Boat

Have Boat Questions? Ask a Boat Repair Expert.

Ask an Expert,
Get an Answer ASAP!

Boat

I have a 2005 8.1L osi- with a MAP sensor error code 81. I

Customer Question
Hi James, I have a...
Hi James, I have a 2005 8.1L osi-B with a MAP sensor error code 81. I swapped sensors with the starboard engine and get the same error. Fuel pump was whining so I replaced that as well. Didn't cure the issue. Any ideas? I'm getting everything answers from injectors to vacuum leak
Submitted: 1 year ago.Category: Boat
Show More
Show Less
Ask Your Own Boat Question
Answered in 2 minutes by:
6/20/2016
Marine Mechanic: Jason, Marine Mechanic replied 1 year ago
Jason
Jason, Marine Mechanic
Category: Boat
Satisfied Customers: 16,416
Experience: Degree in Marine Technology. Gas and diesel marine mechanic.
Verified

Hi David my name is Jason.

What scan tool are you using?

Ask Your Own Boat Question
Customer reply replied 1 year ago
Hi Jason, I'm not sure as it isn't my scanner. I can find out if needed. The engine just runs in limp mode, max @2100 rpm under a load, however will rev free-wheeling.
Marine Mechanic: Jason, Marine Mechanic replied 1 year ago

Are you working on this yourself, or is a mechanic working on this and relaying you information?

Ask Your Own Boat Question
Customer reply replied 1 year ago
I had a mechanic come by and he pulled the code. He is a bit mystified at this point.
Marine Mechanic: Jason, Marine Mechanic replied 1 year ago

Can you find out what tool he is using, and specifically what the code says?

Ask Your Own Boat Question
Customer reply replied 1 year ago
Ok found out the code. Code 41 Shows fault H, G, D, B, A.
Marine Mechanic: Jason, Marine Mechanic replied 1 year ago

This isn't going to work. I will opt out

Ask Your Own Boat Question
Ask Dominick Your Own Question
Dominick
Dominick
Dominick, Marine Mechanic
Category: Boat
Satisfied Customers: 1,009
1,009 Satisfied Customers
Experience: 25 Years Experience as Mechanic, 20 Yrs Boat Yard Owner/Mechanic, Factory Certified

Dominick is online now

A new question is answered every 9 seconds

How JustAnswer works:

  • Ask an ExpertExperts are full of valuable knowledge and are ready to help with any question. Credentials confirmed by a Fortune 500 verification firm.
  • Get a Professional AnswerVia email, text message, or notification as you wait on our site. Ask follow up questions if you need to.
  • 100% Satisfaction GuaranteeRate the answer you receive.

JustAnswer in the News:

Ask-a-doc Web sites: If you've got a quick question, you can try to get an answer from sites that say they have various specialists on hand to give quick answers... Justanswer.com.
JustAnswer.com...has seen a spike since October in legal questions from readers about layoffs, unemployment and severance.
Web sites like justanswer.com/legal
...leave nothing to chance.
Traffic on JustAnswer rose 14 percent...and had nearly 400,000 page views in 30 days...inquiries related to stress, high blood pressure, drinking and heart pain jumped 33 percent.
Tory Johnson, GMA Workplace Contributor, discusses work-from-home jobs, such as JustAnswer in which verified Experts answer people’s questions.
I will tell you that...the things you have to go through to be an Expert are quite rigorous.

What Customers are Saying:

Wonderful service, prompt, efficient, and accurate. Couldn't have asked for more. I cannot thank you enough for your help.

Mary C.Freshfield, Liverpool, UK

This expert is wonderful. They truly know what they are talking about, and they actually care about you. They really helped put my nerves at ease. Thank you so much!!!!

AlexLos Angeles, CA

Thank you for all your help. It is nice to know that this service is here for people like myself, who need answers fast and are not sure who to consult.

GPHesperia, CA

I couldn't be more satisfied! This is the site I will always come to when I need a second opinion.

JustinKernersville, NC

Just let me say that this encounter has been entirely professional and most helpful. I liked that I could ask additional questions and get answered in a very short turn around.

EstherWoodstock, NY

Thank you so much for taking your time and knowledge to support my concerns. Not only did you answer my questions, you even took it a step further with replying with more pertinent information I needed to know.

RobinElkton, Maryland

He answered my question promptly and gave me accurate, detailed information. If all of your experts are half as good, you have a great thing going here.

DianeDallas, TX

< Previous | Next >

Meet the Experts:

Dominick

Dominick

Marine Mechanic

1,009 satisfied customers

25 Years Experience as Mechanic, 20 Yrs Boat Yard Owner/Mechanic, Factory Certified

Ted G.

Ted G.

Rigger, Diagnostician

695 satisfied customers

40 years boating, Safe boating instruct., Offshore Race promoter, Failure Analysis, Expert Witness

John White

John White

Marine Mechanic

306 satisfied customers

11 years experience working on outboards, inboards, sterndrives & pwcs

Jason

Jason

Marine Mechanic

16,416 satisfied customers

Degree in Marine Technology. Gas and diesel marine mechanic.

Tan

Tan

MerCruiser Certified Technician

11,003 satisfied customers

40 yrs. experience with complete engine repairs both inboard/outboard and MerCruiser Certified Technician.

Jeff G.

Jeff G.

Marine Mechanic

4,728 satisfied customers

42 years experience, Certified Master Technician, All Major Outboards, Sterndrives, Hi-Performance

Captain Dave

Captain Dave

Marine Mechanic

2,672 satisfied customers

USCG Licensed Captain, 20+ Years Boating, Fishing, Maintenance and Repair Experience

< Previous | Next >

Related Boat Questions
How do I reset the safe mode to run properly on my Mercury
How do I reset the safe mode to run properly on my Mercury 60 EFI Big Foot out board/ … read more
Charles
Charles
Certified Mercury Tech
4,034 satisfied customers
I don't know how to explain, this is for 2 year old df40
Hi i don't know how to explain, this is for 2 year old df40 house power 4 stroke suzuki, when you put up throttle on power the engine start to choking.… read more
Jason
Jason
Marine Mechanic
16,416 satisfied customers
Flemming again again here from DK. Firing up my Mercruiser
Hi Jason, Flemming again again here from DK. Firing up my Mercruiser 4.3 V6 is a succes, only I have an issue I'd like to run by you. When firing up I get sparks from the distributor case to the carbu… read more
Jason
Jason
Marine Mechanic
16,416 satisfied customers
We're on a Bav 40, 2002 model which has a Volvo Penta MD2030
We're on a Bav 40, 2002 model which has a Volvo Penta MD2030 engine. It has about 1100 hours on it. New fuel pump & mixing elbow 3 yrs ago. Recently, we changed the primary and secondary (racor) filte… read more
Jason
Jason
Marine Mechanic
16,416 satisfied customers
Is there a throttle only button on a quicksilver 88688A26
Hello is there a throttle only button on a quicksilver 88688A26 throttle? … read more
Charles
Charles
Certified Mercury Tech
4,034 satisfied customers
I have a 1988 four winds 160 freedom. 3.0. my first. Again,
Again, my 88 four wimns 160 . First time out put it in reverse backed up from dock and tryed to put it in forward and it would not come out of reverse. Is there a simple reason wh… read more
Jason
Jason
Marine Mechanic
16,416 satisfied customers
BF60A outboard, has had O2 sensor replaced because check
BF60A outboard, has had O2 sensor replaced because check engine light had come on twice, reader confirmed this was fault. It still will not reach full revs at times and when it does it drops back to 4… read more
Boat Doc
Boat Doc
144 satisfied customers
I have a 15hp mercury 2cy that will go to high speed
I have a 15hp mercury 2cy that will go to high speed intermittently. It runs great otherwise. Low speed is smooth and so is high when it decides to go there … read more
Jason
Jason
Marine Mechanic
16,416 satisfied customers
Which standard is maximum power rating calculated to for a
Which standard is maximum power rating calculated to for a Suzuki 150Hp Outboard. Model D150? … read more
Charles
Charles
Certified Mercury Tech
4,034 satisfied customers
My 1994 200V6 Yamaha outboard run out of oil due to a faulty
My 1994 200V6 Yamaha outboard run out of oil due to a faulty oil level sensor in the outboard tank not activating the oil supplyfrom the filler tank. The motor died while running at 75% speed. It is s… read more
Charles
Charles
Certified Mercury Tech
4,034 satisfied customers
I have a 2002 125hp mercury outboard. It has a toggle kill
I have a 2002 125hp mercury outboard. It has a toggle kill switch. Im wanting to replace the kill switch and ignition. Is the current kill switch a 3 wire or 2 wire. If 3 wire, can i replace with a 2 … read more
Jason
Jason
Marine Mechanic
16,416 satisfied customers
Need to install a new Throttle Linkage Kit by wednesday. I
Need to install a new Throttle Linkage Kit by wednesday. I have the kit, and understand what the end result should look like but a step by step would be helpful … read more
Charles
Charles
Certified Mercury Tech
4,034 satisfied customers
Ering a Bertram Purchase and switching from Freshwater Lake
ering a Bertram Purchase and switching from Freshwater Lake usage to Salt Water … read more
Jason
Jason
Marine Mechanic
16,416 satisfied customers
Flemming from DK here. So now I'm almost done with the
Hi Jason, Flemming from DK here. So now I'm almost done with the wiring on the engine, that you very succesfully helped me with. I'm looking at the switchboard and ignition key now. Quick question, is… read more
Jason
Jason
Marine Mechanic
16,416 satisfied customers
I have a 1993 Yamaha outboard 2 stroke. Which is only
Hi I have a 1993 Yamaha outboard 2 stroke. Which is only running on two of the three cylinders … read more
Charles
Charles
Certified Mercury Tech
4,034 satisfied customers
I have recently purchased a second hand boat which has a
I have recently purchased a second hand boat which has a HDS5X fitted but I cannot get the split screen to disappear, could you please give me some advice. … read more
Charles
Charles
Certified Mercury Tech
4,034 satisfied customers
I have an issue with my 1998 25hp NMO Autolube Yamaha. It
Hi I have an issue with my 1998 25hp NMO Autolube Yamaha. It has a backfire/sneeze on tick over only, it is fine through the rest of the power range. I have taken the carbs off had them fully cleaned … read more
Charles
Charles
Certified Mercury Tech
4,034 satisfied customers
Iwant to install a bow thruster on my Sea Ray 240 OB, 2015.
Iwant to install a bow thruster on my Sea Ray 240 OB, 2015. Will it work? Do you recommend it? … read more
Charles
Charles
Certified Mercury Tech
4,034 satisfied customers
Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

Show MoreShow Less

Ask Your Question

x