Boat

Have Boat Questions? Ask a Boat Repair Expert.

Connect one-on-one with {0} who will answer your question

Related Boat Questions
I have a 2004 Yamaha XLT1200. I'm having an issue where the
I have a 2004 Yamaha XLT1200. I'm having an issue where the jet ski wont go over about 15 mph and dies if you quickly pull the throttle. I have replaced all the seals in the carbs, replaced all the fu… read more
RSRBOB
RSRBOB
MC / Pwc Shop Owner
Vocational, Technical or Trade Scho
457 satisfied customers
I'm jeff i just got off the water today after a rebuilt carb
i'm jeff i just got off the water today after a rebuilt carb swap by a mercruiser cert tech. and the motor goes to full throttle fine from idle with just a little lag, but if i throttle slowly or thro… read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,409 satisfied customers
motor starts fine but now all of the sudden I get up to 2800
motor starts fine but now all of the sudden I get up to 2800 rpm it starts to sputter and then I must back throttle down . I changed fuel filter and also water/gas fltr .I also cleaned all 4 fuel inje… read more
briggs archer
briggs archer
master marine mechanic
Associate Degree
403 satisfied customers
Previous questions resolved. New question. Engine runs ruff
Previous questions resolved. New question. Engine runs ruff / shakes until above 4300rpms. It starts easy, does not bog down when you take off. But is lacking some power and seems like one cylinder is… read more
Charles
Charles
Marine Mechanic
Certified Mercury Tech
5,754 satisfied customers
My jet ski runs fine for a few seconds, then bogs down a few
My jet ski runs fine for a few seconds, then bogs down a few seconds then repeats over and over. I recently purchased the ski from a marine mechanic. He had just rebuilt both carbs and put in all new … read more
Jeremy R.
Jeremy R.
5,362 satisfied customers
I purchased. A used 98 Sea Doo XP with 50 hours on it. Both
I purchased. A used 98 Sea Doo XP with 50 hours on it. Both carbs has just been rebuilt by a mechanic. Other then a brief bog coming off idel its been running great. Yesterday I noticed if I stay near… read more
Chris
Chris
Senior Mechanic & Technician
Factory Training
163 satisfied customers
I have a 1995 OMC Cobra (Volvo Penta) 5.0 L Ford V8 I/O in
I have a 1995 OMC Cobra (Volvo Penta) 5.0 L Ford V8 I/O in a 1995 Four Winns 190 Horizon with two problems. Sunday the ignition was on, all the guages were up, the blower was on and ready to go. We hi… read more
orcamarine
orcamarine
Proprietor
Vocational, Technical or Trade Scho
7 satisfied customers
i have a 2003 60hp mercury bigfoot rebuilt carbs set float
i have a 2003 60hp mercury bigfoot rebuilt carbs set float from carb body at 9/16 as service manuel indicated. set linkage to service manaul instructions set idle timing to from 2 degree btdc and two … read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,409 satisfied customers
2000 Yamaha 1200 XL PWC. Need to know what the black knob adjustment
2000 Yamaha 1200 XL PWC. Need to know what the black knob adjustment is for that goes to the carbs. It has a screwdiver slot on top.… read more
Chris
Chris
Senior Mechanic & Technician
Factory Training
163 satisfied customers
1996 Yamaha Wave Venture 700 bogs when hot(not thermal)
Hello, I have a pair of 1996 Yamaha Wave Venture 700's that my family enjoys. The last half dozen times we've taken them out, one of them starts bogging down when it gets hot. It started doing this af… read more
James
James
Certified Marine Mechanic
Vocational, Technical or Trade Scho
4,094 satisfied customers
1997 gsx seadoo has a persistent problem. Around 5000 rpm cruising
1997 gsx seadoo has a persistent problem. Around 5000 rpm cruising speed, the machine boggles down even though you push on the throttle. Pushing it twice always gets it to respond though. Also from id… read more
James
James
Certified Marine Mechanic
Vocational, Technical or Trade Scho
4,094 satisfied customers
I have a 2004 Yamaha 60hp 4 stroke, purchased new by me. It
I have a 2004 Yamaha 60hp 4 stroke, purchased new by me. It now has 1300 hrs. and has developed a mid range hesitation or 'bogging' when accelerating. It idles a little rough, but trolls fine from 120… read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade School
22,043 satisfied customers
No Power from Yamaha Waverunner - 2 MPH. I asked the following
No Power from Yamaha Waverunner - 2 MPH. I asked the following question: http://www.justanswer.com/questions/3nlib-no-power-from-yamaha-waverunner-2-mph-i-have-a-2001-yamaha here is what i have done: … read more
RSRBOB
RSRBOB
MC / Pwc Shop Owner
Vocational, Technical or Trade Scho
457 satisfied customers
when i start my boat up it runs great for about 15 minutes
when i start my boat up it runs great for about 15 minutes and then bogs down and i cannot get any rpms. it still starts good and idles ok but will not rev up without bogging down. i had the carbureto… read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,409 satisfied customers
i have a 1989 340DA sea ray with twin 7.4 carb. while out
i have a 1989 340DA sea ray with twin 7.4 carb. while out on the boat last night.. about 40 mins into the cruise heard a "bump" behind myself (starboard engine) sounded like someone closing a cabinet.… read more
capt ron 1959
capt ron 1959
Owner/Marine Mechanic
Vocational, Technical or Trade Scho
348 satisfied customers
when you open the throttle the seadoo bogs down and will only
when you open the throttle the seadoo bogs down and will only go about 20 mph. We have changed the gas, plugs, and adjusted the carbs. Any other suggestions?… read more
Joe
Joe
Owner Kingsland Auto & Marine Services
Vocational, Technical or Trade Scho
1,396 satisfied customers
Hello. I have a 1999 Mercury 150 that has been giving me problems
Hello. I have a 1999 Mercury 150 that has been giving me problems recently. I used it about 2.5 months ago with not problems, but two weeks ago, it was hard to start and eventually died when I came to… read more
ROCKET
ROCKET
MASTER CERTIFIED TECH
Vocational, Technical or Trade Scho
426 satisfied customers
I have a Kawasaki Ultra 150. Runs rough and bogs down at about
I have a Kawasaki Ultra 150. Runs rough and bogs down at about 4000 rpm.Was in shop twice last season but never ran the way it had before.… read more
Jeremy R.
Jeremy R.
5,362 satisfied customers
Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

JustAnswer in the News:

Ask-a-doc Web sites: If you've got a quick question, you can try to get an answer from sites that say they have various specialists on hand to give quick answers... Justanswer.com.
JustAnswer.com...has seen a spike since October in legal questions from readers about layoffs, unemployment and severance.
Web sites like justanswer.com/legal
...leave nothing to chance.
Traffic on JustAnswer rose 14 percent...and had nearly 400,000 page views in 30 days...inquiries related to stress, high blood pressure, drinking and heart pain jumped 33 percent.
Tory Johnson, GMA Workplace Contributor, discusses work-from-home jobs, such as JustAnswer in which verified Experts answer people’s questions.
I will tell you that...the things you have to go through to be an Expert are quite rigorous.

What Customers are Saying:

Wonderful service, prompt, efficient, and accurate. Couldn't have asked for more. I cannot thank you enough for your help.

Mary C.Freshfield, Liverpool, UK

This expert is wonderful. They truly know what they are talking about, and they actually care about you. They really helped put my nerves at ease. Thank you so much!!!!

AlexLos Angeles, CA

Thank you for all your help. It is nice to know that this service is here for people like myself, who need answers fast and are not sure who to consult.

GPHesperia, CA

I couldn't be more satisfied! This is the site I will always come to when I need a second opinion.

JustinKernersville, NC

Just let me say that this encounter has been entirely professional and most helpful. I liked that I could ask additional questions and get answered in a very short turn around.

EstherWoodstock, NY

Thank you so much for taking your time and knowledge to support my concerns. Not only did you answer my questions, you even took it a step further with replying with more pertinent information I needed to know.

RobinElkton, Maryland

He answered my question promptly and gave me accurate, detailed information. If all of your experts are half as good, you have a great thing going here.

DianeDallas, TX

< Previous | Next >

Meet the Experts:

Ted G.

Ted G.

Rigger, Diagnostician

2,678 satisfied customers

40 years boating, Safe boating instruct., Offshore Race promoter, Failure Analysis, Expert Witness

Dominick

Dominick

Marine Mechanic

1,009 satisfied customers

25 Years Experience as Mechanic, 20 Yrs Boat Yard Owner/Mechanic, Factory Certified

John White

John White

Marine Mechanic

306 satisfied customers

11 years experience working on outboards, inboards, sterndrives & pwcs

Jason

Jason

Marine Mechanic

22,043 satisfied customers

Degree in Marine Technology. Gas and diesel marine mechanic.

Tan

Tan

MerCruiser Certified Technician

11,409 satisfied customers

40 yrs. experience with complete engine repairs both inboard/outboard and MerCruiser Certified Technician.

Jeff G.

Jeff G.

Marine Mechanic

4,730 satisfied customers

42 years experience, Certified Master Technician, All Major Outboards, Sterndrives, Hi-Performance

Captain Dave

Captain Dave

Marine Mechanic

2,672 satisfied customers

USCG Licensed Captain, 20+ Years Boating, Fishing, Maintenance and Repair Experience

< Previous | Next >

Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

Show MoreShow Less

Ask Your Question

x