Boat

Have Boat Questions? Ask a Boat Repair Expert.

Connect one-on-one with {0} who will answer your question

Related Boat Questions
My 2016 Yamaha 300 hp is diving while running when rpm's are
my 2016 Yamaha 300 hp is diving while running when rpm's are 2800-3200. over that rpm it runs fine and under that rpm it runs fine as well … read more
Blake P
Blake P
Certified RV & Marine Technician
120 satisfied customers
Idle speed missing and engine dies. When slowing to a slow
When slowing to a slow or idle speed the engine is cutting off. It had been missing a little but just started cutting off. I have been putting in neutral and reving the motor then quickly into gear. … read more
Charles
Charles
Certified Mercury Tech
5,366 satisfied customers
I just replaced my 1992 90 hp Yamaha outboard with a 1986
I just replaced my 1992 90 hp Yamaha outboard with a 1986 115 Yamaha outboard on a 1992 17 foot Scout boat. All the wiring and cables hooked up. When first starting the motor it reved up high and had … read more
Jeff G.
Jeff G.
Marine Mechanic
Vocational, Technical or Trade Scho
4,730 satisfied customers
Late 70's merc 85 hp. Outboard motor. Several years ago I
Late 70's merc 85 hp. Outboard motor. Several years ago I took the lower unit in to the shop for work on (seals, bearings, water pump) and I remounted it. I also removed the starter button and key to … read more
Jeff G.
Jeff G.
Marine Mechanic
Vocational, Technical or Trade Scho
4,730 satisfied customers
My motor will not go over 4K RPM it goes into guardian mode?
My motor will not go over 4K RPM it goes into guardian mode? It does this whether in neutral or drive. Is there an over rev limiter while in neutral and is there a switch that tells the motor that it … read more
Charles
Charles
Certified Mercury Tech
5,366 satisfied customers
I have a 115 HP Mercury Outboard (2007)..... When getting RPMs
I have a 115 HP Mercury Outboard (2007)..... When getting RPM's 0ver 2500 motor cuts out and alarm goes off (I'm sure it is the heat alarm)..... I have replaced the heat sensor, impeller, gasoline fil… read more
Charles
Charles
Certified Mercury Tech
5,366 satisfied customers
I have a 2004 Yamaha HPDI 250. Have had numerous issues with
I have a 2004 Yamaha HPDI 250. Have had numerous issues with boat and motor that have left it in the shop. Present issue is there is fire to all 6 cylinders at ignition. Motor idles correctly. However… read more
Jason
Jason
Marine Mechanic
19,307 satisfied customers
I have a 2003 Crownline 208 bowrider with a Volvo Penta i/o
I have a 2003 Crownline 208 bowrider with a Volvo Penta i/o 5.0GL 4-stroke V8 engine. We only go boating right now about 1 every two months. The boat is on a trailer at our house, so every weekend I t… read more
James
James
Certified Marine Mechanic
Vocational, Technical or Trade Scho
4,094 satisfied customers
I recently purchased a boat with a Yamaha 115 hp outboard (S/N
I recently purchased a boat with a Yamaha 115 hp outboard (S/N C115TXRQ) that idles too fast. I haven't put a tachometer on it yet but even in the lowest throttle position pushes the boat along to qui… read more
Jason Forsberg
Jason Forsberg
Outboard Marine Mechanic
Vocational, Technical or Trade Scho
531 satisfied customers
1986 70 hp Yamaha outboard motor Problem: Will start and
1986 70 hp Yamaha outboard motor Problem: Will start and run just fine. After a few minutes the motor goes into a serious shake. Almost like if it had a bent prop. But it acts the same if it is in neu… read more
orcamarine
orcamarine
Proprietor
Vocational, Technical or Trade Scho
7 satisfied customers
I have an 08 stratos 176 xt. Has a 50 hp yamaha motor. Took
I have an 08 stratos 176 xt. Has a 50 hp yamaha motor. Took cover off and went to start it up. I primed the motor and turned ignition. Did not start up but cranking. I anm new to these newer boats. An… read more
James
James
Certified Marine Mechanic
Vocational, Technical or Trade Scho
4,094 satisfied customers
I have a 1992 18 four winns I/O bowrider (180 Freedom). I
I have a 1992 18' four winns I/O bowrider (180 Freedom). I was pulling my kids today on a tube and all of a sudden I lost torque at the propeller. With the throttles full forward the tach would read a… read more
James
James
Certified Marine Mechanic
Vocational, Technical or Trade Scho
4,094 satisfied customers
1994 Yamaha 115 2 stroke outboard w/ 704 Yamaha Remote Control
1994 Yamaha 115 2 stroke outboard w/ 704 Yamaha "Remote Control" was cruising along just fine. Coming in to dock, shifted to neutral, then reverse to complete docking. motor stayed in neutral (tho con… read more
James
James
Certified Marine Mechanic
Vocational, Technical or Trade Scho
4,094 satisfied customers
I have a 2003 115 4 stroke yamaha; the last two times on water
I have a 2003 115 4 stroke yamaha; the last two times on water an alarm went off, I shut the motor off, and it would not crank. After I got it home; two days later I hooked the water hose to it and it… read more
Jeremy R.
Jeremy R.
5,362 satisfied customers
I have a yamaha 650 lx jetski and it has been started for a
I have a yamaha 650 lx jetski and it has been started for a year I started it out of water with water hooked up and it ideled ok when I gave it some throttle it reved up and would not rev back down fo… read more
James
James
Certified Marine Mechanic
Vocational, Technical or Trade Scho
4,094 satisfied customers
I have a mercury outboard, its a 50 hp. 4 stroke engine, sitting
I have a mercury outboard, it's a 50 hp. 4 stroke engine, sitting at idle the engine will attain 6000 rpms. but when I go out and put aload on it, it will only attain about 3500 to 3800 rpms and thats… read more
Larry B.
Larry B.
Marine Service Tech
High School or GED
574 satisfied customers
I have a Yamaha 115 outboard engine. The problem is the prop
I have a Yamaha 115 outboard engine. The problem is the prop turns while throttle is in neutral. This I believe is causing the engine to stall while in neutral. What would cause the prop to turn?… read more
ROCKET
ROCKET
MASTER CERTIFIED TECH
Vocational, Technical or Trade Scho
426 satisfied customers
My 70 hp Yamaha motor 1986 will not trim down completely and
My 70 hp Yamaha motor 1986? will not trim down completely and seems to work slow, as well when I hold the trim button down when at speed above 2,000 rpm it drops the prms considerably. I am new to boa… read more
orcamarine
orcamarine
Proprietor
Vocational, Technical or Trade Scho
7 satisfied customers
Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

JustAnswer in the News:

Ask-a-doc Web sites: If you've got a quick question, you can try to get an answer from sites that say they have various specialists on hand to give quick answers... Justanswer.com.
JustAnswer.com...has seen a spike since October in legal questions from readers about layoffs, unemployment and severance.
Web sites like justanswer.com/legal
...leave nothing to chance.
Traffic on JustAnswer rose 14 percent...and had nearly 400,000 page views in 30 days...inquiries related to stress, high blood pressure, drinking and heart pain jumped 33 percent.
Tory Johnson, GMA Workplace Contributor, discusses work-from-home jobs, such as JustAnswer in which verified Experts answer people’s questions.
I will tell you that...the things you have to go through to be an Expert are quite rigorous.

What Customers are Saying:

Wonderful service, prompt, efficient, and accurate. Couldn't have asked for more. I cannot thank you enough for your help.

Mary C.Freshfield, Liverpool, UK

This expert is wonderful. They truly know what they are talking about, and they actually care about you. They really helped put my nerves at ease. Thank you so much!!!!

AlexLos Angeles, CA

Thank you for all your help. It is nice to know that this service is here for people like myself, who need answers fast and are not sure who to consult.

GPHesperia, CA

I couldn't be more satisfied! This is the site I will always come to when I need a second opinion.

JustinKernersville, NC

Just let me say that this encounter has been entirely professional and most helpful. I liked that I could ask additional questions and get answered in a very short turn around.

EstherWoodstock, NY

Thank you so much for taking your time and knowledge to support my concerns. Not only did you answer my questions, you even took it a step further with replying with more pertinent information I needed to know.

RobinElkton, Maryland

He answered my question promptly and gave me accurate, detailed information. If all of your experts are half as good, you have a great thing going here.

DianeDallas, TX

< Previous | Next >

Meet the Experts:

Dominick

Dominick

Marine Mechanic

1,009 satisfied customers

25 Years Experience as Mechanic, 20 Yrs Boat Yard Owner/Mechanic, Factory Certified

Ted G.

Ted G.

Rigger, Diagnostician

747 satisfied customers

40 years boating, Safe boating instruct., Offshore Race promoter, Failure Analysis, Expert Witness

John White

John White

Marine Mechanic

306 satisfied customers

11 years experience working on outboards, inboards, sterndrives & pwcs

Jason

Jason

Marine Mechanic

19,307 satisfied customers

Degree in Marine Technology. Gas and diesel marine mechanic.

Tan

Tan

MerCruiser Certified Technician

11,399 satisfied customers

40 yrs. experience with complete engine repairs both inboard/outboard and MerCruiser Certified Technician.

Jeff G.

Jeff G.

Marine Mechanic

4,730 satisfied customers

42 years experience, Certified Master Technician, All Major Outboards, Sterndrives, Hi-Performance

Captain Dave

Captain Dave

Marine Mechanic

2,672 satisfied customers

USCG Licensed Captain, 20+ Years Boating, Fishing, Maintenance and Repair Experience

< Previous | Next >

Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

Show MoreShow Less

Ask Your Question

x