure who to consult.

GPHesperia, CA

I couldn't be more satisfied! This is the site I will always come to when I need a second opinion.

JustinKernersville, NC

Just let me say that this encounter has been entirely professional and most helpful. I liked that I could ask additional questions and get answered in a very short turn around.

EstherWoodstock, NY

Thank you so much for taking your time and knowledge to support my concerns. Not only did you answer my questions, you even took it a step further with replying with more pertinent information I needed to know.

RobinElkton, Maryland

He answered my question promptly and gave me accurate, detailed information. If all of your experts are half as good, you have a great thing going here.

DianeDallas, TX

< Previous | Next >

Meet the Experts:

Dominick

Dominick

Marine Mechanic

1,009 satisfied customers

25 Years Experience as Mechanic, 20 Yrs Boat Yard Owner/Mechanic, Factory Certified

Ted G.

Ted G.

Rigger, Diagnostician

747 satisfied customers

40 years boating, Safe boating instruct., Offshore Race promoter, Failure Analysis, Expert Witness

John White

John White

Marine Mechanic

306 satisfied customers

11 years experience working on outboards, inboards, sterndrives & pwcs

Jason

Jason

Marine Mechanic

19,289 satisfied customers

Degree in Marine Technology. Gas and diesel marine mechanic.

Tan

Tan

MerCruiser Certified Technician

11,399 satisfied customers

40 yrs. experience with complete engine repairs both inboard/outboard and MerCruiser Certified Technician.

Jeff G.

Jeff G.

Marine Mechanic

4,730 satisfied customers

42 years experience, Certified Master Technician, All Major Outboards, Sterndrives, Hi-Performance

Captain Dave

Captain Dave

Marine Mechanic

2,672 satisfied customers

USCG Licensed Captain, 20+ Years Boating, Fishing, Maintenance and Repair Experience

< Previous | Next >

Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

Show MoreShow Less

Ask Your Question

x