Boat

Have Boat Questions? Ask a Boat Repair Expert.

Ask an Expert,
Get an Answer ASAP!

I have a 2006 Glastron GX205 with a volvo penta 5.0 GL stern…

Customer Question
I have a 2006...

I have a 2006 Glastron GX205 with a volvo penta 5.0 GL stern drive. Lately I've notice a whirring airy sound coming from the motor. The boat isn't performing any differently, not loosing power or speed. Is it supposed to sound like that? The motor has about 135 hours on it

Submitted: 9 months ago.Category: Boat
Show More
Show Less
Ask Your Own Boat Question
Answered in 7 minutes by:
7/31/2017
Marine Mechanic: Jason, Marine Mechanic replied 9 months ago
Jason
Jason, Marine Mechanic
Category: Boat
Satisfied Customers: 16,985
Experience: Degree in Marine Technology. Gas and diesel marine mechanic.
Verified

Hello my name is ***** ***** am I speaking with? When you say motor are you talking about the engine or the electric trim motor?

Ask Your Own Boat Question
Customer reply replied 9 months ago
It's Kevin. It's the engine. You can hear while driving and while idling. It almost sounds like power steering but it's not.
Marine Mechanic: Jason, Marine Mechanic replied 9 months ago

Hi Kevin. Can you take any kind of video with sound and upload it to youtube so I can hear it for myself?

Ask Your Own Boat Question
Customer reply replied 9 months ago
I am not with he boat now and won't be with it for 3 weeks again.
Marine Mechanic: Jason, Marine Mechanic replied 9 months ago

Without being able to hear what you are hearing I don't really know how to continue.

Ask Your Own Boat Question
Customer reply replied 9 months ago
Hope I can get my money back then.
Marine Mechanic: Jason, Marine Mechanic replied 9 months ago

Sure. You can put in for a refund, no problem

Ask Your Own Boat Question
Customer reply replied 9 months ago
Thank you
Was this answer helpful?
Ask Dominick Your Own Question
Dominick
Dominick
Dominick, Marine Mechanic
Category: Boat
Satisfied Customers: 1,009
1,009 Satisfied Customers
Experience: 25 Years Experience as Mechanic, 20 Yrs Boat Yard Owner/Mechanic, Factory Certified

Dominick is online now

A new question is answered every 9 seconds

How JustAnswer works:

  • Ask an ExpertExperts are full of valuable knowledge and are ready to help with any question. Credentials confirmed by a Fortune 500 verification firm.
  • Get a Professional AnswerVia email, text message, or notification as you wait on our site. Ask follow up questions if you need to.
  • 100% Satisfaction GuaranteeRate the answer you receive.

JustAnswer in the News:

Ask-a-doc Web sites: If you've got a quick question, you can try to get an answer from sites that say they have various specialists on hand to give quick answers... Justanswer.com.
JustAnswer.com...has seen a spike since October in legal questions from readers about layoffs, unemployment and severance.
Web sites like justanswer.com/legal
...leave nothing to chance.
Traffic on JustAnswer rose 14 percent...and had nearly 400,000 page views in 30 days...inquiries related to stress, high blood pressure, drinking and heart pain jumped 33 percent.
Tory Johnson, GMA Workplace Contributor, discusses work-from-home jobs, such as JustAnswer in which verified Experts answer people’s questions.
I will tell you that...the things you have to go through to be an Expert are quite rigorous.

What Customers are Saying:

Wonderful service, prompt, efficient, and accurate. Couldn't have asked for more. I cannot thank you enough for your help.

Mary C.Freshfield, Liverpool, UK

This expert is wonderful. They truly know what they are talking about, and they actually care about you. They really helped put my nerves at ease. Thank you so much!!!!

AlexLos Angeles, CA

Thank you for all your help. It is nice to know that this service is here for people like myself, who need answers fast and are not sure who to consult.

GPHesperia, CA

I couldn't be more satisfied! This is the site I will always come to when I need a second opinion.

JustinKernersville, NC

Just let me say that this encounter has been entirely professional and most helpful. I liked that I could ask additional questions and get answered in a very short turn around.

EstherWoodstock, NY

Thank you so much for taking your time and knowledge to support my concerns. Not only did you answer my questions, you even took it a step further with replying with more pertinent information I needed to know.

RobinElkton, Maryland

He answered my question promptly and gave me accurate, detailed information. If all of your experts are half as good, you have a great thing going here.

DianeDallas, TX

< Previous | Next >

Meet the Experts:

Dominick

Dominick

Marine Mechanic

1,009 satisfied customers

25 Years Experience as Mechanic, 20 Yrs Boat Yard Owner/Mechanic, Factory Certified

Ted G.

Ted G.

Rigger, Diagnostician

695 satisfied customers

40 years boating, Safe boating instruct., Offshore Race promoter, Failure Analysis, Expert Witness

John White

John White

Marine Mechanic

306 satisfied customers

11 years experience working on outboards, inboards, sterndrives & pwcs

Jason

Jason

Marine Mechanic

16,985 satisfied customers

Degree in Marine Technology. Gas and diesel marine mechanic.

Tan

Tan

MerCruiser Certified Technician

11,003 satisfied customers

40 yrs. experience with complete engine repairs both inboard/outboard and MerCruiser Certified Technician.

Jeff G.

Jeff G.

Marine Mechanic

4,728 satisfied customers

42 years experience, Certified Master Technician, All Major Outboards, Sterndrives, Hi-Performance

Captain Dave

Captain Dave

Marine Mechanic

2,672 satisfied customers

USCG Licensed Captain, 20+ Years Boating, Fishing, Maintenance and Repair Experience

< Previous | Next >

Related Boat Questions
I am working on a 175 yamaha vmax and it has issues with
I am working on a 175 yamaha vmax and it has issues with charging the battery … read more
Jason
Jason
Marine Mechanic
16,985 satisfied customers
I have a 2004 Yamaha f50tlrc. Have a fuel issue on #3 carb
I have a 2004 Yamaha f50tlrc . Have a fuel issue on #3 carb >it misses because of flooding and gas is coming out of vent hole on the start assist primer housing … read more
Clamp-onTech
Clamp-onTech
405 satisfied customers
I have a 1991 evinrude 60hp vro motor. When starting it in
I have a 1991 evinrude 60hp vro motor. When starting it in the driveway, it dies after 30 seconds to 1 minute. It starts right back up next crank.… read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,003 satisfied customers
Turns over won't start negative cable got hot on battery,
Turns over won't start negative cable got hot on battery … read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,003 satisfied customers
Volvo penta 5.0 gl boat motor- serpentine belt flips off at
Volvo penta 5.0 gl boat motor- serpentine belt flips off at higher rpms … read more
Jason
Jason
Marine Mechanic
16,985 satisfied customers
What should my compression test at temp be on twin Yamaha
what should my compression test at temp be on twin Yamaha 225hp 2004 engines with 1300 hrs? … read more
Jason
Jason
Marine Mechanic
16,985 satisfied customers
What do I have to do to have an old previous owner's MMSI on
What do I have to do to have an old previous owner's MMSI on my VHF replaced with mine? … read more
Jason
Jason
Marine Mechanic
16,985 satisfied customers
I have a 1987 19-foot Four Winns Sundowner and I'm having an
Second opinion] I have a 1987 19-foot Four Winns Sundowner and I'm having an engine problem(s). It's a four cylinder Mercruiser 180. First, it stalls while idling (at 500 RPM) and the oil is starting … read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,003 satisfied customers
I have a 2018 Back Cove w Dometic head and holding tank
Hello -- I have a 2018 Back Cove w Dometic head and holding tank system installed. I have NO indication whatsoever on the tank level indicating LED lights -- fuse for "waste tank" is good, no obvious … read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,003 satisfied customers
Wont start. New battery, boat turn over. Tried starter
New battery, boat turn over. Tried starter fluid, started- stops. … read more
Jason
Jason
Marine Mechanic
16,985 satisfied customers
My boat has been sitting for 2 years. what all should I
my boat has been sitting for 2 years. what all should I replace before starting the 2002 Yamaha 225 VX225TLRA. … read more
Jason
Jason
Marine Mechanic
16,985 satisfied customers
I have a 2001 bayliner with a single 7.4 liter mercruiser
Hi....i have a 2001 bayliner with a single 7.4 liter mercruiser and fhe gauges will not click on or turnover. I just replaced all my instrument gauges. Battery is good. … read more
Jason
Jason
Marine Mechanic
16,985 satisfied customers
5.0 ltr io will not rev past 2500 rpm and runs rough. Engine
5.0 ltr io will not rev past 2500 rpm and runs rough … read more
Jason
Jason
Marine Mechanic
16,985 satisfied customers
Yanmar 3GM30F smokes after about 5-10 minutes of warm up.
Yanmar 3GM30F smokes white after about 5-10 minutes of warm up. Seems to run good, starts easy, and no apparent power loss. This just started after sitting over the winter. Was not smoking last fall. … read more
Jason
Jason
Marine Mechanic
16,985 satisfied customers
I have a 1983 seahorse ---- its not starting --- I looked to
i have a 1983 johnson seahorse ---- its not starting --- I looked to see if it is getting spark to the plugs ---- & i dont think it is --- tyr a new plug or what else might it be? … read more
Jason
Jason
Marine Mechanic
16,985 satisfied customers
I have a 97 Volvo Penta 5.7 engine on a boat. I need the oil
I have a 97 Volvo Penta 5.7 engine on a boat. I need the oil type and capacity. Oil filter type, fuel filter type/size. I also need the spark plug type/brand. Thanks… read more
Jason
Jason
Marine Mechanic
16,985 satisfied customers
I have a 2008 regal 3760 with came with a Raymarine E series
I have a 2008 regal 3760 with came with a Raymarine E series plotter and a raymarine depth sounder. The plotter works buy there is no 12 volts to the depth sounder. The circuit breaker is good. Seems … read more
Clamp-onTech
Clamp-onTech
405 satisfied customers
Wont go past 4000rpm under load in water outboard evinrude
wont go past 4000rpm under load in water outboard evinrude 225 old model 1997 carburated … read more
Jason
Jason
Marine Mechanic
16,985 satisfied customers
Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

Show MoreShow Less

Ask Your Question

x