Boat

Have Boat Questions? Ask a Boat Repair Expert.

Connect one-on-one with {0} who will answer your question

Related Boat Questions
I have a mag 496 ho with a bravo 3. The steering level which
Hello. I have a mag 496 ho with a bravo 3.The steering level which connects To the swivel shaft broke. Is this something I can fix from the engine compartment? Or is it a must that I pull the stern dr… read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade Scho
18,277 satisfied customers
1984 Maxim 2400 SCR: Motor not turning a full 360 degree. Why?
I have a 4.3L Alpha 1 gen 2 in my boat. Last year I took the motor out and replaced it with a long block, swapping over my old components onto the new engine. This year I'm finishing and have the moto… read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade Scho
18,277 satisfied customers
what is the torque for the bolts that hold on the engine coupling
what is the torque for the bolts that hold on the engine coupling and the torque on the bell housing bolts and hinge bolts… read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade Scho
18,277 satisfied customers
1987 Mastercraft 351 inmar engine, velvet drive trans, make
1987 Mastercraft 351 inmar engine, velvet drive trans, make slapping noise around bell housing or trans at idle, not in gear. Noise ceases when idled up or in gear at running speed. Engine in tune run… read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade Scho
18,277 satisfied customers
I have a 2005 merc 496 mag with an overheat issue. Overheat
I have a 2005 merc 496 mag with an overheat issue. Overheat would occur when boat was on plane and engine was above 3500rpms. Found the water supply through the transom plate to be the issue. Had it r… read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade Scho
18,277 satisfied customers
I HAVE A MODEL TE115TLEND EVINRUDE 115 HP 1992 OUTBOARD. I
I HAVE A MODEL TE115TLEND EVINRUDE 115 HP 1992 OUTBOARD. I NEED TO CHANGE THERMOSTATS. I NEED TO KNOW HOW TO DROP THE BOTTOM MOTOR COVER TO GAIN ACCESS TO THERMOSTAT COVER. HOW DO I GO ABOUT THIS?… read more
Jeff G.
Jeff G.
Marine Mechanic
Vocational, Technical or Trade Scho
4,730 satisfied customers
Is the transom on a 2012 Mercury Ocean runner inflatable boat
Is the transom on a 2012 Mercury Ocean runner inflatable boat made of fiberglass and, if so, can I drill through it to make holes to install a 177 pound outboard?… read more
Malta Tech
Malta Tech
Marine Tech
High School or GED
287 satisfied customers
I RECENTLY CHANGED MY 5.0L MERCRUISER FOR A 5.7L. INSTALLATION
I RECENTLY CHANGED MY 5.0L MERCRUISER FOR A 5.7L. INSTALLATION WENT WELL EXCEPT THAT I CAN'T REALIGN THE OUTPUT SHAFT. I TORQUED THE REAR ENGINE MOUNT BOLTS TO 40 FTLBS. I CAN STILL ROTATE THE FIBRE W… read more
K. Kergan
K. Kergan
Inboard/Outboard Mechanic
Vocational, Technical or Trade Scho
1,031 satisfied customers
I have a 16 bayliner yr 86 and want to install a downrigger.
I have a 16' bayliner yr 86 and want to install a downrigger. How do i do that? thanks, Billy… read more
Jeff G.
Jeff G.
Marine Mechanic
Vocational, Technical or Trade Scho
4,730 satisfied customers
I have a 1989 268 sundancer with the 7.4 and bravo I outdrive.
I have a 1989 268 sundancer with the 7.4 and bravo I outdrive. The rubber housing that connects the outdrive to I think the flywheel keeps ripping out. The marina has replaced it twice now and it let … read more
James
James
Certified Marine Mechanic
Vocational, Technical or Trade Scho
4,094 satisfied customers
Mercury Optimax 135, 2001 model year. The top and bottom bolts
Mercury Optimax 135, 2001 model year. The top and bottom bolts that mount the motor to the stern attachment are corroded and need replaced. The bottom attachment looks fairly straightforward. What is … read more
Jeff G.
Jeff G.
Marine Mechanic
Vocational, Technical or Trade Scho
4,730 satisfied customers
hi john here, i have a 1986 170 224 alpha stern drive i need
hi john here, i have a 1986 170 224 alpha stern drive i need to replace the engine coupler what is the easyest way to do this.… read more
Master Tech
Master Tech
Service Manager/Technician
Vocational, Technical or Trade Scho
1,167 satisfied customers
When I try to align the engine to the Gimbal bearing the engine
When I try to align the engine to the Gimbal bearing the engine is .100" too the port side of the center of the bearing. How do I address this?… read more
Whitecap36
Whitecap36
Service Manager/Technician
Vocational, Technical or Trade Scho
1,556 satisfied customers
Is it neccissary to remove the sterndrive to remove a mercruiser454chev(
Is it neccissary to remove the sterndrive to remove a mercruiser454chev( mid 90's vintage) from a daycruiser?… read more
Kenny
Kenny
Mercury & Mercruiser Diagnostics
Master's Degree
99 satisfied customers
Hello I have a mercruiser 165 and I am replacing the rear engine
Hello I have a mercruiser 165 and I am replacing the rear engine mounts and bolts can you tell me the order in which the spring washer spacer and fiber are installed on the mount… read more
John White
John White
Marine Mechanic
Vocational, Technical or Trade Scho
306 satisfied customers
i have 1996 larsonCustomerwith a 350 chevy 5.7l. i had to change
i have 1996 larsonCustomerwith a 350 chevy 5.7l. i had to change motor due to valve seat breaking and was sucked through manafold and damaged every piston.bought a new motor and put in. runs great,but… read more
Mike of Pompano Beach
Mike of Pompano Beach
Charter Fleet Maintenance
18 satisfied customers
You recently helped me out with good sucess on replacing exhaust
You recently helped me out with good sucess on replacing exhaust gaskets with a 5.7L Bravo 3. I guess I should tell you that I had the engine out to replace a rusting oil pan among other items. Here i… read more
mercmastertech
mercmastertech
Service Manager, Master technician
Technical School
249 satisfied customers
what would be involved in changing the v6 engine in my boat
I have an 87 sunray with a 4.3 v6 and I was wanting to change it over to a v8 . I beleive that chevy engines have the same mountings for the flywheel and rear mounting of the engine but I don''t think… read more
Pappy's Sales and Service
Pappy's Sales and Service
Vocational, Technical or Trade Scho
586 satisfied customers
Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

JustAnswer in the News:

Ask-a-doc Web sites: If you've got a quick question, you can try to get an answer from sites that say they have various specialists on hand to give quick answers... Justanswer.com.
JustAnswer.com...has seen a spike since October in legal questions from readers about layoffs, unemployment and severance.
Web sites like justanswer.com/legal
...leave nothing to chance.
Traffic on JustAnswer rose 14 percent...and had nearly 400,000 page views in 30 days...inquiries related to stress, high blood pressure, drinking and heart pain jumped 33 percent.
Tory Johnson, GMA Workplace Contributor, discusses work-from-home jobs, such as JustAnswer in which verified Experts answer people’s questions.
I will tell you that...the things you have to go through to be an Expert are quite rigorous.

What Customers are Saying:

Wonderful service, prompt, efficient, and accurate. Couldn't have asked for more. I cannot thank you enough for your help.

Mary C.Freshfield, Liverpool, UK

This expert is wonderful. They truly know what they are talking about, and they actually care about you. They really helped put my nerves at ease. Thank you so much!!!!

AlexLos Angeles, CA

Thank you for all your help. It is nice to know that this service is here for people like myself, who need answers fast and are not sure who to consult.

GPHesperia, CA

I couldn't be more satisfied! This is the site I will always come to when I need a second opinion.

JustinKernersville, NC

Just let me say that this encounter has been entirely professional and most helpful. I liked that I could ask additional questions and get answered in a very short turn around.

EstherWoodstock, NY

Thank you so much for taking your time and knowledge to support my concerns. Not only did you answer my questions, you even took it a step further with replying with more pertinent information I needed to know.

RobinElkton, Maryland

He answered my question promptly and gave me accurate, detailed information. If all of your experts are half as good, you have a great thing going here.

DianeDallas, TX

< Previous | Next >

Meet the Experts:

Dominick

Dominick

Marine Mechanic

1,009 satisfied customers

25 Years Experience as Mechanic, 20 Yrs Boat Yard Owner/Mechanic, Factory Certified

Ted G.

Ted G.

Rigger, Diagnostician

747 satisfied customers

40 years boating, Safe boating instruct., Offshore Race promoter, Failure Analysis, Expert Witness

John White

John White

Marine Mechanic

306 satisfied customers

11 years experience working on outboards, inboards, sterndrives & pwcs

Jason

Jason

Marine Mechanic

18,277 satisfied customers

Degree in Marine Technology. Gas and diesel marine mechanic.

Tan

Tan

MerCruiser Certified Technician

11,504 satisfied customers

40 yrs. experience with complete engine repairs both inboard/outboard and MerCruiser Certified Technician.

Jeff G.

Jeff G.

Marine Mechanic

4,730 satisfied customers

42 years experience, Certified Master Technician, All Major Outboards, Sterndrives, Hi-Performance

Captain Dave

Captain Dave

Marine Mechanic

2,672 satisfied customers

USCG Licensed Captain, 20+ Years Boating, Fishing, Maintenance and Repair Experience

< Previous | Next >

Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

Show MoreShow Less

Ask Your Question

x