Boat

Have Boat Questions? Ask a Boat Repair Expert.

Connect one-on-one with {0} who will answer your question

Related Boat Questions
Jason, what would the part number be on the fuel pump for my
Jason, what would the part number be on the fuel pump for my 2006 mercruiser 5.0 mpi? Also, the filter if that should be changed out also since they kind of share the same housing. Thanks… read more
Jason
Jason
Marine Mechanic
23,303 satisfied customers
When i turn the key to on - a horn comes on and stays on.
when i turn the key to on - a horn comes on and stays on. when i start the engine, the horn goes off. Engine runs normally to 2000 rpm, but will not go higher, no matter what the throttle position is.… read more
Boat Doc
Boat Doc
253 satisfied customers
5.0 mpi serial no 1A652134. Audible warning sounds at low
5.0 mpi serial no 1A652134. Audible warning sounds at low rpms and engine goes into limp mode. All gauges look good. My mechanics plugged in diagnostic and shows a number of low water pressure errors.… read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,409 satisfied customers
I HAVE A HOUSEBOAT, SUMERSET 2006, WITH 2 MERCRUISER 5.0
I HAVE A HOUSEBOAT, SUMERSET 2006, WITH 2 MERCRUISER 5.0 MPI, 265 HORSEPOWER ENGINES. THE STARBOARD ENGINE HAS RUN GREAT UNTIL ABOUT A WEEK AGO, AND I CAN'T KEEP IT RUNNING. WHEN I START IT YOU CAN KE… read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,409 satisfied customers
I'm pat we have a sea ray 205 with a mercruiser 5.0 mpi
Hi I'm pat we have a sea ray 205 with a mercruiser 5.0 mpi has no power down the boat doesn't over heat runs smooth and when gets up too speed it's fine… read more
Jason
Jason
Marine Mechanic
23,303 satisfied customers
Mercruiser 5.0 MPI engine shut down while operating
Mercruiser 5.0 MPI engine shut down while boating at 3.0k RPM. Appears to be starved for gas. Engine will not start. When key is turned on the fuel pump appears to activate and then shuts off. Engine … read more
Expert
Expert
2012 Mercruiser 5.0 MPI température is stable at 175 deg at
2012 Mercruiser 5.0 MPI température is stable at 175 deg at idle but drops to 0 deg when RPM is above 1000. Then slowly comes back to 175 deg when returning to idle. Any clue?… read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,409 satisfied customers
hi I have twin 5.0 MPI mercruisers in my boat, whilst out
hi I have twin 5.0 MPI mercruisers in my boat, whilst out on it yesterday the alarm sounded and a fault came up with " shift switch fault on starboard engine" Could you advise ? Thanks… read more
Jason
Jason
Marine Mechanic
23,303 satisfied customers
I am in market for used bowrider in $ 25000 range what is
I am in market for used bowrider in $ 25000 range what is the difference in value , reliability and performance etc of the Mercruiser 5.0 TKS 220 HP vs 5.0 MPI 260 HP should I only pursue the later ? … read more
Malta Tech
Malta Tech
Marine Tech
High School or GED
287 satisfied customers
is there a big difference in horse power between the 2006 mercruiser
is there a big difference in horse power between the 2006 mercruiser 5.0 mpi and the standard 5.0 in a baja outlaw 20 ?… read more
Ted G.
Ted G.
Rigger, Diagnostician
Vocational, Technical or Trade Scho
3,148 satisfied customers
I recently purchased a 2006 Four Winns with a single MerCruiser
I recently purchased a 2006 Four Winns with a single MerCruiser 350 MAG MPI. The first few times boat was running fine, but now the boat will not pass 2000 RPM and max speed of 8 mph. I have replaced … read more
James
James
Certified Marine Mechanic
Vocational, Technical or Trade Scho
4,094 satisfied customers
I have a mercruiser 5.0 mpi and had to install a long block
I have a mercruiser 5.0 mpi and had to install a long block due to a cracked block. Everything bolted right back up and the engine runs smoothly. However it is sluggish coming out of the hole and I on… read more
Jeremy R.
Jeremy R.
5,362 satisfied customers
2006 mercruiser 305 mpi, useing diacom software code is active
2006 mercruiser 305 mpi, useing diacom software code is active steering ckt low, when i erase it it comes right back and i get two beeps every minute!!!!!!!! Help… read more
James
James
Certified Marine Mechanic
Vocational, Technical or Trade Scho
4,094 satisfied customers
I have a 2003 5.0 MPI Mercruiser, that has a steady ticking
I have a 2003 5.0 MPI Mercruiser, that has a steady ticking noise at idle speed and incrases as the engine rpms increase.. Engine has 228 hrs. Is this exhaust related or could it possibly be the visco… read more
James
James
Certified Marine Mechanic
Vocational, Technical or Trade Scho
4,094 satisfied customers
Can a 2008 ecm for a mercruiser 5.0 MPI be reprogrammed to
Can a 2008 ecm for a mercruiser 5.0 MPI be reprogrammed to use in a 2008 5.7 MPI? If so, who does that type of work?… read more
Joe
Joe
Owner Kingsland Auto & Marine Services
Vocational, Technical or Trade Scho
1,396 satisfied customers
I have a 2006 Mercruiser 5.0 w/ Bravo III. The engine stalls
I have a 2006 Mercruiser 5.0 w/ Bravo III. The engine stalls at idle after being run 30 minutes or so. The engine will not start again until it has apparently cooled down. I have hade the entire fuel … read more
capt ron 1959
capt ron 1959
Owner/Marine Mechanic
Vocational, Technical or Trade Scho
348 satisfied customers
2006 5.0 mpi audio warning. 2 sounds about every 60 seconds.
2006 5.0 mpi audio warning. 2 sounds about every 60 seconds. Checked all fluids, found foot oil low and was corrected. All gauges read good. Very rough idle, but in gear or with a little throttle, smo… read more
Larry B.
Larry B.
Marine Service Tech
High School or GED
574 satisfied customers
I am considering a boat and I have a choice between motors
I am considering a boat and I have a choice between motors of a Mercruiser 4.3 MPI fuel injected V6 220 horse and a Volvo GL/SX 5.0 220 HP V8. Can you help me decide objectively?… read more
Infiniti Nissan Specialist
Infiniti Nissan Specialist
Master Technician
Vocational, Technical or Trade Scho
915 satisfied customers
Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

JustAnswer in the News:

Ask-a-doc Web sites: If you've got a quick question, you can try to get an answer from sites that say they have various specialists on hand to give quick answers... Justanswer.com.
JustAnswer.com...has seen a spike since October in legal questions from readers about layoffs, unemployment and severance.
Web sites like justanswer.com/legal
...leave nothing to chance.
Traffic on JustAnswer rose 14 percent...and had nearly 400,000 page views in 30 days...inquiries related to stress, high blood pressure, drinking and heart pain jumped 33 percent.
Tory Johnson, GMA Workplace Contributor, discusses work-from-home jobs, such as JustAnswer in which verified Experts answer people’s questions.
I will tell you that...the things you have to go through to be an Expert are quite rigorous.

What Customers are Saying:

Wonderful service, prompt, efficient, and accurate. Couldn't have asked for more. I cannot thank you enough for your help.

Mary C.Freshfield, Liverpool, UK

This expert is wonderful. They truly know what they are talking about, and they actually care about you. They really helped put my nerves at ease. Thank you so much!!!!

AlexLos Angeles, CA

Thank you for all your help. It is nice to know that this service is here for people like myself, who need answers fast and are not sure who to consult.

GPHesperia, CA

I couldn't be more satisfied! This is the site I will always come to when I need a second opinion.

JustinKernersville, NC

Just let me say that this encounter has been entirely professional and most helpful. I liked that I could ask additional questions and get answered in a very short turn around.

EstherWoodstock, NY

Thank you so much for taking your time and knowledge to support my concerns. Not only did you answer my questions, you even took it a step further with replying with more pertinent information I needed to know.

RobinElkton, Maryland

He answered my question promptly and gave me accurate, detailed information. If all of your experts are half as good, you have a great thing going here.

DianeDallas, TX

< Previous | Next >

Meet the Experts:

Ted G.

Ted G.

Rigger, Diagnostician

3,148 satisfied customers

40 years boating, Safe boating instruct., Offshore Race promoter, Failure Analysis, Expert Witness

Dominick

Dominick

Marine Mechanic

1,009 satisfied customers

25 Years Experience as Mechanic, 20 Yrs Boat Yard Owner/Mechanic, Factory Certified

John White

John White

Marine Mechanic

306 satisfied customers

11 years experience working on outboards, inboards, sterndrives & pwcs

Jason

Jason

Marine Mechanic

23,303 satisfied customers

Degree in Marine Technology. Gas and diesel marine mechanic.

Tan

Tan

MerCruiser Certified Technician

11,409 satisfied customers

40 yrs. experience with complete engine repairs both inboard/outboard and MerCruiser Certified Technician.

Jeff G.

Jeff G.

Marine Mechanic

4,730 satisfied customers

42 years experience, Certified Master Technician, All Major Outboards, Sterndrives, Hi-Performance

Captain Dave

Captain Dave

Marine Mechanic

2,672 satisfied customers

USCG Licensed Captain, 20+ Years Boating, Fishing, Maintenance and Repair Experience

< Previous | Next >

Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

Show MoreShow Less

Ask Your Question

x