Boat

Have Boat Questions? Ask a Boat Repair Expert.

Connect one-on-one with {0} who will answer your question

Related Boat Questions
I have a 1978 15 hp tiller. Motor runs fine but yesterday
I have a 1978 johnson 15 hp tiller. Motor runs fine but yesterday developed a big problem. Anything past idle when in gear and the engine starts running like it is cavitating and doesnt get any speed.… read more
Charles
Charles
Certified Mercury Tech
5,441 satisfied customers
I have a 15 horse mercury two-stroke experiencing cavitation
I have a 15 horse mercury two-stroke experiencing cavitation just about when it's going to plane have check for Spohn of without any issue could this be internal to the lower unit… read more
Ted G.
Ted G.
Rigger, Diagnostician
Vocational, Technical or Trade Scho
747 satisfied customers
have a 1986 250 coastal 25 foot cavitates had a 13 by 15 pitch
have a 1986 250 coastal 25 foot cavitates had a 13 by 15 pitch prop changed it today to a 13.5 by 21 pitch doesnt cavitate and increased speed can i go bigger prop and should i think about putting one… read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade Scho
18,277 satisfied customers
I have twin 60 hp mercury outboards on the back of a Twin Vee
I have twin 60 hp mercury outboards on the back of a Twin Vee 20 foot cat. I currently have four blade propellers stamped 48-878614.13p. The engines are NOT BIGFOOT MODEL. What size is the best three … read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,399 satisfied customers
Bent the prop on my 2001 25 horse three cylinder outboard.
Bent the prop on my 2001 25 horse three cylinder outboard. Cannot determine the size, pitch, etc. for a replacement prop, no markings on the current prop. What size should I buy?… read more
davesoutboard
davesoutboard
owner
Associate Degree
1,570 satisfied customers
I have a 2002 30 hp. 4 stroke it has a 10.8x11p. prop is that
I have a 2002 30 hp. 4 stroke it has a 10.8x11p. prop is that the right prop. i also have a a 10.8x14p prop that a freind gave me that will fit can i use that or will it drop the rpm to low. the motor… read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,399 satisfied customers
I have a 20 hp Mercury outboard that has an eight spline prop
I have a 20 hp Mercury outboard that has an eight spline prop shaft. The serial number of the motor is(NNN) NNN-NNNN Every place I look shows that all Mercury 20 hp motors have a ten spline prop shaft… read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade Scho
18,277 satisfied customers
I have a 16 ft. aluminum Legend fishing boat (side console).
I have a 16 ft. aluminum Legend fishing boat (side console). The hull Weight is 640 lbs. Maximum capacity is 1,220 lbs. The outboard engine is 25 HP EFI 4-Stroke. The engine's full throttle RPM range … read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade Scho
18,277 satisfied customers
I have a 2005 Boston Whaler nantucket with a Mercury 125 Saltwater
I have a 2005 Boston Whaler nantucket with a Mercury 125 Saltwater outboard. Prop is aluminium 13 1/4" Pitch 21. RPM is 4800 flat out. Engine is right down on the transom, and I wonder what height I s… read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,399 satisfied customers
I have a 2004 Johnson 4 stroke 40 HP outboard. I need a new
I have a 2004 Johnson 4 stroke 40 HP outboard. I need a new prop. I will get a 3 blade aluminum prop. It is on 14.5 ft fiberglass boat w/ stick steering. I do not what you call the style of the boat..… read more
Jeremy R.
Jeremy R.
5,362 satisfied customers
I recently ran my boat and on ocassion I top it out for a minute
I recently ran my boat and on ocassion I top it out for a minute it usually will get around 4700 rpms now it will max at 4200rpm with motor trimmed up. I changed the plugs and water seperator.… read more
Whitecap36
Whitecap36
Service Manager/Technician
Vocational, Technical or Trade Scho
1,556 satisfied customers
I have a Fisher 200 Freedom Fish pontoon boat with a Merc 50hp,
I have a Fisher 200 Freedom Fish pontoon boat with a Merc 50hp, 4cyl, 4 stroke outboard. Both are 1996 vintage. I need a new prop. The current prop is 10.5" dia with about a 11" pitch. It has always e… read more
Captain Dave
Captain Dave
Marine Mechanic
Master's Degree
2,672 satisfied customers
have a Tracker marine bass boat TXW 175, with a 60 hp merc
have a Tracker marine bass boat TXW 175, with a 60 hp merc elpto 4 stroke and an aluminum 14 pitch prop. having issues with 2 people and live well full, boat a little slow comming out of the hole. and… read more
Jeff G.
Jeff G.
Marine Mechanic
Vocational, Technical or Trade Scho
4,730 satisfied customers
what size outboard do i need for a 13 foot aluminum boat
what size outboard do i need for a 13' foot aluminum boat? I am only using it to fish in lakes, rivers and ponds.… read more
Whitecap36
Whitecap36
Service Manager/Technician
Vocational, Technical or Trade Scho
1,556 satisfied customers
i have a caribbean 2400 f/glass runabout net weight 1750 kg
i have a caribbean 2400 f/glass runabout net weight 1750 kg with 2008 225 etec 15.5 x 17 rebel propeller i can not get over 5000 rpm wot with 3 men on board and 300 ltres off fuel the engine is also v… read more
John White
John White
Marine Mechanic
Vocational, Technical or Trade Scho
306 satisfied customers
i have a 14 ft Nautica Rib with a Yamaha T60 and am have big
i have a 14 ft Nautica Rib with a Yamaha T60 and am have big performance issues with a 13 1/2 x 15 propeller. Do you have and suggestions?… read more
John White
John White
Marine Mechanic
Vocational, Technical or Trade Scho
306 satisfied customers
I have a 20 pontoon boat with a 1998 50 hp johnson 2 stroke
I have a 20' pontoon boat with a 1998 50 hp johnson 2 stroke with short shank. I have been having cavitating problems with it. It will just go along, then revs up as if it was out of the water. I was … read more
ROCKET
ROCKET
MASTER CERTIFIED TECH
Vocational, Technical or Trade Scho
426 satisfied customers
I have a 24 ft pontoon boat with a 2005 90 hp outboard ,the
I have a 24 ft pontoon boat with a 2005 90 hp outboard ,the engine cavitates alot some times at 3500 rpm somtimes higher ,cruising at 3000 to 3500 for no reason at all the rpms start climbing. the eng… read more
Dominick
Dominick
Marine Mechanic
Vocational, Technical or Trade Scho
1,009 satisfied customers
Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

JustAnswer in the News:

Ask-a-doc Web sites: If you've got a quick question, you can try to get an answer from sites that say they have various specialists on hand to give quick answers... Justanswer.com.
JustAnswer.com...has seen a spike since October in legal questions from readers about layoffs, unemployment and severance.
Web sites like justanswer.com/legal
...leave nothing to chance.
Traffic on JustAnswer rose 14 percent...and had nearly 400,000 page views in 30 days...inquiries related to stress, high blood pressure, drinking and heart pain jumped 33 percent.
Tory Johnson, GMA Workplace Contributor, discusses work-from-home jobs, such as JustAnswer in which verified Experts answer people’s questions.
I will tell you that...the things you have to go through to be an Expert are quite rigorous.

What Customers are Saying:

Wonderful service, prompt, efficient, and accurate. Couldn't have asked for more. I cannot thank you enough for your help.

Mary C.Freshfield, Liverpool, UK

This expert is wonderful. They truly know what they are talking about, and they actually care about you. They really helped put my nerves at ease. Thank you so much!!!!

AlexLos Angeles, CA

Thank you for all your help. It is nice to know that this service is here for people like myself, who need answers fast and are not sure who to consult.

GPHesperia, CA

I couldn't be more satisfied! This is the site I will always come to when I need a second opinion.

JustinKernersville, NC

Just let me say that this encounter has been entirely professional and most helpful. I liked that I could ask additional questions and get answered in a very short turn around.

EstherWoodstock, NY

Thank you so much for taking your time and knowledge to support my concerns. Not only did you answer my questions, you even took it a step further with replying with more pertinent information I needed to know.

RobinElkton, Maryland

He answered my question promptly and gave me accurate, detailed information. If all of your experts are half as good, you have a great thing going here.

DianeDallas, TX

< Previous | Next >

Meet the Experts:

Dominick

Dominick

Marine Mechanic

1,009 satisfied customers

25 Years Experience as Mechanic, 20 Yrs Boat Yard Owner/Mechanic, Factory Certified

Ted G.

Ted G.

Rigger, Diagnostician

747 satisfied customers

40 years boating, Safe boating instruct., Offshore Race promoter, Failure Analysis, Expert Witness

John White

John White

Marine Mechanic

306 satisfied customers

11 years experience working on outboards, inboards, sterndrives & pwcs

Jason

Jason

Marine Mechanic

18,277 satisfied customers

Degree in Marine Technology. Gas and diesel marine mechanic.

Tan

Tan

MerCruiser Certified Technician

11,399 satisfied customers

40 yrs. experience with complete engine repairs both inboard/outboard and MerCruiser Certified Technician.

Jeff G.

Jeff G.

Marine Mechanic

4,730 satisfied customers

42 years experience, Certified Master Technician, All Major Outboards, Sterndrives, Hi-Performance

Captain Dave

Captain Dave

Marine Mechanic

2,672 satisfied customers

USCG Licensed Captain, 20+ Years Boating, Fishing, Maintenance and Repair Experience

< Previous | Next >

Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

Show MoreShow Less

Ask Your Question

x