Boat

Have Boat Questions? Ask a Boat Repair Expert.

Connect one-on-one with {0} who will answer your question

Related Boat Questions
Mercruiser alpha one runs fine for 20 minutes or so on the
mercruiser alpha one runs fine for 20 minutes or so on the water. Runs great forever out of water with earmuffs. After 20 min on the water it feels like the propeller is slipping. boat has no thrust a… read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade Scho
18,277 satisfied customers
Just replaced spun out engine coupler, lower unit drive
just replaced spun out engine coupler, lower unit drive shaft and u-joints on 1984 mercruiser alpha drive on a 19 ft glastron sx-190, with 260 hp 5.7 liter. boat ran great for first 45 minutes at idle… read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,504 satisfied customers
would it damage the engine in my mercruiser if i hit a snall
would it damage the engine in my mercruiser if i hit a snall sand bar at low speed damaging the prop a little is ther a chance for long term engine problems from getting the propellor banged up?… read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,504 satisfied customers
01 MerCruiser Alpha 1 in 24foot SunTracker Deck boat. This
01 MerCruiser Alpha 1 in 24foot SunTracker Deck boat. This weekend while pulling a tube the motor RPM increased and our forward momentum ceased. We were able to idle back to our dock, but any accelera… read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,504 satisfied customers
I just replaced my bellows/drive shaft with the sierra u joint
I just replaced my bellows/drive shaft with the sierra u joint from online. also replaced the gimbal bearing and seal. I now have the vibration when turning. I don't have the vibration on a turn when … read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,504 satisfied customers
I have a 99 5.7 mercruiser bravoXXXXX Has only 412
I have a 99 5.7 mercruiser bravoXXXXX Has only 412 hrs. I recently spun out the rubber drive coupler on the back of the motor. Replaced it, and it has spun out again with about only 2hrs of running. I… read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,504 satisfied customers
I have a 2010 seadoo rxt-x. The ski has been running fine
Hello, I have a 2010 seadoo rxt-x. The ski has been running fine and has only 16hrs on it. I was jumping waves (non-salt water) with it. After jumping a wave, ski vibrated when throttling and had no p… read more
KKassel
KKassel
OWNER
High School or GED
381 satisfied customers
Seems like spun hub on volvo penta. No noise no vibration.
Seems like spun hub on volvo penta. No noise no vibration. At WOT 4200RPM, rpm go up speed falls off. New hub in old prop -- same thing. New prop with new hub. same thing. in minutes. I am thinking cl… read more
briggs archer
briggs archer
master marine mechanic
Associate Degree
374 satisfied customers
I hit bottom this afternoon with my Mercruiser IO lower unit.
I hit bottom this afternoon with my Mercruiser IO lower unit. The propeller was damaged some and there was a vibration upon acceleration after that, but the boat operated fine for about 5 minutes. The… read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,504 satisfied customers
we just bought a used boat. We had the dealer make it ready
we just bought a used boat. We had the dealer make it ready for summer use and picked it up from him. After launching the boat we drove it for about an hour and everything seemed fine. After a while w… read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,504 satisfied customers
i am looking at buying a 2004 four winns boat that has a 5.0l
i am looking at buying a 2004 four winns boat that has a 5.0l v8 220 hp with volvo penta outdrive in it. When you turn the boat very tight at high speed it vibrates. They guy I'm buying it from took i… read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,504 satisfied customers
i have a 1989 40 hp mariner outboard motor thats feels like
i have a 1989 40 hp mariner outboard motor thats feels like its slipping when u reach half throttle or more… read more
Jason Forsberg
Jason Forsberg
Outboard Marine Mechanic
Vocational, Technical or Trade Scho
531 satisfied customers
I spun a prop changed prop I get rpm but not full speed and
I spun a prop changed prop I get rpm but not full speed and at higher rpm's I get a vibration.… read more
Jeff G.
Jeff G.
Marine Mechanic
Vocational, Technical or Trade Scho
4,730 satisfied customers
How can you tell if you have spun a prop Volvo DPH 2007
How can you tell if you have spun a prop ? Volvo DPH 2007 (bronze/brass duo prop) Are there alignment marks on the prop and prop guts? Looking for a bad vibration Havent looked to see if I have water … read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,504 satisfied customers
I had had many questions and answears on my boat sterndrive
I had had many questions and answears on my boat sterndrive a 1987 merc 5.7 alpha 1 sterndrive took it to a shop for noise in drive now I have a boat that only idles when under load just revs.... a sh… read more
briggs archer
briggs archer
master marine mechanic
Associate Degree
374 satisfied customers
Question 87 alpha 1 sterndrive problem took in for service
Question 87' alpha 1 sterndrive problem took in for service and now the boat revs up but won't go past idle speed, the last mechanic here said spun hub? did the test put the boat in gear and the prop … read more
Joe
Joe
Owner Kingsland Auto & Marine Services
Vocational, Technical or Trade Scho
1,392 satisfied customers
yamaha 200 hp about 1987 runs good....... I herd a pop (also
yamaha 200 hp about 1987 runs good....... I herd a pop (also felt like i hit a fish(?)) the boat now over revs when power is applied but it turns the prop in low power. I was also pulling a two person… read more
ROCKET
ROCKET
MASTER CERTIFIED TECH
Vocational, Technical or Trade Scho
426 satisfied customers
I have a Mercury 120 Force motor, 4 cylinder 2 cycle engine
I have a Mercury 120 Force motor, 4 cylinder 2 cycle engine on a 17 foot bayliner, 1995. I bought it last year and it ran fine. I slowly began having issues where I cannot drop the hammer to get it ou… read more
Captain Dave
Captain Dave
Marine Mechanic
Master's Degree
2,672 satisfied customers
Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

JustAnswer in the News:

Ask-a-doc Web sites: If you've got a quick question, you can try to get an answer from sites that say they have various specialists on hand to give quick answers... Justanswer.com.
JustAnswer.com...has seen a spike since October in legal questions from readers about layoffs, unemployment and severance.
Web sites like justanswer.com/legal
...leave nothing to chance.
Traffic on JustAnswer rose 14 percent...and had nearly 400,000 page views in 30 days...inquiries related to stress, high blood pressure, drinking and heart pain jumped 33 percent.
Tory Johnson, GMA Workplace Contributor, discusses work-from-home jobs, such as JustAnswer in which verified Experts answer people’s questions.
I will tell you that...the things you have to go through to be an Expert are quite rigorous.

What Customers are Saying:

Wonderful service, prompt, efficient, and accurate. Couldn't have asked for more. I cannot thank you enough for your help.

Mary C.Freshfield, Liverpool, UK

This expert is wonderful. They truly know what they are talking about, and they actually care about you. They really helped put my nerves at ease. Thank you so much!!!!

AlexLos Angeles, CA

Thank you for all your help. It is nice to know that this service is here for people like myself, who need answers fast and are not sure who to consult.

GPHesperia, CA

I couldn't be more satisfied! This is the site I will always come to when I need a second opinion.

JustinKernersville, NC

Just let me say that this encounter has been entirely professional and most helpful. I liked that I could ask additional questions and get answered in a very short turn around.

EstherWoodstock, NY

Thank you so much for taking your time and knowledge to support my concerns. Not only did you answer my questions, you even took it a step further with replying with more pertinent information I needed to know.

RobinElkton, Maryland

He answered my question promptly and gave me accurate, detailed information. If all of your experts are half as good, you have a great thing going here.

DianeDallas, TX

< Previous | Next >

Meet the Experts:

Dominick

Dominick

Marine Mechanic

1,009 satisfied customers

25 Years Experience as Mechanic, 20 Yrs Boat Yard Owner/Mechanic, Factory Certified

Ted G.

Ted G.

Rigger, Diagnostician

747 satisfied customers

40 years boating, Safe boating instruct., Offshore Race promoter, Failure Analysis, Expert Witness

John White

John White

Marine Mechanic

306 satisfied customers

11 years experience working on outboards, inboards, sterndrives & pwcs

Jason

Jason

Marine Mechanic

18,277 satisfied customers

Degree in Marine Technology. Gas and diesel marine mechanic.

Tan

Tan

MerCruiser Certified Technician

11,504 satisfied customers

40 yrs. experience with complete engine repairs both inboard/outboard and MerCruiser Certified Technician.

Jeff G.

Jeff G.

Marine Mechanic

4,730 satisfied customers

42 years experience, Certified Master Technician, All Major Outboards, Sterndrives, Hi-Performance

Captain Dave

Captain Dave

Marine Mechanic

2,672 satisfied customers

USCG Licensed Captain, 20+ Years Boating, Fishing, Maintenance and Repair Experience

< Previous | Next >

Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

Show MoreShow Less

Ask Your Question

x