Boat

Have Boat Questions? Ask a Boat Repair Expert.

Connect one-on-one with {0} who will answer your question

Related Boat Questions
I have a 2000 50 hp only wants to run by spraying gas in
I have a 2000 50 hp johnson only wants to run by spraying gas in cards throat have rebuilt this motor used pistons has 145 lb compression on both. replaced reeds, redone carbs twice help … read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade School
22,043 satisfied customers
Do I need an engine pod or just a transom plate to hang a
Do I need an engine pod or just a transom plate to hang a Johnson 50hp on a 16' pontoon, as long as the cavitation plate is below water line. What is the pod used for? … read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade School
22,043 satisfied customers
I have a pontoon boat with 1999 75 hp outboard and can not
I have a pontoon boat with 1999 johnson 75 hp outboard and can not figure out how to increase idle speed when starting. There is a black rubber covered button on top of control which feels like is has… read more
Charles
Charles
Marine Mechanic
Certified Mercury Tech
5,754 satisfied customers
I have a 50 hp 1999 outboard. It was running fine at almost
Hello, I have a 50 hp Johnson 1999 outboard. It was running fine at almost full rpm's until I ran into seaweed and the motor started to over heat, no water coming out the water outlet hole. I brought … read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,409 satisfied customers
I have a 110hp Mercury outboard. It shifts easily when the
I have a 110hp Mercury outboard. It shifts easily when the motor is shut off. When I put it in the water and start the motor the shifter gets really stiff. What's wrong? Melvin… read more
Charles
Charles
Marine Mechanic
Certified Mercury Tech
5,754 satisfied customers
2000 johnson 50 hp outboard , loud pop while cruising and then
2000 johnson 50 hp outboard , loud pop while cruising and then it fell out of gear. It runs fine but will not go into either forward or reverse. With engine off, key out, I put the boat in forward gea… read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,409 satisfied customers
I just purchased a used pontoon with a 1999 Johnson 50 HP outboard
I just purchased a used pontoon with a 1999 Johnson 50 HP outboard model J50PLEE, When the motor is operating over 4000 RPM it occasionally starts to race and accelerate to over 5500 RPM. if kept at o… read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade School
22,043 satisfied customers
I have a 1999 Johnson 90 hp outboard. The motor seems to idle
I have a 1999 Johnson 90 hp outboard. The motor seems to idle pretty good and will operate at high speeds fine but once it has run for a bit and is shut down it will start and idle fine, but soon as I… read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade School
22,043 satisfied customers
i hsave a 96 crest 18 ft pontoon with a 70 hp johnson. the
i hsave a 96 crest 18 ft pontoon with a 70 hp johnson. the helm is located at the rear. the boat is rated 1900 lbs/75hp . when i am towing a tube, the majority of the outboard shaft is under water and… read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade School
22,043 satisfied customers
I have a 1996 130 HP johnson outboard Ran fine last year This
I have a 1996 130 HP johnson outboard Ran fine last year This year after taking out of storage I had a hard time starting it I though it might be the gas so I drained the tank put in new gas and new p… read more
Jeremy R.
Jeremy R.
5,362 satisfied customers
I have a 2004, 150HP XR6 Mercury Outboard that starts hard
I have a 2004, 150HP XR6 Mercury Outboard that starts hard when it is cold. I pump the ball unitl it is hard and push in the key to operate the choke, but it turns over for 30 seconds before it even f… read more
Whitecap36
Whitecap36
Service Manager/Technician
Vocational, Technical or Trade Scho
1,557 satisfied customers
I have a 2000 Johnson 150 HP outboard (carburated). It will
I have a 2000 Johnson 150 HP outboard (carburated). It will start, idle and run above about 1500 RPM fine. However it will quite frequently stall after puting it in gear, idling for a few seconds and … read more
Shane Creekmore
Shane Creekmore
Certified Mercury Marine technician
High School or GED
535 satisfied customers
I have a 2005 Mercury outboard 50 HP EPLO motor on a pontoon
I have a 2005 Mercury outboard 50 HP EPLO motor on a pontoon boat. The motor starts easily the first time but after running it for 2 to 4 hours around the lake and then leaving it turned off while we … read more
Jeremy R.
Jeremy R.
5,362 satisfied customers
I have a 1966 80 HP Johnson outboard, that starts & runs fine,
I have a 1966 80 HP Johnson outboard, that starts & runs fine, until I shut it off. Then it is hard to start & only runs at an extremely low idle. Idle speed control on the control box has no effect, … read more
Master Tech
Master Tech
Service Manager/Technician
Vocational, Technical or Trade Scho
1,167 satisfied customers
I have a 2005 Suzuki 50 hp outboard with EFI . I store it
I have a 2005 Suzuki 50 hp outboard with EFI . I store it for the winter and run it only 5-6 times a month. It has run fine all summer long until yesterday when I went ot fishing. It ran fine to the f… read more
Master Tech
Master Tech
Service Manager/Technician
Vocational, Technical or Trade Scho
1,167 satisfied customers
I have a 1996 50 hp Johnson outboard that is very hard to start
I have a 1996 50 hp Johnson outboard that is very hard to start and when it does I have to keep the RPM's high or the engine will die. The engine used to start easily and run good until it set for one… read more
ROCKET
ROCKET
MASTER CERTIFIED TECH
Vocational, Technical or Trade Scho
426 satisfied customers
I have a 2000 Johnson 150 hp outboard motor. Last week, it
I have a 2000 Johnson 150 hp outboard motor. Last week, it over-heated, I shut it down right away. All the cylinders checked good for compression. Installed new water pump, & spark plugs. It idles gre… read more
Pappy's Sales and Service
Pappy's Sales and Service
Vocational, Technical or Trade Scho
586 satisfied customers
I have a 22Ft. Odyssey 2000 pontoon boat, Equipped with a ...
I have a 22Ft. Odyssey 2000 pontoon boat, Equipped with a year 2000 Johnson 50 HP Outboard (J50PLSSM). I am about to replace this motor with an Evinrude 90 HP. However it seems to me, that the rear en… read more
Scott
Scott
Marine technician
Vocational, Technical or Trade Scho
543 satisfied customers
Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

JustAnswer in the News:

Ask-a-doc Web sites: If you've got a quick question, you can try to get an answer from sites that say they have various specialists on hand to give quick answers... Justanswer.com.
JustAnswer.com...has seen a spike since October in legal questions from readers about layoffs, unemployment and severance.
Web sites like justanswer.com/legal
...leave nothing to chance.
Traffic on JustAnswer rose 14 percent...and had nearly 400,000 page views in 30 days...inquiries related to stress, high blood pressure, drinking and heart pain jumped 33 percent.
Tory Johnson, GMA Workplace Contributor, discusses work-from-home jobs, such as JustAnswer in which verified Experts answer people’s questions.
I will tell you that...the things you have to go through to be an Expert are quite rigorous.

What Customers are Saying:

Wonderful service, prompt, efficient, and accurate. Couldn't have asked for more. I cannot thank you enough for your help.

Mary C.Freshfield, Liverpool, UK

This expert is wonderful. They truly know what they are talking about, and they actually care about you. They really helped put my nerves at ease. Thank you so much!!!!

AlexLos Angeles, CA

Thank you for all your help. It is nice to know that this service is here for people like myself, who need answers fast and are not sure who to consult.

GPHesperia, CA

I couldn't be more satisfied! This is the site I will always come to when I need a second opinion.

JustinKernersville, NC

Just let me say that this encounter has been entirely professional and most helpful. I liked that I could ask additional questions and get answered in a very short turn around.

EstherWoodstock, NY

Thank you so much for taking your time and knowledge to support my concerns. Not only did you answer my questions, you even took it a step further with replying with more pertinent information I needed to know.

RobinElkton, Maryland

He answered my question promptly and gave me accurate, detailed information. If all of your experts are half as good, you have a great thing going here.

DianeDallas, TX

< Previous | Next >

Meet the Experts:

Ted G.

Ted G.

Rigger, Diagnostician

2,678 satisfied customers

40 years boating, Safe boating instruct., Offshore Race promoter, Failure Analysis, Expert Witness

Dominick

Dominick

Marine Mechanic

1,009 satisfied customers

25 Years Experience as Mechanic, 20 Yrs Boat Yard Owner/Mechanic, Factory Certified

John White

John White

Marine Mechanic

306 satisfied customers

11 years experience working on outboards, inboards, sterndrives & pwcs

Jason

Jason

Marine Mechanic

22,043 satisfied customers

Degree in Marine Technology. Gas and diesel marine mechanic.

Tan

Tan

MerCruiser Certified Technician

11,409 satisfied customers

40 yrs. experience with complete engine repairs both inboard/outboard and MerCruiser Certified Technician.

Jeff G.

Jeff G.

Marine Mechanic

4,730 satisfied customers

42 years experience, Certified Master Technician, All Major Outboards, Sterndrives, Hi-Performance

Captain Dave

Captain Dave

Marine Mechanic

2,672 satisfied customers

USCG Licensed Captain, 20+ Years Boating, Fishing, Maintenance and Repair Experience

< Previous | Next >

Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

Show MoreShow Less

Ask Your Question

x