Boat

Have Boat Questions? Ask a Boat Repair Expert.

Connect one-on-one with {0} who will answer your question

Related Boat Questions
Having problem with maintain rpms at wot. motor is an erude
Having problem with maintain rpms at wot. motor is an erude 1990 150hp with vro disconnected. fuel vacuum switch bypassed to determine cause of horn sounding an intermitten beep. new powerpack and wat… read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,399 satisfied customers
I have just replaced a 2002 Mercury (ser. #OT728950) 40hp 2
I have just replaced a 2002 Mercury (ser. #OT728950) 40hp 2 cycle with a 2013 Mercury (ser. #1C235905) 40hp 4 stroke. I bought a wiring harness adapter to make the new motor compatible with the remote… read more
Charles
Charles
Marine Mechanic
5,244 satisfied customers
I have a mercury 2007 225hp optimax. It's on a 25ft c_hawk.
Hi. I have a mercury 2007 225hp optimax. It's on a 25ft c_hawk . When I first got the boat I used a 18 gallon tank above the floor but now have switched over to the tank in the floor after pumping it … read more
Michael
Michael
master marine technician/charter captain
Vocational, Technical or Trade Scho
256 satisfied customers
I have an 2008 mercury bigfoot 50hp. Every since it was
I have an 2008 mercury bigfoot 50hp. Every since it was brand new it surges about 100 to 300 rpms between 3000 and 4000 rpms. I took it in once they said it was fixed came home still the same. 1 1/2 h… read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade Scho
18,277 satisfied customers
2006 Mercury 40hp EFI bigfoot. Motor cranks-problem getting
2006 Mercury 40hp EFI bigfoot. Motor cranks-problem getting fuel to injectors-installed new fuel pump-spark plugs-cleaned fuel tank,lines ect.. Below the ingition coils there is what looks like an add… read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade Scho
18,277 satisfied customers
Problem with volvo penta 489hp losing revs and having power
Problem with volvo penta 489hp losing revs and having power surges. Problem is intermittent making it hard to work out what is happening Any suggestions?… read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,399 satisfied customers
I have a 40hp bigfoot 2005 eptl. When cruzing it starts to
I have a 40hp bigfoot 2005 eptl. When cruzing it starts to loose power and the primer bulb has to be squeezed several times and it picks back up. I changsd water gas sep filter, in line and canistsr f… read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,399 satisfied customers
On 11/28 2011 you answered a querry concerning twin 270 hp
On 11/28 2011 you answered a querry concerning twin 270 hp crusader engine 1988. I have similar engines with the same problem. The port engine loses rpm after about 30 minutes of running at about 3200… read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,399 satisfied customers
Can water in fuel tank just cause poor performance such as
Can water in fuel tank just cause poor performance such as low top rpm (3200) with vibration or would it affect starting as well? I have a 2006 Bigfoot 40hp on a 20ft Pontoon. I get slightly better pe… read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,399 satisfied customers
i have a 2003 60hp mercury bigfoot rebuilt carbs set float
i have a 2003 60hp mercury bigfoot rebuilt carbs set float from carb body at 9/16 as service manuel indicated. set linkage to service manaul instructions set idle timing to from 2 degree btdc and two … read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,399 satisfied customers
My boss has a Honda BF200 I believe about a 2002 with surging
My boss has a Honda BF200 I believe about a 2002 with surging issues. on its last trip out the starboard engine began to surge at about 2200 rpm's and continued without letting up the entire trip. The… read more
James
James
Certified Marine Mechanic
Vocational, Technical or Trade Scho
4,094 satisfied customers
We have a Regal Commodore 402 with two 7.4L MPI 454s. Starboard
We have a Regal Commodore 402 with two 7.4L MPI 454s. Starboard engine had 73PSI at the schraeder valve. Replaced fuel pump, same thing. Replaced fuel pressure regulator, same thing. Checked for any f… read more
James
James
Certified Marine Mechanic
Vocational, Technical or Trade Scho
4,094 satisfied customers
I have a 1994 40hp Evinrude outboard motor. It has a oil injector/fuel
I have a 1994 40hp Evinrude outboard motor. It has a oil injector/fuel pump assy on it now. The fuel pump is bad so i want to get rid of the oil injector and put a regular block fuel pump on it and mi… read more
Noel Schembri
Noel Schembri
Marine mechanic
Diploma
1,793 satisfied customers
I have a 1999 MerCruiser 350 MPI MAG Bluewater Inboard MIE
I have a 1999 MerCruiser 350 MPI MAG Bluewater Inboard MIE engine in my Shamrock 26' boat. The engine had ~850 hours on it last season, so we removed it and had it freshened up. New pistons, rings, be… read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,399 satisfied customers
I have a 310 Celebrity with twin 5.0 Volvos. The boat is new
I have a 310 Celebrity with twin 5.0 Volvos. The boat is new to me and prior to purchase I had the boat inspected and all recommended work performed. I just got the boat back from the local service sh… read more
James
James
Certified Marine Mechanic
Vocational, Technical or Trade Scho
4,094 satisfied customers
Hello! I have an intermittent problem with my 93 7.4 litre
Hello! I have an intermittent problem with my '93 7.4 litre carbureted mercruiser Bravo 1. After running fine for between 20 minutes to an hour, it will start to lose power. When it does this, I can b… read more
Dominick
Dominick
Marine Mechanic
Vocational, Technical or Trade Scho
1,009 satisfied customers
I have the 1gm10. I neglected to open the the fuel tank vent.
I have the 1gm10. I neglected to open the the fuel tank vent. the motor died. I have done the bleed as far as the filter. However, I can't get fuel to show at the high pressure line from the filter. I… read more
Yachtwork
Yachtwork
Owner Team Yachtwork
Technical or Trade School
1,048 satisfied customers
I have a 1970 Uniflite power boat with twin 318 Chrysler eng
I have one of two 318 Chryslers in a 31' powerboat, that was recently rebuilt, ever since rebuild it runs good, it will run great up to about 2800 rpm, then it will lose power, lose vacuum, and will s… read more
Captain Dave
Captain Dave
Marine Mechanic
Master's Degree
2,672 satisfied customers
Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

JustAnswer in the News:

Ask-a-doc Web sites: If you've got a quick question, you can try to get an answer from sites that say they have various specialists on hand to give quick answers... Justanswer.com.
JustAnswer.com...has seen a spike since October in legal questions from readers about layoffs, unemployment and severance.
Web sites like justanswer.com/legal
...leave nothing to chance.
Traffic on JustAnswer rose 14 percent...and had nearly 400,000 page views in 30 days...inquiries related to stress, high blood pressure, drinking and heart pain jumped 33 percent.
Tory Johnson, GMA Workplace Contributor, discusses work-from-home jobs, such as JustAnswer in which verified Experts answer people’s questions.
I will tell you that...the things you have to go through to be an Expert are quite rigorous.

What Customers are Saying:

Wonderful service, prompt, efficient, and accurate. Couldn't have asked for more. I cannot thank you enough for your help.

Mary C.Freshfield, Liverpool, UK

This expert is wonderful. They truly know what they are talking about, and they actually care about you. They really helped put my nerves at ease. Thank you so much!!!!

AlexLos Angeles, CA

Thank you for all your help. It is nice to know that this service is here for people like myself, who need answers fast and are not sure who to consult.

GPHesperia, CA

I couldn't be more satisfied! This is the site I will always come to when I need a second opinion.

JustinKernersville, NC

Just let me say that this encounter has been entirely professional and most helpful. I liked that I could ask additional questions and get answered in a very short turn around.

EstherWoodstock, NY

Thank you so much for taking your time and knowledge to support my concerns. Not only did you answer my questions, you even took it a step further with replying with more pertinent information I needed to know.

RobinElkton, Maryland

He answered my question promptly and gave me accurate, detailed information. If all of your experts are half as good, you have a great thing going here.

DianeDallas, TX

< Previous | Next >

Meet the Experts:

Dominick

Dominick

Marine Mechanic

1,009 satisfied customers

25 Years Experience as Mechanic, 20 Yrs Boat Yard Owner/Mechanic, Factory Certified

Ted G.

Ted G.

Rigger, Diagnostician

747 satisfied customers

40 years boating, Safe boating instruct., Offshore Race promoter, Failure Analysis, Expert Witness

John White

John White

Marine Mechanic

306 satisfied customers

11 years experience working on outboards, inboards, sterndrives & pwcs

Jason

Jason

Marine Mechanic

18,277 satisfied customers

Degree in Marine Technology. Gas and diesel marine mechanic.

Tan

Tan

MerCruiser Certified Technician

11,399 satisfied customers

40 yrs. experience with complete engine repairs both inboard/outboard and MerCruiser Certified Technician.

Jeff G.

Jeff G.

Marine Mechanic

4,730 satisfied customers

42 years experience, Certified Master Technician, All Major Outboards, Sterndrives, Hi-Performance

Captain Dave

Captain Dave

Marine Mechanic

2,672 satisfied customers

USCG Licensed Captain, 20+ Years Boating, Fishing, Maintenance and Repair Experience

< Previous | Next >

Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

Show MoreShow Less

Ask Your Question

x