Boat

Have Boat Questions? Ask a Boat Repair Expert.

Connect one-on-one with {0} who will answer your question

Related Boat Questions
I have a 2002 Mercury 25 HP. Serial # OT531201. It starts
I have a 2002 Mercury 25 HP. Serial # OT531201. It starts and idles perfectly. It idles up fine on the rap … read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade School
19,348 satisfied customers
I have a 1993 Evinrude 115 HP outboard (TE115TLETS) that
I have a 1993 Evinrude 115 HP outboard (TE115TLETS) that starts easy and seems to idle very smooth. The right bank was running 10 degrees hotter than the left (135 vs 125 degrees) after 10 minutes run… read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade School
19,348 satisfied customers
2001 Yamaha 60 tlrz outboard. Only running on one cylinder
2001 Yamaha 60 tlrz outboard. Only running on one cylinder of the 3. Top cylinder runs, center and bottom not running. Have spark, plugs new this spring, less than 20 hrs, plugs wet after running. … read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade School
19,348 satisfied customers
My 25 hp Yamaha 2 stoke will only idle when accelerating
My 25 hp Yamaha 2 stoke will only idle when accelerating starts cutting out and will die. Had water in the tank but carbs have been cleaned filter replaced pouring clean gas now. just will nor acceler… read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade School
19,348 satisfied customers
My new boat question. You helped me before. I have a 1983
For Jason. My new boat question. You helped me before. I have a 1983 Mercury 50 serial number(###) ###-#### I am rebuilding the two carbs for the first time myself. I believe they are Tillotson. I hav… read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade School
19,348 satisfied customers
I have a 2003 Honda BF40 that has poor acceleration, no hole
I have a 2003 Honda BF40 that has poor acceleration, no hole shot ? It will plane my boat but I can't get a skier up. Carbs were rebuild twice a year or two ago. Have fresh fuel.… read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade School
19,348 satisfied customers
I have a 1998 DT200 and I did a compression check and found
I have a 1998 DT200 and I did a compression check and found the following; #1 - 78# #2 - 92# #3 - 60# #4 - 90# #5 - 82# #6 - 84# The specs in the manual say 88# ***** compression. I know that #3 is re… read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade School
19,348 satisfied customers
1970 something Johnson 70hp die on full power and in gear
Hello, we just bought a 1973 hartly cabin cruiser with a 1970 somthing Johnson 70 hp outboard. Issue we are having is that it will die if we try to leave it in ideal and its hard to get it into gear f… read more
Jeff G.
Jeff G.
Marine Mechanic
Vocational, Technical or Trade Scho
4,730 satisfied customers
I recently made a $100 deposit on a Honda 15 HP 4-stroke electric
I recently made a $100 deposit on a Honda 15 HP 4-stroke electric start outboard (p/n BF15A BAAS1101729) which Honda Marine informs me is a 1990 Model. The owners, heirs of the original owner, told me… read more
James
James
Certified Marine Mechanic
Vocational, Technical or Trade Scho
4,094 satisfied customers
Hi I have a bf50a 50HP Honda outboard recently, replaced all
Hi I have a bf50a 50HP Honda outboard recently, replaced all intake gaskets etc while cleaning the carbs, I took the boat out for a water test and she seems to idle very well at 1100rpm or so, goes in… read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade School
19,348 satisfied customers
I have a 1983 25hp 2cylinder Mariner (SN 695L 555205) that
I have a 1983 25hp 2cylinder Mariner (SN 695L 555205) that stutters intermittantly evey few seconds. A short video clip is available at slow idle and at running speed, where it 'hiccups', sometimes to… read more
Jeremy R.
Jeremy R.
5,362 satisfied customers
1984 Evinrude 115hp. Loses power and misfires under heavy
1984 Evinrude 115hp. Loses power and misfires under heavy load. It runs fine until I ski behind it, then it loses power and misfires. It almost seems to be four cycling, as it is a very even misfire. … read more
Jeff G.
Jeff G.
Marine Mechanic
Vocational, Technical or Trade Scho
4,730 satisfied customers
1999 johnson 70hp outboard after trolling the plugs foul and
1999 johnson 70hp outboard after trolling the plugs foul and will not restart until the plugs are changed or cleaned. Any suggestions to resolve this problem.… read more
Jeff G.
Jeff G.
Marine Mechanic
Vocational, Technical or Trade Scho
4,730 satisfied customers
Looking at a used 2001 29 Pro sport cat has twin 2001 200 HP
Looking at a used 2001 29 Pro sport cat has twin 2001 200 HP Yamaha HPDI outboards on it. I know the newer 200 HP Yamaha HPDI outboards are pretty good reliable motors but I was wondering if the older… read more
Jason Forsberg
Jason Forsberg
Outboard Marine Mechanic
Vocational, Technical or Trade Scho
531 satisfied customers
I have a 2003 Mercury 50HP outboard on a 22 foot pontoon boat.
I have a 2003 Mercury 50HP outboard on a 22 foot pontoon boat. Up until this year it has ran great with plenty of power. This year when going forward it will only rev up to around 3500 RPM when in pre… read more
Jason Forsberg
Jason Forsberg
Outboard Marine Mechanic
Vocational, Technical or Trade Scho
531 satisfied customers
I have a 70 hp 1974 evinrude that has not been run much this
I have a 70 hp 1974 evinrude that has not been run much this past year - it starts fine, it revs to higher rpms, but under load - it will not get up to more than 3000 rpms?… read more
orcamarine
orcamarine
Proprietor
Vocational, Technical or Trade Scho
7 satisfied customers
Engine Mercury 2000 outboard 40hp 4 stroke. Boat has push
Engine: Mercury 2000 outboard 40hp 4 stroke. Boat has push to choke ignition switch. Manual shows electrothermal auto enrichener. Auto enrichener is wired in paralell with the ECM to the power bobbin … read more
orcamarine
orcamarine
Proprietor
Vocational, Technical or Trade Scho
7 satisfied customers
As part of routine servicing, do Evinrude specify that the
As part of routine servicing, do Evinrude specify that the reed valve block mounting bolts be checked?… read more
orcamarine
orcamarine
Proprietor
Vocational, Technical or Trade Scho
7 satisfied customers
Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

JustAnswer in the News:

Ask-a-doc Web sites: If you've got a quick question, you can try to get an answer from sites that say they have various specialists on hand to give quick answers... Justanswer.com.
JustAnswer.com...has seen a spike since October in legal questions from readers about layoffs, unemployment and severance.
Web sites like justanswer.com/legal
...leave nothing to chance.
Traffic on JustAnswer rose 14 percent...and had nearly 400,000 page views in 30 days...inquiries related to stress, high blood pressure, drinking and heart pain jumped 33 percent.
Tory Johnson, GMA Workplace Contributor, discusses work-from-home jobs, such as JustAnswer in which verified Experts answer people’s questions.
I will tell you that...the things you have to go through to be an Expert are quite rigorous.

What Customers are Saying:

Wonderful service, prompt, efficient, and accurate. Couldn't have asked for more. I cannot thank you enough for your help.

Mary C.Freshfield, Liverpool, UK

This expert is wonderful. They truly know what they are talking about, and they actually care about you. They really helped put my nerves at ease. Thank you so much!!!!

AlexLos Angeles, CA

Thank you for all your help. It is nice to know that this service is here for people like myself, who need answers fast and are not sure who to consult.

GPHesperia, CA

I couldn't be more satisfied! This is the site I will always come to when I need a second opinion.

JustinKernersville, NC

Just let me say that this encounter has been entirely professional and most helpful. I liked that I could ask additional questions and get answered in a very short turn around.

EstherWoodstock, NY

Thank you so much for taking your time and knowledge to support my concerns. Not only did you answer my questions, you even took it a step further with replying with more pertinent information I needed to know.

RobinElkton, Maryland

He answered my question promptly and gave me accurate, detailed information. If all of your experts are half as good, you have a great thing going here.

DianeDallas, TX

< Previous | Next >

Meet the Experts:

Dominick

Dominick

Marine Mechanic

1,009 satisfied customers

25 Years Experience as Mechanic, 20 Yrs Boat Yard Owner/Mechanic, Factory Certified

Ted G.

Ted G.

Rigger, Diagnostician

747 satisfied customers

40 years boating, Safe boating instruct., Offshore Race promoter, Failure Analysis, Expert Witness

John White

John White

Marine Mechanic

306 satisfied customers

11 years experience working on outboards, inboards, sterndrives & pwcs

Jason

Jason

Marine Mechanic

19,348 satisfied customers

Degree in Marine Technology. Gas and diesel marine mechanic.

Tan

Tan

MerCruiser Certified Technician

11,399 satisfied customers

40 yrs. experience with complete engine repairs both inboard/outboard and MerCruiser Certified Technician.

Jeff G.

Jeff G.

Marine Mechanic

4,730 satisfied customers

42 years experience, Certified Master Technician, All Major Outboards, Sterndrives, Hi-Performance

Captain Dave

Captain Dave

Marine Mechanic

2,672 satisfied customers

USCG Licensed Captain, 20+ Years Boating, Fishing, Maintenance and Repair Experience

< Previous | Next >

Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

Show MoreShow Less

Ask Your Question

x