Boat

Have Boat Questions? Ask a Boat Repair Expert.

Connect one-on-one with {0} who will answer your question

Related Boat Questions
Merc 5.0 Bravo 3 restricted raw water transom assembly
merc 5.0 Bravo 3 restricted raw water transom assembly disimalar metal connetot known problem, want to install alternate source thru hull water source not sure where to connect to. … read more
Ted G.
Ted G.
Rigger, Diagnostician
Vocational, Technical or Trade Scho
3,332 satisfied customers
I have dual V8 engines. One engine temperature gauge read
I have dual V8 engines. One engine temperature gauge read hot. At idle, it stays in green (middle of the gauge), on a sea trial at speed it eventually goes into the red. The port side riser runs hotte… read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade School
24,896 satisfied customers
I have a '93 OMC Cobra outdrive 5 liter Ford-based engine. I
I have a '93 OMC Cobra outdrive 5 liter Ford-based engine. I have a serious overheat problem. One complete sieze-up which required engine rebuild and 3 additional primary water pump complete meltdowns… read more
James
James
Certified Marine Mechanic
Vocational, Technical or Trade Scho
4,094 satisfied customers
Hey Jason, I have twin bravo 3 drives with 496 mercs. My Starboard engine runs 30 degrees
Hey Jason, I have twin bravo 3 drives with 496 mercs. My Starboard engine runs 30 degrees hotter than port and the exhaust overheat alarm sounds above 3400 rpm and guardian kicks in. The temp gauge sh… read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade School
24,896 satisfied customers
Mercruise 260 hp 5.7l Thunderbolt iv ignition 1988. starboard
Mercruise 260 hp 5.7l Thunderbolt iv ignition 1988. starboard motor bogged out, there was a smell of something burning...no temperature reading oil pressure slightly higher than port side motor. resta… read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade School
24,896 satisfied customers
Have 2001 Baja 212 Islander with 6.2 Mercruiser MX EFI with
Have 2001 Baja 212 Islander with 6.2 Mercruiser MX EFI with Bravo One outdrive. I have noticed that the starboard riser eventually gets to hot to touch for longer than a second, the port riser is warm… read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade School
24,896 satisfied customers
I have a 77 OMC 140hp and all new motor etc. It would die
I have a 77 OMC 140hp and all new motor etc. It would die back and get rough running( sort of vibration feeling) with no misfire or backfire, I'd back off throttle and at about 1500 RPM it would smoot… read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade School
24,896 satisfied customers
Hello, My elderly friend has a 1976 Bayliner with a 305 Chev
Hello, My elderly friend has a 1976 Bayliner with a 305 Chev V8 and a Volvo Penta 280 Outdrive. I am a heavy Duty mechanic and he has asked me to try and help him out. When we go fishing down here in … read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,409 satisfied customers
Mercruiser 228 MCM over heating I replaced the lower unit
Mercruiser 228 MCM over heating I replaced the lower unit of the outdrive with a new (used) one. I also put in a new water pump impeller and housing. Now the engine is over heating. It goes to the red… read more
James
James
Certified Marine Mechanic
Vocational, Technical or Trade Scho
4,094 satisfied customers
I have a Bell exhaust tube that is spraying water. 350 mercruiser.
I have a Bell exhaust tube that is spraying water. 350 mercruiser. Do I need to pull it out of the water to replace and is it that difficult to install?… read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade School
24,896 satisfied customers
hi,i have 1986 volvo190 power trim out drive twin unit with
hi,i have 1986 volvo 290 power trim out drive twin unit's with power steering ,my port out .drive steering yoke is no longer engaged to the arm inside. the out drive is swinging free what do you sugge… read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade School
24,896 satisfied customers
1998 5.7 fresh water only cooled engines that overheat (both
1998 5.7 fresh water only cooled engines that overheat (both at different times) whenever we attempt to get the boat (1998 silverton 31.2 flybridge cruiser) up on plane. We have tried tie following: r… read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,409 satisfied customers
converted my v8 mercruiser log stye manifold system to the
converted my v8 mercruiser log stye manifold system to the Center rise model...The problem is that one side of the exhaust runs warm and the other side runs hot ? The temp guage on dash is normal...Wh… read more
Kenny
Kenny
Mercury & Mercruiser Diagnostics
Master's Degree
99 satisfied customers
I have an 89 Donzi Regazza that is starting to leak oil and
I have an '89 Donzi Regazza that is starting to leak oil and has serious spark knock at high acceleration. Use to run 50MPH top end now tops is maybe 44. Should I: A. Buy a crate engine. B. Replace ne… read more
John White
John White
Marine Mechanic
Vocational, Technical or Trade Scho
306 satisfied customers
Hey guys, Im disabled and cant afford brand new engines.
Hey guys, I'm disabled and can't afford brand new engines. I have a 30 ft. pacemaker sf powered by crusader model 220's some have told me they are 305 's and some have told me they are 350's 260 hp, t… read more
capt ron 1959
capt ron 1959
Owner/Marine Mechanic
Vocational, Technical or Trade Scho
348 satisfied customers
Starboard engine running 25 degrees hotter than port enginge.
Starboard engine running 25 degrees hotter than port enginge. Both engines sound like they are running smooth. Impeller is fine in starboard engine and there is nothing impeding water flow. 2 weeks ag… read more
capt ron 1959
capt ron 1959
Owner/Marine Mechanic
Vocational, Technical or Trade Scho
348 satisfied customers
502 BBc 9to 1 compression, Merc 500 hp cam, Demon marine 750
502 BBc 9to 1 compression, Merc 500 hp cam, Demon marine 750 carb, MSD ignition running 32 Degrees total advance. Runs great to about 4200 rpm and destroys pistons at about 4300. two motors in a row, … read more
Pappy's Sales and Service
Pappy's Sales and Service
Vocational, Technical or Trade Scho
586 satisfied customers
How to remove injectors in a 6 cylinder Caterpiller diesel?
I have a 6 cylinder 540 HP Caterpiller diesel engine 3406b in my 77 ft. trawler. I need to remove injectors to turn motor over with no compression. Water has gone down the exhaust and I need to releas… read more
Dan Boy
Dan Boy
Amusement ride technician
High School or GED
110 satisfied customers
Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

JustAnswer in the News:

Ask-a-doc Web sites: If you've got a quick question, you can try to get an answer from sites that say they have various specialists on hand to give quick answers... Justanswer.com.
JustAnswer.com...has seen a spike since October in legal questions from readers about layoffs, unemployment and severance.
Web sites like justanswer.com/legal
...leave nothing to chance.
Traffic on JustAnswer rose 14 percent...and had nearly 400,000 page views in 30 days...inquiries related to stress, high blood pressure, drinking and heart pain jumped 33 percent.
Tory Johnson, GMA Workplace Contributor, discusses work-from-home jobs, such as JustAnswer in which verified Experts answer people’s questions.
I will tell you that...the things you have to go through to be an Expert are quite rigorous.

What Customers are Saying:

Wonderful service, prompt, efficient, and accurate. Couldn't have asked for more. I cannot thank you enough for your help.

Mary C.Freshfield, Liverpool, UK

This expert is wonderful. They truly know what they are talking about, and they actually care about you. They really helped put my nerves at ease. Thank you so much!!!!

AlexLos Angeles, CA

Thank you for all your help. It is nice to know that this service is here for people like myself, who need answers fast and are not sure who to consult.

GPHesperia, CA

I couldn't be more satisfied! This is the site I will always come to when I need a second opinion.

JustinKernersville, NC

Just let me say that this encounter has been entirely professional and most helpful. I liked that I could ask additional questions and get answered in a very short turn around.

EstherWoodstock, NY

Thank you so much for taking your time and knowledge to support my concerns. Not only did you answer my questions, you even took it a step further with replying with more pertinent information I needed to know.

RobinElkton, Maryland

He answered my question promptly and gave me accurate, detailed information. If all of your experts are half as good, you have a great thing going here.

DianeDallas, TX

< Previous | Next >

Meet the Experts:

Ted G.

Ted G.

Rigger, Diagnostician

3,332 satisfied customers

40 years boating, Safe boating instruct., Offshore Race promoter, Failure Analysis, Expert Witness

Dominick

Dominick

Marine Mechanic

1,009 satisfied customers

25 Years Experience as Mechanic, 20 Yrs Boat Yard Owner/Mechanic, Factory Certified

John White

John White

Marine Mechanic

306 satisfied customers

11 years experience working on outboards, inboards, sterndrives & pwcs

Jason

Jason

Marine Mechanic

24,896 satisfied customers

Degree in Marine Technology. Gas and diesel marine mechanic.

Tan

Tan

MerCruiser Certified Technician

11,409 satisfied customers

40 yrs. experience with complete engine repairs both inboard/outboard and MerCruiser Certified Technician.

Jeff G.

Jeff G.

Marine Mechanic

4,730 satisfied customers

42 years experience, Certified Master Technician, All Major Outboards, Sterndrives, Hi-Performance

Noel Schembri

Noel Schembri

Marine Mechanic

2,759 satisfied customers

Advanced technical diploma

< Previous | Next >

Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

Show MoreShow Less

Ask Your Question

x