Boat

Have Boat Questions? Ask a Boat Repair Expert.

Connect one-on-one with {0} who will answer your question

Related Boat Questions
I have a 1996 25 elh mariner tiller at full throttle it will
I have a 1996 25 elh mariner tiller at full throttle it will run 12mph but when I pulled the choke out it will rev up and run 18 mph but when I push the choke back it it slows back to 12 It idles good… read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,507 satisfied customers
Mercruiser 3.0 with 2 bbl. After the boat sits for three or
Mercruiser 3.0 with 2 bbl. After the boat sits for three or four days engine won't start unless gas poured down the carburetor. Starts right up and runs fine after that. Otherwise I have to crank the … read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,507 satisfied customers
The last time I had it out, it ran perfectly. This time it
The last time I had it out, it ran perfectly. This time it backfires through the exhaust and dies. Nothing has been to the motor between those times. … read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,507 satisfied customers
I have a 1996 Mercury outboard motor and when it starts it
I have a 1996 Mercury outboard motor and when it starts it runs fine. When I open up the throttle and run it will for say 20 to 30 seconds , then it loses power. If I pull out the choke it will run at… read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,507 satisfied customers
I have a older 20hp mercury outboard. The fuel bulb will not
I have a older 20hp mercury outboard. The fuel bulb will not pump up firm like i am used to. The motor won't start except with starting fluid. I changed tanks, and put a new Atwood bulb and fuel hose … read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,507 satisfied customers
25 horse,bought in 2000, will only run with choke pulled
Johnson 25 horse,bought in 2000, will only run with choke pulled half way out and at half throttle. Suggestion as to what I should try to do to get it to run normally. Thanks… read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,507 satisfied customers
My 1989 sea ray 160 IO 4 cylinder GM engine fires on a few
my 1989 sea ray 160 IO 4 cylinder GM engine fires on a few cylinders and runs rough when idling. However when I rev engine and when it is in anything but idle mode it runs great. After it runs a while… read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,507 satisfied customers
Father in law gave me a five horse kicker, two stroke. Looks
Father in law gave me a five horse kicker, two stroke. Looks pretty new, but has been in a garage for a while. I have got it started, it ran but the speed varied at the same setting. It would run for … read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,507 satisfied customers
Have a 2000 40hp ELPT, runs well with no load( in water), but
Have a 2000 40hp ELPT, runs well with no load( in water), but seems to be drying out and only runs when choked. Drained all the old fuel, added stabil marine , and fresh fuel, drained fuel bowl, repla… read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,507 satisfied customers
mariner 8hp: bought a 8hp mariner outboard had trouble starting
bought a 8hp mariner outboard had trouble starting only ran for seconds before stalling. blew out carb with air, now starts right up but only stays running when I play with the choke. what could this … read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,507 satisfied customers
I have a 30 hp outboard johnson long shaft with controls that
I have a 30 hp outboard johnson long shaft with controls that i just put on my pontoon boat. When i start it by choking it and pulling up throttle it will start and run for 5-10 seconds then it quits.… read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,507 satisfied customers
Hello my 1982 80 hp outboard starts fine, revs fine in neutral,
Hello my 1982 80 hp outboard starts fine, revs fine in neutral, but when put under load, in drive and you give it power it wants to stall out. I can use the choke to help it along put is hard to do. I… read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,507 satisfied customers
Johnson Outboard 1998 70hp start well and working well when
Johnson Outboard 1998 70hp start well and working well when the transmission OF,bat stop working in 5...10 sec. when I put transmission to ON (motor is enough hot). How We can fix this problem?… read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,507 satisfied customers
i have a 2002 25 horse foure stroke outboard it start good
i have a 2002 25 horse foure stroke outboard it start good but it only runs about 5 to10 seco seconds and quicks could it be my ecm… read more
Charles
Charles
Certified Mercury Tech
5,752 satisfied customers
1985 15 horse Evenruid: Starts and excellerates perfect until
1985 15 horse Evenruid: Starts and excellerates perfect until reaching running temp. Then when attempting to excellerate from low rpm it dies out unless I choke it in time to keep it going.… read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,507 satisfied customers
i have a 04 bayliner with a 3.0 mercruiser 4cyl. when i try
i have a 04 bayliner with a 3.0 mercruiser 4cyl. when i try turning it on it stalls in the neutral position, i changed the pump filter on it and new gas non ethenol. still the same. I am having to pus… read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,507 satisfied customers
Hi. i have a Mercury 75hp. It wont start unless you push up
Hi. i have a Mercury 75hp. It wont start unless you push up the button under the solenoid, is this the choke ? Once it started i took the pipes off and sealed the ends and we went out for an hour, on … read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,507 satisfied customers
Good Morning, I have a older Suzuki DT4 on my sailboat that
Good Morning, I have a older Suzuki DT4 on my sailboat that won't stay cranked for more then 10 minutes, if I wait 20 then it will run another 10. I initially ran it at the reccomended 100:1 then ran … read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,507 satisfied customers
Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

JustAnswer in the News:

Ask-a-doc Web sites: If you've got a quick question, you can try to get an answer from sites that say they have various specialists on hand to give quick answers... Justanswer.com.
JustAnswer.com...has seen a spike since October in legal questions from readers about layoffs, unemployment and severance.
Web sites like justanswer.com/legal
...leave nothing to chance.
Traffic on JustAnswer rose 14 percent...and had nearly 400,000 page views in 30 days...inquiries related to stress, high blood pressure, drinking and heart pain jumped 33 percent.
Tory Johnson, GMA Workplace Contributor, discusses work-from-home jobs, such as JustAnswer in which verified Experts answer people’s questions.
I will tell you that...the things you have to go through to be an Expert are quite rigorous.

What Customers are Saying:

Wonderful service, prompt, efficient, and accurate. Couldn't have asked for more. I cannot thank you enough for your help.

Mary C.Freshfield, Liverpool, UK

This expert is wonderful. They truly know what they are talking about, and they actually care about you. They really helped put my nerves at ease. Thank you so much!!!!

AlexLos Angeles, CA

Thank you for all your help. It is nice to know that this service is here for people like myself, who need answers fast and are not sure who to consult.

GPHesperia, CA

I couldn't be more satisfied! This is the site I will always come to when I need a second opinion.

JustinKernersville, NC

Just let me say that this encounter has been entirely professional and most helpful. I liked that I could ask additional questions and get answered in a very short turn around.

EstherWoodstock, NY

Thank you so much for taking your time and knowledge to support my concerns. Not only did you answer my questions, you even took it a step further with replying with more pertinent information I needed to know.

RobinElkton, Maryland

He answered my question promptly and gave me accurate, detailed information. If all of your experts are half as good, you have a great thing going here.

DianeDallas, TX

< Previous | Next >

Meet the Experts:

Ted G.

Ted G.

Rigger, Diagnostician

3,332 satisfied customers

40 years boating, Safe boating instruct., Offshore Race promoter, Failure Analysis, Expert Witness

Dominick

Dominick

Marine Mechanic

1,009 satisfied customers

25 Years Experience as Mechanic, 20 Yrs Boat Yard Owner/Mechanic, Factory Certified

John White

John White

Marine Mechanic

306 satisfied customers

11 years experience working on outboards, inboards, sterndrives & pwcs

Jason

Jason

Marine Mechanic

22,804 satisfied customers

Degree in Marine Technology. Gas and diesel marine mechanic.

Tan

Tan

MerCruiser Certified Technician

11,507 satisfied customers

40 yrs. experience with complete engine repairs both inboard/outboard and MerCruiser Certified Technician.

Jeff G.

Jeff G.

Marine Mechanic

4,730 satisfied customers

42 years experience, Certified Master Technician, All Major Outboards, Sterndrives, Hi-Performance

Noel Schembri

Noel Schembri

Marine Mechanic

2,759 satisfied customers

Advanced technical diploma

< Previous | Next >

Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

Show MoreShow Less

Ask Your Question

x