Boat

Have Boat Questions? Ask a Boat Repair Expert.

Connect one-on-one with {0} who will answer your question

Related Boat Questions
I have a 2004, 20 foot aries bass boat with a 200 3.0 efi
I have a 2004, 20 foot aries bass boat with a 200 3.0 efi mercury and it vibrates when coming out of hole and trying to get on plane. was doing it before i took to a friend who is boat mechanic and st… read more
Noel Schembri
Noel Schembri
Marine mechanic
Diploma
2,711 satisfied customers
Got a 2007 Mercury 250 EFI idols good but when you tried to
Got a 2007 Mercury 250 EFI idols good but when you tried to get on a plane motor start breaking down won't go… read more
Charles
Charles
Certified Mercury Tech
5,752 satisfied customers
1984 115 hp inline 6. Had carbs rebuilt. wont get above 1500
All fuel line and primer bulb have been replaced also.… read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,507 satisfied customers
Its 175 efi mercury spitts nd sputters tryuing to get on
its 175 efi mercury spitts nd sputters tryuing to get on plane … read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade School
22,043 satisfied customers
I have a mercury 200 efi boat runs fine except when taking
I have a mercury 200 efi boat runs fine except when taking off. You can floor it and it does nothing rpms badly go up and will just sit there until I start to trim up about 6 inches then it takes off … read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade School
22,043 satisfied customers
I have a 2010 mercury 350 mag engine, a problem started with
I have a 2010 mercury 350 mag engine, a problem started with engine stalling while trying to get on plane, I could ease into throttle and boat would run but would stall under full load. I figured that… read more
Charles
Charles
Certified Mercury Tech
5,752 satisfied customers
My 1993 merc 25 hp serial 0D255484 2 cylinder runs great
My 1993 merc 25 hp serial 0D255484 2 cylinder runs great (fresh rebuild carb.) for 10 to 20 minutes on plane at 3/4 throttle . Then dies down to slow speed running very rough. Once it cools completely… read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,507 satisfied customers
I have a 76 mercury 115hp thunderbolt. I took it out for
Hi, I have a 76 mercury 115hp thunderbolt. I took it out for the first time and didn't have any problems. The next time I took it out, I could get about half throttle, right before the boat started to… read more
Jeff G.
Jeff G.
Marine Mechanic
Vocational, Technical or Trade Scho
4,730 satisfied customers
Have 1999 sprint 296 w mercury 200 efi.... getting 2 alarms...beeping
Have 1999 sprint 296 w mercury 200 efi.... getting 2 alarms...beeping one all time then solid alarm after 5-10mins at throttle....also boat starts hopping very very bad after running a min or 2 at pla… read more
Charles
Charles
Certified Mercury Tech
5,752 satisfied customers
I have a 2008 Mercury 250 Pro Xs. I have been having issues
I have a 2008 Mercury 250 Pro Xs. I have been having issues with motor losing power, cutting in and out like a coil is going bad. Some times it runs great hits top end with no problem and hits hums al… read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade School
22,043 satisfied customers
I have a 1973 Mako 19. I have had the boat completely rebuilt,
I have a 1973 Mako 19. I have had the boat completely rebuilt, the soaked foam was taken out from between the hulls, the boat was then rebuilt with wood beams and inner keels etc. The two hulls are no… read more
Jeff G.
Jeff G.
Marine Mechanic
Vocational, Technical or Trade Scho
4,730 satisfied customers
I have a 12 ft. Valco Aluminum skiff. Will a 9.9 HP 4 stroke
I have a 12 ft. Valco Aluminum skiff. Will a 9.9 HP 4 stroke outboard provide enough power to plane the boat?… read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade School
22,043 satisfied customers
I have a 1998 mariner 225. Its completely rebuilt and installed
I have a 1998 mariner 225. Its completely rebuilt and installed on my boat. When at the boat ramp I can hit the throttle and spinds right up. Ill start going down the channel and it will start spittin… read more
James
James
Certified Marine Mechanic
Vocational, Technical or Trade Scho
4,094 satisfied customers
My son has a 200 HP Mercury EFI engine on a ranger bass boat.
My son has a 200 HP Mercury EFI engine on a ranger bass boat. The original engine locked up aproximately 14 months ago. It was replaced with a rebuilt power head and has been running fine since then. … read more
Scott Martin
Scott Martin
Service manager
Vocational, Technical or Trade Scho
167 satisfied customers
1998 Mercury 200 2 stroke oil injection removed Engine problem It
1998 Mercury 200 2 stroke oil injection removed Engine problem It feels like if it was a carb motor, dirty jets or it is just not firing on all cylinders (guardian mode) About 100 miles on rebuild Fue… read more
Jeremy R.
Jeremy R.
5,362 satisfied customers
I just purchased a boat that was in storage for three years.
I just purchased a boat that was in storage for three years. Boat started right up and pumped water. (with motor muffs on) It's a 1999 225 Four Winns with a 5.0 GL and a SX Outdrive-low hours I put th… read more
Jeremy R.
Jeremy R.
5,362 satisfied customers
Hom much would a new Mecury 120 jet motor cost to purchase
Hom much would a new Mecury 120 jet motor cost to purchase and installed and a rebuilt motor for a 16' tender. The boat is a 1998 and the motor has not woked in 2 yrs.… read more
Kenny
Kenny
Mercury & Mercruiser Diagnostics
Master's Degree
99 satisfied customers
i have a 1999 200 efi ser # XXXXX bought new has low hours
i have a 1999 200 efi ser # XXXXX bought new has low hours and hit something under water and broke the crankshaft right under flywheel and my insurance co. tells me it was due to metal fatigue not imp… read more
davesoutboard
davesoutboard
owner
Associate Degree
1,570 satisfied customers
Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

JustAnswer in the News:

Ask-a-doc Web sites: If you've got a quick question, you can try to get an answer from sites that say they have various specialists on hand to give quick answers... Justanswer.com.
JustAnswer.com...has seen a spike since October in legal questions from readers about layoffs, unemployment and severance.
Web sites like justanswer.com/legal
...leave nothing to chance.
Traffic on JustAnswer rose 14 percent...and had nearly 400,000 page views in 30 days...inquiries related to stress, high blood pressure, drinking and heart pain jumped 33 percent.
Tory Johnson, GMA Workplace Contributor, discusses work-from-home jobs, such as JustAnswer in which verified Experts answer people’s questions.
I will tell you that...the things you have to go through to be an Expert are quite rigorous.

What Customers are Saying:

Wonderful service, prompt, efficient, and accurate. Couldn't have asked for more. I cannot thank you enough for your help.

Mary C.Freshfield, Liverpool, UK

This expert is wonderful. They truly know what they are talking about, and they actually care about you. They really helped put my nerves at ease. Thank you so much!!!!

AlexLos Angeles, CA

Thank you for all your help. It is nice to know that this service is here for people like myself, who need answers fast and are not sure who to consult.

GPHesperia, CA

I couldn't be more satisfied! This is the site I will always come to when I need a second opinion.

JustinKernersville, NC

Just let me say that this encounter has been entirely professional and most helpful. I liked that I could ask additional questions and get answered in a very short turn around.

EstherWoodstock, NY

Thank you so much for taking your time and knowledge to support my concerns. Not only did you answer my questions, you even took it a step further with replying with more pertinent information I needed to know.

RobinElkton, Maryland

He answered my question promptly and gave me accurate, detailed information. If all of your experts are half as good, you have a great thing going here.

DianeDallas, TX

< Previous | Next >

Meet the Experts:

Ted G.

Ted G.

Rigger, Diagnostician

2,678 satisfied customers

40 years boating, Safe boating instruct., Offshore Race promoter, Failure Analysis, Expert Witness

Dominick

Dominick

Marine Mechanic

1,009 satisfied customers

25 Years Experience as Mechanic, 20 Yrs Boat Yard Owner/Mechanic, Factory Certified

John White

John White

Marine Mechanic

306 satisfied customers

11 years experience working on outboards, inboards, sterndrives & pwcs

Jason

Jason

Marine Mechanic

22,043 satisfied customers

Degree in Marine Technology. Gas and diesel marine mechanic.

Tan

Tan

MerCruiser Certified Technician

11,507 satisfied customers

40 yrs. experience with complete engine repairs both inboard/outboard and MerCruiser Certified Technician.

Jeff G.

Jeff G.

Marine Mechanic

4,730 satisfied customers

42 years experience, Certified Master Technician, All Major Outboards, Sterndrives, Hi-Performance

Captain Dave

Captain Dave

Marine Mechanic

2,672 satisfied customers

USCG Licensed Captain, 20+ Years Boating, Fishing, Maintenance and Repair Experience

< Previous | Next >

Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

Show MoreShow Less

Ask Your Question

x