Boat

Have Boat Questions? Ask a Boat Repair Expert.

Ask an Expert,
Get an Answer ASAP!

I HAVE a150 omc with water pump failure how do I remove lower…

Customer Question
I HAVE a150 omc with...
I HAVE a150 omc with water pump failure how do I remove lower unit ? 2000 year E150 FPL SSM
Submitted: 3 years ago.Category: Boat
Show More
Show Less
Ask Your Own Boat Question
Answered in 4 days by:
7/17/2015
Marine Mechanic: Charles, Marine Mechanic replied 3 years ago
Charles
Charles, Marine Mechanic
Category: Boat
Satisfied Customers: 4,914
Experience: US Navy (Ret) Certified Mercury Marine Tech with over a decade of repair experience.
Verified
Hello, my name is***** you for allowing me to assist you today.
Remove bolt 29 from under the carbs, this will release the shit shaft and allow you to get the case off. Make sure that when yo go back together, you get the shift shaft into the grove of 31.
http://www.boats.net/parts/search/BRP/EVINRUDE/2000/E150FPLSSV/CYLINDER%20&%20CRANKCASE/parts.html
Ask Your Own Boat Question
Was this answer helpful?

How JustAnswer works

step-image
Describe your issueThe assistant will guide you
step-image
Chat 1:1 with a marine mechanicLicensed Experts are available 24/7
step-image
100% satisfaction guaranteeGet all the answers you need
Ask Charles Your Own Question
Charles
Charles
Charles, Marine Mechanic
Category: Boat
Satisfied Customers: 4,914
4,914 Satisfied Customers
Experience: US Navy (Ret) Certified Mercury Marine Tech with over a decade of repair experience.

Charles is online now

A new question is answered every 9 seconds

How JustAnswer works:

  • Ask an ExpertExperts are full of valuable knowledge and are ready to help with any question. Credentials confirmed by a Fortune 500 verification firm.
  • Get a Professional AnswerVia email, text message, or notification as you wait on our site. Ask follow up questions if you need to.
  • 100% Satisfaction GuaranteeRate the answer you receive.

JustAnswer in the News:

Ask-a-doc Web sites: If you've got a quick question, you can try to get an answer from sites that say they have various specialists on hand to give quick answers... Justanswer.com.
JustAnswer.com...has seen a spike since October in legal questions from readers about layoffs, unemployment and severance.
Web sites like justanswer.com/legal
...leave nothing to chance.
Traffic on JustAnswer rose 14 percent...and had nearly 400,000 page views in 30 days...inquiries related to stress, high blood pressure, drinking and heart pain jumped 33 percent.
Tory Johnson, GMA Workplace Contributor, discusses work-from-home jobs, such as JustAnswer in which verified Experts answer people’s questions.
I will tell you that...the things you have to go through to be an Expert are quite rigorous.

What Customers are Saying:

Wonderful service, prompt, efficient, and accurate. Couldn't have asked for more. I cannot thank you enough for your help.

Mary C.Freshfield, Liverpool, UK

This expert is wonderful. They truly know what they are talking about, and they actually care about you. They really helped put my nerves at ease. Thank you so much!!!!

AlexLos Angeles, CA

Thank you for all your help. It is nice to know that this service is here for people like myself, who need answers fast and are not sure who to consult.

GPHesperia, CA

I couldn't be more satisfied! This is the site I will always come to when I need a second opinion.

JustinKernersville, NC

Just let me say that this encounter has been entirely professional and most helpful. I liked that I could ask additional questions and get answered in a very short turn around.

EstherWoodstock, NY

Thank you so much for taking your time and knowledge to support my concerns. Not only did you answer my questions, you even took it a step further with replying with more pertinent information I needed to know.

RobinElkton, Maryland

He answered my question promptly and gave me accurate, detailed information. If all of your experts are half as good, you have a great thing going here.

DianeDallas, TX

< Previous | Next >

Meet the Experts:

Dominick

Dominick

Marine Mechanic

1,009 satisfied customers

25 Years Experience as Mechanic, 20 Yrs Boat Yard Owner/Mechanic, Factory Certified

Ted G.

Ted G.

Rigger, Diagnostician

704 satisfied customers

40 years boating, Safe boating instruct., Offshore Race promoter, Failure Analysis, Expert Witness

John White

John White

Marine Mechanic

306 satisfied customers

11 years experience working on outboards, inboards, sterndrives & pwcs

Jason

Jason

Marine Mechanic

17,310 satisfied customers

Degree in Marine Technology. Gas and diesel marine mechanic.

Tan

Tan

MerCruiser Certified Technician

11,264 satisfied customers

40 yrs. experience with complete engine repairs both inboard/outboard and MerCruiser Certified Technician.

Jeff G.

Jeff G.

Marine Mechanic

4,729 satisfied customers

42 years experience, Certified Master Technician, All Major Outboards, Sterndrives, Hi-Performance

Captain Dave

Captain Dave

Marine Mechanic

2,672 satisfied customers

USCG Licensed Captain, 20+ Years Boating, Fishing, Maintenance and Repair Experience

< Previous | Next >

Related Boat Questions
I have a 140HP 4cyl with an OMC outdrive...1979 Larsen Boat
I have a 140HP 4cyl with an OMC outdrive...1979 Larsen Boat 17'9". Replaced impeller because no water getting to motor for cooling. After reassembling we get no water up to the engine. Unhooked the ho… read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,264 satisfied customers
There is a screw on my lower unit left side about middle
There is a screw on my lower unit left side about middle ways up it spits water I unscrewed it like an idiot and the nut fell into the unit and I'm not sure how to get back what is it for and how do I… read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade Scho
17,310 satisfied customers
Have 88 5.7 OMC. Pulled from lake to clean after 4 years in
Have 88 5.7 OMC. Pulled from lake to clean after 4 years in fresh water. Impeller broke on rentry to lake after 2 weeks out. Pulled and replaced impeller and thermostat. Heated up again when put in la… read more
Jeremy R
Jeremy R
1,069 satisfied customers
omc 2.5 1987 Cobra outdrive, sterndrive water pump new, no
omc 2.5 1987 Cobra outdrive, sterndrive water pump new, no water blockage to pump, in the lake with total outdrive under water, stenndrive water pump pumps air, won't pump water.?????????????… read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade Scho
17,310 satisfied customers
I have a 2000 johnson 90 hp outboard, I need a new lower end
I have a 2000 johnson 90 hp outboard, I need a new lower end gear and purchased one from the 80's. I installed the unit and the gears don't seem to work right...I have forward end nuetral, the shiftin… read more
James
James
Certified Marine Mechanic
Vocational, Technical or Trade Scho
4,094 satisfied customers
I have a 1989 Donzi rigizza cuddy with a omc 5.7 not used much
I have a 1989 Donzi rigizza cuddy with a omc 5.7 not used much but always in fresh water did not use it untill Oct this year put in the water got about 1/4 miles and overheated no water in any of the … read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,264 satisfied customers
I have a 1993 OMC Cobra, 5.0L Ford that overheated last year.
I have a 1993 OMC Cobra, 5.0L Ford that overheated last year. Replaced the lower unit water pump, engine thermostat, riser gaskets, intake gaskets, etc. Ran it a couple of times this year with no prob… read more
Greg
Greg
Senior service manager
Vocational, Technical or Trade Scho
9 satisfied customers
Is there any pump in the out-drive on an OMC [1988] [v-6],
Is there any pump in the out-drive on an OMC [1988] [v-6], or is the watert pump on the inboard eng. the only pump? also how do I supply enough water to the eng. so that I can run it long enough to do… read more
Jeff G.
Jeff G.
Marine Mechanic
Vocational, Technical or Trade Scho
4,729 satisfied customers
I have a four winns boat with 7.4GL volvo penta I am trying
I have a four winns boat with 7.4GL volvo penta I am trying to find the "sea water pump" thisengine has acirculating pump on the front of the engine but nothing else for a sea water pump I have traced… read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade Scho
17,310 satisfied customers
I have a 1984 Baja 19.5 boat with a 3.8 chevy engine and a
I have a 1984 Baja 19.5 boat with a 3.8 chevy engine and a OMC lower unit. I had it out last week end and it just locked up tight the engine wouldn't even turn over i check it out but didn't apeare to… read more
Jeremy R
Jeremy R
1,069 satisfied customers
i have a 1981 omc stern drive w/ a 4.3 I can hear the trim
i have a 1981 omc stern drive w/ a 4.3 I can hear the trim motor go on but the engine does'nt move up or down the trim is in the down position the engine mounta look ok but I don't know if they are do… read more
Master Tech
Master Tech
Service Manager/Technician
Vocational, Technical or Trade Scho
1,167 satisfied customers
I have an old (1976 I think) 120 HP OMC I/O with electric shift.
I have an old (1976 I think) 120 HP OMC I/O with electric shift. It runs and works great but the engine overheats under load. I have changed the thermostat (twice) with no improvement. I have also rep… read more
Dan Oostdyk
Dan Oostdyk
Vocational, Technical or Trade Scho
89 satisfied customers
I trashed the lower unit on my 76 70hp johnson. I bought an
I trashed the lower unit on my 76 70hp johnson. I bought an OMC 70hp lower unit off of ebay. Guy said is was new. Had theXXXXXshaft and fitted perfect when I mounted it. Got on the lake pushed the con… read more
capt ron 1959
capt ron 1959
Owner/Marine Mechanic
Vocational, Technical or Trade Scho
348 satisfied customers
I have a 1989 Galaxie 18.05 ft. boat with a 175 horsepower
I have a 1989 Galaxie 18.05 ft. boat with a 175 horsepower in/out V6 motor. on the lower chamber, there are 3 plugs. Is the bottom plug where I put gear oil? What is the middle plug for?… read more
mercmastertech
mercmastertech
Service Manager, Master technician
Technical School
249 satisfied customers
Good morning! I have a 1991 OMC Cobra I/O with a 4.3 L V6
Good morning! I have a 1991 OMC Cobra I/O with a 4.3 L V6 Chevy. I am trying to drop the Foot of the drive to change the impeller for the cooling pick up. I have the 4 bolts out and the still cannot g… read more
FieldServiceTech
FieldServiceTech
Vocational, Technical or Trade Scho
146 satisfied customers
I have a water leak around the starter area and the intake
I have a water leak around the starter area and the intake manifold does not seem to be getting water.. Also this is my first inboard and do not know if the water pump is located on the lower unit or … read more
briggs archer
briggs archer
master marine mechanic
Associate Degree
374 satisfied customers
wuts up. i have a v4 omc sea drive. it was free so it needed
wuts up. i have a v4 omc sea drive. it was free so it needed alot of work. iam in the process of getting to run but i only have spark to 3 cylinders. they have no voltage going to the power packs from… read more
Captain Dave
Captain Dave
Marine Mechanic
Master's Degree
2,672 satisfied customers
I have a 225 Johnson outboard motor year 2000 and I have had
I have a 225 Johnson outboard motor year 2000 and I have had the transmission replaced 3 times in the last month. i am in mexico and the mechanic here simply keeps saying that I hit something and ther… read more
Michael
Michael
master marine technician/charter captain
Vocational, Technical or Trade Scho
256 satisfied customers
Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

Show MoreShow Less

Ask Your Question

x