Boat

Have Boat Questions? Ask a Boat Repair Expert.

Connect one-on-one with {0} who will answer your question

Related Boat Questions
I recently purchased a 1993 dt115 Suzuki 2 stroke and have
I recently purchased a 1993 dt115 Suzuki 2 stroke and have replaced the starter cleaned the carbs and put a new temperature sender switch that runs to the temp gauge. I was told it sat for a little ov… read more
DAVID BALLARD
DAVID BALLARD
OWNER
Vocational, Technical or Trade School
7 satisfied customers
I have an 06 merc 150 optimax. A steady alarm comes on at
I have an 06 merc 150 optimax. A steady alarm comes on at around 2500 rpm.I replaced the water pump impeller, and pulled the seawater strainer. Strainer was not clogged. Good stream from pee hole but … read more
Charles
Charles
Certified Mercury Tech
5,377 satisfied customers
I have a 2000 7.4 GSI that is having oil pressure alarms. The
I have a 2000 7.4 GSI that is having oil pressure alarms. The pressure gage at higher RPM reads in the medium high range. When slowing to idle it reads medium for a shot time then the needle begins to… read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,399 satisfied customers
I own a 1989 single engine Carver Allegra 2587. When starting
I own a 1989 single engine Carver Allegra 2587. When starting the engine and after running for 30 seconds or so, the ignition switch alarm is going off that normally would activate if the key was left… read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,399 satisfied customers
I have a 1997 200 HP Johnson SeaMaster, I have a temp light
I have a 1997 200 HP Johnson SeaMaster, I have a temp light that will not go out. I grounded the leads and still cannot get the error light to go out. I have replaced the water pump and it pees with a… read more
Jeff G.
Jeff G.
Marine Mechanic
Vocational, Technical or Trade Scho
4,730 satisfied customers
I have 7.4 l mercruser with new valve job 30 hrs on it new
I have 7.4 l mercruser with new valve job 30 hrs on it new distributor rebuild new plug wires new fuel sepeator and fresh oil the ngine stumbles at low rpm and backfires as throtle up could this be a … read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade School
19,333 satisfied customers
I have a 1996 evinrude 130. It has been to the mechanic twice
I have a 1996 evinrude 130. It has been to the mechanic twice and they worked on it for over a month, have same problem. I purchased the boat and motor this spring, it had no thermostats or poppet val… read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade School
19,333 satisfied customers
I have a 1989 Rinker 236 with a 7.4 lt Mercruser with a Bravo
I have a 1989 Rinker 236 with a 7.4 lt Mercruser with a Bravo One Drive. Can you tell me the steps to remove the engine (from the Drive etc) so that I can replace the Freeze plugs at the rear of the e… read more
James
James
Certified Marine Mechanic
Vocational, Technical or Trade Scho
4,094 satisfied customers
i have 1998 JOHNSON 150 OPTICAL IGNITON . MY PROBLEM IS THE
i have 1998 JOHNSON 150 OPTICAL IGNITON . MY PROBLEM IS THE ENGINE KEEPS GOING INTO SLOW MODE . THE LIGHT ON THE DASH IS THE OVERHEAT LIGHT. THE ENGINE IS NOT OVER HEATING CHECK IT W/A TEMP GUN.138-15… read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade School
19,333 satisfied customers
i have a mercruiser 7.4 mpi. my temp gauge is bouncing from
i have a mercruiser 7.4 mpi. my temp gauge is bouncing from 200 to 220. a heat gun tells me its only at 170 degrees. i have replaced the water temp sender and the engine coolant temp sender. now the b… read more
Noel Schembri
Noel Schembri
Marine mechanic
Diploma
1,803 satisfied customers
2003 4.3gxi, fresh water only,Always ran at 175 or 9 00 on
2003 4.3gxi, fresh water only,Always ran at 175 or 9:00 on the gauge, never went above it. started to over heat when run over 4000, slow down and it drops below 175 then back to 175. Changed impeller,… read more
Jeremy R.
Jeremy R.
5,362 satisfied customers
i have a 98 dt 115. hot light and horn sound off with in i
i have a 98 dt 115. hot light and horn sound off with in i minute of starting motor from being cold.i pulled the thermostat and put the hose on the flush line on back of motor .there is good water flo… read more
Noel Schembri
Noel Schembri
Marine mechanic
Diploma
1,803 satisfied customers
I have a warning beep going off. I talked to a mechanic & they
I have a warning beep going off. I talked to a mechanic & they said it goes off if the oil pressure is too low or if the water temp is too high. The alert only sounds when idling or slow speed. Once t… read more
Larry B.
Larry B.
Marine Service Tech
High School or GED
574 satisfied customers
Baja islander 252 islander, 454 magnum, bravo 1, over heated
Baja islander 252 islander, 454 magnum, bravo 1, over heated due to impeller issue, alarm went off, power reduced, lost approx 10 mph just before it throttled itself back. I had the impeller fixed, no… read more
Ted G.
Ted G.
Rigger, Diagnostician
Vocational, Technical or Trade Scho
747 satisfied customers
I have a Maxum boat 2100SR 350 Mercruser 300hp, I have this
I have a Maxum boat 2100SR 350 Mercruser 300hp, I have this buzzer very loud goes off almost everytime we are cruzing it has a purple wire and a brown/blue strip wire and runs back to a round plastic … read more
Jeremy R.
Jeremy R.
5,362 satisfied customers
Had a remanufactured long block 5.7 Mercruser 350 MAG with
Had a remanufactured long block 5.7 Mercruser 350 MAG with 270 HP installed in a 23 Bowrider (replacing a 7.4 Mercruiser engine). When we test drove it made a funny smell and the mechanic looked at it… read more
Master Tech
Master Tech
Service Manager/Technician
Vocational, Technical or Trade Scho
1,167 satisfied customers
i have suzuki 2001 DT224 outboard motor, the heat light keeps
i have suzuki 2001 DT224 outboard motor, the heat light keeps coming on and motor goes into safe mode. I had water pump and thermostats replaced. the engine temp is not that hot… read more
Captain Dave
Captain Dave
Marine Mechanic
Master's Degree
2,672 satisfied customers
I warm my boat up and when I put it into gear it dies. I was
I warm my boat up and when I put it into gear it dies. I was woundering if the idel is to low or if it might be something else. If it is the idel which screws should I adjust. I have a 7.4 mercruser e… read more
Joe
Joe
Owner Kingsland Auto & Marine Services
Vocational, Technical or Trade Scho
1,392 satisfied customers
Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

JustAnswer in the News:

Ask-a-doc Web sites: If you've got a quick question, you can try to get an answer from sites that say they have various specialists on hand to give quick answers... Justanswer.com.
JustAnswer.com...has seen a spike since October in legal questions from readers about layoffs, unemployment and severance.
Web sites like justanswer.com/legal
...leave nothing to chance.
Traffic on JustAnswer rose 14 percent...and had nearly 400,000 page views in 30 days...inquiries related to stress, high blood pressure, drinking and heart pain jumped 33 percent.
Tory Johnson, GMA Workplace Contributor, discusses work-from-home jobs, such as JustAnswer in which verified Experts answer people’s questions.
I will tell you that...the things you have to go through to be an Expert are quite rigorous.

What Customers are Saying:

Wonderful service, prompt, efficient, and accurate. Couldn't have asked for more. I cannot thank you enough for your help.

Mary C.Freshfield, Liverpool, UK

This expert is wonderful. They truly know what they are talking about, and they actually care about you. They really helped put my nerves at ease. Thank you so much!!!!

AlexLos Angeles, CA

Thank you for all your help. It is nice to know that this service is here for people like myself, who need answers fast and are not sure who to consult.

GPHesperia, CA

I couldn't be more satisfied! This is the site I will always come to when I need a second opinion.

JustinKernersville, NC

Just let me say that this encounter has been entirely professional and most helpful. I liked that I could ask additional questions and get answered in a very short turn around.

EstherWoodstock, NY

Thank you so much for taking your time and knowledge to support my concerns. Not only did you answer my questions, you even took it a step further with replying with more pertinent information I needed to know.

RobinElkton, Maryland

He answered my question promptly and gave me accurate, detailed information. If all of your experts are half as good, you have a great thing going here.

DianeDallas, TX

< Previous | Next >

Meet the Experts:

Dominick

Dominick

Marine Mechanic

1,009 satisfied customers

25 Years Experience as Mechanic, 20 Yrs Boat Yard Owner/Mechanic, Factory Certified

Ted G.

Ted G.

Rigger, Diagnostician

747 satisfied customers

40 years boating, Safe boating instruct., Offshore Race promoter, Failure Analysis, Expert Witness

John White

John White

Marine Mechanic

306 satisfied customers

11 years experience working on outboards, inboards, sterndrives & pwcs

Jason

Jason

Marine Mechanic

19,333 satisfied customers

Degree in Marine Technology. Gas and diesel marine mechanic.

Tan

Tan

MerCruiser Certified Technician

11,399 satisfied customers

40 yrs. experience with complete engine repairs both inboard/outboard and MerCruiser Certified Technician.

Jeff G.

Jeff G.

Marine Mechanic

4,730 satisfied customers

42 years experience, Certified Master Technician, All Major Outboards, Sterndrives, Hi-Performance

Captain Dave

Captain Dave

Marine Mechanic

2,672 satisfied customers

USCG Licensed Captain, 20+ Years Boating, Fishing, Maintenance and Repair Experience

< Previous | Next >

Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

Show MoreShow Less

Ask Your Question

x