Boat

Have Boat Questions? Ask a Boat Repair Expert.

Connect one-on-one with {0} who will answer your question

Related Boat Questions
1994 200hp. I blew a piston and pretty much destroyed the
1994 Johnson 200hp. I blew a piston and pretty much destroyed the block. I just purchased a 1995 Johnson 200hp power head long block to replace it. I have never really trusted the oil injection (VRO?)… read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade School
23,197 satisfied customers
I have an old Johnson 225 VRO mounted on 1972 21.5ft Boston
I have an old Johnson 225 VRO mounted on 1972 21.5ft Boston Whaler Outrage. I bought this used and I am the third owner with no owner's manual. The VRO is disconnected and I manually mix the 2-stroke … read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,409 satisfied customers
Johnson 110hp vro 1987 I just bought this motor, its vro
Johnson 110hp vro 1987 I just bought this motor, it's vro is disconnected. It was running for ten to fifteen minutes with a hesitation about every 30 seconds that sounded like it was going to run out … read more
Evinrude/Johnson
Evinrude/Johnson
Evinrude/Johnson marine technician
Vocational, Technical or Trade Scho
41 satisfied customers
alarm is going off after motor runs for a few minutes,1991
alarm is going off after motor runs for a few minutes,1991 johnson 40 hp.boats has been sitting for about year.1 solid beep that will get faster if i rev it up.motor is still pumping water out and doe… read more
Jeff G.
Jeff G.
Marine Mechanic
Vocational, Technical or Trade Scho
4,730 satisfied customers
I have a 2003 90hp johnson outboard. It will not idle. it
I have a 2003 90hp johnson outboard. It will not idle. it will stall when i'm running at 2000 rpm's or less... What can I do to fix the problem? I put new plugs in and fresh gas 93 octane.… read more
James
James
Certified Marine Mechanic
Vocational, Technical or Trade Scho
4,094 satisfied customers
I have a 1990 60hp OMC johnson outboard, the problem is that
I have a 1990 60hp OMC johnson outboard, the problem is that it wants to bog down after about 5 min. on the water if I squeeze the primer bulb it will keep running, but when I quit the engine will die… read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,409 satisfied customers
Jeff Thank you for your information concerning the above mentioned
Jeff Thank you for your information concerning the above mentioned Honda 4 stroke Marine engine. I know the following question is a difficult one to answer as I am asking for your opinion/advice. The … read more
Jeff G.
Jeff G.
Marine Mechanic
Vocational, Technical or Trade Scho
4,730 satisfied customers
Just fired up my 87 Johnson 50 hp w/ VRO after not using it
Just fired up my 87 Johnson 50 hp w/ VRO after not using it since last August, and it smokes bad and will not idle long. Last year it smoked a little and would stop running when idling or trolling eve… read more
Whitecap36
Whitecap36
Service Manager/Technician
Vocational, Technical or Trade Scho
1,557 satisfied customers
Trying to start a 1994 Johnson 120 V4 outboard that has been
Trying to start a 1994 Johnson 120 V4 outboard that has been sitting since its original 48 hours. It starts and runs for about 3-4 seconds and dies. Where do you recommend starting first? Plenty of go… read more
Shane Creekmore
Shane Creekmore
Certified Mercury Marine technician
High School or GED
535 satisfied customers
My boat is powered with 2-120hp Johnson outboards. The port
My boat is powered with 2-120hp Johnson outboards. The port engine occassionally starves for gas when operating over 3000 rpm. I have changed both filters, changed fuel lines, changed plugs, & added g… read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,409 satisfied customers
I have 1987 Omc sea drives. They now have blue smoke when I
I have 1987 Omc sea drives. They now have blue smoke when I start them. and I have lost a lot of power and speed.It has happened in the last to trips out. My boat is a 25' wellcraft… read more
tom
tom
outboard mechanic
High School or GED
117 satisfied customers
1998 Johnson 200 V6 Oceanrunner. New vro pump and oil tank
1998 Johnson 200 V6 Oceanrunner. New vro pump and oil tank just installed. Everything hooked up correctly and primed. System Check lights and horn all work fine. After running approx. 15 minutes, No O… read more
Jeff G.
Jeff G.
Marine Mechanic
Vocational, Technical or Trade Scho
4,730 satisfied customers
motor #70etlf 1989 my cylnders are receiving to much oil when
motor #70etlf 1989 my cylnders are receiving to much oil when running and when i shut the engine off oil leaks down the lower end what should i be checking for this problem.The compresion readings are… read more
Jeff G.
Jeff G.
Marine Mechanic
Vocational, Technical or Trade Scho
4,730 satisfied customers
i have a 1990 gt 200 johnson and the problem im having is sometimes
i have a 1990 gt 200 johnson and the problem im having is sometimes at around 3000 rpm's the motor will start missing real bad so i back off throttle and it idles fine the only way i can get it to run… read more
Jeff G.
Jeff G.
Marine Mechanic
Vocational, Technical or Trade Scho
4,730 satisfied customers
90hp evinrude outboard 1991 engine runs well at high rpms,
90hp evinrude outboard 1991 engine runs well at high rpms, but has a heavy smoke exhust aand will not run at low rpms..oil streaks on the shaft cover appears to be coming out of the upper unit???????… read more
Dominick
Dominick
Marine Mechanic
Vocational, Technical or Trade Scho
1,009 satisfied customers
I have a 2005 Johnson 90HP. The oil is in a seperate reservoir.
I have a 2005 Johnson 90HP. The oil is in a seperate reservoir. I seem to have some oil dripping from the front of the motor when the motor is in the "up" position. The motor also seems to run rough w… read more
Master Tech
Master Tech
Service Manager/Technician
Vocational, Technical or Trade Scho
1,167 satisfied customers
I have a 2001 Johnson 90hp outboard motor oil injection. It
I have a 2001 Johnson 90hp outboard motor oil injection. It is very hard to start if it has been sitting for 2 weeks are more. When it does start I have to keep pressing the choke to keep it running u… read more
Master Tech
Master Tech
Service Manager/Technician
Vocational, Technical or Trade Scho
1,167 satisfied customers
1993 Evinrude 120hp is smokey at low rpm. Engine seems to
1993 Evinrude 120hp is smokey at low rpm. Engine seems to lose power while trolling at 2200rpm .............. clears after a few mins at 3000rpm. Am now mixing at 75:1 and operating at 4500 rpm max. P… read more
Pappy's Sales and Service
Pappy's Sales and Service
Vocational, Technical or Trade Scho
586 satisfied customers
Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

JustAnswer in the News:

Ask-a-doc Web sites: If you've got a quick question, you can try to get an answer from sites that say they have various specialists on hand to give quick answers... Justanswer.com.
JustAnswer.com...has seen a spike since October in legal questions from readers about layoffs, unemployment and severance.
Web sites like justanswer.com/legal
...leave nothing to chance.
Traffic on JustAnswer rose 14 percent...and had nearly 400,000 page views in 30 days...inquiries related to stress, high blood pressure, drinking and heart pain jumped 33 percent.
Tory Johnson, GMA Workplace Contributor, discusses work-from-home jobs, such as JustAnswer in which verified Experts answer people’s questions.
I will tell you that...the things you have to go through to be an Expert are quite rigorous.

What Customers are Saying:

Wonderful service, prompt, efficient, and accurate. Couldn't have asked for more. I cannot thank you enough for your help.

Mary C.Freshfield, Liverpool, UK

This expert is wonderful. They truly know what they are talking about, and they actually care about you. They really helped put my nerves at ease. Thank you so much!!!!

AlexLos Angeles, CA

Thank you for all your help. It is nice to know that this service is here for people like myself, who need answers fast and are not sure who to consult.

GPHesperia, CA

I couldn't be more satisfied! This is the site I will always come to when I need a second opinion.

JustinKernersville, NC

Just let me say that this encounter has been entirely professional and most helpful. I liked that I could ask additional questions and get answered in a very short turn around.

EstherWoodstock, NY

Thank you so much for taking your time and knowledge to support my concerns. Not only did you answer my questions, you even took it a step further with replying with more pertinent information I needed to know.

RobinElkton, Maryland

He answered my question promptly and gave me accurate, detailed information. If all of your experts are half as good, you have a great thing going here.

DianeDallas, TX

< Previous | Next >

Meet the Experts:

Ted G.

Ted G.

Rigger, Diagnostician

2,678 satisfied customers

40 years boating, Safe boating instruct., Offshore Race promoter, Failure Analysis, Expert Witness

Dominick

Dominick

Marine Mechanic

1,009 satisfied customers

25 Years Experience as Mechanic, 20 Yrs Boat Yard Owner/Mechanic, Factory Certified

John White

John White

Marine Mechanic

306 satisfied customers

11 years experience working on outboards, inboards, sterndrives & pwcs

Jason

Jason

Marine Mechanic

23,197 satisfied customers

Degree in Marine Technology. Gas and diesel marine mechanic.

Tan

Tan

MerCruiser Certified Technician

11,409 satisfied customers

40 yrs. experience with complete engine repairs both inboard/outboard and MerCruiser Certified Technician.

Jeff G.

Jeff G.

Marine Mechanic

4,730 satisfied customers

42 years experience, Certified Master Technician, All Major Outboards, Sterndrives, Hi-Performance

Captain Dave

Captain Dave

Marine Mechanic

2,672 satisfied customers

USCG Licensed Captain, 20+ Years Boating, Fishing, Maintenance and Repair Experience

< Previous | Next >

Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

Show MoreShow Less

Ask Your Question

x