Boat

Have Boat Questions? Ask a Boat Repair Expert.

Connect one-on-one with {0} who will answer your question

Related Boat Questions
60 hp 4 stroke running very rough at 6K - 7K RPM but fine
60 hp 4 stroke running very rough at 6K - 7K RPM but fine below that … read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade School
21,048 satisfied customers
Just came across this site. Don't know how it works. 2013
Just came across this site. Don't know how it works. … read more
Charles
Charles
Marine Mechanic
Certified Mercury Tech
5,657 satisfied customers
40 hp evinrude ,vro,1993, had no oil horn warning, i did add
40 hp evinrude ,vro,1993, had no oil horn warning, i did add oil, it was low. motor starts fine and revs up strong... motor wont go past approx 2000 rpms, under load, sounds fine, not bogging, i know … read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,409 satisfied customers
I have a 2003 50 HP Mercury Bigfoot motor on a 20 foot
I have a 2003 50 HP Mercury Bigfoot motor on a 20 foot pontoon boat. In neutral it will rev up to 6,200 RPM and set off the alarm. It idles smoothly at 800 RPM. On the lake under load (2 people) the m… read more
Charles
Charles
Marine Mechanic
Certified Mercury Tech
5,657 satisfied customers
Yamaha 115 hp wont go over 3000 rpm. Really bogs down. 41-44
yamaha 115 hp wont go over 3000 rpm. Really bogs down. 41-44 psi under load. Plugs new. Injectors, pressure pump, filters new 8 hours ago.… read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade School
21,048 satisfied customers
I HAVE A 2005 HONDA 4 STROKE 50 HP. MOTOR ON A CAROLINA SKIFF.
I HAVE A 2005 HONDA 4 STROKE 50 HP. MOTOR ON A CAROLINA SKIFF. IN FEB. AND MARCH 2011 THE MOTOR RAN FINE, PUT IT IN THE WATER LAST MONTH AND IT WOULDN'T GO PAST 2500 RPM , IF YOU TRY TO OPEN IT UP, IT… read more
Jeremy R.
Jeremy R.
5,362 satisfied customers
1992 Yamaha 115 HP two stroke jet drive. Started boat and
1992 Yamaha 115 HP two stroke jet drive. Started boat and it ran fine for 2 minutes, then RPM went to 3200 and would go no higher. Replaced plugs, new fuel filters, carbs rebuilt, spark and all that i… read more
Jeremy R.
Jeremy R.
5,362 satisfied customers
I have a 1997 60 hp mercury bigfoot 2 stroke engine. I will
I have a 1997 60 hp mercury bigfoot 2 stroke engine. I will bog down occasionally at 3200 rpms and stall out. I will run under 3200 rpms fine and idle great.… read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade School
21,048 satisfied customers
I have a 1987 Mercruiser 5.7L 260 HP with Alpha 1 drive unit.
I have a 1987 Mercruiser 5.7L 260 HP with Alpha 1 drive unit. It runs great, but at 3200 RPM the engine disengages and RPMs kick up to around 4000 RPM and I usually have to go back to neutral to re-en… read more
Jeremy R.
Jeremy R.
5,362 satisfied customers
I have a 2007 Carver 45 Cockpit Motor Yacht about 37,000 lbs
I have a 2007 Carver 45 Cockpit Motor Yacht about 37,000 lbs with fuel. I have Volvo D6 370 HP inboard engines. I think it's under powered and is very sensitive to Barnacles, wind and currents. It sho… read more
Yachtwork
Yachtwork
Owner Team Yachtwork
Technical or Trade School
1,747 satisfied customers
I have a 115 hp Mercury EFI 4 stroke 2008 ( Latin America version
I have a 115 hp Mercury EFI 4 stroke 2008 ( Latin America version if that matters) that alarm sounds and she cuts out over approx 3200 rpm. The motor seems to run good below 3200, but over somewhere b… read more
Jeff G.
Jeff G.
Marine Mechanic
Vocational, Technical or Trade Scho
4,730 satisfied customers
I have a yamaha 60 hp 4 stroke big foot outboard and on Tuesday
I have a yamaha 60 hp 4 stroke big foot outboard and on Tuesday I ran for aprox full speed which was 25 knots and then switched off for approx 10 minutes. When I tried to start engine, it did not fire… read more
Jason Forsberg
Jason Forsberg
Outboard Marine Mechanic
Vocational, Technical or Trade Scho
531 satisfied customers
I have an Envirude 88 SPL on a 17 Montauk Whaler. Top spped
I have an Envirude 88 SPL on a 17" Montauk Whaler. Top spped about 40. Today was running fine, buzzing along, all of a sudden severe power loss. Now top speed 12mph, +/- 2300 rpm. Check all linkage ev… read more
Jason Forsberg
Jason Forsberg
Outboard Marine Mechanic
Vocational, Technical or Trade Scho
531 satisfied customers
Hi all Im Dutch so i hope you can read my bad English (American) I
Hi all I'm Dutch so i hope you can read my bad English (American) I own a 175 HP Yamaha 2 stroke from 1992. The problem is running above 3200 RPM, the fuel system is checked compleet,pumps are replace… read more
Jeremy R.
Jeremy R.
5,362 satisfied customers
What the story with 2001 Mercury 60 hp 2 stroke. I have been
What the story with 2001 Mercury 60 hp 2 stroke. I have been through 4 (3 under warranty)heads in the past three years, usually number three cylinder goes out. I don't get more than 20 hours on each. … read more
Pappy's Sales and Service
Pappy's Sales and Service
Vocational, Technical or Trade Scho
586 satisfied customers
I have a 2005 Johnson 70 HP 4 stroke outboard that boggs down
I have a 2005 Johnson 70 HP 4 stroke outboard that boggs down & won't run at high RPM's, but runs fine below 3000 RPM's. What is the problem.… read more
Dominick
Dominick
Marine Mechanic
Vocational, Technical or Trade Scho
1,009 satisfied customers
hi, i have a mercury oil injected, carb, 175 hp 1998. it ...
hi, i have a mercury oil injected, carb, 175 hp 1998. it was running fine for about 15 min then lost power and stalled. it will rev high in neutral but will not grt over 1800 rpm in gear. i have drain… read more
Larry B.
Larry B.
Marine Service Tech
High School or GED
574 satisfied customers
Have a Mercury 90 HP 2 stroke 3cyl. Will only produce ...
Have a Mercury 90 HP 2 stroke 3cyl. Will only produce 2800 to 3400 rpm. New Plugs compression 118 each cyl. any suggestions… read more
BC Boat Guy
BC Boat Guy
Lecturer/Instructor
Vocational, Technical or Trade Scho
56 satisfied customers
Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

JustAnswer in the News:

Ask-a-doc Web sites: If you've got a quick question, you can try to get an answer from sites that say they have various specialists on hand to give quick answers... Justanswer.com.
JustAnswer.com...has seen a spike since October in legal questions from readers about layoffs, unemployment and severance.
Web sites like justanswer.com/legal
...leave nothing to chance.
Traffic on JustAnswer rose 14 percent...and had nearly 400,000 page views in 30 days...inquiries related to stress, high blood pressure, drinking and heart pain jumped 33 percent.
Tory Johnson, GMA Workplace Contributor, discusses work-from-home jobs, such as JustAnswer in which verified Experts answer people’s questions.
I will tell you that...the things you have to go through to be an Expert are quite rigorous.

What Customers are Saying:

Wonderful service, prompt, efficient, and accurate. Couldn't have asked for more. I cannot thank you enough for your help.

Mary C.Freshfield, Liverpool, UK

This expert is wonderful. They truly know what they are talking about, and they actually care about you. They really helped put my nerves at ease. Thank you so much!!!!

AlexLos Angeles, CA

Thank you for all your help. It is nice to know that this service is here for people like myself, who need answers fast and are not sure who to consult.

GPHesperia, CA

I couldn't be more satisfied! This is the site I will always come to when I need a second opinion.

JustinKernersville, NC

Just let me say that this encounter has been entirely professional and most helpful. I liked that I could ask additional questions and get answered in a very short turn around.

EstherWoodstock, NY

Thank you so much for taking your time and knowledge to support my concerns. Not only did you answer my questions, you even took it a step further with replying with more pertinent information I needed to know.

RobinElkton, Maryland

He answered my question promptly and gave me accurate, detailed information. If all of your experts are half as good, you have a great thing going here.

DianeDallas, TX

< Previous | Next >

Meet the Experts:

Ted G.

Ted G.

Rigger, Diagnostician

2,242 satisfied customers

40 years boating, Safe boating instruct., Offshore Race promoter, Failure Analysis, Expert Witness

Dominick

Dominick

Marine Mechanic

1,009 satisfied customers

25 Years Experience as Mechanic, 20 Yrs Boat Yard Owner/Mechanic, Factory Certified

John White

John White

Marine Mechanic

306 satisfied customers

11 years experience working on outboards, inboards, sterndrives & pwcs

Jason

Jason

Marine Mechanic

21,048 satisfied customers

Degree in Marine Technology. Gas and diesel marine mechanic.

Tan

Tan

MerCruiser Certified Technician

11,409 satisfied customers

40 yrs. experience with complete engine repairs both inboard/outboard and MerCruiser Certified Technician.

Jeff G.

Jeff G.

Marine Mechanic

4,730 satisfied customers

42 years experience, Certified Master Technician, All Major Outboards, Sterndrives, Hi-Performance

Captain Dave

Captain Dave

Marine Mechanic

2,672 satisfied customers

USCG Licensed Captain, 20+ Years Boating, Fishing, Maintenance and Repair Experience

< Previous | Next >

Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

Show MoreShow Less

Ask Your Question

x