Boat

Have Boat Questions? Ask a Boat Repair Expert.

Connect one-on-one with {0} who will answer your question

Related Boat Questions
Yanmar 6CXM GTE- White/grey fuel- smoke- engine has a
Yanmar 6CXM GTE- White/grey fuel- smoke- engine has a “bubbling” sound when pushed to 1000 rpms- as if not all cylinders are firing off- idk- smoke clears up after it warms up but no change in the way… read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade Scho
18,277 satisfied customers
1998 Mariner 225 3.ltr 2 stroke EFI: Starts just fine, idle
1998 Mariner 225 3.ltr 2 stroke EFI: Starts just fine, idle is smooth but at times will increases on its own. When powering up to get on step, it is hesitant and seems to try to get with the program t… read more
Shane Creekmore
Shane Creekmore
Certified Mercury Marine technician
High School or GED
354 satisfied customers
I have an older 3208 NA 210 HP caterpillar in my commercial
I have an older 3208 NA 210 HP caterpillar in my commercial work boat. This week it starting losing high rpm power and was blowing black smoke out of the port side. We had an old Kenworth a long time … read more
K. Kergan
K. Kergan
Inboard/Outboard Mechanic
Vocational, Technical or Trade Scho
1,031 satisfied customers
2000 Crusader 7.4L MPI MEFI FWC in 2000 2900 Tiara problem
2000 Crusader 7.4L MPI MEFI FWC in 2000 2900 Tiara problem started yesterday - CEL came on at idle - ran rough - when increase throttle, ran smooth - cruised fine at 3200 RPM for an hour. However, whe… read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade Scho
18,277 satisfied customers
Tan, After I start my 350 MAG MPI and it warms up I get
Tan, After I start my 350 MAG MPI and it warms up I get smoke coming from the starboard exhaust. This disappears when I increase rpm's It's a whitish smoke but smells of fumes or oil.… read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,504 satisfied customers
Hi Jason I have a 2008 150 optimax that stalls underload when
Hi Jason I have a 2008 150 optimax that stalls underload when in gear but will clear up when you run it wot then bring it back to idle again . But if you leave it about 15-20 minutes at idle it will b… read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade Scho
18,277 satisfied customers
I own a 1996 21 Chaparral with a carbureted 350 inboard engine.
I own a 1996 21' Chaparral with a carbureted 350 inboard engine. It only has about 300 hours on it. I have noticed that it's performance has dropped considerably in the last few years. The maximum rpm… read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade Scho
18,277 satisfied customers
I have 1987 350/270 crusaders 1160 hrs. Im have an issue
I have 1987 350/270 crusaders 1160 hrs. I'm have an issue with my port engine, starts up fine. Idle is a little rough. Louder than the starboard. Up to 1200 RPM they both seemed the same, after that I… read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade Scho
18,277 satisfied customers
I have a Yanmar 4JH3/HTE in my Uniflight Salty Pup. I just
I have a Yanmar 4JH3/HTE in my Uniflight Salty Pup. I just bought this boat and ran it today for the first time. The engine started right up and seemed to run well. After she was warmed up, I tried to… read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade Scho
18,277 satisfied customers
99 250 efi merc twin engines, strbd engine idles ruff and
99 250 efi merc twin engines, strbd engine idles ruff and has oil smoke at idle even when warmed up. it obviously has too much oil going in at idle. it runs great off idle up to wot of 5800rpm. the pl… read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade Scho
18,277 satisfied customers
Hi-i have twin 350 CI Crusaders (1987)-both of which were changed
Hi-i have twin 350 CI Crusaders (1987)-both of which were changed over to electronic ignition a few years ago. Last year the port engine began to "drop out" (not stall) intermitently, at various times… read more
briggs archer
briggs archer
master marine mechanic
Associate Degree
374 satisfied customers
just replaced exhaust manifold and turbo box on marine Perkins
just replaced exhaust manifold and turbo box on marine Perkins ht 6354. when tested, black smoke from exhaust. when exhaust manifold was removed one port was very wet with oil. as was the turbo base b… read more
KKassel
KKassel
OWNER
High School or GED
381 satisfied customers
I have a 1979 350/260hp chevy mercruiser with 440hrs. on it.
I have a 1979 350/260hp chevy mercruiser with 440hrs. on it. It starts good when first on the water, but after running for awhile it wants to die @ idle. I pulled all of the plugs and ran a compressio… read more
James
James
Certified Marine Mechanic
Vocational, Technical or Trade Scho
4,094 satisfied customers
Hi, I have a Fairline Phantom 43 motor boat fitted with TAM
Hi, I have a Fairline Phantom 43 motor boat fitted with TAM 75 P engines, recently I noticed excessive carbon deposits on the rear transom area, this has steadily got worse. Last weekend I took the bo… read more
Yachtwork
Yachtwork
Owner Team Yachtwork
Technical or Trade School
1,048 satisfied customers
I have two Crusader inboard 2001 MPI HO 5.7L V8s. The port
I have two Crusader inboard 2001 MPI HO 5.7L V8's. The port engine is having problems and keeps stalling. After multiple attempts, I have to run it at a higher rpm to keep it from stalling out. When I… read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,504 satisfied customers
I have twin 350 crusaders with rochester quadra carbs...the
I have twin 350 crusaders with rochester quadra carbs...the starbord engine starts rough and blows out black smoke...runs great after warming up...how can i adjust carb or choke… read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade Scho
18,277 satisfied customers
My Volvo MD5A throws out a small amount of grey oily water
My Volvo MD5A throws out a small amount of grey oily water from the exhaust and the exhaust smoke looks a little darker aswell, when I rev the engine over half full revs, I guess about 1000rpm. Below … read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,504 satisfied customers
I have a 1995 regal commador 256 with a 5.7 350 gi. It wont
I have a 1995 regal commador 256 with a 5.7 350 gi. It won't get on top,the engine wont go over 1800rpm's. It revs fine in out of gear. Changed Hi & Lo fuel pumps, oil sending unit,& guages.Just seems… read more
Yachtwork
Yachtwork
Owner Team Yachtwork
Technical or Trade School
1,048 satisfied customers
Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

JustAnswer in the News:

Ask-a-doc Web sites: If you've got a quick question, you can try to get an answer from sites that say they have various specialists on hand to give quick answers... Justanswer.com.
JustAnswer.com...has seen a spike since October in legal questions from readers about layoffs, unemployment and severance.
Web sites like justanswer.com/legal
...leave nothing to chance.
Traffic on JustAnswer rose 14 percent...and had nearly 400,000 page views in 30 days...inquiries related to stress, high blood pressure, drinking and heart pain jumped 33 percent.
Tory Johnson, GMA Workplace Contributor, discusses work-from-home jobs, such as JustAnswer in which verified Experts answer people’s questions.
I will tell you that...the things you have to go through to be an Expert are quite rigorous.

What Customers are Saying:

Wonderful service, prompt, efficient, and accurate. Couldn't have asked for more. I cannot thank you enough for your help.

Mary C.Freshfield, Liverpool, UK

This expert is wonderful. They truly know what they are talking about, and they actually care about you. They really helped put my nerves at ease. Thank you so much!!!!

AlexLos Angeles, CA

Thank you for all your help. It is nice to know that this service is here for people like myself, who need answers fast and are not sure who to consult.

GPHesperia, CA

I couldn't be more satisfied! This is the site I will always come to when I need a second opinion.

JustinKernersville, NC

Just let me say that this encounter has been entirely professional and most helpful. I liked that I could ask additional questions and get answered in a very short turn around.

EstherWoodstock, NY

Thank you so much for taking your time and knowledge to support my concerns. Not only did you answer my questions, you even took it a step further with replying with more pertinent information I needed to know.

RobinElkton, Maryland

He answered my question promptly and gave me accurate, detailed information. If all of your experts are half as good, you have a great thing going here.

DianeDallas, TX

< Previous | Next >

Meet the Experts:

Dominick

Dominick

Marine Mechanic

1,009 satisfied customers

25 Years Experience as Mechanic, 20 Yrs Boat Yard Owner/Mechanic, Factory Certified

Ted G.

Ted G.

Rigger, Diagnostician

747 satisfied customers

40 years boating, Safe boating instruct., Offshore Race promoter, Failure Analysis, Expert Witness

John White

John White

Marine Mechanic

306 satisfied customers

11 years experience working on outboards, inboards, sterndrives & pwcs

Jason

Jason

Marine Mechanic

18,277 satisfied customers

Degree in Marine Technology. Gas and diesel marine mechanic.

Tan

Tan

MerCruiser Certified Technician

11,504 satisfied customers

40 yrs. experience with complete engine repairs both inboard/outboard and MerCruiser Certified Technician.

Jeff G.

Jeff G.

Marine Mechanic

4,730 satisfied customers

42 years experience, Certified Master Technician, All Major Outboards, Sterndrives, Hi-Performance

Captain Dave

Captain Dave

Marine Mechanic

2,672 satisfied customers

USCG Licensed Captain, 20+ Years Boating, Fishing, Maintenance and Repair Experience

< Previous | Next >

Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

Show MoreShow Less

Ask Your Question

x