Boat

Have Boat Questions? Ask a Boat Repair Expert.

Ask an Expert,
Get an Answer ASAP!

I have a 74 merc 500 50 hp tilt trim squirts fluid from a small…

Customer Question
i have a 74 merc...
i have a 74 merc 500 50 hp tilt trim squirts fluid from a small port on the bottom of pump when raised or lowered
Submitted: 3 years ago.Category: Boat
Show More
Show Less
Ask Your Own Boat Question
Answered in 11 minutes by:
6/30/2015
Marine Mechanic: Tan, MerCruiser Certified Technician replied 3 years ago
Tan
Tan, MerCruiser Certified Technician
Category: Boat
Satisfied Customers: 11,426
Experience: 40 yrs. experience with complete engine repairs both inboard/outboard and MerCruiser Certified Technician.
Verified
Hello. I really can't say what the issue is here unless I can see what is happening or where the leak is. But the problem is there are no parts available for repair on that unit. Can you post a pic of where the leak is?
Ask Your Own Boat Question
Customer reply replied 3 years ago
i will try to get a picture tomarrow with it squirting
Marine Mechanic: Tan, MerCruiser Certified Technician replied 3 years ago
Ok
Ask Your Own Boat Question
Was this answer helpful?

How JustAnswer works

step-image
Describe your issueThe assistant will guide you
step-image
Chat 1:1 with a marine mechanicLicensed Experts are available 24/7
step-image
100% satisfaction guaranteeGet all the answers you need
Ask Dominick Your Own Question
Dominick
Dominick
Dominick, Marine Mechanic
Category: Boat
Satisfied Customers: 1,009
1,009 Satisfied Customers
Experience: 25 Years Experience as Mechanic, 20 Yrs Boat Yard Owner/Mechanic, Factory Certified

Dominick is online now

A new question is answered every 9 seconds

How JustAnswer works:

  • Ask an ExpertExperts are full of valuable knowledge and are ready to help with any question. Credentials confirmed by a Fortune 500 verification firm.
  • Get a Professional AnswerVia email, text message, or notification as you wait on our site. Ask follow up questions if you need to.
  • 100% Satisfaction GuaranteeRate the answer you receive.

JustAnswer in the News:

Ask-a-doc Web sites: If you've got a quick question, you can try to get an answer from sites that say they have various specialists on hand to give quick answers... Justanswer.com.
JustAnswer.com...has seen a spike since October in legal questions from readers about layoffs, unemployment and severance.
Web sites like justanswer.com/legal
...leave nothing to chance.
Traffic on JustAnswer rose 14 percent...and had nearly 400,000 page views in 30 days...inquiries related to stress, high blood pressure, drinking and heart pain jumped 33 percent.
Tory Johnson, GMA Workplace Contributor, discusses work-from-home jobs, such as JustAnswer in which verified Experts answer people’s questions.
I will tell you that...the things you have to go through to be an Expert are quite rigorous.

What Customers are Saying:

Wonderful service, prompt, efficient, and accurate. Couldn't have asked for more. I cannot thank you enough for your help.

Mary C.Freshfield, Liverpool, UK

This expert is wonderful. They truly know what they are talking about, and they actually care about you. They really helped put my nerves at ease. Thank you so much!!!!

AlexLos Angeles, CA

Thank you for all your help. It is nice to know that this service is here for people like myself, who need answers fast and are not sure who to consult.

GPHesperia, CA

I couldn't be more satisfied! This is the site I will always come to when I need a second opinion.

JustinKernersville, NC

Just let me say that this encounter has been entirely professional and most helpful. I liked that I could ask additional questions and get answered in a very short turn around.

EstherWoodstock, NY

Thank you so much for taking your time and knowledge to support my concerns. Not only did you answer my questions, you even took it a step further with replying with more pertinent information I needed to know.

RobinElkton, Maryland

He answered my question promptly and gave me accurate, detailed information. If all of your experts are half as good, you have a great thing going here.

DianeDallas, TX

< Previous | Next >

Meet the Experts:

Dominick

Dominick

Marine Mechanic

1,009 satisfied customers

25 Years Experience as Mechanic, 20 Yrs Boat Yard Owner/Mechanic, Factory Certified

Ted G.

Ted G.

Rigger, Diagnostician

704 satisfied customers

40 years boating, Safe boating instruct., Offshore Race promoter, Failure Analysis, Expert Witness

John White

John White

Marine Mechanic

306 satisfied customers

11 years experience working on outboards, inboards, sterndrives & pwcs

Jason

Jason

Marine Mechanic

17,310 satisfied customers

Degree in Marine Technology. Gas and diesel marine mechanic.

Tan

Tan

MerCruiser Certified Technician

11,426 satisfied customers

40 yrs. experience with complete engine repairs both inboard/outboard and MerCruiser Certified Technician.

Jeff G.

Jeff G.

Marine Mechanic

4,729 satisfied customers

42 years experience, Certified Master Technician, All Major Outboards, Sterndrives, Hi-Performance

Captain Dave

Captain Dave

Marine Mechanic

2,672 satisfied customers

USCG Licensed Captain, 20+ Years Boating, Fishing, Maintenance and Repair Experience

< Previous | Next >

Related Boat Questions
UNIT WILL NOT TRIM-UP HIGH ENOUGH TO CLEAR BOTTOM OF BOAT.
UNIT WILL NOT TRIM-UP HIGH ENOUGH TO CLEAR BOTTOM OF BOAT . … read more
Tan
Tan
MerCruiser Certified Technician
11,426 satisfied customers
Help I am having difficulty getting my power tilt trim to
Help I am having difficulty getting my power tilt trim to take a fill of new fluid I have opened the bottom screw to let air out but the pump dose not pull in the new fluid when I push up button and f… read more
Tan
Tan
MerCruiser Certified Technician
11,426 satisfied customers
My 1998 Wellcraft 180 V6 4.3L leaks when I raise the lower
My 1998 Wellcraft 180 V6 4.3L leaks when I raise the lower unit Stops mostly when it is put down to run… read more
Tan
Tan
MerCruiser Certified Technician
11,426 satisfied customers
I have a two johnson 150 outboards on my boat. one motor will
I have a two johnson 150 outboards on my boat. one motor will not lower when the trim/tilt switch is activated at the throttle or by the switch on the motor. You can hear the pump but nothing happens.… read more
Tan
Tan
MerCruiser Certified Technician
11,426 satisfied customers
my 60 hp merc outboard power trim/tilt got water inside system
my 60 hp merc outboard power trim/tilt got water inside system so without getting instruction i took trim moter off pump and manually raised and lowered moter to get the bad atf out i also took the bo… read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade Scho
17,310 satisfied customers
how do i release the tilt/trim motor/ boat motor so i can replace
how do i release the tilt/trim motor/ boat motor so i can replace the decayed wires to the tilt motor. they were grounding out and the motor would raise so i replaced the wire i could access. problem … read more
Jeff G.
Jeff G.
Marine Mechanic
Vocational, Technical or Trade Scho
4,729 satisfied customers
after installing a new hydraulic pump for the tilt & trim on
after installing a new hydraulic pump for the tilt & trim on a 93 75 hp merc i still cant get the motor to go up or down , the motor lifted up, will not move now ! dont know if the motor should be rai… read more
Tan
Tan
MerCruiser Certified Technician
11,426 satisfied customers
How do I check and add power trim fluid in a 1996 Yamaha 40
How do I check and add power trim fluid in a 1996 Yamaha 40 hp, 2-stroke Hi, I just changed my power trim motor and there was some fluid leaking out. Now the motor works but the engine isn't tilted. H… read more
Tan
Tan
MerCruiser Certified Technician
11,426 satisfied customers
I have a model 2009 40-hp Evinrude E-tec. The power tilt and
I have a model 2009 40-hp Evinrude E-tec. The power tilt and trim will no longer tilt the engine, but I can hear the tilt motor running. I suspect the mechanism is low on fluid. How do I check the flu… read more
Tan
Tan
MerCruiser Certified Technician
11,426 satisfied customers
ok i have a 90 hp force outboard with tilt trim. tilt trim
ok i have a 90 hp force outboard with tilt trim. tilt trim not working after i tried to change fluid. I took a cap off the bottom and raised and lowered the motor by hand a few time to get the fluid o… read more
Noel
Noel
Marine mechanic
Diploma
44 satisfied customers
I have a Yamaha 225 hp, 4 stroke, Salt water series outboard
I have a Yamaha 225 hp, 4 stroke, Salt water series outboard motor. The outboard is in the up postion. (Tilted up). Won't drop back down. I push the up botton on the throtle. I can hear noise. The two… read more
Tan
Tan
MerCruiser Certified Technician
11,426 satisfied customers
I have a 2001 135 merc aptimax and the tilt cylinder is dumping
I have a 2001 135 merc aptimax and the tilt cylinder is dumping fluid from the tube running down the back of the ram have resealed and same problem… read more
James
James
Certified Marine Mechanic
Vocational, Technical or Trade Scho
4,094 satisfied customers
I have a 1993 Evinrude 120 hp with T/T tilt will not operate
I have a 1993 Evinrude 120 hp with T/T tilt will not operate relays click but no motor noise.I checked the connection on port side the blue and green wire and there is no voltage at the plug. I can;t … read more
Jeff G.
Jeff G.
Marine Mechanic
Vocational, Technical or Trade Scho
4,729 satisfied customers
I have a 2003 yamaha 115 hp 4 stroke that gives me troubles
I have a 2003 yamaha 115 hp 4 stroke that gives me troubles tilting it up off of the tilt locks. At the upper end of the travel it seems to skip out more than low or mid range. I think it needs fluid … read more
Jeremy R
Jeremy R
1,069 satisfied customers
I either cant find the release for the motor tilt or need
I either can't find the release for the motor tilt or need to know how to tilt the motor it is locked in the down position… read more
Master Tech
Master Tech
Service Manager/Technician
Vocational, Technical or Trade Scho
1,167 satisfied customers
Hi Can you tell me if the power trim/tilt unit from a 1976
Hi Can you tell me if the power trim/tilt unit from a 1976 50 hp merc will fit a 1974 65 hp merc Thanks Rick… read more
Jason Forsberg
Jason Forsberg
Outboard Marine Mechanic
Vocational, Technical or Trade Scho
531 satisfied customers
My cousin has a johnson OB, older model 88 HP with tilt and
My cousin has a johnson OB, older model "88 HP" with tilt and trim problems. the motor will lower but will not raise back up. There is what looks like a center piston to raise the motor up and down or… read more
davesoutboard
davesoutboard
owner
Associate Degree
1,570 satisfied customers
I have just purchased a bass boat with a 1989 Evinrude model
I have just purchased a bass boat with a 1989 Evinrude model E50TLCEC 50 HP outboard. The problem is that the tilt/trim does not work properly. The t/t motor makes noise up and down from either pair o… read more
The Man on the Dock
The Man on the Dock
Marina Owner, Operator
Vocational, Technical or Trade Scho
74 satisfied customers
Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

Show MoreShow Less

Ask Your Question

x