Boat

Have Boat Questions? Ask a Boat Repair Expert.

Connect one-on-one with {0} who will answer your question

Related Boat Questions
60 HP Mercury outboard on pontoon. Under lower speeds
60 HP Mercury outboard on pontoon. Under lower speeds (1500-1800 rpm) the motor runs fine for about 20 minutes, then "stumbles" like it isn't getting fuel. Pumping the primer bulb does not help. Event… read more
CalebA820
CalebA820
Technician
Marine technology
18 satisfied customers
60 hp 4 stroke running very rough at 6K - 7K RPM but fine
60 hp 4 stroke running very rough at 6K - 7K RPM but fine below that … read more
Jason
Jason
Marine Mechanic
22,852 satisfied customers
2002 60 hp yamaha replaced throttle cable & controller,now
2002 60 hp yamaha replaced throttle cable & controller,now when acceratting at 2000 rpm shutters and misses … read more
Jason
Jason
Marine Mechanic
22,852 satisfied customers
2008 75 HP 4 stroke EFI. Hesitation when throttle up between
2008 75 HP 4 stroke EFI. Hesitation when throttle up between 1000 and 2000 RPM, only when sitting for week. Idles and starts fine. after several hesitations, runs fine at 4-5000 Rpm. Gas or electric p… read more
Charles
Charles
Certified Mercury Tech
5,746 satisfied customers
60 hp "2000" idles fine at first after bringing it up to
60 hp "2000 " idles fine at first after bringing it up to half to full throttle it boggs down nd dies. Hard to restart. I replaced the gas completely ( thier was water ) I replaced the fuel pump. Than… read more
Jason
Jason
Marine Mechanic
22,852 satisfied customers
I have 60 hp 2 stroke mercury. About 12 years old?? I'm not
I have 60 hp 2 stroke mercury. About 12 years old?? I'm not original owner. We drive it for about a half an hour just fine about 20-22 mph; then when we restart it goes and then cuts out at full throt… read more
Jason
Jason
Marine Mechanic
22,852 satisfied customers
i have a 2003 yamaha 4 stroke fr50tlb that runs fine but will
i have a 2003 yamaha 4 stroke fr50tlb that runs fine but will not exceed past 4200 rpm. carbs have been cleaned twice with all new gaskets, new plugs. all fluid levels checked and all good. by hand an… read more
Joe
Joe
Owner Kingsland Auto & Marine Services
Vocational, Technical or Trade Scho
1,396 satisfied customers
60 Yamaha 2 stroke appears to go into safe mode and wont run
60 Yamaha 2 stroke appears to go into safe mode and won't run over 2000 rpm when put in gear. runs and accelerates in idle fine. new filters. irradic, safe mode no alrms though?… read more
Jason
Jason
Marine Mechanic
22,852 satisfied customers
2011 Yamaha 70 hp outboard. In the past 5 days of running
2011 Yamaha 70 hp outboard. In the past 5 days of running about 4 hrs a day Two to three times a day I have experiences A miss or something similar to running out Of gas. RPM's drop. I change throttle… read more
Jeremy R.
Jeremy R.
5,362 satisfied customers
I have a 2011 Yamaha 4 stroke 150. It spudders at about 5000
I have a 2011 Yamaha 4 stroke 150. It spudders at about 5000 rpm but runs fine at lower rpm?… read more
James
James
Certified Marine Mechanic
Vocational, Technical or Trade Scho
4,094 satisfied customers
I am looking for a pair of outboard engines for my boat. How
I am looking for a pair of outboard engines for my boat. How is new Yamaha V6 4.2l 300hp (2011) Reliability? Running cost when comparing to evinrude 300hp (2011)? Which one have more power. Tanawat… read more
Jeff G.
Jeff G.
Marine Mechanic
Vocational, Technical or Trade Scho
4,730 satisfied customers
My 60 HP. 4 STROKE ( 2007 ) DOES NOT ACCELLERATE , ONLY GETS
My 60 HP. 4 STROKE ( 2007 ) DOES NOT ACCELLERATE , ONLY GETS UP TO 4000 rpms AT FULL THROTTLE, COULD THIS BE SOME SORT OF VAPOR LOCK ? THERE IS ONLY 25 HOURS ON THE MOTOR. SEEMS TO START FINE AND NO M… read more
Jason
Jason
Marine Mechanic
22,852 satisfied customers
I have a new skiff/center console with a 2010/2011 30hp mercury
I have a new skiff/center console with a 2010/2011 30hp mercury 4 stroke. I'm about 3 hours into the breakin period where you can run it at full throttle for minutes at a time. The motor at full throt… read more
Jeremy R.
Jeremy R.
5,362 satisfied customers
I have a yamaha 60 hp 4 stroke motor. the fuel line was cut
I have a yamaha 60 hp 4 stroke motor. the fuel line was cut some how and now it is fixed and I pumped the line and I know the motor is getting fuel but will not start. It was working fine untill this … read more
Noel Schembri
Noel Schembri
Marine mechanic
Diploma
2,628 satisfied customers
I have a 2006 90HP Yamaha 4 stroke engine. It is on a 23ft
I have a 2006 90HP Yamaha 4 stroke engine. It is on a 23ft pontoon boat. It has started to run at about 2000 rpms in neutral. Sometimes it will idle down and then after a few moments it will begin to … read more
Jeremy R.
Jeremy R.
5,362 satisfied customers
I have a 2008 yamaha two stroke 50 HP. First time leaving the
I have a 2008 yamaha two stroke 50 HP. First time leaving the ramp, the boat runs great with a minor engine cut out @ 2000 rpm. After shutting down the engine, then trying to throttle up again, the en… read more
orcamarine
orcamarine
Proprietor
Vocational, Technical or Trade Scho
7 satisfied customers
I have a 2003 Yamaha 4 stroke 115 hp that started having water
I have a 2003 Yamaha 4 stroke 115 hp that started having water in the oil after a full servicing. Only at higher rpms. Below 3500 it will actually "remove" the water. This happened before and eventual… read more
CAPT MARCIO
CAPT MARCIO
engineer
Vocational, Technical or Trade Scho
60 satisfied customers
Compare Yamaha 60 hp, 4 stroke to Evenrude, 60 hp e-tec
Have a tired 70 hp evenrude that is always hard to start year after year. Can't start it again, stored with stabil etc. for 4 months. Can't take it any more after 16 plus year. Want a 60 hp ,and I am … read more
davesoutboard
davesoutboard
owner
Associate Degree
1,570 satisfied customers
Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

JustAnswer in the News:

Ask-a-doc Web sites: If you've got a quick question, you can try to get an answer from sites that say they have various specialists on hand to give quick answers... Justanswer.com.
JustAnswer.com...has seen a spike since October in legal questions from readers about layoffs, unemployment and severance.
Web sites like justanswer.com/legal
...leave nothing to chance.
Traffic on JustAnswer rose 14 percent...and had nearly 400,000 page views in 30 days...inquiries related to stress, high blood pressure, drinking and heart pain jumped 33 percent.
Tory Johnson, GMA Workplace Contributor, discusses work-from-home jobs, such as JustAnswer in which verified Experts answer people’s questions.
I will tell you that...the things you have to go through to be an Expert are quite rigorous.

What Customers are Saying:

Wonderful service, prompt, efficient, and accurate. Couldn't have asked for more. I cannot thank you enough for your help.

Mary C.Freshfield, Liverpool, UK

This expert is wonderful. They truly know what they are talking about, and they actually care about you. They really helped put my nerves at ease. Thank you so much!!!!

AlexLos Angeles, CA

Thank you for all your help. It is nice to know that this service is here for people like myself, who need answers fast and are not sure who to consult.

GPHesperia, CA

I couldn't be more satisfied! This is the site I will always come to when I need a second opinion.

JustinKernersville, NC

Just let me say that this encounter has been entirely professional and most helpful. I liked that I could ask additional questions and get answered in a very short turn around.

EstherWoodstock, NY

Thank you so much for taking your time and knowledge to support my concerns. Not only did you answer my questions, you even took it a step further with replying with more pertinent information I needed to know.

RobinElkton, Maryland

He answered my question promptly and gave me accurate, detailed information. If all of your experts are half as good, you have a great thing going here.

DianeDallas, TX

< Previous | Next >

Meet the Experts:

Ted G.

Ted G.

Rigger, Diagnostician

2,729 satisfied customers

40 years boating, Safe boating instruct., Offshore Race promoter, Failure Analysis, Expert Witness

Dominick

Dominick

Marine Mechanic

1,009 satisfied customers

25 Years Experience as Mechanic, 20 Yrs Boat Yard Owner/Mechanic, Factory Certified

John White

John White

Marine Mechanic

306 satisfied customers

11 years experience working on outboards, inboards, sterndrives & pwcs

Jason

Jason

Marine Mechanic

22,852 satisfied customers

Degree in Marine Technology. Gas and diesel marine mechanic.

Tan

Tan

MerCruiser Certified Technician

11,409 satisfied customers

40 yrs. experience with complete engine repairs both inboard/outboard and MerCruiser Certified Technician.

Jeff G.

Jeff G.

Marine Mechanic

4,730 satisfied customers

42 years experience, Certified Master Technician, All Major Outboards, Sterndrives, Hi-Performance

Captain Dave

Captain Dave

Marine Mechanic

2,672 satisfied customers

USCG Licensed Captain, 20+ Years Boating, Fishing, Maintenance and Repair Experience

< Previous | Next >

Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

Show MoreShow Less

Ask Your Question

x