Boat

Have Boat Questions? Ask a Boat Repair Expert.

Connect one-on-one with {0} who will answer your question

Related Boat Questions
1990 Evinrude 60 HP not running properly. Rebuilt cylinders
1990 Evinrude 60 HP not running properly. Rebuilt cylinders and pistons Nov 2017. Rebuilt carbs Nov 2017. Engine starts and idles ok--stalls on occasion. Bogs down under load-spits and sputters past h… read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade School
22,043 satisfied customers
I HAVE A 2004 YAMAHA 40 HP TLRC CARBS HAVE BEEN REBUILT NEW
I HAVE A 2004 YAMAHA 40 HP TLRC CARBS HAVE BEEN REBUILT NEW FUEL PUMP, COMPRESSION IS 110 ON ALL 3 CYL. ITS CHUGGING AT AN IDLE AND SEEMS TO BE BACKFIRING AT WOT, I PUULED THE PLUG WIRES ONE AT A TIME… read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,507 satisfied customers
1994 40 HP Evinrude. Occasionally will die when moving from
1994 40 HP Evinrude. Occasionally will die when moving from neutral into gear. Starts right back up when you turn it on, but requires a fair amount of throttle so it wont quit. I checked and replaced … read more
Noel Schembri
Noel Schembri
Marine mechanic
Diploma
2,632 satisfied customers
Have a 1990 50 hp evinrude motor ... Starts fine but does when
Have a 1990 50 hp evinrude motor ... Starts fine but does when put it in gear or let it idle too long . Also have a button below the ignition switch which seems to be able to rotate left and right but… read more
Charles
Charles
Certified Mercury Tech
5,747 satisfied customers
I just installed a new E-TEC 40 hp and a new E-TEC 60 hp on
I just installed a new E-TEC 40 hp and a new E-TEC 60 hp on two different boats. The 60 hp works just fine, but the 40 hp have an oil related problem. The instrument is warning for NO OIL and the buzz… read more
MarineService8
MarineService8
49 satisfied customers
1992 evinrude 40 hp. Idles fine but top cylinder looses spark
1992 evinrude 40 hp. Idles fine but top cylinder looses spark when revs up. Replaced CID pac no help. Both cylinders have 110 compression.… read more
briggs archer
briggs archer
master marine mechanic
Associate Degree
402 satisfied customers
Have a 1991 Evinrude 40 hp. 110 pounds of compression on each
Have a 1991 Evinrude 40 hp. 110 pounds of compression on each cylinder. will not idle nicely, and sometimes dies when put into drive. Previous mechanic recommended carb rebuild. I painstaking did this… read more
Charles
Charles
Certified Mercury Tech
5,747 satisfied customers
my outboard 115 hp (1997) often dies while at a slow trolling
my outboard 115 hp (1997) often dies while at a slow trolling speed--It will kick hard and just die--always restarts easily. Have had the carbs gone thru with kits by local dealership(Marine)… read more
Michael
Michael
master marine technician/charter captain
Vocational, Technical or Trade Scho
256 satisfied customers
Dear Sirs, i own a 1990,Evirude 90 hp outboard. I have a trolling
Dear Sirs, i own a 1990,Evirude 90 hp outboard. I have a trolling plate on it and lately after approx. 40 minutes of trolling the engine starts to stall out and will not idle smoothly. It will start a… read more
Michael
Michael
master marine technician/charter captain
Vocational, Technical or Trade Scho
256 satisfied customers
I have an 1979 20 hp johnson. It runs great and my grandpa
I have an 1979 20 hp johnson. It runs great and my grandpa has taken care of it for a long time. I have acquired it recently and took it out for a spin and after I full throttled it it kicked out of g… read more
Evinrude/Johnson
Evinrude/Johnson
Evinrude/Johnson marine technician
Vocational, Technical or Trade Scho
41 satisfied customers
I HAVE 1987 40 HP #E40ELCUD PROBLEMS WITH REMOTE CONTROL
I HAVE 1987 40 HP #E40ELCUD PROBLEMS WITH REMOTE CONTROL WAS SHIFTED FORWARD WHILE IDLE LEVER WAS UP ! IDLE COTROL HARDLY WORKS VERY LITTLE RPMS IN REVERSE FORWARD CAN OBTAIN ALMOST MAX SPEED BUT CONT… read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,507 satisfied customers
I am working on Eninrude 8 hp 1987. It will run but it pops
I am working on Eninrude 8 hp 1987. It will run but it pops and backfires and stops. will fire right back up but wil lnot run smoothly. Both plugs seem to have spark. There are no points to check. Do … read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,507 satisfied customers
I repowered my boat in 2009 with Crusader 8.1 Captains choice
I repowered my boat in 2009 with Crusader 8.1 Captains choice engines. Have had no problems with engines until recently. The throttle on the port engine seems to work intermittently in terms of adding… read more
James
James
Certified Marine Mechanic
Vocational, Technical or Trade Scho
4,094 satisfied customers
I have a 66 evinrude 40 horse big twin electric start what
I have a 66 evinrude 40 horse big twin electric start what is the fuel to oil ratio is it 40 to 1 or 50 to 1. It ran great for two days here at the lake but then now when putting slowly for awhile you… read more
Jeff G.
Jeff G.
Marine Mechanic
Vocational, Technical or Trade Scho
4,730 satisfied customers
We purchased an older Glastron recently with 1986 mercury 115
We purchased an older Glastron recently with 1986 mercury 115 hp 6 cylinder outboard. It has been running great for the last 5 or 6 trips out. This last trip yesterday, we launched it and right away s… read more
Jeff G.
Jeff G.
Marine Mechanic
Vocational, Technical or Trade Scho
4,730 satisfied customers
Hello, I have an 1996 Evinrude 90 HP (BE90SLEDR 1996) It
Hello, I have an 1996 Evinrude 90 HP (BE90SLEDR 1996) It sounds it´s low oil alarm even though I have it fully topped of. I shut the engine of waited and restarted. And there was no re occuring alarms… read more
James
James
Certified Marine Mechanic
Vocational, Technical or Trade Scho
4,094 satisfied customers
I have a 1992 Nissan 18hp which seems to run fine and full
I have a 1992 Nissan 18hp which seems to run fine and full power when in neutral, but when I engage forward gear, and open the throttle fully, motor seems to not open to full power potential, so far, … read more
Steve Sr.
Steve Sr.
No Title
High School or GED
79 satisfied customers
i need to no how to set the points on a 1963 evinrude lark
i need to no how to set the points on a 1963 evinrude lark 40 hp its getting spark butt keeps back fireing wont start up think u very much ever one.… read more
orcamarine
orcamarine
Proprietor
Vocational, Technical or Trade Scho
7 satisfied customers
Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

JustAnswer in the News:

Ask-a-doc Web sites: If you've got a quick question, you can try to get an answer from sites that say they have various specialists on hand to give quick answers... Justanswer.com.
JustAnswer.com...has seen a spike since October in legal questions from readers about layoffs, unemployment and severance.
Web sites like justanswer.com/legal
...leave nothing to chance.
Traffic on JustAnswer rose 14 percent...and had nearly 400,000 page views in 30 days...inquiries related to stress, high blood pressure, drinking and heart pain jumped 33 percent.
Tory Johnson, GMA Workplace Contributor, discusses work-from-home jobs, such as JustAnswer in which verified Experts answer people’s questions.
I will tell you that...the things you have to go through to be an Expert are quite rigorous.

What Customers are Saying:

Wonderful service, prompt, efficient, and accurate. Couldn't have asked for more. I cannot thank you enough for your help.

Mary C.Freshfield, Liverpool, UK

This expert is wonderful. They truly know what they are talking about, and they actually care about you. They really helped put my nerves at ease. Thank you so much!!!!

AlexLos Angeles, CA

Thank you for all your help. It is nice to know that this service is here for people like myself, who need answers fast and are not sure who to consult.

GPHesperia, CA

I couldn't be more satisfied! This is the site I will always come to when I need a second opinion.

JustinKernersville, NC

Just let me say that this encounter has been entirely professional and most helpful. I liked that I could ask additional questions and get answered in a very short turn around.

EstherWoodstock, NY

Thank you so much for taking your time and knowledge to support my concerns. Not only did you answer my questions, you even took it a step further with replying with more pertinent information I needed to know.

RobinElkton, Maryland

He answered my question promptly and gave me accurate, detailed information. If all of your experts are half as good, you have a great thing going here.

DianeDallas, TX

< Previous | Next >

Meet the Experts:

Ted G.

Ted G.

Rigger, Diagnostician

2,678 satisfied customers

40 years boating, Safe boating instruct., Offshore Race promoter, Failure Analysis, Expert Witness

Dominick

Dominick

Marine Mechanic

1,009 satisfied customers

25 Years Experience as Mechanic, 20 Yrs Boat Yard Owner/Mechanic, Factory Certified

John White

John White

Marine Mechanic

306 satisfied customers

11 years experience working on outboards, inboards, sterndrives & pwcs

Jason

Jason

Marine Mechanic

22,043 satisfied customers

Degree in Marine Technology. Gas and diesel marine mechanic.

Tan

Tan

MerCruiser Certified Technician

11,507 satisfied customers

40 yrs. experience with complete engine repairs both inboard/outboard and MerCruiser Certified Technician.

Jeff G.

Jeff G.

Marine Mechanic

4,730 satisfied customers

42 years experience, Certified Master Technician, All Major Outboards, Sterndrives, Hi-Performance

Captain Dave

Captain Dave

Marine Mechanic

2,672 satisfied customers

USCG Licensed Captain, 20+ Years Boating, Fishing, Maintenance and Repair Experience

< Previous | Next >

Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

Show MoreShow Less

Ask Your Question

x