star-filledicon-cnnicon-foxicon-nbcicon-nyticon-today

Boat

Have Boat Questions? Ask a Boat Repair Expert.

Ask an Expert,
Get an Answer ASAP!

Related Boat Questions
I have a 2004 Evinrude 115 when at the dock my friend
I have a 2004 Evinrude 115 when at the dock my friend started it in full throttle and in forward gear. Now when you start the boat it starts at 3000 rpm. You also cannot put it in neutral only forward… read more
Charles
Charles
Certified Mercury Tech
5,117 satisfied customers
Ive got a 2002 115 hp evinrude ficht outboard. Last time at
Ive got a 2002 115 hp evinrude ficht outboard. Last time at the lake it started rough idling and then stop running. After several attempts it finally kept running but then idle crept up to 4000 rpm. T… read more
Matthew John
Matthew John
Cert II Electronic Engineering
73 satisfied customers
1999 Mercury 250 two stroke EFI, (I have had for a few
1999 Mercury 250 two stroke EFI, (I have had for a few years). I average 150 hours per year and run marine stabile every fill up (pre mix). At idle engine shakes extremely, at 5000 rpms runs good then… read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade Scho
17,310 satisfied customers
I have a 2005 90hp evinrude etec. It sat for about 6 months.
I have a 2005 90hp evinrude etec. It sat for about 6 months. I didn't add any fuel stabilizer. Before I let it sit it ran fine. Now , runs fine at low rpm. When throttled up it boggs down. Drained gas… read more
Charles
Charles
Certified Mercury Tech
5,117 satisfied customers
1999 200 horse evinrude outboard. 200fpleen motor. always
1999 200 horse evinrude outboard. 200fpleen motor. always started up fine. no starting issues ever. one injector broke in 2004 and a piece went into the motor scarring up on piston. had the motor rebu… read more
Joe
Joe
Owner Kingsland Auto & Marine Services
Vocational, Technical or Trade Scho
1,382 satisfied customers
I have a volvo penta 5.7gi problem. Engine has about 450 hours, but sat over the winter w
I have a volvo penta 5.7gi problem. Engine has about 450 hours, but sat over the winter with water dripping on back of engine and cold temps. Fuel filters were changed and had water in them. Not sure … read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade Scho
17,310 satisfied customers
Hello Jason we spoke last week regarding a posible bad sensor
Hello Jason we spoke last week regarding a posible bad sensor on a Suzuki DF70 I wanted to ask you if it is possable for a cam sensor to make the engine not start as well… read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade Scho
17,310 satisfied customers
year 2000 mercury 200 efi missfire / bogging/ surging issue
year 2000 mercury 200 efi missfire / bogging/ surging issue serial 0T068394 currently looking to investigate possible trigger issue. or further help if trigger not an issue diagnosing today i noticed … read more
Charles
Charles
Certified Mercury Tech
5,117 satisfied customers
Have a 2000 225 merc it hunts at an idle and at 2000 rpm the
Have a 2000 225 merc it hunts at an idle and at 2000 rpm the engine rpm climb on there own… read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,264 satisfied customers
i HAVE A 2007 EVINRUDE ETEC WITH 200 HRS.WAS HAVING PROBLEMS
i HAVE A 2007 EVINRUDE ETEC WITH 200 HRS.WAS HAVING PROBLEMS ACCELERATING OUT OF THE HOLE THOUGHT IT WAS FUEL.CHANGED PLUGS, FILTERS, PUMPED OUT FUEL TANK, PUT IN FRESH FUEL.FINally brought it to etec… read more
davesoutboard
davesoutboard
owner
Associate Degree
1,570 satisfied customers
I HAVE AN ETEC 115 AND IT DEVELOPS AN ENGINE MISS WHEN UNDER
I HAVE AN ETEC 115 AND IT DEVELOPS AN ENGINE MISS WHEN UNDER LOAD IN THE REV RANGE BETWEEN 3100 AND 3600 AND ALSO CONNOT MAINTAIN A CONSTANT REV IN THE SAME RANGE I HAVE YO KEEP ADJUSTING THE THROTTLE… read more
James
James
Certified Marine Mechanic
Vocational, Technical or Trade Scho
4,094 satisfied customers
2005 evinrude 150 h.p.di. miss fire or running rough between
2005 evinrude 150 h.p.di. miss fire or running rough between idle and 2000 rpm idles smooth fuel pump has went bad but replaced .runs smooth above 2000 rpm -any ideas or suggestions. 2 sets of plugs a… read more
davesoutboard
davesoutboard
owner
Associate Degree
1,570 satisfied customers
I have a evinrude etec 90 horse. it was running ruff and than
I have a evinrude etec 90 horse. it was running ruff and than just died out. I cannot get it to turn over even though I put in new plugs and gas filter. I also added staybil to the gas. The battery is… read more
Conservative
Conservative
Service Advisor
Vocational, Technical or Trade Scho
154 satisfied customers
2004 Evinrude e-tec 75 hp with less than 100 hours. Cranks,
2004 Evinrude e-tec 75 hp with less than 100 hours. Cranks, idles, and runs fine until appx 4500-4800 rpm at which time it suddenly slows to idle speed. Then, have to take the throttle lever back to i… read more
davesoutboard
davesoutboard
owner
Associate Degree
1,570 satisfied customers
I have a 2006 etec 250 on a ranger bass boat. it has about
I have a 2006 etec 250 on a ranger bass boat. it has about 200+ hours. I had it out on the water when it shut down to Idle only. No alarms. The service tech check for codes and found nothing. uplug th… read more
Master Tech
Master Tech
Service Manager/Technician
Vocational, Technical or Trade Scho
1,167 satisfied customers
Please tell me what the compression and fuel pressure should
Please tell me what the compression and fuel pressure should be for an Evinrude, OMC Fitch fuel injection motor. year 2000 - horse power 200. Just bought boat - doesnt get over 4000 rpms. Tuned up, sh… read more
Jason
Jason
Associate Degree
210 satisfied customers
I have a 1999 70HP 4 stroke fuel injected outboard Evinrude.
I have a 1999 70HP 4 stroke fuel injected outboard Evinrude. I have replaced the fuel filter and have this problem. The motor runs smooth up to about 2200 RPM but dies at 2500 RPM. It there some trans… read more
davesoutboard
davesoutboard
owner
Associate Degree
1,570 satisfied customers
i have 1996 evinrude etec 150hp i cant get it to take the tps
i have 1996 evinrude etec 150hp i cant get it to take the tps code 11 to stay in memory ihave tried to adjust several times this problem came up same time oil sending unit was bad that has been replac… read more
davesoutboard
davesoutboard
owner
Associate Degree
1,570 satisfied customers
Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.
Dominick

Dominick

Marine Mechanic

25 Years Experience as Mechanic, 20 Yrs Boat Yard Owner/Mechanic, Factory Certified

1009 Satisfied Customers

Pearl avatarPearl, Assistant

JustAnswer in the News:

Ask-a-doc Web sites: If you've got a quick question, you can try to get an answer from sites that say they have various specialists on hand to give quick answers... Justanswer.com.
JustAnswer.com...has seen a spike since October in legal questions from readers about layoffs, unemployment and severance.
Web sites like justanswer.com/legal
...leave nothing to chance.
Traffic on JustAnswer rose 14 percent...and had nearly 400,000 page views in 30 days...inquiries related to stress, high blood pressure, drinking and heart pain jumped 33 percent.
Tory Johnson, GMA Workplace Contributor, discusses work-from-home jobs, such as JustAnswer in which verified Experts answer people’s questions.
I will tell you that...the things you have to go through to be an Expert are quite rigorous.

What Customers are Saying:

Wonderful service, prompt, efficient, and accurate. Couldn't have asked for more. I cannot thank you enough for your help.

Mary C.Freshfield, Liverpool, UK

This expert is wonderful. They truly know what they are talking about, and they actually care about you. They really helped put my nerves at ease. Thank you so much!!!!

AlexLos Angeles, CA

Thank you for all your help. It is nice to know that this service is here for people like myself, who need answers fast and are not sure who to consult.

GPHesperia, CA

I couldn't be more satisfied! This is the site I will always come to when I need a second opinion.

JustinKernersville, NC

Just let me say that this encounter has been entirely professional and most helpful. I liked that I could ask additional questions and get answered in a very short turn around.

EstherWoodstock, NY

Thank you so much for taking your time and knowledge to support my concerns. Not only did you answer my questions, you even took it a step further with replying with more pertinent information I needed to know.

RobinElkton, Maryland

He answered my question promptly and gave me accurate, detailed information. If all of your experts are half as good, you have a great thing going here.

DianeDallas, TX

< Previous | Next >

Meet the Experts:

Dominick

Dominick

Marine Mechanic

1,009 satisfied customers

25 Years Experience as Mechanic, 20 Yrs Boat Yard Owner/Mechanic, Factory Certified

Ted G.

Ted G.

Rigger, Diagnostician

704 satisfied customers

40 years boating, Safe boating instruct., Offshore Race promoter, Failure Analysis, Expert Witness

John White

John White

Marine Mechanic

306 satisfied customers

11 years experience working on outboards, inboards, sterndrives & pwcs

Jason

Jason

Marine Mechanic

17,310 satisfied customers

Degree in Marine Technology. Gas and diesel marine mechanic.

Tan

Tan

MerCruiser Certified Technician

11,264 satisfied customers

40 yrs. experience with complete engine repairs both inboard/outboard and MerCruiser Certified Technician.

Jeff G.

Jeff G.

Marine Mechanic

4,729 satisfied customers

42 years experience, Certified Master Technician, All Major Outboards, Sterndrives, Hi-Performance

Captain Dave

Captain Dave

Marine Mechanic

2,672 satisfied customers

USCG Licensed Captain, 20+ Years Boating, Fishing, Maintenance and Repair Experience

< Previous | Next >

Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

Show MoreShow Less

Ask Your Question

x