Boat

Have Boat Questions? Ask a Boat Repair Expert.

Connect one-on-one with {0} who will answer your question

Related Boat Questions
I bought a used 2005 Mercury 250L VER I then the DTC Command
I bought a used 2005 Mercury 250L VER I then the DTC Command Module Kit installed everything and can not get the motor to do anythiny … read more
Charles
Charles
Certified Mercury Tech
5,748 satisfied customers
I own a 1978 Mercury Model 1150 inline 6. I recently
Hello, I own a 1978 Mercury Model 1150 inline 6. I recently purchased a new Quicksilver remote control (part # 881170A12) along w/ a conversion harness (part # 84-892329A01) in order to match the numb… read more
Charles
Charles
Certified Mercury Tech
5,748 satisfied customers
Where is the aerator switch on a 1992 Cajun, just don't know
just don't know where/how to activate the livewell on the boat … read more
Charles
Charles
Certified Mercury Tech
5,748 satisfied customers
We have an 2005 Bayliner Trophy 18.2 Cuddy cab outboard and
We have an 2005 Bayliner Trophy 18.2 Cuddy cab outboard and want to know if the steering system is sealed & can be lubricated. it feels like it's binding up at the steering mechanism behind the bulkhe… read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,507 satisfied customers
I have an older boat that had an Evinrude 140 V-4 with a
I have an older boat that had an Evinrude 140 V-4 with a "Power Pilot" control unit. Engine blown! I've got a 1979 Mercury 90HP set to go except for wiring the pigtail plug of the Merc to the wiring h… read more
Jeff G.
Jeff G.
Marine Mechanic
Vocational, Technical or Trade Scho
4,730 satisfied customers
1990 Johnson 90hp VRO No fire. I replaced rectifier and power
1990 Johnson 90hp VRO No fire. I replaced rectifier and power pack and red wiring harness outside engine up to dashboard and ignition switch. Still no fire. Stator checks out fine, so does ohm check o… read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,507 satisfied customers
I would like to know the best way to remove the lower steering
I would like to know the best way to remove the lower steering station cable and install a new one in a 1986 Bayliner 2650 convertible[flybridge]] Thanks.… read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,507 satisfied customers
I have a 2007 Yamaha G3 pontoon boat with a 70hp motor.
I have a 2007 Yamaha G3 pontoon boat with a 70hp motor. Can you please tell me where the main ground wire is to the lights, gas gauge and horn. With a tester all wires show power, however, nothing wor… read more
Charles
Charles
Certified Mercury Tech
5,748 satisfied customers
i have rack and pinion steering on my starcraft fishmaster
i have rack and pinion steering on my starcraft fishmaster 190 with a mercury 90 outboard motor. The steering wheel wont turn so i figured the problem to be in the tilt tube. i have freed the cable at… read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,507 satisfied customers
trying to hook up wires from 50 hp 2005 Mercury outboard to guages on Tracker boat (amp an
trying to hook up wires from 50 hp 2005 Mercury outboard to guages on Tracker boat (amp and rpms). need color code of wires schematics. Please… read more
Charles
Charles
Certified Mercury Tech
5,748 satisfied customers
1995 Suntracker Pontoon boat with 90 hp Mercury. I am replacing
1995 Suntracker Pontoon boat with 90 hp Mercury. I am replacing all seats and helm. I need advice on what to replace all wiring with from motor forward. I have already purchased new guages (tach,amp,v… read more
Charles
Charles
Certified Mercury Tech
5,748 satisfied customers
the steering on my mercury classic 50 binds, and i lubed the
the steering on my mercury classic 50 binds, and i lubed the engine tilt tube and rod for the steering..… read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,507 satisfied customers
Hi Tan - I know you are a Mercury guru so not sure how much
Hi Tan - I know you are a Mercury guru so not sure how much you are up on Raymarine electronics. My question is sort of inbetween the two. I am replacing my Raymarine C70 MFD with a new E120W model. I… read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,507 satisfied customers
Hi, I am building a runabout and have a Mercury 60 EFI 4 stroke.
Hi, I am building a runabout and have a Mercury 60 EFI 4 stroke. I wired the boat for the smartcraft gauges. Just found out the 60 HP EFI 4 stroke engine does not support all the smartcraft functions.… read more
James
James
Certified Marine Mechanic
Vocational, Technical or Trade Scho
4,094 satisfied customers
Just in time. I have another project. 88 aloha pontoon boat.
Just in time. I have another project. 88 aloha pontoon boat. 115 yamaha, enginen code C115TLRP, i think around 91. I'm replacing the captain stand and thought I properly tagged the spaghetti bowl of w… read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,507 satisfied customers
2004 Larson Cabrio 274 with Volvo Penta Gas 5.7 GXI Dp. Steering
2004 Larson Cabrio 274 with Volvo Penta Gas 5.7 GXI Dp. Steering wheel turns lower unit 100% to right but 75% to the left. Noticeable while docking. Is this normal or is there steering adjustments to … read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,507 satisfied customers
I have a 75hp mercury outboard. unknown year, serial # XXXXX It
I have a 75hp mercury outboard. unknown year, serial # XXXXX It has no over heat/oil alarm. I need to install one. Where is it attached to the engine? Can I get an after market part or do I order a Me… read more
Jack
Jack
Marine Technician
Vocational, Technical or Trade Scho
54 satisfied customers
I have a 1989 90hp 3 cyl merc outboard I have only an internal
I have a 1989 90hp 3 cyl merc outboard I have only an internal wireing diagram and want to hook up a new ignition switch and guages "tach, volt, fuel". I have a new factory ignition switch and guages.… read more
Mechman45
Mechman45
Vocational, Technical or Trade School
152 satisfied customers
Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

JustAnswer in the News:

Ask-a-doc Web sites: If you've got a quick question, you can try to get an answer from sites that say they have various specialists on hand to give quick answers... Justanswer.com.
JustAnswer.com...has seen a spike since October in legal questions from readers about layoffs, unemployment and severance.
Web sites like justanswer.com/legal
...leave nothing to chance.
Traffic on JustAnswer rose 14 percent...and had nearly 400,000 page views in 30 days...inquiries related to stress, high blood pressure, drinking and heart pain jumped 33 percent.
Tory Johnson, GMA Workplace Contributor, discusses work-from-home jobs, such as JustAnswer in which verified Experts answer people’s questions.
I will tell you that...the things you have to go through to be an Expert are quite rigorous.

What Customers are Saying:

Wonderful service, prompt, efficient, and accurate. Couldn't have asked for more. I cannot thank you enough for your help.

Mary C.Freshfield, Liverpool, UK

This expert is wonderful. They truly know what they are talking about, and they actually care about you. They really helped put my nerves at ease. Thank you so much!!!!

AlexLos Angeles, CA

Thank you for all your help. It is nice to know that this service is here for people like myself, who need answers fast and are not sure who to consult.

GPHesperia, CA

I couldn't be more satisfied! This is the site I will always come to when I need a second opinion.

JustinKernersville, NC

Just let me say that this encounter has been entirely professional and most helpful. I liked that I could ask additional questions and get answered in a very short turn around.

EstherWoodstock, NY

Thank you so much for taking your time and knowledge to support my concerns. Not only did you answer my questions, you even took it a step further with replying with more pertinent information I needed to know.

RobinElkton, Maryland

He answered my question promptly and gave me accurate, detailed information. If all of your experts are half as good, you have a great thing going here.

DianeDallas, TX

< Previous | Next >

Meet the Experts:

Ted G.

Ted G.

Rigger, Diagnostician

2,678 satisfied customers

40 years boating, Safe boating instruct., Offshore Race promoter, Failure Analysis, Expert Witness

Dominick

Dominick

Marine Mechanic

1,009 satisfied customers

25 Years Experience as Mechanic, 20 Yrs Boat Yard Owner/Mechanic, Factory Certified

John White

John White

Marine Mechanic

306 satisfied customers

11 years experience working on outboards, inboards, sterndrives & pwcs

Jason

Jason

Marine Mechanic

22,043 satisfied customers

Degree in Marine Technology. Gas and diesel marine mechanic.

Tan

Tan

MerCruiser Certified Technician

11,507 satisfied customers

40 yrs. experience with complete engine repairs both inboard/outboard and MerCruiser Certified Technician.

Jeff G.

Jeff G.

Marine Mechanic

4,730 satisfied customers

42 years experience, Certified Master Technician, All Major Outboards, Sterndrives, Hi-Performance

Captain Dave

Captain Dave

Marine Mechanic

2,672 satisfied customers

USCG Licensed Captain, 20+ Years Boating, Fishing, Maintenance and Repair Experience

< Previous | Next >

Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

Show MoreShow Less

Ask Your Question

x