Boat

Have Boat Questions? Ask a Boat Repair Expert.

Connect one-on-one with {0} who will answer your question

Related Boat Questions
Outboard ignition issues. Motor starts ok. when running down
motor starts ok. when running down the lake on plane there is a dead miss. for a second the motor shuts off and starts back up. … read more
Blake P
Blake P
Certified RV & Marine Technician
132 satisfied customers
1988 merc 35 hp electric start pwr tilt, just bought it last
1988 merc 35 hp electric start pwr tilt , just bought it last week , ran ok then it wont start. Put new plugs in, new fuel, new bulb hose. New battery. No spark. Mechanic came out and said that the co… read more
Charles
Charles
Certified Mercury Tech
5,522 satisfied customers
I have a 1994 Venom 200hp with a power head. It is on a bass
I have a 1994 Johnson Venom 200hp with a blown power head. It is on a bass boat, and I believe it has a 20" shaft. All I seem to be able to find out there in this vintage are 25" shafts. Would I be ab… read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade School
18,955 satisfied customers
run low on oil motor shut down is there a shut off switch if
run low on oil motor shut down is there a shut off switch if so where do I find it and how do I reset Motor Johnson 175 Outboard 2 Stroke… read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,504 satisfied customers
My 2005 90 HP johnson 2 cycle/v-4 outboard is stuck in neutral.
My 2005 90 HP johnson 2 cycle/v-4 outboard is stuck in neutral. I have taken loose the cables and the cotter pin that locks the shifter shaft to the linkage and all works fine until the shaft is engag… read more
davesoutboard
davesoutboard
owner
Associate Degree
1,570 satisfied customers
I have a 1983 70 hp Johnson Outboard, it went down in a lake
I have a 1983 70 hp Johnson Outboard, it went down in a lake last weekend, I have since drained it cleaned it replaced some parts on it and started it. It is running fine, when it went down the motor … read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,504 satisfied customers
I have a 2000 johnson 90 HP outboard. THe trim switch in the
I have a 2000 johnson 90 HP outboard. THe trim switch in the control handle is going bad. (have to push really hard to get the up trim to work, down works fine) Switch seems to be pressed back into ha… read more
James
James
Certified Marine Mechanic
Vocational, Technical or Trade Scho
4,094 satisfied customers
I just purchased a 1981 35 HP johnson with a jet drive. (Almost
I just purchased a 1981 35 HP johnson with a jet drive. (Almost like new) Started it... ran good but it was stuck in forward. Tooling along and pop... it jumped into neutral and the shift lever won't … read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,504 satisfied customers
we have a 1990 60 hp Johnson outboard, need to change water
we have a 1990 60 hp Johnson outboard, need to change water pump but book does not explain how to disconnect shift rod to remove lower unit can you help.… read more
James
James
Certified Marine Mechanic
Vocational, Technical or Trade Scho
4,094 satisfied customers
I have a 1997 Force motor. It will not shut off with key switch
I have a 1997 Force motor. It will not shut off with key switch in off position. Have changed ignition switch. The tether safety switch when pulled will not shut off engine either. How can i hook up a… read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,504 satisfied customers
have just bought a used boat and motor -- Johnson 48 Hp, 1987,
have just bought a used boat and motor -- Johnson 48 Hp, 1987, #G03073762, -- Everything on the boat works well - motor is clean - low use. However, will not start (Great!) Gas is getting to cylinders… read more
Jeff G.
Jeff G.
Marine Mechanic
Vocational, Technical or Trade Scho
4,730 satisfied customers
Ive got an evinrude 8 hp outboard.Its about 25 years old.It
I've got an evinrude 8 hp outboard.It's about 25 years old.It will not start till I disconnect and reconnect the two wires for the kill switch.I put a omhmeter tester to check the kill switch and it s… read more
Whitecap36
Whitecap36
Service Manager/Technician
Vocational, Technical or Trade Scho
1,556 satisfied customers
I have a 200 HP Yamaha outboard. How do I change the drive
I have a 200 HP Yamaha outboard. How do I change the drive oil for the winter. Is there anything else I need to do to it. I also have a 8 hp kicker yamaha, same deal.… read more
Larry B.
Larry B.
Marine Service Tech
High School or GED
574 satisfied customers
My 40 HP Johnson outboard and boat has been sitting on the
My 40 HP Johnson outboard and boat has been sitting on the boat lift due to the low water level in the lake. I can not get the lower end to lift up. It seems that nothing I do will release the mechani… read more
Master Tech
Master Tech
Service Manager/Technician
Vocational, Technical or Trade Scho
1,167 satisfied customers
We have a 1974 115 hp outboard Johnson. Runs great but will
We have a 1974 115 hp outboard Johnson. Runs great but will not shut off without using the choke. Installed a kill switch,nothing, checked wires and fuse and they are ok. Now we are thinking maybe the… read more
Greg Robinson
Greg Robinson
Senior service manager
Vocational, Technical or Trade Scho
199 satisfied customers
I have a 2000 Johnson 150 hp outboard motor. Last week, it
I have a 2000 Johnson 150 hp outboard motor. Last week, it over-heated, I shut it down right away. All the cylinders checked good for compression. Installed new water pump, & spark plugs. It idles gre… read more
Pappy's Sales and Service
Pappy's Sales and Service
Vocational, Technical or Trade Scho
586 satisfied customers
i have a 1966 silverline with a 100 hp johnson golden ...
i have a 1966 silverline with a 100 hp johnson golden metoer engine and i can get all the rpms i want when i give it gas but cant get it in gear were should i start looking im not sure how te drive sy… read more
Pappy's Sales and Service
Pappy's Sales and Service
Vocational, Technical or Trade Scho
586 satisfied customers
1981 JOHNSON 100 HP OUTBOARD NO FIRE TO ANY 4 CYL W2
1981 JOHNSON 100 HP OUTBOARD NO FIRE TO ANY 4 CYL W2 POWERPACKS WHAT STEPS SHOULD I CHECK FIRST ?fuse seems to be ok all conections have been unpluged and repluged put new ignition switch 3 months ago… read more
JUST-IN-TIME
JUST-IN-TIME
CERTIFIED MARINE/PWC TECHNICIAN
Vocational, Technical or Trade Scho
74 satisfied customers
Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

JustAnswer in the News:

Ask-a-doc Web sites: If you've got a quick question, you can try to get an answer from sites that say they have various specialists on hand to give quick answers... Justanswer.com.
JustAnswer.com...has seen a spike since October in legal questions from readers about layoffs, unemployment and severance.
Web sites like justanswer.com/legal
...leave nothing to chance.
Traffic on JustAnswer rose 14 percent...and had nearly 400,000 page views in 30 days...inquiries related to stress, high blood pressure, drinking and heart pain jumped 33 percent.
Tory Johnson, GMA Workplace Contributor, discusses work-from-home jobs, such as JustAnswer in which verified Experts answer people’s questions.
I will tell you that...the things you have to go through to be an Expert are quite rigorous.

What Customers are Saying:

Wonderful service, prompt, efficient, and accurate. Couldn't have asked for more. I cannot thank you enough for your help.

Mary C.Freshfield, Liverpool, UK

This expert is wonderful. They truly know what they are talking about, and they actually care about you. They really helped put my nerves at ease. Thank you so much!!!!

AlexLos Angeles, CA

Thank you for all your help. It is nice to know that this service is here for people like myself, who need answers fast and are not sure who to consult.

GPHesperia, CA

I couldn't be more satisfied! This is the site I will always come to when I need a second opinion.

JustinKernersville, NC

Just let me say that this encounter has been entirely professional and most helpful. I liked that I could ask additional questions and get answered in a very short turn around.

EstherWoodstock, NY

Thank you so much for taking your time and knowledge to support my concerns. Not only did you answer my questions, you even took it a step further with replying with more pertinent information I needed to know.

RobinElkton, Maryland

He answered my question promptly and gave me accurate, detailed information. If all of your experts are half as good, you have a great thing going here.

DianeDallas, TX

< Previous | Next >

Meet the Experts:

Ted G.

Ted G.

Rigger, Diagnostician

1,074 satisfied customers

40 years boating, Safe boating instruct., Offshore Race promoter, Failure Analysis, Expert Witness

Dominick

Dominick

Marine Mechanic

1,009 satisfied customers

25 Years Experience as Mechanic, 20 Yrs Boat Yard Owner/Mechanic, Factory Certified

John White

John White

Marine Mechanic

306 satisfied customers

11 years experience working on outboards, inboards, sterndrives & pwcs

Jason

Jason

Marine Mechanic

18,955 satisfied customers

Degree in Marine Technology. Gas and diesel marine mechanic.

Tan

Tan

MerCruiser Certified Technician

11,504 satisfied customers

40 yrs. experience with complete engine repairs both inboard/outboard and MerCruiser Certified Technician.

Jeff G.

Jeff G.

Marine Mechanic

4,730 satisfied customers

42 years experience, Certified Master Technician, All Major Outboards, Sterndrives, Hi-Performance

Captain Dave

Captain Dave

Marine Mechanic

2,672 satisfied customers

USCG Licensed Captain, 20+ Years Boating, Fishing, Maintenance and Repair Experience

< Previous | Next >

Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

Show MoreShow Less

Ask Your Question

x