Boat

Have Boat Questions? Ask a Boat Repair Expert.

Connect one-on-one with {0} who will answer your question

Related Boat Questions
1987 2850 contessa bayliner omc/ v p transom plates with vp
1987 2850 contessa bayliner omc/ v p transom plates with vp dp stern drive. boat sits low in water put in water and have a slow leak. from transom … read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade School
19,319 satisfied customers
When I put Muffs on my Penta 275 Outboard and start it it is
when I put Muffs on my Penta 275 Outboard and start it it is not pulling in water. I replaced the Impeller in the seawater pump but I still get nothing out of the exhaust. I then Filled a 40 gallon tu… read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade School
19,319 satisfied customers
Tan, it's Alex with the 200 with a different question. My
Tan, it's Alex with the 200 Johnson with a different question. My trim/tilt is not working. I can hear something clicking when I press the buttons. I raised the engine manually after releasing the pre… read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,399 satisfied customers
I have a 90 Volvo penta 5.7, 1981 bayliner saratoga. Installed
I have a 90 Volvo penta 5.7, 1981 bayliner saratoga. Installed edelbrock 1409 when purchased 3 years ago. Boat ran great for most of 1st season. Started misfiring & have been chasing problems ever sin… read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,399 satisfied customers
how do I remove the shaft and housing from a Volvo penta 280
how do I remove the shaft and housing from a Volvo penta 280 ? I removed the two allen bolts and I cant pull it off for the life of me . im using a slide hammer that is screwed on to the prop shaft… read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade School
19,319 satisfied customers
I have a Volvo Penta 2011 5.7 GXI with a Ocean X outdrive
I have a Volvo Penta 2011 5.7 GXI with a Ocean X outdrive Is there a how to manual for both the engine and the out drive and is there a special tool needed to fill the gear lube from inside the prop s… read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade School
19,319 satisfied customers
I have an earley 1970s AQ 130C four .Engine has been rebuilt,175
I have an earley 1970s AQ 130C four .Engine has been rebuilt,175 lbs compression. New exhaust manafold,solex carbs,gas tank,electric fuel pump,gas lines points,condencer ,plugs. Timing and dwell set,2… read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade School
19,319 satisfied customers
Need help with how to remove stuck Volvo DPS-m outdrive. The
Need help with how to remove stuck Volvo DPS-m outdrive. The stern of this boat was under water when bilge failed. Engine seized. I want to remove the outdrive but am having trouble. Everything is unb… read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade School
19,319 satisfied customers
Hi, Ive got a 97 Regal 23 bowrider with 350/5.7L & Volvo
Hi, I've got a '97 Regal 23' bowrider with 350/5.7L & Volvo Penta dual prop outdrive. Outdrive & trim overhauled last Feb. with VP parts. The boat idles fine but will not go into gear (forward or reve… read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade School
19,319 satisfied customers
I have a 1994 115 hp mercury outboard. Very stiff steering.
I have a 1994 115 hp mercury outboard. Very stiff steering. It's not the cable since it moves freely when disconencted from the motor. The steering shaft of the motor is well greased but still is stif… read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade School
19,319 satisfied customers
i have a volvo penta 2.3 i/o motor the battery was dead so
i have a volvo penta 2.3 i/o motor the battery was dead so i bought another one and installed it and it was weak so i charge it for a while but wouldnt start went weak quick so i jumped with cables an… read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade School
19,319 satisfied customers
What are the 4 plugs on the left side of the cylinder head
What are the 4 plugs on the left side of the cylinder head of my Volvo penta AQ 130. Water is leaking out of the second one from the front. Is there a repair for this?… read more
Whitecap36
Whitecap36
Service Manager/Technician
Vocational, Technical or Trade Scho
1,556 satisfied customers
i have a 1982 bayliner with an aq125a volvo penta with a 170
i have a 1982 bayliner whith an aq125a volvo penta with a 170 outdrive it needs a new shift cable how do you replace it and unconect it from the shifter this is a boat question… read more
K. Kergan
K. Kergan
Inboard/Outboard Mechanic
Vocational, Technical or Trade Scho
1,031 satisfied customers
I just got a Bayliner Contessa 2850 with a Volvo Penta 260
I just got a Bayliner Contessa 2850 with a Volvo Penta 260 package.... it did not come with the owners manual, or repair manual. The engine looks like your standard chevy big block. I'm wondering what… read more
Kenny
Kenny
Mercury & Mercruiser Diagnostics
Master's Degree
99 satisfied customers
hello, i run a ADQ40 165 volvo penta coupled to a volvo 280
hello, i run a ADQ40 165 volvo penta coupled to a volvoXXXXX i wish to remove the stern drive from the boat to replace the drive and exhaust boots as per maintainance procedures , my question is how d… read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,399 satisfied customers
I am looking at a couple boats to purchase next week. The
I am looking at a couple boats to purchase next week. The both have 305 CI Volvo Penta 231 A's in them. Just interesting in your thoughts on the on those motors and any specifics I should be looking f… read more
mercmastertech
mercmastertech
Service Manager, Master technician
Technical School
249 satisfied customers
Hi, I have a 2004 Volvo 8.1 GiE stern drive. I need to replace
Hi, I have a 2004 Volvo 8.1 GiE stern drive. I need to replace the steering cable, How does the cable come apart or pull out of the power steering cylinder control valve. I see a pin at what would be … read more
mercmastertech
mercmastertech
Service Manager, Master technician
Technical School
249 satisfied customers
I have a 1984 Bayliner 21 foot, volvo penta 4 cylinder. returned
I have a 1984 Bayliner 21 foot, volvo penta 4 cylinder. returned from a fishing trip and it wont start. its getting gas, plugs and distributor as well as wires are good, brand new Battery. A Guy says … read more
gearheadII
gearheadII
Bachelor's Degree
138 satisfied customers
Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

JustAnswer in the News:

Ask-a-doc Web sites: If you've got a quick question, you can try to get an answer from sites that say they have various specialists on hand to give quick answers... Justanswer.com.
JustAnswer.com...has seen a spike since October in legal questions from readers about layoffs, unemployment and severance.
Web sites like justanswer.com/legal
...leave nothing to chance.
Traffic on JustAnswer rose 14 percent...and had nearly 400,000 page views in 30 days...inquiries related to stress, high blood pressure, drinking and heart pain jumped 33 percent.
Tory Johnson, GMA Workplace Contributor, discusses work-from-home jobs, such as JustAnswer in which verified Experts answer people’s questions.
I will tell you that...the things you have to go through to be an Expert are quite rigorous.

What Customers are Saying:

Wonderful service, prompt, efficient, and accurate. Couldn't have asked for more. I cannot thank you enough for your help.

Mary C.Freshfield, Liverpool, UK

This expert is wonderful. They truly know what they are talking about, and they actually care about you. They really helped put my nerves at ease. Thank you so much!!!!

AlexLos Angeles, CA

Thank you for all your help. It is nice to know that this service is here for people like myself, who need answers fast and are not sure who to consult.

GPHesperia, CA

I couldn't be more satisfied! This is the site I will always come to when I need a second opinion.

JustinKernersville, NC

Just let me say that this encounter has been entirely professional and most helpful. I liked that I could ask additional questions and get answered in a very short turn around.

EstherWoodstock, NY

Thank you so much for taking your time and knowledge to support my concerns. Not only did you answer my questions, you even took it a step further with replying with more pertinent information I needed to know.

RobinElkton, Maryland

He answered my question promptly and gave me accurate, detailed information. If all of your experts are half as good, you have a great thing going here.

DianeDallas, TX

< Previous | Next >

Meet the Experts:

Dominick

Dominick

Marine Mechanic

1,009 satisfied customers

25 Years Experience as Mechanic, 20 Yrs Boat Yard Owner/Mechanic, Factory Certified

Ted G.

Ted G.

Rigger, Diagnostician

747 satisfied customers

40 years boating, Safe boating instruct., Offshore Race promoter, Failure Analysis, Expert Witness

John White

John White

Marine Mechanic

306 satisfied customers

11 years experience working on outboards, inboards, sterndrives & pwcs

Jason

Jason

Marine Mechanic

19,319 satisfied customers

Degree in Marine Technology. Gas and diesel marine mechanic.

Tan

Tan

MerCruiser Certified Technician

11,399 satisfied customers

40 yrs. experience with complete engine repairs both inboard/outboard and MerCruiser Certified Technician.

Jeff G.

Jeff G.

Marine Mechanic

4,730 satisfied customers

42 years experience, Certified Master Technician, All Major Outboards, Sterndrives, Hi-Performance

Captain Dave

Captain Dave

Marine Mechanic

2,672 satisfied customers

USCG Licensed Captain, 20+ Years Boating, Fishing, Maintenance and Repair Experience

< Previous | Next >

Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

Show MoreShow Less

Ask Your Question

x