Boat

Have Boat Questions? Ask a Boat Repair Expert.

Connect one-on-one with {0} who will answer your question

Related Boat Questions
Just finished a carb rebuild on a mercruiser 3.0 liter, alpha
just finished a carb rebuild on a mercruiser 3.0 liter, alpha 1, mercarb. It will not idle. I noticed fuel dripping from the venturi. I'm guessing this is causing the engine to stall at low rpm. Is th… read more
Jeremy R.
Jeremy R.
5,362 satisfied customers
cleaned and rebuit the carburaters on a 50 hp yamaha engine
cleaned and rebuit the carburaters on a 50 hp yamaha engine and now i have gas pouring out of the bottom carbwith the engin not running or running when i prime the bulb gas flows out… read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,409 satisfied customers
My Mercury 2006 15 hp 4-stroke 2-cylinder outboard will start,
My Mercury 2006 15 hp 4-stroke 2-cylinder outboard will start, but not idle well. It runs at high RPM all the time unless I choke it. If I try to throttle down, it slows and stops, unless I use choke … read more
Jeff G.
Jeff G.
Marine Mechanic
Vocational, Technical or Trade Scho
4,730 satisfied customers
What is the float setting on a Mercury 90 four stroke 2001
What is the float setting on a Mercury 90 four stroke 2001 90 ELPT, Model 1F90412YD? I rebuilt the carbs and set them at 13 to 15 mm as the picture you sent me showed. The carbs all leaked gas and flo… read more
Noel Schembri
Noel Schembri
Marine mechanic
Diploma
2,681 satisfied customers
I have a Sea Ray 1995 with Mercruiser 3.oLX engine with 2
I have a Sea Ray 1995 with Mercruiser 3.oLX engine with 2 barrel mercarb(1995) #3310-805924A-1. Engine starts right up when cold but after warmed , I need to open the throttle about 1/3 otherwise it w… read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,409 satisfied customers
My mercruiser alpha one 3.0 TKS cranks but will not start.
My mercruiser alpha one 3.0 TKS cranks but will not start. It all began when I hit a wake hard and the engine goes "bang!" and died. I was anble to start it up and go but died again a little later. It… read more
K. Kergan
K. Kergan
Inboard/Outboard Mechanic
Vocational, Technical or Trade Scho
1,031 satisfied customers
1996 evinrude 150 ocean pro carb rebuild. I noticed the inlet
1996 evinrude 150 ocean pro carb rebuild. I noticed the inlet valve washer was not used at the last rebuild 3 years ago. I have read online not to use this washer. My thoughts are the washer is in the… read more
Jeff G.
Jeff G.
Marine Mechanic
Vocational, Technical or Trade Scho
4,730 satisfied customers
I have a 1990 Johnson225hp j225txess.When I trim up the motor
I have a 1990 Johnson225hp j225txess.When I trim up the motor gas spills from the small hole in the middle of the carb body next to the float bowl.What would cause this.Motor runs fine. Thanks John… read more
Evinrude/Johnson
Evinrude/Johnson
Evinrude/Johnson marine technician
Vocational, Technical or Trade Scho
41 satisfied customers
Have Twin Yamaha ETXD 200 (1990) outboards. The port engine
Have Twin Yamaha ETXD 200 (1990) outboards. The port engine runs fine. The stbd engine will start and idle around 600. Start out and accelerate, both engines will run up to 4000-4200 and run fine.Then… read more
Jeff G.
Jeff G.
Marine Mechanic
Vocational, Technical or Trade Scho
4,730 satisfied customers
HI TAN THIS IS MIKE ,THANKS FOR HELP, I THINK IT FIXED THE
HI TAN THIS IS MIKE ,THANKS FOR HELP, I THINK IT FIXED THE PROBLEM, DO HAVE A LITTLE GAS FLOODING IN BOTTOM CARB, I DID LET ENGINE IDLE A LITTLE WHILE, MY BOOK SAID IT COULD ALSO BE TO MUCH FUEL PUMP … read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,409 satisfied customers
i have a 1992 5 horse power force motor i have replace the
i have a 1992 5 horse power force motor i have replace the float needle and seat carb gaskets, and diaphram fual pump and when i try to start it without the gas line hooked up it runs fine for about 2… read more
Whitecap36
Whitecap36
Service Manager/Technician
Vocational, Technical or Trade Scho
1,557 satisfied customers
have a old 40 horse evinrude outboard that will start up and
have a old 40 horse evinrude outboard that will start up and run fine for 4-5 minutes then fuel starts coming out the front of the carburator and floods out the engine. You retry it and it does it aga… read more
Jeff G.
Jeff G.
Marine Mechanic
Vocational, Technical or Trade Scho
4,730 satisfied customers
I have a 1985 Four Winns 19 foot open bow with a 140 horse
I have a 1985 Four Winns 19 foot open bow with a 140 horse Mercrusier I/O 4 cylinder small block. It starts and runs well when cold, but after it's run 1/2 to 1 hour and is warm, it doesn't want to st… read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,409 satisfied customers
Hi, I have a 1988 Mariner 8 boat motor with a WMC18B CARB.
Hi, I have a 1988 Mariner 8 boat motor with a WMC18B CARB. on it, Can you please tell me what the Float adjustment is and where you measure from ? also would you know the standard turns out for the ai… read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,409 satisfied customers
i have gas coming out of the port just to the top right of
i have gas coming out of the port just to the top right of butterfly just below the adjustment screw for idle on my 89 classic 50 2 cy--four cyl… read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,409 satisfied customers
I have a 9.9 Johnson and the motor will run for aboy 10 seconds
I have a 9.9 Johnson and the motor will run for aboy 10 seconds and the gets flooded. I can actually un hook the gas line from the tank and the motor starts and runs fro about 5 minutes just fine. Wha… read more
tom
tom
outboard mechanic
High School or GED
117 satisfied customers
Ill try to explain as best as I can. The first year I bought
Ill try to explain as best as I can. The first year I bought my boat if i left the motor down on the water not running it would have a hard time starting and once it started it smoked hevaly then it w… read more
Whitecap36
Whitecap36
Service Manager/Technician
Vocational, Technical or Trade Scho
1,557 satisfied customers
I own a 1941 Chris Craft with a model B 60 HP engine. I cleaned
I own a 1941 Chris Craft with a model B 60 HP engine. I cleaned the Zenith carb and reassembled it several times in the past. This year i took the carb apart, cleaned it and ressembled. The motor woul… read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,409 satisfied customers
Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

JustAnswer in the News:

Ask-a-doc Web sites: If you've got a quick question, you can try to get an answer from sites that say they have various specialists on hand to give quick answers... Justanswer.com.
JustAnswer.com...has seen a spike since October in legal questions from readers about layoffs, unemployment and severance.
Web sites like justanswer.com/legal
...leave nothing to chance.
Traffic on JustAnswer rose 14 percent...and had nearly 400,000 page views in 30 days...inquiries related to stress, high blood pressure, drinking and heart pain jumped 33 percent.
Tory Johnson, GMA Workplace Contributor, discusses work-from-home jobs, such as JustAnswer in which verified Experts answer people’s questions.
I will tell you that...the things you have to go through to be an Expert are quite rigorous.

What Customers are Saying:

Wonderful service, prompt, efficient, and accurate. Couldn't have asked for more. I cannot thank you enough for your help.

Mary C.Freshfield, Liverpool, UK

This expert is wonderful. They truly know what they are talking about, and they actually care about you. They really helped put my nerves at ease. Thank you so much!!!!

AlexLos Angeles, CA

Thank you for all your help. It is nice to know that this service is here for people like myself, who need answers fast and are not sure who to consult.

GPHesperia, CA

I couldn't be more satisfied! This is the site I will always come to when I need a second opinion.

JustinKernersville, NC

Just let me say that this encounter has been entirely professional and most helpful. I liked that I could ask additional questions and get answered in a very short turn around.

EstherWoodstock, NY

Thank you so much for taking your time and knowledge to support my concerns. Not only did you answer my questions, you even took it a step further with replying with more pertinent information I needed to know.

RobinElkton, Maryland

He answered my question promptly and gave me accurate, detailed information. If all of your experts are half as good, you have a great thing going here.

DianeDallas, TX

< Previous | Next >

Meet the Experts:

Ted G.

Ted G.

Rigger, Diagnostician

2,678 satisfied customers

40 years boating, Safe boating instruct., Offshore Race promoter, Failure Analysis, Expert Witness

Dominick

Dominick

Marine Mechanic

1,009 satisfied customers

25 Years Experience as Mechanic, 20 Yrs Boat Yard Owner/Mechanic, Factory Certified

John White

John White

Marine Mechanic

306 satisfied customers

11 years experience working on outboards, inboards, sterndrives & pwcs

Jason

Jason

Marine Mechanic

22,043 satisfied customers

Degree in Marine Technology. Gas and diesel marine mechanic.

Tan

Tan

MerCruiser Certified Technician

11,409 satisfied customers

40 yrs. experience with complete engine repairs both inboard/outboard and MerCruiser Certified Technician.

Jeff G.

Jeff G.

Marine Mechanic

4,730 satisfied customers

42 years experience, Certified Master Technician, All Major Outboards, Sterndrives, Hi-Performance

Captain Dave

Captain Dave

Marine Mechanic

2,672 satisfied customers

USCG Licensed Captain, 20+ Years Boating, Fishing, Maintenance and Repair Experience

< Previous | Next >

Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

Show MoreShow Less

Ask Your Question

x