Boat

Have Boat Questions? Ask a Boat Repair Expert.

Ask an Expert,
Get an Answer ASAP!

9. four stroke 2002 mercury out board runs but no water

Customer Question
9. four stroke 2002...

9. four stroke 2002 mercury out board runs but no water coolan comes out the motor to cool it

Mechanic's Assistant: Sometimes things that you think will be really complicated end up being easy to fix. The Marine Mechanic I'm going to connect you with knows all the tricks and shortcuts. Tell me a bit more about what's going on so the Marine Mechanic can help you best.

Does this motor put out water to cool the engine

Mechanic's Assistant: Is there anything else the Marine Mechanic should be aware of?

It's a 2002 4 stroke engine runs good

Submitted: 8 months ago.Category: Boat
Show More
Show Less
Ask Your Own Boat Question
Answered in 18 minutes by:
7/31/2017
Marine Mechanic: Jason, Marine Mechanic replied 8 months ago
Jason
Jason, Marine Mechanic
Category: Boat
Satisfied Customers: 16,744
Experience: Degree in Marine Technology. Gas and diesel marine mechanic.
Verified

Hello my name is ***** ***** am I speaking with? I read what you wrote. What is the size of this outboard or better yet, the serial number on it so I can properly ID it? Is the engine overheating as well, or is it running cool but just no water stream?

Ask Your Own Boat Question
Was this answer helpful?
Ask Dominick Your Own Question
Dominick
Dominick
Dominick, Marine Mechanic
Category: Boat
Satisfied Customers: 1,009
1,009 Satisfied Customers
Experience: 25 Years Experience as Mechanic, 20 Yrs Boat Yard Owner/Mechanic, Factory Certified

Dominick is online now

A new question is answered every 9 seconds

How JustAnswer works:

  • Ask an ExpertExperts are full of valuable knowledge and are ready to help with any question. Credentials confirmed by a Fortune 500 verification firm.
  • Get a Professional AnswerVia email, text message, or notification as you wait on our site. Ask follow up questions if you need to.
  • 100% Satisfaction GuaranteeRate the answer you receive.

JustAnswer in the News:

Ask-a-doc Web sites: If you've got a quick question, you can try to get an answer from sites that say they have various specialists on hand to give quick answers... Justanswer.com.
JustAnswer.com...has seen a spike since October in legal questions from readers about layoffs, unemployment and severance.
Web sites like justanswer.com/legal
...leave nothing to chance.
Traffic on JustAnswer rose 14 percent...and had nearly 400,000 page views in 30 days...inquiries related to stress, high blood pressure, drinking and heart pain jumped 33 percent.
Tory Johnson, GMA Workplace Contributor, discusses work-from-home jobs, such as JustAnswer in which verified Experts answer people’s questions.
I will tell you that...the things you have to go through to be an Expert are quite rigorous.

What Customers are Saying:

Wonderful service, prompt, efficient, and accurate. Couldn't have asked for more. I cannot thank you enough for your help.

Mary C.Freshfield, Liverpool, UK

This expert is wonderful. They truly know what they are talking about, and they actually care about you. They really helped put my nerves at ease. Thank you so much!!!!

AlexLos Angeles, CA

Thank you for all your help. It is nice to know that this service is here for people like myself, who need answers fast and are not sure who to consult.

GPHesperia, CA

I couldn't be more satisfied! This is the site I will always come to when I need a second opinion.

JustinKernersville, NC

Just let me say that this encounter has been entirely professional and most helpful. I liked that I could ask additional questions and get answered in a very short turn around.

EstherWoodstock, NY

Thank you so much for taking your time and knowledge to support my concerns. Not only did you answer my questions, you even took it a step further with replying with more pertinent information I needed to know.

RobinElkton, Maryland

He answered my question promptly and gave me accurate, detailed information. If all of your experts are half as good, you have a great thing going here.

DianeDallas, TX

< Previous | Next >

Meet the Experts:

Dominick

Dominick

Marine Mechanic

1,009 satisfied customers

25 Years Experience as Mechanic, 20 Yrs Boat Yard Owner/Mechanic, Factory Certified

Ted G.

Ted G.

Rigger, Diagnostician

695 satisfied customers

40 years boating, Safe boating instruct., Offshore Race promoter, Failure Analysis, Expert Witness

John White

John White

Marine Mechanic

306 satisfied customers

11 years experience working on outboards, inboards, sterndrives & pwcs

Jason

Jason

Marine Mechanic

16,744 satisfied customers

Degree in Marine Technology. Gas and diesel marine mechanic.

Tan

Tan

MerCruiser Certified Technician

11,003 satisfied customers

40 yrs. experience with complete engine repairs both inboard/outboard and MerCruiser Certified Technician.

Jeff G.

Jeff G.

Marine Mechanic

4,728 satisfied customers

42 years experience, Certified Master Technician, All Major Outboards, Sterndrives, Hi-Performance

Captain Dave

Captain Dave

Marine Mechanic

2,672 satisfied customers

USCG Licensed Captain, 20+ Years Boating, Fishing, Maintenance and Repair Experience

< Previous | Next >

Related Boat Questions
I have a Lowrance Elite 7 HDI that worked fine when I stored
I have a Lowrance Elite 7 HDI that worked fine when I stored it for winter. Plugged it in this week and nothing. I feel it has to be the power source or the unit itself. Any suggestions? I don't want … read more
Clamp-onTech
Clamp-onTech
405 satisfied customers
I have a 1993 Mercury 200 Black Max. It will start and idle
I have a 1993 Mercury 200 Black Max. It will start and idle fine. Whenever I put it in gear and give it all the throttle it will not rev over 2000 rpms. … read more
Clamp-onTech
Clamp-onTech
405 satisfied customers
My global map3500c 100106006 after powerd off periodically
my global map3500c ###-##-####after powerd off periodically turns back on with a on off flashing screen and warning signal blairing drainin … read more
Clamp-onTech
Clamp-onTech
405 satisfied customers
I attached a 30 amp thermal circuit breaker to boat battery
i attached a 30 amp thermal circuit breaker to boat battery but current is still getting to baterry because battery can still be charged while breaker is on. is that suppose to happen … read more
Clamp-onTech
Clamp-onTech
405 satisfied customers
Just installed a Lowrance elite 9ti when I turn it on it
Just installed a Lowrance elite 9ti when I turn it on it makes a constant beeping sound. I have not taken the boat out of the garage yet didn't know if this is part of the problem or if something is n… read more
Clamp-onTech
Clamp-onTech
405 satisfied customers
Got solix 12,out of box it has, unit,power wire,gimbel, 1
Hey, got solix 12,out of box it has, unit,power wire,gimbel, 1 transducer mount, but 2 transducers,no other wires or good directions … read more
Clamp-onTech
Clamp-onTech
405 satisfied customers
Runs fine in yard hooked up to garden hose. put in lake and
runs fine in yard hooked up to garden hose. put in lake and it dies friend told me probably is water pump not pumping enough water causing temp solenoid to shut down motor … read more
Jason
Jason
Marine Mechanic
16,744 satisfied customers
I have a 1999 Volvo penta duoprop. Overheating when slightly
I have a 1999 Volvo penta duoprop. Overheating when slightly trimmed. Runs cool when completely down. New bellows, good risers and impeller. … read more
Jason
Jason
Marine Mechanic
16,744 satisfied customers
1998 J150ELECD. I'm replacing the stator. With all the
1998 johnson J150ELECD. I'm replacing the stator. With all the fumbling around trying to secure the flywheel during removal I'm afraid the wheel has turn, possible a whole rotation. Will I have kept t… read more
Clamp-onTech
Clamp-onTech
405 satisfied customers
I have two new gen 3 units on my boat. When I look at the
I have two new gen 3 units on my boat. When I look at the transducer I have for each in settings it says unknown. I asked my dealer and he told me I can leave them on unknown. Is that true … read more
Clamp-onTech
Clamp-onTech
405 satisfied customers
I have a 1998 evinrude 225 hp I need to know how to test the
I have a 1998 evinrude 225 hp I need to know how to test the timing trigger plate … read more
Jason
Jason
Marine Mechanic
16,744 satisfied customers
After seeing multiple techs without any resolve, here's my
After seeing multiple techs without any resolve, here's my problem: After running flawlessly, I have an alarm with a "check engine" message and the boat will not start. As I said, several techs and di… read more
Jason
Jason
Marine Mechanic
16,744 satisfied customers
I just purchased a 1980 bass tracker boat the engine cover
Hi I just purchased a 1980 bass tracker boat the engine cover says Mercury 50 but the title says 80 HP? think this could be a typo on the title. The serial number is(###) ###-#### … read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,003 satisfied customers
I hope your winter went well. I had Mercruiser 383 Stroker
Hi Jason, I hope your winter went well. I had Mercruiser 383 Stroker remanufactured engines installed in my boat over the winter...you may recall all the problems I was having last year. We sea triale… read more
Jason
Jason
Marine Mechanic
16,744 satisfied customers
Tan, I have a 60 hp Mercury Bigfoot, 2008 and have a
Tan, I have a 60 hp Mercury Bigfoot, 2008 and have a problem. We've had a dockside mechanic come by. He found a fuel filter had a slight leak and maybe it was sucking air? new filter, installed, nice … read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,003 satisfied customers
Changing the lower unit oil on Yamaha 150 4 stroke, I
Changing the lower unit oil on Yamaha 150 4 stroke, I noticed about 1/2 ounce of water came out first, Is this small amount something to be concerned with, it has been 2 seasons since last time lower … read more
Jason
Jason
Marine Mechanic
16,744 satisfied customers
I am trying to start my 2006 90 horse power Mainer motor. I
I am trying to start my 2006 90 horse power Mainer motor. I have it on a motor stand, How do I Bypass the safety kill system and how to jump the starter off.is this a 12 volt are 24 volt … read more
Jason
Jason
Marine Mechanic
16,744 satisfied customers
My 1999 130HP has an issue where it doesn't run well unless
My 1999 Johnson 130HP has an issue where it doesn't run well unless the temp sensor on the port side is unplugged. Could this be the sensor or is it a computer issue? Where is the computer? Thanks.… read more
Jason
Jason
Marine Mechanic
16,744 satisfied customers
Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

Show MoreShow Less

Ask Your Question

x