Boat

Have Boat Questions? Ask a Boat Repair Expert.

Ask an Expert,
Get an Answer ASAP!

Related Boat Questions
Yea 7.4 vovlo replaced the IAC rough idel was good replaced
hi yea 7.4 vovlo replaced the IAC rough idel was good replaced water pump mest have loosend the fuel filter also suspect throttle position sensor if I unplug it there is no differance … read more
Jason
Jason
Marine Mechanic
18,487 satisfied customers
2005 yamaha 225 4 strokes . 290 hrs . launched boat just idling
2005 yamaha 225 4 strokes . 290 hrs . launched boat just idling out of channel starboard motor died . we go anchor starts back up when give it gas then dies again . changed both fuel filter water /fue… read more
Jason
Jason
Marine Mechanic
18,487 satisfied customers
I have installed two new AIC control valves before we launched
I have installed two new AIC control valves before we launched the boat this year due to the boat stalling upon start up the year before. Engines are Mercruiser 7.4 2000 models. Upon launching, the bo… read more
Expert-Repair
Expert-Repair
Owner Kingsland Auto & Marine Services
Vocational, Technical or Trade Scho
11 satisfied customers
I have twin D3 diesels on my power cat. They would both always
I have twin D3 diesels on my power cat. They would both always pull 4,000 rpm at wot. recently, however, starboard won't pull more than 2,500rpm. Temps are good at about 180 degrees, fuel consumption … read more
Malta Tech
Malta Tech
Marine Tech
High School or GED
151 satisfied customers
Another question from this earlier post: "I have a 7.4 Gi
Another question from this earlier post: "I have a 7.4 Gi volvo penta (97'') and it was running mint and then it just slowed right down and stopped running. It turns over but shows no sign of starting… read more
James
James
Certified Marine Mechanic
Vocational, Technical or Trade Scho
4,094 satisfied customers
Hi, I have a (1999) Volvo Penta 7.4 GI, Ive not had the boat
Hi, I have a (1999) Volvo Penta 7.4 GI, I've not had the boat that long the maximum RPM I was getting was around 3000 rpm (with an F7 SS prop) which got the boat to around 28-30 mph, I thought this wa… read more
James
James
Certified Marine Mechanic
Vocational, Technical or Trade Scho
4,094 satisfied customers
I have twin 454 MIE 7.4L MerCruisers in a 1992 Sea Ray 370
I have twin 454 MIE 7.4L MerCruisers in a 1992 Sea Ray 370 Sedan Bridge. Both are original and run great. 1,000 hours each. My starboard engine occassionally stalls at idle either before pulling away … read more
James
James
Certified Marine Mechanic
Vocational, Technical or Trade Scho
4,094 satisfied customers
Hi, I have a 2004 Volvo Penta 5.7liter Gi that has two alarms
Hi, I have a 2004 Volvo Penta 5.7liter Gi that has two alarms going off: 1. Single Beep very 30 seconds 2. At high RPM's (4500+) the boat alarm will beep quickly, and then the engine automatically slo… read more
James
James
Certified Marine Mechanic
Vocational, Technical or Trade Scho
4,094 satisfied customers
I have a 1998 volvo penta 7.4 gi/dp. We have replaced the fuel
I have a 1998 volvo penta 7.4 gi/dp. We have replaced the fuel pump because it wasn't getting any fuel. now when we ran the boat to test it. It ran for about 30 minutes and then lost power to the fuel… read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,264 satisfied customers
WE HAVE A 2005 RINKER FIESTA VEE 342 WITH TWO VOLVO PENTA 5.7
WE HAVE A 2005 RINKER FIESTA VEE 342 WITH TWO VOLVO PENTA 5.7 OSXI-DF MOTORS. THE PORT MOTOR WILL ONLY TO GO 4000 RPM, BUT THE STERN MOTOR GOES TO 5000 RPM. WE ARE MIFFED.… read more
Jeremy R
Jeremy R
1,069 satisfied customers
I have a volvo penta 5.7 Gi in my Four Winns 268 vista cruiser.
I have a volvo penta 5.7 Gi in my Four Winns 268 vista cruiser. Started first time everytime for last four years, over the last few days it required two or three times cranking it over to start. Yeste… read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,264 satisfied customers
I have volvo 8.1 Gis in my boat, the starboard engine will
I have volvo 8.1 Gi's in my boat, the starboard engine will not get up to full RPM (2500-3000 tops) while under load (in gear and running), changed both filters (eng and racor), different tank (port),… read more
Dominick
Dominick
Marine Mechanic
Vocational, Technical or Trade Scho
1,009 satisfied customers
I have a 2001 volvo penta 7.4 gi with 1000 hrs on her.When
I have a 2001 volvo penta 7.4 gi with 1000 hrs on her.When idling ,sounds great but when you give her the throttle she breaks up,backfires & has no power.I have three cylinders reading 120#'s each & t… read more
James
James
Certified Marine Mechanic
Vocational, Technical or Trade Scho
4,094 satisfied customers
I have a 2001 7.4 gi volvo i/o,she idles beautiful,no knocking,
I have a 2001 7.4 gi volvo i/o,she idles beautiful,no knocking, can go anywhere @ 10 mph,then as I give her more throttle she backfires thru the flame arrestor & can't get up on plane,she has no power… read more
James
James
Certified Marine Mechanic
Vocational, Technical or Trade Scho
4,094 satisfied customers
I have two 1988 130HP outboards. They both feed off on water
I have two 1988 130HP outboards. They both feed off on water seperator designed for double feed. The Port motor runs perfect. The starboard motor starts great, runs good for time and then when running… read more
Shane
Shane
Technician
High School or GED
1 satisfied customers
I have a 1999 70HP 4 stroke fuel injected outboard Evinrude.
I have a 1999 70HP 4 stroke fuel injected outboard Evinrude. I have replaced the fuel filter and have this problem. The motor runs smooth up to about 2200 RPM but dies at 2500 RPM. It there some trans… read more
davesoutboard
davesoutboard
owner
Associate Degree
1,570 satisfied customers
have a 7.4volvo runs good every once in a while at low idle
have a 7.4volvo runs good every once in a while at low idle 600-650rpm shuts down, but will start right up, feels like its starving for gas, but pumps seem fine… read more
TOM
TOM
Vocational, Technical or Trade Scho
196 satisfied customers
1997 5.7 L GI Volvo Penta Over the past two years engine wo
1997 5.7 L GI Volvo Penta Over the past two years engine would start rev to 2500rpms then die would do three to 4 time before it would run, also would cut out if it was running at low rpms idle for pe… read more
Ted G.
Ted G.
Rigger, Diagnostician
Vocational, Technical or Trade Scho
704 satisfied customers
Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

JustAnswer in the News:

Ask-a-doc Web sites: If you've got a quick question, you can try to get an answer from sites that say they have various specialists on hand to give quick answers... Justanswer.com.
JustAnswer.com...has seen a spike since October in legal questions from readers about layoffs, unemployment and severance.
Web sites like justanswer.com/legal
...leave nothing to chance.
Traffic on JustAnswer rose 14 percent...and had nearly 400,000 page views in 30 days...inquiries related to stress, high blood pressure, drinking and heart pain jumped 33 percent.
Tory Johnson, GMA Workplace Contributor, discusses work-from-home jobs, such as JustAnswer in which verified Experts answer people’s questions.
I will tell you that...the things you have to go through to be an Expert are quite rigorous.

What Customers are Saying:

Wonderful service, prompt, efficient, and accurate. Couldn't have asked for more. I cannot thank you enough for your help.

Mary C.Freshfield, Liverpool, UK

This expert is wonderful. They truly know what they are talking about, and they actually care about you. They really helped put my nerves at ease. Thank you so much!!!!

AlexLos Angeles, CA

Thank you for all your help. It is nice to know that this service is here for people like myself, who need answers fast and are not sure who to consult.

GPHesperia, CA

I couldn't be more satisfied! This is the site I will always come to when I need a second opinion.

JustinKernersville, NC

Just let me say that this encounter has been entirely professional and most helpful. I liked that I could ask additional questions and get answered in a very short turn around.

EstherWoodstock, NY

Thank you so much for taking your time and knowledge to support my concerns. Not only did you answer my questions, you even took it a step further with replying with more pertinent information I needed to know.

RobinElkton, Maryland

He answered my question promptly and gave me accurate, detailed information. If all of your experts are half as good, you have a great thing going here.

DianeDallas, TX

< Previous | Next >

Meet the Experts:

Dominick

Dominick

Marine Mechanic

1,009 satisfied customers

25 Years Experience as Mechanic, 20 Yrs Boat Yard Owner/Mechanic, Factory Certified

Ted G.

Ted G.

Rigger, Diagnostician

704 satisfied customers

40 years boating, Safe boating instruct., Offshore Race promoter, Failure Analysis, Expert Witness

John White

John White

Marine Mechanic

306 satisfied customers

11 years experience working on outboards, inboards, sterndrives & pwcs

Jason

Jason

Marine Mechanic

18,487 satisfied customers

Degree in Marine Technology. Gas and diesel marine mechanic.

Tan

Tan

MerCruiser Certified Technician

11,264 satisfied customers

40 yrs. experience with complete engine repairs both inboard/outboard and MerCruiser Certified Technician.

Jeff G.

Jeff G.

Marine Mechanic

4,729 satisfied customers

42 years experience, Certified Master Technician, All Major Outboards, Sterndrives, Hi-Performance

Captain Dave

Captain Dave

Marine Mechanic

2,672 satisfied customers

USCG Licensed Captain, 20+ Years Boating, Fishing, Maintenance and Repair Experience

< Previous | Next >

Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

Show MoreShow Less

Ask Your Question

x