Boat

Have Boat Questions? Ask a Boat Repair Expert.

Ask an Expert,
Get an Answer ASAP!

Related Boat Questions
I inherited a 1998 Ranger fishing boat. And while we were
I inherited a 1998 Ranger fishing boat. And while we were going fast it started to shriek. I adjusted the motor but, noting happened. I have a 200 horse Merc motor. … read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade Scho
17,310 satisfied customers
I Have a mercruiser 5.7 and it over heated. when i put
i Have a mercruiser 5.7 and it over heated. when i put antifreeze in it it all disappears. there is no water in the oil but when i pulled the plugs there was water on four of them on the same side of … read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade Scho
17,310 satisfied customers
Its a mercrusier EFI 35o chevy in a Malibuand just ran it no
its a mercrusier EFI 35o chevy in a Malibuand just ran it no power ?? only goes 30 mph flat out someone suggested fuel filter boat sat all winter … read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade Scho
17,310 satisfied customers
I need to order a Bravo 2 upper and lower gear case seal kit
Hi Jason, I need to order a Bravo 2 upper and lower gear case seal kit and possibly bearings for my 2004 Bayliner 289EC 1431 with Bravo 2 2.20 to 1. I think these are the OEM numbers 26-76868A2 & 26-1… read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade Scho
17,310 satisfied customers
Bayliner 1989 Avanti 3255 Sundeck: Looking for a electric
looking for a electric diagram (Motor Part for Bayliner 1989 Avanti Sundeck … read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade Scho
17,310 satisfied customers
I lost the gears overnight. The engine starts and shifts
I lost the gears overnight. The engine starts and shifts into forward or aft fine but the gears don't engage. I can also start it in gear. … read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade Scho
17,310 satisfied customers
After about an hour of running my port engine rpm drop from
After about an hour of running my port engine rpm drop from 3500 rpm to 1000, then goes up and down. Eventually it will steady at 2100 but will not go higher. After turning off for about a half hour i… read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade Scho
17,310 satisfied customers
Mercury 2010 60 HP Outboard. Sudden onset rough idle, low
Mercury 2010 60 HP Outboard. Sudden onset rough idle, low power, stumbles, spits. feels like its down a cylinder. Local marina scans and finds no stored codes or issues. eliminated water in the fuel a… read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade Scho
17,310 satisfied customers
My Bayliner 245 BR has a similar beeping noise when it is
My Bayliner 245 BR has a similar beeping noise when it is running at mid-throttle. If I idle, drive slower or very fast it goes away. … read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade Scho
17,310 satisfied customers
I have a rubber line that hooks on to what looks like a
I have a rubber line that hooks on to what looks like a filter on one and fits on to another line on the other end on a Mercury 50 horse out board it looks like the fittings the line goes over are dif… read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade Scho
17,310 satisfied customers
My new 30 horse 4 stroke won't go over 3200 at full
my new 30 horse 4 stroke won't go over 3200 at full throttle … read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade Scho
17,310 satisfied customers
I am looking for part numberfor my 2003 maxum 2400 sd it is
I am looking for part number(###) ###-####for my 2003 maxum 2400 sd it is a u shaped window braket that goes to my convertable top (bimini) … read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,264 satisfied customers
I have 2006 bigfoot 60 horse. Plugs just replaced but engine
I have 2006 bigfoot 60 horse. Plugs just replaced but engine runs rough and won't get my boat to top speed. … read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade Scho
17,310 satisfied customers
Would a faulty ignition module cause catastrophic engine
Would a faulty ignition module cause catastrophic engine damage? … read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade Scho
17,310 satisfied customers
I'm looking at a bayliner avanti '89 3486. Did Bayliner core
I'm looking at a bayliner avanti '89 3486. Did Bayliner core the bottom on that boat and if so what did they use (foam or wood). Pascoe seems to think cored bottoms are a big problem. Also twin fwc 45… read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade Scho
17,310 satisfied customers
Hello, We are considering purchasing a Bayliner and some have
Hello, We are considering purchasing a Bayliner and some have Hino's and some Cummins. I looked at one today that had Cummins and the salesman noted that since Bayliner was the only boat builder to us… read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade Scho
17,310 satisfied customers
Hino 150 runs up to 198 F at 2700 rpm and stays there. Cools
Hino 150 runs up to 198 F at 2700 rpm and stays there. Cools right down slightly below normal at 1700. Plenty of water out the exhaust. Could high temperature be caused by bad thermostat?… read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,264 satisfied customers
Hi, I have a 1989 3400 Mariner Cruiser with nicknamed smokey
Hi, I have a 1989 3400 Mariner Cruiser with nicknamed "smokey" TAMD 40A's. Flaps used in exhaust pipes used as a remedy have been removed.If I rebuild the motors what would you sugest I do to fix the … read more
Diesel Boat Doc
Diesel Boat Doc
High School or GED
120 satisfied customers
Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

JustAnswer in the News:

Ask-a-doc Web sites: If you've got a quick question, you can try to get an answer from sites that say they have various specialists on hand to give quick answers... Justanswer.com.
JustAnswer.com...has seen a spike since October in legal questions from readers about layoffs, unemployment and severance.
Web sites like justanswer.com/legal
...leave nothing to chance.
Traffic on JustAnswer rose 14 percent...and had nearly 400,000 page views in 30 days...inquiries related to stress, high blood pressure, drinking and heart pain jumped 33 percent.
Tory Johnson, GMA Workplace Contributor, discusses work-from-home jobs, such as JustAnswer in which verified Experts answer people’s questions.
I will tell you that...the things you have to go through to be an Expert are quite rigorous.

What Customers are Saying:

Wonderful service, prompt, efficient, and accurate. Couldn't have asked for more. I cannot thank you enough for your help.

Mary C.Freshfield, Liverpool, UK

This expert is wonderful. They truly know what they are talking about, and they actually care about you. They really helped put my nerves at ease. Thank you so much!!!!

AlexLos Angeles, CA

Thank you for all your help. It is nice to know that this service is here for people like myself, who need answers fast and are not sure who to consult.

GPHesperia, CA

I couldn't be more satisfied! This is the site I will always come to when I need a second opinion.

JustinKernersville, NC

Just let me say that this encounter has been entirely professional and most helpful. I liked that I could ask additional questions and get answered in a very short turn around.

EstherWoodstock, NY

Thank you so much for taking your time and knowledge to support my concerns. Not only did you answer my questions, you even took it a step further with replying with more pertinent information I needed to know.

RobinElkton, Maryland

He answered my question promptly and gave me accurate, detailed information. If all of your experts are half as good, you have a great thing going here.

DianeDallas, TX

< Previous | Next >

Meet the Experts:

Dominick

Dominick

Marine Mechanic

1,009 satisfied customers

25 Years Experience as Mechanic, 20 Yrs Boat Yard Owner/Mechanic, Factory Certified

Ted G.

Ted G.

Rigger, Diagnostician

704 satisfied customers

40 years boating, Safe boating instruct., Offshore Race promoter, Failure Analysis, Expert Witness

John White

John White

Marine Mechanic

306 satisfied customers

11 years experience working on outboards, inboards, sterndrives & pwcs

Jason

Jason

Marine Mechanic

17,310 satisfied customers

Degree in Marine Technology. Gas and diesel marine mechanic.

Tan

Tan

MerCruiser Certified Technician

11,264 satisfied customers

40 yrs. experience with complete engine repairs both inboard/outboard and MerCruiser Certified Technician.

Jeff G.

Jeff G.

Marine Mechanic

4,729 satisfied customers

42 years experience, Certified Master Technician, All Major Outboards, Sterndrives, Hi-Performance

Captain Dave

Captain Dave

Marine Mechanic

2,672 satisfied customers

USCG Licensed Captain, 20+ Years Boating, Fishing, Maintenance and Repair Experience

< Previous | Next >

Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

Show MoreShow Less

Ask Your Question

x