Boat

Have Boat Questions? Ask a Boat Repair Expert.

Connect one-on-one with {0} who will answer your question

Related Boat Questions
Not getting enough rpms wot is at 5300 rpms. Its a 2008
its a 2008 mercury verado 275 . As I turn on and put into gear the alarm goes off for throttle lever then stops. top speed is only 32mph @ 5300 rpm. im sure I should be 6200 rpms @ 50-55 mph … read more
Charles
Charles
Certified Mercury Tech
5,523 satisfied customers
I have a 2003 50hp Suzuki 4 stroke (tiller Model) that has
I have a 2003 50hp Suzuki 4 stroke (tiller Model) that has always ran like a dream. A few weeks ago on a 10 day fishing trip to Northern Quebec I noticed a strong gas smell coming from the exhaust por… read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade School
20,025 satisfied customers
Hi Jason I have a 2008 150 optimax that stalls underload when
Hi Jason I have a 2008 150 optimax that stalls underload when in gear but will clear up when you run it wot then bring it back to idle again . But if you leave it about 15-20 minutes at idle it will b… read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade School
20,025 satisfied customers
Hi, Just took the boat out for first time this summer. We
Hi, Just took the boat out for first time this summer. We have a 2005 Bayliner Bowrider, with the MerCruiser 5.0 220 hp inboard/outboard engine. Started fine, and ran pretty well to start. But in a fe… read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade School
20,025 satisfied customers
Boat has a cracked fuel injector. Would not go above 2500 rpm
Boat has a cracked fuel injector. Would not go above 2500 rpm before bogging down. Strong gas smell and exhaust coming out of water exhaust port. Replaced injector and some other fouled plugs. Boat ra… read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,406 satisfied customers
2003 SeaRay 320DA with 6.2 inboards Props 18x17x 2.0 reconditioned
2003 SeaRay 320DA with 6.2 inboards Props 18x17x 2.0 reconditioned 3 days ago Clean bottom New plugs, cap, rotor, wires, fuel filter WOT 4500 rpm, 27 mph, 22 GPH fuel burn each Blue white exhaust Port… read more
Charles
Charles
Certified Mercury Tech
5,523 satisfied customers
The 2/3 coil on my 2003 Suzuki DF115 overheated and burst open.
The 2/3 coil on my 2003 Suzuki DF115 overheated and burst open. I replaced it with a new coil and the new coil won't fire. I have 12 volts to the coil with key on. What could be the cause. Does this e… read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade School
20,025 satisfied customers
i have a volvo penta 5.7 in a 2003 Larson 28. we have changed
i have a volvo penta 5.7 in a 2003 Larson 28'. we have changed the coil, spark plugs, spark plug wires and distributor cap. Yet, the engine still cuts out at WOT. We have also changed all fuel line fi… read more
K. Kergan
K. Kergan
Inboard/Outboard Mechanic
Vocational, Technical or Trade Scho
1,031 satisfied customers
yamaha 40 elh 1987 out board i have dripping water at the tell
yamaha 40 elh 1987 out board i have dripping water at the tell tale. i replaced the water pump/impeller. the hose is clear from the engine to the tell tale. dripping water at the engine fitting when i… read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,406 satisfied customers
I have a 2003 Sundancer w/ twin Mercruiser 4.3 s - Enginea
I have a 2003 Sundancer w/ twin Mercruiser 4.3 s - Enginea run fine at idle but Starboard bogged down trying to (unsuccessfully) get on plane. Heard a ticking and smelled some burning rubber / plastic… read more
James
James
Certified Marine Mechanic
Vocational, Technical or Trade Scho
4,094 satisfied customers
Mercury marine 250xl efi saltwater: I just purchased a 25
I just purchased a 25' fountain open with 1997 250 XL EFI 3.0L: it wants to run at 2000 RPMs and burns really dirty and keeps fouling plugs. It idles rough (almost sounds like it misses). I can creep … read more
Jeff G.
Jeff G.
Marine Mechanic
Vocational, Technical or Trade Scho
4,730 satisfied customers
I have 2010 twin CMD QSD 4.2 320s with Bravo II out drives.
I have 2010 twin CMD QSD 4.2 320's with Bravo II out drives. The engines have done 260 hours and have been maintained to exact factory specifications by qualified Mercury techs. Cruising at 3300 rpm, … read more
James
James
Certified Marine Mechanic
Vocational, Technical or Trade Scho
4,094 satisfied customers
I have a 2003 suzuki df 140 outboard. It overheated yesterday
I have a 2003 suzuki df 140 outboard. It overheated yesterday and dropped my rpm to a max of 2000,I was trying to outrun a thunderstorm in very rough seas for a few miles. I never har rpm"s above 5500… read more
Jeremy R.
Jeremy R.
5,362 satisfied customers
I have a 1993 50 HP Mercury outboard motor ( 2 stroke, 3 cylinder)
I have a 1993 50 HP Mercury outboard motor ( 2 stroke, 3 cylinder) on my SOS Express speedboat. It only has about 100 operating hours and has had immaculate care and maintenance since the original pur… read more
Whitecap36
Whitecap36
Service Manager/Technician
Vocational, Technical or Trade Scho
1,556 satisfied customers
I have a 2006 Suzuki DF200. It is losing power, I had the injectors
I have a 2006 Suzuki DF200. It is losing power, I had the injectors cleaned, new filters, (all of them) tank cleaned, new fuel lines, VST tank cleaned, new plugs, and new low pressure fuel filter. It … read more
Jeff G.
Jeff G.
Marine Mechanic
Vocational, Technical or Trade Scho
4,730 satisfied customers
Hey guys heres my question 2004 Cig. with 525s Its with sportmasters
Hey guys heres my question 2004 Cig. with 525s Its with sportmasters two weeks ago sea pump blew apart so I back flushed from heat exchanger and alot of debris came out. I then installed new pump asse… read more
Jeremy R.
Jeremy R.
5,362 satisfied customers
I own a 2004 Stingray 240CS. 305 mpfi 260 hp with 170 hours.
I own a 2004 Stingray 240CS. 305 mpfi 260 hp with 170 hours. I have been chashing an engine miss since last fall. At approx 4400 rpm (judging the tach is accurate) the eng will miss "run, ugh....run, … read more
Jeremy R.
Jeremy R.
5,362 satisfied customers
I have a 2003 Yamaha 70 outboard that is difficult to start
I have a 2003 Yamaha 70 outboard that is difficult to start and when it starts, idles roughly. Seems to run okay once it is throttled up, but is burning way too much oil gas. What would cause this?… read more
Pappy's Sales and Service
Pappy's Sales and Service
Vocational, Technical or Trade Scho
586 satisfied customers
Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

JustAnswer in the News:

Ask-a-doc Web sites: If you've got a quick question, you can try to get an answer from sites that say they have various specialists on hand to give quick answers... Justanswer.com.
JustAnswer.com...has seen a spike since October in legal questions from readers about layoffs, unemployment and severance.
Web sites like justanswer.com/legal
...leave nothing to chance.
Traffic on JustAnswer rose 14 percent...and had nearly 400,000 page views in 30 days...inquiries related to stress, high blood pressure, drinking and heart pain jumped 33 percent.
Tory Johnson, GMA Workplace Contributor, discusses work-from-home jobs, such as JustAnswer in which verified Experts answer people’s questions.
I will tell you that...the things you have to go through to be an Expert are quite rigorous.

What Customers are Saying:

Wonderful service, prompt, efficient, and accurate. Couldn't have asked for more. I cannot thank you enough for your help.

Mary C.Freshfield, Liverpool, UK

This expert is wonderful. They truly know what they are talking about, and they actually care about you. They really helped put my nerves at ease. Thank you so much!!!!

AlexLos Angeles, CA

Thank you for all your help. It is nice to know that this service is here for people like myself, who need answers fast and are not sure who to consult.

GPHesperia, CA

I couldn't be more satisfied! This is the site I will always come to when I need a second opinion.

JustinKernersville, NC

Just let me say that this encounter has been entirely professional and most helpful. I liked that I could ask additional questions and get answered in a very short turn around.

EstherWoodstock, NY

Thank you so much for taking your time and knowledge to support my concerns. Not only did you answer my questions, you even took it a step further with replying with more pertinent information I needed to know.

RobinElkton, Maryland

He answered my question promptly and gave me accurate, detailed information. If all of your experts are half as good, you have a great thing going here.

DianeDallas, TX

< Previous | Next >

Meet the Experts:

Ted G.

Ted G.

Rigger, Diagnostician

1,074 satisfied customers

40 years boating, Safe boating instruct., Offshore Race promoter, Failure Analysis, Expert Witness

Dominick

Dominick

Marine Mechanic

1,009 satisfied customers

25 Years Experience as Mechanic, 20 Yrs Boat Yard Owner/Mechanic, Factory Certified

John White

John White

Marine Mechanic

306 satisfied customers

11 years experience working on outboards, inboards, sterndrives & pwcs

Jason

Jason

Marine Mechanic

20,025 satisfied customers

Degree in Marine Technology. Gas and diesel marine mechanic.

Tan

Tan

MerCruiser Certified Technician

11,406 satisfied customers

40 yrs. experience with complete engine repairs both inboard/outboard and MerCruiser Certified Technician.

Jeff G.

Jeff G.

Marine Mechanic

4,730 satisfied customers

42 years experience, Certified Master Technician, All Major Outboards, Sterndrives, Hi-Performance

Captain Dave

Captain Dave

Marine Mechanic

2,672 satisfied customers

USCG Licensed Captain, 20+ Years Boating, Fishing, Maintenance and Repair Experience

< Previous | Next >

Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

Show MoreShow Less

Ask Your Question

x