Boat

Have Boat Questions? Ask a Boat Repair Expert.

Connect one-on-one with {0} who will answer your question

Related Boat Questions
Have. Have a Yamaha 115tlrz, no spark port bank. tested both
have a Yamaha 115tlrz, no spark port bank. tested both pulsers ( dva 7 volts, ohms 330 ) High and low charge coils 90volts and 160 volts, no shorts to ground/ ohms to spec. using my key switch at engine side harness ( used boat switch also for all tests ) disconnected all of PBS oil system harnesses and both temp switches. 12 volts battery present on yellow wire to CDI box even while cranking. THIRD new CDI box installed- still no primary voltage to port coils ? … read more
DAVID BALLARD
DAVID BALLARD
OWNER
Vocational, Technical or Trade School
8 satisfied customers
1997 Polaris sl 1050 after acceleratinf on plane total
1997 Polaris sl 1050 after acceleratinf on plane total ignition shutdown, after a couple of minutes it will restart and do the same thing. Carburators rebuilt, coils reading .5 ohms, cdi brown wire ou… read more
Boat Doc
Boat Doc
252 satisfied customers
Jazz 120 hp. see common problem. no plain. I put elec. trim
jazz 120 hp. see common problem. no plain. I put elec. trim tabs, helped a little, still a dog. wont pull a tube, or even more than one person in boat its a struggle to get it to level out and get any… read more
Charles
Charles
Certified Mercury Tech
5,519 satisfied customers
How to I test the pulser coils on Yamaha 2 stroke 1997
how to I test the pulser coils on Yamaha 2 stroke 1997 c40tlrv with meter? … read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,406 satisfied customers
I have a 1996 Kawasaki SS 750 jet ski. At the moment it gets
Hello, I have a 1996 Kawasaki SS 750 jet ski. At the moment it gets no spark to either cylinder. We pulled the stater and tested it, both measurements were within the correct range. 1.1 ohms between t… read more
Kenny O.
Kenny O.
Personal Watercraft Specialist, Kawasaki Jet Ski, Yamaha Wave Runners, Sea Doo Watercraft
1,022 satisfied customers
2001tracker by mercury 75 4cycle spark on both wires out of
2001tracker by mercury 75 4cycle spark on both wires out of one coil none out of coil 2 switch the primary power now coil 2 sp arks but coil 1 does not … read more
Charles
Charles
Certified Mercury Tech
5,519 satisfied customers
My 1990 Yamaha ProV 150 sat idle few years. Putting it back
My 1990 Yamaha ProV 150 sat idle for a few years. Putting it back on the water it ran great on 1st run, but after coming off plane could hardly get back on plane. Local shop replaced stator (said high… read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade School
18,955 satisfied customers
I am having a starting issue with my 1998 xl1200 Yamaha
I am having a starting issue with my 1998 xl1200 Yamaha waverunner. After an engine rebuild it would not start. 5 years later I have rebuilt the carbs due to no fuel and am back with the original star… read more
Kenny O.
Kenny O.
Personal Watercraft Specialist, Kawasaki Jet Ski, Yamaha Wave Runners, Sea Doo Watercraft
1,022 satisfied customers
I have a 1998 Yamaha exciter 220, my passinger engine will
I have a 1998 Yamaha exciter 220, my passinger engine will not start, everyone says stater base ass. Or pulser coil ass.I've checked both with a multi meter and there in the ranges. I've tryed to swit… read more
Kenny O.
Kenny O.
Personal Watercraft Specialist, Kawasaki Jet Ski, Yamaha Wave Runners, Sea Doo Watercraft
1,022 satisfied customers
I have a 25 hp 2 stroke 1994 yamaha. It is on a 13 ft skiff. used to plane out easily and
i have a 25 hp 2 stroke 1994 yamaha. It is on a 13 ft skiff. used to plane out easily and haul butt, it will not plane out now. it idles smooth, i have new gas, has 120 psi both cyliders… read more
Charles
Charles
Certified Mercury Tech
5,519 satisfied customers
I have an M40D tohatsu (1997). Never had a problem with it till recently. Might be electro
I have an M40D tohatsu (1997). Never had a problem with it till recently. Might be electronic. Get an occasional clacking sound around the flywheel. Do For a while it didn't have any effect on the run… read more
Jeff G.
Jeff G.
Marine Mechanic
Vocational, Technical or Trade Scho
4,730 satisfied customers
ok have 1988 dt 115 for 12 years, never fouled out the plugs
ok have 1988 dt 115 for 12 years, never fouled out the plugs until now, foule out every time since, checked voltage output of cdi ( 50 volts , manual says should be 150 ) then checked the pulser coil … read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade School
18,955 satisfied customers
I have a 96-70hp johnson ob. motor completely rebuilt. from
I have a 96-70hp johnson ob. motor completely rebuilt. from fuel tanks, key switch to pistons. the only thing not rebuilt or replaced charging coils, timing coils, temp sender(temp sender unhooked). S… read more
orcamarine
orcamarine
Proprietor
Vocational, Technical or Trade Scho
7 satisfied customers
2005 50hp mercury outboard. run beautiful for a few minutes
2005 50hp mercury outboard. run beautiful for a few minutes then shuts down to idle by itself. but if you keep pushing choke button, it finally takes off. now during this whole episode, the motor neve… read more
Jeff G.
Jeff G.
Marine Mechanic
Vocational, Technical or Trade Scho
4,730 satisfied customers
I have a 1999 johnson 225 ho and i have been having trouble
I have a 1999 johnson 225 ho and i have been having trouble with starting at times and with stalling out. It will run great but if you stop and fish a spot for 20mins or longer it will start but you w… read more
Jeff G.
Jeff G.
Marine Mechanic
Vocational, Technical or Trade Scho
4,730 satisfied customers
Still having a no start problem with one of my waverunners.....
Still having a no start problem with one of my waverunners..... I have (2) 2002 Yamaha xl700a's... one run great the other is a little bit of a problem... it starts cold and runs great but after it's … read more
Jeremy R.
Jeremy R.
5,362 satisfied customers
I have a 98 C60 Yamaha that runs rough and fouls the plugs.
I have a 98 C60 Yamaha that runs rough and fouls the plugs. It seems to be loading up when it idles. Compression 115 on all three. Cleaned/rebuilt carbs, float height set @ .51 inches. Diaphragm check… read more
Larry B.
Larry B.
Marine Service Tech
High School or GED
574 satisfied customers
1986 Yamaha ProV 150, starts and runs good but has no top ...
1986 Yamaha ProV 150, starts and runs good but has no top end rpm, rpms top at 4600 then surges towards wot. What are some things to try to recover full performance? Motor also idles fine.… read more
Pappy's Sales and Service
Pappy's Sales and Service
Vocational, Technical or Trade Scho
586 satisfied customers
Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

JustAnswer in the News:

Ask-a-doc Web sites: If you've got a quick question, you can try to get an answer from sites that say they have various specialists on hand to give quick answers... Justanswer.com.
JustAnswer.com...has seen a spike since October in legal questions from readers about layoffs, unemployment and severance.
Web sites like justanswer.com/legal
...leave nothing to chance.
Traffic on JustAnswer rose 14 percent...and had nearly 400,000 page views in 30 days...inquiries related to stress, high blood pressure, drinking and heart pain jumped 33 percent.
Tory Johnson, GMA Workplace Contributor, discusses work-from-home jobs, such as JustAnswer in which verified Experts answer people’s questions.
I will tell you that...the things you have to go through to be an Expert are quite rigorous.

What Customers are Saying:

Wonderful service, prompt, efficient, and accurate. Couldn't have asked for more. I cannot thank you enough for your help.

Mary C.Freshfield, Liverpool, UK

This expert is wonderful. They truly know what they are talking about, and they actually care about you. They really helped put my nerves at ease. Thank you so much!!!!

AlexLos Angeles, CA

Thank you for all your help. It is nice to know that this service is here for people like myself, who need answers fast and are not sure who to consult.

GPHesperia, CA

I couldn't be more satisfied! This is the site I will always come to when I need a second opinion.

JustinKernersville, NC

Just let me say that this encounter has been entirely professional and most helpful. I liked that I could ask additional questions and get answered in a very short turn around.

EstherWoodstock, NY

Thank you so much for taking your time and knowledge to support my concerns. Not only did you answer my questions, you even took it a step further with replying with more pertinent information I needed to know.

RobinElkton, Maryland

He answered my question promptly and gave me accurate, detailed information. If all of your experts are half as good, you have a great thing going here.

DianeDallas, TX

< Previous | Next >

Meet the Experts:

Ted G.

Ted G.

Rigger, Diagnostician

1,074 satisfied customers

40 years boating, Safe boating instruct., Offshore Race promoter, Failure Analysis, Expert Witness

Dominick

Dominick

Marine Mechanic

1,009 satisfied customers

25 Years Experience as Mechanic, 20 Yrs Boat Yard Owner/Mechanic, Factory Certified

John White

John White

Marine Mechanic

306 satisfied customers

11 years experience working on outboards, inboards, sterndrives & pwcs

Jason

Jason

Marine Mechanic

18,955 satisfied customers

Degree in Marine Technology. Gas and diesel marine mechanic.

Tan

Tan

MerCruiser Certified Technician

11,406 satisfied customers

40 yrs. experience with complete engine repairs both inboard/outboard and MerCruiser Certified Technician.

Jeff G.

Jeff G.

Marine Mechanic

4,730 satisfied customers

42 years experience, Certified Master Technician, All Major Outboards, Sterndrives, Hi-Performance

Captain Dave

Captain Dave

Marine Mechanic

2,672 satisfied customers

USCG Licensed Captain, 20+ Years Boating, Fishing, Maintenance and Repair Experience

< Previous | Next >

Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

Show MoreShow Less

Ask Your Question

x