Boat

Have Boat Questions? Ask a Boat Repair Expert.

Connect one-on-one with {0} who will answer your question

Related Boat Questions
Had a quick question on a bravo to outdrive one installed
Good morning Jason had a quick question on a bravo to outdrive one installed into the bell housing what actually seals the U joint Bellows from water getting in there are no O-rings of any kind around… read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade School
22,043 satisfied customers
DXP outdrive when connected to water thru engine when
DXP outdrive when connected to water thru engine when flushing engine there seems to be a very small leak pin hole like when engine is running from Bellows. is there a one way leak hole in bellows or … read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,507 satisfied customers
I Tan.. I was getting loud noise from the gimbal bearing so
I Tan.. I was getting loud noise from the gimbal bearing so I decided to change it. The only thing is that I changed it last summer. As I was loosening the six outdrive screw apart, I noticed water co… read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,507 satisfied customers
Hi Tan.. I noticed more water than usual in the bilge the
Hi Tan.. I noticed more water than usual in the bilge the last time the boat was used. The last day I had it in the water and could not engage gear it was on water for 2 hours and did not see any wate… read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,507 satisfied customers
hi tan,I have a bravo3 SN#0W971391problem gear lube leak
hi tan, I have a bravo3 SN#0W971391 problem gear lube leak between bell housing and upper shaft drive housing starboard side. I have several quistions. 1: is the u joint inside the u joint bellow lubr… read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,507 satisfied customers
I have a 1984 bayliner with the v/p I/O and cant seem to get
I have a 1984 bayliner with the v/p I/O and cant seem to get it to idle under 800 rpms. Carb cover says timing should be 6 or 8 deg btdc at 650 rpm. This is a 5.7 with a 280 outdrive that will run gre… read more
K. Kergan
K. Kergan
Inboard/Outboard Mechanic
Vocational, Technical or Trade Scho
1,031 satisfied customers
Hi, I am changing the u-joint bellows in my alpha one, gen
Hi, I am changing the u-joint bellows in my alpha one, gen 1 outdrive. I assume you need to remove the bell housing for this repair. Is this correct? If so, is there any way I can remove the bell hous… read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,507 satisfied customers
1987 Merc Alpha One. Found after freezing winter storage to
1987 Merc Alpha One. Found after freezing winter storage to have a cracked propeller hub, all gearcase oil on garage floor. Removed outdrive, found water in U-joint bellows, but cannot see or feel any… read more
K. Kergan
K. Kergan
Inboard/Outboard Mechanic
Vocational, Technical or Trade Scho
1,031 satisfied customers
I took my boat to the dealer and he tells me the shift bellows
I took my boat to the dealer and he tells me the shift bellows is leaking, but he doesn't think that is where the water is coming from. Has not found any leaks in the engine, manifolds, or outdrive th… read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,507 satisfied customers
My outdrive reservoir keeps losing oil. It will drain from
My outdrive reservoir keeps losing oil. It will drain from full line to almost empty in less than 30 minutes of running. The outdrive was full before I ran (opened vent hole at top of side of Bravo an… read more
K. Kergan
K. Kergan
Inboard/Outboard Mechanic
Vocational, Technical or Trade Scho
1,031 satisfied customers
Hello, I have a mercruiser 1987 Alpha one, Generation One
Hello, I have a mercruiser 1987 Alpha one, Generation One outdrive that leaks outdrive fluid and water into the bilge. In the summer of 2010 I noticed that the outdrive oil reservoir level would drop … read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,507 satisfied customers
BRAVO one gear oil leaking into bellows and backing into the
BRAVO one gear oil leaking into bellows and backing into the bilge. Reservior tube not leaking at fitting into transom assembly and check valve in outdrive is clean. Where could the sourse of the leak… read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,507 satisfied customers
On a Mercruiser Bravo Two Drive 1996, what should be the average
On a Mercruiser Bravo Two Drive 1996, what should be the average cost to have a SHOP replace the u-joint BELLOWS? I have water leaking into the bilge - (about 1 gallon after 6 hrs. on the water). I ca… read more
Ted G.
Ted G.
Rigger, Diagnostician
Vocational, Technical or Trade Scho
2,678 satisfied customers
I have 2008 bravo 3 outdrive (1 1/2 yrs old/100 hrs, boat keep
I have 2008 bravo 3 outdrive (1 1/2 yrs old/100 hrs, boat keep in water) and my gimble bearing/u-joints, the bearing between the engine and outdrive are completely gone...The bellows were full of wate… read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,507 satisfied customers
hi i have just got a 2006 bayliner 195 with a mercruiser 3.0/alpha
hi i have just got a 2006 bayliner 195 with a mercruiser 3.0/alpha one drive.gear lube tank empties after an hour cruising and the seems to be in the bilge… read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,507 satisfied customers
I have a 1996 Maxum 32 SCR with 7.4 L mercruiser engines with
I have a 1996 Maxum 32 SCR with 7.4 L mercruiser engines with Bravo III drives. I have a water leak which looks to be at the very rear of engine on the bottom where the cast iron exhaust bellows meet … read more
James
James
Certified Marine Mechanic
Vocational, Technical or Trade Scho
4,094 satisfied customers
my bravo 2 prop outdrive gets water in it after every season
my bravo 2 prop outdrive gets water in it after every season of use. the dealer says the vent might be getting swamped by the bilge. can you identify the vent location [picture] or suggest a cure? tha… read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,507 satisfied customers
Have a Century 2000 with a Mercruiser 228 serial number(NNN) NNN-NNNN
Have a Century 2000 with a Mercruiser 228 serial number(NNN) NNN-NNNN We put in a new drain plug. When we put the boat in the water and run for a about 1/2 hour we get a small amount of water in the b… read more
Larry B.
Larry B.
Marine Service Tech
High School or GED
574 satisfied customers
Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

JustAnswer in the News:

Ask-a-doc Web sites: If you've got a quick question, you can try to get an answer from sites that say they have various specialists on hand to give quick answers... Justanswer.com.
JustAnswer.com...has seen a spike since October in legal questions from readers about layoffs, unemployment and severance.
Web sites like justanswer.com/legal
...leave nothing to chance.
Traffic on JustAnswer rose 14 percent...and had nearly 400,000 page views in 30 days...inquiries related to stress, high blood pressure, drinking and heart pain jumped 33 percent.
Tory Johnson, GMA Workplace Contributor, discusses work-from-home jobs, such as JustAnswer in which verified Experts answer people’s questions.
I will tell you that...the things you have to go through to be an Expert are quite rigorous.

What Customers are Saying:

Wonderful service, prompt, efficient, and accurate. Couldn't have asked for more. I cannot thank you enough for your help.

Mary C.Freshfield, Liverpool, UK

This expert is wonderful. They truly know what they are talking about, and they actually care about you. They really helped put my nerves at ease. Thank you so much!!!!

AlexLos Angeles, CA

Thank you for all your help. It is nice to know that this service is here for people like myself, who need answers fast and are not sure who to consult.

GPHesperia, CA

I couldn't be more satisfied! This is the site I will always come to when I need a second opinion.

JustinKernersville, NC

Just let me say that this encounter has been entirely professional and most helpful. I liked that I could ask additional questions and get answered in a very short turn around.

EstherWoodstock, NY

Thank you so much for taking your time and knowledge to support my concerns. Not only did you answer my questions, you even took it a step further with replying with more pertinent information I needed to know.

RobinElkton, Maryland

He answered my question promptly and gave me accurate, detailed information. If all of your experts are half as good, you have a great thing going here.

DianeDallas, TX

< Previous | Next >

Meet the Experts:

Ted G.

Ted G.

Rigger, Diagnostician

2,678 satisfied customers

40 years boating, Safe boating instruct., Offshore Race promoter, Failure Analysis, Expert Witness

Dominick

Dominick

Marine Mechanic

1,009 satisfied customers

25 Years Experience as Mechanic, 20 Yrs Boat Yard Owner/Mechanic, Factory Certified

John White

John White

Marine Mechanic

306 satisfied customers

11 years experience working on outboards, inboards, sterndrives & pwcs

Jason

Jason

Marine Mechanic

22,043 satisfied customers

Degree in Marine Technology. Gas and diesel marine mechanic.

Tan

Tan

MerCruiser Certified Technician

11,507 satisfied customers

40 yrs. experience with complete engine repairs both inboard/outboard and MerCruiser Certified Technician.

Jeff G.

Jeff G.

Marine Mechanic

4,730 satisfied customers

42 years experience, Certified Master Technician, All Major Outboards, Sterndrives, Hi-Performance

Captain Dave

Captain Dave

Marine Mechanic

2,672 satisfied customers

USCG Licensed Captain, 20+ Years Boating, Fishing, Maintenance and Repair Experience

< Previous | Next >

Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

Show MoreShow Less

Ask Your Question

x