Boat

Have Boat Questions? Ask a Boat Repair Expert.

Connect one-on-one with {0} who will answer your question

Related Boat Questions
New Ranger Comanche 518 L bass boat. 13 hrs on the 200 Pro
New Ranger Comanche 518 L bass boat. 13 hrs on the 200 Pro XS just broke in by the book. The boat fully loaded weighs less than 3000 lbs. The prop is a Mercury Fury 22P. RPM range is 5600 to 6200. All… read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade School
22,804 satisfied customers
Motor will run fine, I'll stop and restart and all is good.
Motor will run fine, I'll stop and restart and all is good. After about 3 start attempts, motor will stall and cannot restart. After a few hours motor will restart with same same problem stated above.… read more
Charles
Charles
Certified Mercury Tech
5,752 satisfied customers
225 merc runs up to 3000 rpm drops to idle. 1998 mercury 225
1998 mercury 225 efi under load goes up to 3000 rpm shuts down and go to idle, fuel pressure is 35 psi … read more
Charles
Charles
Certified Mercury Tech
5,752 satisfied customers
i have a 2004 mercury 225 hp 2 stroke. Motor ran great open
i have a 2004 mercury 225 hp 2 stroke. Motor ran great open throttle,idle etc then leaving the beach, about 30 seconds out the motor dropped from 5,000 rpm to about 2,000 rpm and then shut off. It wou… read more
Charles
Charles
Certified Mercury Tech
5,752 satisfied customers
I recently bought a 2002 Pro-Line 23 sport with a 2003
Jack, I recently bought a 2002 Pro-Line 23 sport with a 2003 Mercury 225 EFI and it seems to run rough from idle to about 1500 rpms but after that it runs great. Any idea what could be causing this? T… read more
orcamarine
orcamarine
Proprietor
Vocational, Technical or Trade Scho
7 satisfied customers
I have a 2007 (bought new in 2010) Mercury EFI 40 with jet
I have a 2007 (bought new in 2010) Mercury EFI 40 with jet drive. According to my dealer it is common for these engines to loose power at higher elevations. The best I can get my Merc to do at high el… read more
Charles
Charles
Certified Mercury Tech
5,752 satisfied customers
I have a Mercury 225 2 stroke efi engine that is running erratic.
I have a Mercury 225 2 stroke efi engine that is running erratic. The engine is hard to start. Once started rpm is erratic and the engine seems to be missing and not a dead miss. Once you put in gear … read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,409 satisfied customers
I have a 1999 Mercury 225 EFI ...the last 2 times i had the
I have a 1999 Mercury 225 EFI ...the last 2 times i had the boat out this what happened...1st time...got the boat up on plane and was running around 50mph(5200-5400rpm)and the rpms died and motor cut … read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade School
22,804 satisfied customers
I have a 1998 mariner 225. Its completely rebuilt and installed
I have a 1998 mariner 225. Its completely rebuilt and installed on my boat. When at the boat ramp I can hit the throttle and spinds right up. Ill start going down the channel and it will start spittin… read more
James
James
Certified Marine Mechanic
Vocational, Technical or Trade Scho
4,094 satisfied customers
i am purchasing a 2001 scarab 29 open sport with twin 225 efi
i am purchasing a 2001 scarab 29 open sport with twin 225 efi engines they only turn 5200 with 19 pitch props and the compression ratios range from 110 to 115. is this normal for this setup. both sets… read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade School
22,804 satisfied customers
what should the rpm range be for this model 21 semi v hull
what should the rpm range be for this model 21' semi v hull 2200#(Renegade powerboat) mirage plus 14x21… read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,409 satisfied customers
I have a 2001 Mercury 250XL EFI motor on my 26 angler panga
I have a 2001 Mercury 250XL EFI motor on my 26' angler panga boat...I'm running a 19P Rev 4 prop...going out in the morning I'm turning 5800 to 6000 rpm depending on trim setting....on the way back in… read more
Jeff G.
Jeff G.
Marine Mechanic
4,730 satisfied customers
I have 2001 mercury 200hp XL EFI 2-stroke on a 23 Trophy.
I have 2001 mercury 200hp XL EFI 2-stroke on a 23' Trophy. I just bought the Boat. It was not used in 2008. My 3rd time out ....first 2 were light usage......learning.... never exceeding 3800 rpm's. S… read more
Dominick
Dominick
Marine Mechanic
Vocational, Technical or Trade Scho
1,009 satisfied customers
Jack, I have a Mercury 225 EFI on a Boston Whaler 21 Outrage.
Jack, I have a Mercury 225 EFI on a Boston Whaler 21 Outrage. The motor was built about 2001. Runs really well, except my battery only lasts about 4 hours. Does this motor have an alternator? If so, d… read more
Pappy's Sales and Service
Pappy's Sales and Service
Vocational, Technical or Trade Scho
586 satisfied customers
Honda 45 hp. 93 or 94 I think. runs fine under load up
Honda 45 hp. '93 or '94 I think. runs fine under load up to about 2200 rpm. then cuts out. Reducing throttle quick enough will allow it to start firing again. Otherwise has to be restarted. Will hold … read more
Captain Dave
Captain Dave
Charter Captain & I.S. Director
Master's Degree
2,808 satisfied customers
I have a 1998 225 EFI 2 stroke outboared..I cannot get 4500
I have a 1998 225 EFI 2 stroke outboared..I cannot get 4500 rpm and when I trim the motor up, it will go to 4900 rpm, thats it..When I first go full throttle it goes to 3000 rpm..After a little bit it… read more
Mechman45
Mechman45
Vocational, Technical or Trade School
152 satisfied customers
motor is running on port top cylinder and starboard bottom
motor is running on port top cylinder and starboard bottom cylinder no spark to other four cylinders 01 mercury 225 efi… read more
Pappy's Sales and Service
Pappy's Sales and Service
Vocational, Technical or Trade Scho
586 satisfied customers
I have a mercury 96 225 efi . my question is at 3000 rpm the
I have a mercury 96 225 efi . my question is at 3000 rpm the engine miss and when going at idle speed with the motor trimed up it will lose power and die. Any other time it run great… read more
Dominick
Dominick
Marine Mechanic
Vocational, Technical or Trade Scho
1,009 satisfied customers
Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

JustAnswer in the News:

Ask-a-doc Web sites: If you've got a quick question, you can try to get an answer from sites that say they have various specialists on hand to give quick answers... Justanswer.com.
JustAnswer.com...has seen a spike since October in legal questions from readers about layoffs, unemployment and severance.
Web sites like justanswer.com/legal
...leave nothing to chance.
Traffic on JustAnswer rose 14 percent...and had nearly 400,000 page views in 30 days...inquiries related to stress, high blood pressure, drinking and heart pain jumped 33 percent.
Tory Johnson, GMA Workplace Contributor, discusses work-from-home jobs, such as JustAnswer in which verified Experts answer people’s questions.
I will tell you that...the things you have to go through to be an Expert are quite rigorous.

What Customers are Saying:

Wonderful service, prompt, efficient, and accurate. Couldn't have asked for more. I cannot thank you enough for your help.

Mary C.Freshfield, Liverpool, UK

This expert is wonderful. They truly know what they are talking about, and they actually care about you. They really helped put my nerves at ease. Thank you so much!!!!

AlexLos Angeles, CA

Thank you for all your help. It is nice to know that this service is here for people like myself, who need answers fast and are not sure who to consult.

GPHesperia, CA

I couldn't be more satisfied! This is the site I will always come to when I need a second opinion.

JustinKernersville, NC

Just let me say that this encounter has been entirely professional and most helpful. I liked that I could ask additional questions and get answered in a very short turn around.

EstherWoodstock, NY

Thank you so much for taking your time and knowledge to support my concerns. Not only did you answer my questions, you even took it a step further with replying with more pertinent information I needed to know.

RobinElkton, Maryland

He answered my question promptly and gave me accurate, detailed information. If all of your experts are half as good, you have a great thing going here.

DianeDallas, TX

< Previous | Next >

Meet the Experts:

Ted G.

Ted G.

Rigger, Diagnostician

3,936 satisfied customers

40 years boating, Safe boating instruct., Offshore Race promoter, Failure Analysis, Expert Witness

Dominick

Dominick

Marine Mechanic

1,009 satisfied customers

25 Years Experience as Mechanic, 20 Yrs Boat Yard Owner/Mechanic, Factory Certified

John White

John White

Marine Mechanic

306 satisfied customers

11 years experience working on outboards, inboards, sterndrives & pwcs

Jason

Jason

Marine Mechanic

22,804 satisfied customers

Degree in Marine Technology. Gas and diesel marine mechanic.

Tan

Tan

MerCruiser Certified Technician

11,409 satisfied customers

40 yrs. experience with complete engine repairs both inboard/outboard and MerCruiser Certified Technician.

Jeff G.

Jeff G.

Marine Mechanic

4,730 satisfied customers

42 years experience, Certified Master Technician, All Major Outboards, Sterndrives, Hi-Performance

Noel Schembri

Noel Schembri

Marine Mechanic

2,759 satisfied customers

Advanced technical diploma

< Previous | Next >

Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

Show MoreShow Less

Ask Your Question

x