Boat

Have Boat Questions? Ask a Boat Repair Expert.

Connect one-on-one with {0} who will answer your question

Related Boat Questions
1978 55 Hp acts like it runs out of gas when I go to slow
1978 johnson 55 Hp acts like it runs out of gas when I go to slow idle. If I cycle the choke on and off it evens out for a while then returns to same stalling condition.The primer bulb stays hard and … read more
NicholasH311
NicholasH311
Owner/ lead technician
motorcycle and marine certifications
135 satisfied customers
Idles fine but when you but in gear and add a little
idles fine but when you but in gear and add a little throttle to it, it bogs down. push the choke in a cpl times it catches up and then runs fine at full throttle … read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade School
22,804 satisfied customers
I have a 2000 50 hp only wants to run by spraying gas in
I have a 2000 50 hp johnson only wants to run by spraying gas in cards throat have rebuilt this motor used pistons has 145 lb compression on both. replaced reeds, redone carbs twice help … read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade School
22,804 satisfied customers
I have a 1979 Johnson seahorse 70 HP Model 70el79r that bogs
I have a 1979 Johnson seahorse 70 HP Model 70el79r that bogs down when in gear. motor will not run past 2600 RPMS. feels like I'm dragging the ancor. I've done the the following but it didn't help. Fr… read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,507 satisfied customers
Triton tr20 with a 1999 225 ho engine--carburated--6 of
triton tr20 with a 1999 225 ho johnson engine--carburated--6 of them---when u get on water run for a while get to fishing spot--cut engine of fish for a while--go to crank it up--it usually does but d… read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,507 satisfied customers
I have a 1980 70 hp Mercury outboard (serial #(NNN) NNN-NNNN That
I have a 1980 70 hp Mercury outboard (serial #(NNN) NNN-NNNN That starts fine and will idle up nicely while in neutral. When i put it in gear it idles good at low speeds but usually bogs out when i tr… read more
Jeff G.
Jeff G.
Marine Mechanic
Vocational, Technical or Trade Scho
4,730 satisfied customers
I have a 1995 Kawasaki zxi 900 i switched to premix and removed
I have a 1995 Kawasaki zxi 900 i switched to premix and removed the oil injection. then rebuilt the carbs now it bogging off idle i reset the needles and have gone from lean to rich in 1/4 turns and h… read more
Jeremy R.
Jeremy R.
5,362 satisfied customers
hi, i have a 1978 johnson 55hp, when i transition from idle
hi, i have a 1978 johnson 55hp, when i transition from idle to gear and try to accelerate it will quit as if i turned off the key. this will occur either once-twice several times as you restart each t… read more
Jeremy R.
Jeremy R.
5,362 satisfied customers
I have the 1983 85hp Suzuki, I made a homemade manometer consisting
I have the 1983 85hp Suzuki, I made a homemade manometer consisting of 3 ten foot lengths of clear 1/4" tubing mounted on a wooden board vertically connected on the bottom with a T-fitting. I put TCW3… read more
Noel Schembri
Noel Schembri
Marine Mechanic
Diploma
2,759 satisfied customers
I have a 1978 70 HP evinrude that has a fuel issue. After the
I have a 1978 70 HP evinrude that has a fuel issue. After the motor warms to operating temp it will bog going from idle to full throttle. The primer ball hardness does not change when this occurs. If … read more
Whitecap36
Whitecap36
Service Manager/Technician
Vocational, Technical or Trade Scho
1,557 satisfied customers
HI, 1992 Johnson 88 SPL on a 16 Marlin runabout. - Starts
HI, 1992 Johnson 88 SPL on a 16' Marlin runabout. - Starts w/Full choke - Takes @ least 5 minutes before it will idle - Won't restart w/out full choke - even when fully warmed up. - Boat runs fine, ge… read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,507 satisfied customers
Hi... I will try to describe this as best I can. I have a
Hi... I will try to describe this as best I can. I have a 70 HP Johnson (1982) It runs great... starts every time and purrs like a kitten at idle. Sometimes I cant get it to take off... I will shift i… read more
Whitecap36
Whitecap36
Service Manager/Technician
Vocational, Technical or Trade Scho
1,557 satisfied customers
My 70 hp Evinrude starts and idles fine, but it stalls out
My 70 hp Evinrude starts and idles fine, but it stalls out when I put it in gear and throttle up. After a few times of bogging down it will get us up on a plane and runs well. The carbs were rebuilt l… read more
Shane Creekmore
Shane Creekmore
Certified Mercury Marine technician
High School or GED
570 satisfied customers
Mercury 150 inline 6 / approx 1977 / No power The engine was
Mercury 150 inline 6 / approx 1977 / No power The engine was rebuilt this summer - over 30 pistons / carbs & fuel pump rebuilt. 10 hours of break-in with double oil mix - approx 12 hours running with … read more
Whitecap36
Whitecap36
Service Manager/Technician
Vocational, Technical or Trade Scho
1,557 satisfied customers
I HAVE A 1994 115 EVINRUDE. STARTS GOOD.IDLE GOOD IN GEAR GETS
I HAVE A 1994 115 EVINRUDE. STARTS GOOD.IDLE GOOD IN GEAR GETS UP ON PLANE GOOD FOR ABOUT 20 SECONDS AND BOGS DOWN. RUNS GOOD BACK AT IDLE IN GEAR. WAIT A FEW MINUTES IN GEAR AT IDLE. GET BACK ON PLAN… read more
davesoutboard
davesoutboard
owner
Associate Degree
1,570 satisfied customers
I have a 1978 Johnson 70hp that has a what seems to be a misfire
I have a 1978 Johnson 70hp that has a what seems to be a misfire under load and will not rev over 2500-2600 rpms. It runs fine on the muffs but not during water test. The carbs were rebuilt, the compr… read more
Dr. Joe
Dr. Joe
Bachelor's Degree
198 satisfied customers
I have a 225 Hp Johnson 1999 that idles fine at 850 neutral
I have a 225 Hp Johnson 1999 that idles fine at 850 neutral 700 in gear, comes up good until 3000 rpm and almost on plane then bogs down to 2200 and will not plane.… read more
davesoutboard
davesoutboard
owner
Associate Degree
1,570 satisfied customers
I have a 1971 Johnson 140hp outboard that idles with a ...
I have a 1971 Johnson 140hp outboard that idles with a minor skip from time to time and is sluggish on take off. Once it reaches 3000 rpms, it take off to full rpm. Fuel pump is brand new and carbs we… read more
JUST-IN-TIME
JUST-IN-TIME
CERTIFIED MARINE/PWC TECHNICIAN
Vocational, Technical or Trade Scho
74 satisfied customers
Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

JustAnswer in the News:

Ask-a-doc Web sites: If you've got a quick question, you can try to get an answer from sites that say they have various specialists on hand to give quick answers... Justanswer.com.
JustAnswer.com...has seen a spike since October in legal questions from readers about layoffs, unemployment and severance.
Web sites like justanswer.com/legal
...leave nothing to chance.
Traffic on JustAnswer rose 14 percent...and had nearly 400,000 page views in 30 days...inquiries related to stress, high blood pressure, drinking and heart pain jumped 33 percent.
Tory Johnson, GMA Workplace Contributor, discusses work-from-home jobs, such as JustAnswer in which verified Experts answer people’s questions.
I will tell you that...the things you have to go through to be an Expert are quite rigorous.

What Customers are Saying:

Wonderful service, prompt, efficient, and accurate. Couldn't have asked for more. I cannot thank you enough for your help.

Mary C.Freshfield, Liverpool, UK

This expert is wonderful. They truly know what they are talking about, and they actually care about you. They really helped put my nerves at ease. Thank you so much!!!!

AlexLos Angeles, CA

Thank you for all your help. It is nice to know that this service is here for people like myself, who need answers fast and are not sure who to consult.

GPHesperia, CA

I couldn't be more satisfied! This is the site I will always come to when I need a second opinion.

JustinKernersville, NC

Just let me say that this encounter has been entirely professional and most helpful. I liked that I could ask additional questions and get answered in a very short turn around.

EstherWoodstock, NY

Thank you so much for taking your time and knowledge to support my concerns. Not only did you answer my questions, you even took it a step further with replying with more pertinent information I needed to know.

RobinElkton, Maryland

He answered my question promptly and gave me accurate, detailed information. If all of your experts are half as good, you have a great thing going here.

DianeDallas, TX

< Previous | Next >

Meet the Experts:

Ted G.

Ted G.

Rigger, Diagnostician

3,332 satisfied customers

40 years boating, Safe boating instruct., Offshore Race promoter, Failure Analysis, Expert Witness

Dominick

Dominick

Marine Mechanic

1,009 satisfied customers

25 Years Experience as Mechanic, 20 Yrs Boat Yard Owner/Mechanic, Factory Certified

John White

John White

Marine Mechanic

306 satisfied customers

11 years experience working on outboards, inboards, sterndrives & pwcs

Jason

Jason

Marine Mechanic

22,804 satisfied customers

Degree in Marine Technology. Gas and diesel marine mechanic.

Tan

Tan

MerCruiser Certified Technician

11,507 satisfied customers

40 yrs. experience with complete engine repairs both inboard/outboard and MerCruiser Certified Technician.

Jeff G.

Jeff G.

Marine Mechanic

4,730 satisfied customers

42 years experience, Certified Master Technician, All Major Outboards, Sterndrives, Hi-Performance

Noel Schembri

Noel Schembri

Marine Mechanic

2,759 satisfied customers

Advanced technical diploma

< Previous | Next >

Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

Show MoreShow Less

Ask Your Question

x