Boat

Have Boat Questions? Ask a Boat Repair Expert.

Connect one-on-one with {0} who will answer your question

Related Boat Questions
Better control of trolling speed on Yamaha 8 hp outboard
better control of trolling speed on Yamaha 8 hp outboard motor … read more
Charles
Charles
Certified Mercury Tech
5,378 satisfied customers
I have a 93 yamaha 130XTRR motor that is bogging down under
I have a 93 yamaha 130XTRR motor that is bogging down under a load. Feels as it went to safe mode with no alarms or buzzers going off. Motor runs great and revs to 5000rpms at dock but wont go past 23… read more
Jason
Jason
Marine Mechanic
19,349 satisfied customers
I have a 1999 yamaha 225 vmax ox66, issue just started last
my name is ***** ***** have a 1999 yamaha 225 vmax ox66, issue just started last weekend, when i crank the engine it runs like your turning the key on and off really fast , i have done alot of work to… read more
Jason
Jason
Marine Mechanic
19,349 satisfied customers
I have twin 2001 200 HP HPDMI Yamaha motors. That are
I have twin 2001 200 HP HPDMI Yamaha motors. That are controlled at the helm by a Yamaha 704 Remote Control levers. More often than not I can have the port side lever pushed all the way and have only … read more
Jason
Jason
Marine Mechanic
19,349 satisfied customers
Have yamaha 200. Motor stales above 3000 rpm. Happened a JA:
Have yamaha 200. Motor stales above 3000 rpm. Happened a … read more
Jason
Jason
Marine Mechanic
19,349 satisfied customers
The throttle cable on my boat was replaced in the fall of 2013. I just put the boat in the
The throttle cable on my boat was replaced in the fall of 2013. I just put the boat in the water and the throttle went up but when I tried to bring it back down it was stuck in the up position. Then I… read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,399 satisfied customers
I have just purchased a new boat with a Yamaha V4 135 Saltwater
I have just purchased a new boat with a Yamaha V4 135 Saltwater series motor. I am having difficulty with getting the trim correct when the boat is moving. From start and having the motor fully down i… read more
Charles
Charles
Certified Mercury Tech
5,378 satisfied customers
I have just sea trialed new 300 four stroke yamahas two station
I have just sea trialed new 300 four stroke yamahas two station controls evreything works fine but at 4000 + rpms ,the starboard motor shuts off. Ive run it with just two motors in every combination i… read more
Charles
Charles
Certified Mercury Tech
5,378 satisfied customers
I just purchased a 1975 CC with 1975 twin Yamaha 150 HP (150
I just purchased a 1975 CC with 1975 twin Yamaha 150 HP (150 TXRT) from a friend. I took the boat out today and was extremely pleased with performance and motor operation. When docking the boat for th… read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,399 satisfied customers
I would like to get a generator for my 1998 Bayliner 2855 Ciera.
I would like to get a generator for my 1998 Bayliner 2855 Ciera. Is there one that would go in the engine area or do I get a small portable?… read more
Jason
Jason
Marine Mechanic
19,349 satisfied customers
We are novices just having bought a used pontoon boat. We have
We are novices just having bought a used pontoon boat. We have a 1987 evinrude 60 hp. We cannot get the trim to work. The trim motor makes a noise but the motor does not move. The trim buttons on the … read more
Jason
Jason
Marine Mechanic
19,349 satisfied customers
I have a 1997 Yamaha 225 S225TXRV on a Skeeter Bay Boat. There
I have a 1997 Yamaha 225 S225TXRV on a Skeeter Bay Boat. There are two lights on the dash: one for oil which seems to be working, and the other for overheat which is not. I get 12 volts at the overhea… read more
Jeff G.
Jeff G.
Marine Mechanic
Vocational, Technical or Trade Scho
4,730 satisfied customers
1994 Yamaha 115 2 stroke outboard w/ 704 Yamaha Remote Control
1994 Yamaha 115 2 stroke outboard w/ 704 Yamaha "Remote Control" was cruising along just fine. Coming in to dock, shifted to neutral, then reverse to complete docking. motor stayed in neutral (tho con… read more
James
James
Certified Marine Mechanic
Vocational, Technical or Trade Scho
4,094 satisfied customers
We have a 1993 Yamaha sterndrive on our 1993 Ebbtide boat.
We have a 1993 Yamaha sterndrive on our 1993 Ebbtide boat. When we test the shifting with the boat on the trailer and water attached, it shifts fine, but when we launch the boat and it is in the water… read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,399 satisfied customers
I have 1989 Ski Brendella with a Cleveland engine. The engine
I have 1989 Ski Brendella with a Cleveland engine. The engine runs great, but yesterday, I idled out of the no wake zone with no problem and then prepared to pull my daughter skiing. We she was set, I… read more
Jeremy R.
Jeremy R.
5,362 satisfied customers
I just replaced my 1990 Yamaha 9.9 EXD with a new 09 Yamaha
I just replaced my 1990 Yamaha 9.9 EXD with a new 09 Yamaha T 9.9 GEXH. The 1990 was set up with Yamaha Remote Control Kit, Part No. 6G8-W4831-01, on my sailing trimaran which has a cockpit away from … read more
John White
John White
Marine Mechanic
Vocational, Technical or Trade Scho
306 satisfied customers
My local yamaha dealer says I have a PRIME STARTER ASSY problem
My local yamaha dealer says I have a PRIME STARTER ASSY problem on my 99 yamaha c50. they say it may even be an electrical problem that could start a fire. I paid them the $490 for carb clean and said… read more
Larry B.
Larry B.
Marine Service Tech
High School or GED
574 satisfied customers
hi i have a 1994 bayliner with a 3.o 4 cylinder i/o runs good
hi i have a 1994 bayliner with a 3.o 4 cylinder i/o runs good till 3/4 throttle then it feels like it running out of gas checked filter ok put a fuel presure gauge on it 6lb presure at idle 3/4 thrott… read more
Dominick
Dominick
Marine Mechanic
Vocational, Technical or Trade Scho
1,009 satisfied customers
Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

JustAnswer in the News:

Ask-a-doc Web sites: If you've got a quick question, you can try to get an answer from sites that say they have various specialists on hand to give quick answers... Justanswer.com.
JustAnswer.com...has seen a spike since October in legal questions from readers about layoffs, unemployment and severance.
Web sites like justanswer.com/legal
...leave nothing to chance.
Traffic on JustAnswer rose 14 percent...and had nearly 400,000 page views in 30 days...inquiries related to stress, high blood pressure, drinking and heart pain jumped 33 percent.
Tory Johnson, GMA Workplace Contributor, discusses work-from-home jobs, such as JustAnswer in which verified Experts answer people’s questions.
I will tell you that...the things you have to go through to be an Expert are quite rigorous.

What Customers are Saying:

Wonderful service, prompt, efficient, and accurate. Couldn't have asked for more. I cannot thank you enough for your help.

Mary C.Freshfield, Liverpool, UK

This expert is wonderful. They truly know what they are talking about, and they actually care about you. They really helped put my nerves at ease. Thank you so much!!!!

AlexLos Angeles, CA

Thank you for all your help. It is nice to know that this service is here for people like myself, who need answers fast and are not sure who to consult.

GPHesperia, CA

I couldn't be more satisfied! This is the site I will always come to when I need a second opinion.

JustinKernersville, NC

Just let me say that this encounter has been entirely professional and most helpful. I liked that I could ask additional questions and get answered in a very short turn around.

EstherWoodstock, NY

Thank you so much for taking your time and knowledge to support my concerns. Not only did you answer my questions, you even took it a step further with replying with more pertinent information I needed to know.

RobinElkton, Maryland

He answered my question promptly and gave me accurate, detailed information. If all of your experts are half as good, you have a great thing going here.

DianeDallas, TX

< Previous | Next >

Meet the Experts:

Dominick

Dominick

Marine Mechanic

1,009 satisfied customers

25 Years Experience as Mechanic, 20 Yrs Boat Yard Owner/Mechanic, Factory Certified

Ted G.

Ted G.

Rigger, Diagnostician

747 satisfied customers

40 years boating, Safe boating instruct., Offshore Race promoter, Failure Analysis, Expert Witness

John White

John White

Marine Mechanic

306 satisfied customers

11 years experience working on outboards, inboards, sterndrives & pwcs

Jason

Jason

Marine Mechanic

19,349 satisfied customers

Degree in Marine Technology. Gas and diesel marine mechanic.

Tan

Tan

MerCruiser Certified Technician

11,399 satisfied customers

40 yrs. experience with complete engine repairs both inboard/outboard and MerCruiser Certified Technician.

Jeff G.

Jeff G.

Marine Mechanic

4,730 satisfied customers

42 years experience, Certified Master Technician, All Major Outboards, Sterndrives, Hi-Performance

Captain Dave

Captain Dave

Marine Mechanic

2,672 satisfied customers

USCG Licensed Captain, 20+ Years Boating, Fishing, Maintenance and Repair Experience

< Previous | Next >

Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

Show MoreShow Less

Ask Your Question

x