Boat

Have Boat Questions? Ask a Boat Repair Expert.

Connect one-on-one with {0} who will answer your question

Related Boat Questions
I have a 2005 9.9 four stroke outboard that I use on my sail
I have a 2005 Johnson 9.9 four stroke outboard that I use on my sail boat. It was used but only had a bout 10 hours on it and looked like new, ran like crap because the guy never used it and the carb … read more
Joe
Joe
Owner Kingsland Auto & Marine Services
Vocational, Technical or Trade Scho
1,392 satisfied customers
I have a yahama hpdi 200 outboard 4 stroke. recently had to
I have a yahama hpdi 200 outboard 4 stroke. recently had to replace fuel tank due to leak. boat sat for 3 seasons. now will run for couple minutes- try to come up on plane and shuts offs. will crank b… read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade School
18,955 satisfied customers
Mercury 150 four stroke: I have a 2013 mercury 150 four stroke On
I have a 2013 mercury 150 four stroke On the lake today when I went to give it full throttle it would start to cut out at 2200 rpm sounded like it as missing real bad. I noticed my trim gauge not work… read more
Charles
Charles
Certified Mercury Tech
5,523 satisfied customers
I have a B100 according to the serial number plate (BF100 manual
I have a B100 according to the serial number plate (BF100 manual seems to match perfectly) 10hp (9.9?)hp which I believe is a 1984 model outboard. It starts fine and runs for extended periods when idl… read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade School
18,955 satisfied customers
Hello, Im tuning up my 1992 Evinrude 6 HP 2 stroke/2 cylinder
Hello, I'm tuning up my 1992 Evinrude 6 HP 2 stroke/2 cylinder outboard. In US usenet pages, I read about a guy who replaced the carb of his 6 HP OMC outboard with a 9.9 HP carb and inserted custom po… read more
Jeff G.
Jeff G.
Marine Mechanic
Vocational, Technical or Trade Scho
4,730 satisfied customers
I have a 1981 Evinrude 15 hp model E15RCIS still running. Ive
I have a 1981 Evinrude 15 hp model E15RCIS still running. I've applied to XXXXX for hearing loss and they are claiming my exposure to an outboard engine is a contributing factor. Do you have any Db ra… read more
Jeff G.
Jeff G.
Marine Mechanic
Vocational, Technical or Trade Scho
4,730 satisfied customers
I have a Mercury outboard, 4 stroke, 9.9 hp motor that is about
I have a Mercury outboard, 4 stroke, 9.9 hp motor that is about 4 years old. Recently the motor has begun to stall out after running for about 10 to 15 minutes at full throttle speed. When the motor s… read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade School
18,955 satisfied customers
my outboard 115 hp (1997) often dies while at a slow trolling
my outboard 115 hp (1997) often dies while at a slow trolling speed--It will kick hard and just die--always restarts easily. Have had the carbs gone thru with kits by local dealership(Marine)… read more
Michael
Michael
master marine technician/charter captain
Vocational, Technical or Trade Scho
256 satisfied customers
Dear Sirs, i own a 1990,Evirude 90 hp outboard. I have a trolling
Dear Sirs, i own a 1990,Evirude 90 hp outboard. I have a trolling plate on it and lately after approx. 40 minutes of trolling the engine starts to stall out and will not idle smoothly. It will start a… read more
Michael
Michael
master marine technician/charter captain
Vocational, Technical or Trade Scho
256 satisfied customers
I have a 1999 Force outboard and it stalls while at a slow
I have a 1999 Force outboard and it stalls while at a slow troll. I find that after it stalls the primer bulb is soft, and after priming the engine starts up again. Is it stalling at a slow troll beca… read more
orcamarine
orcamarine
Proprietor
Vocational, Technical or Trade Scho
7 satisfied customers
I have a 9.9 HP Evinrude 4 stroke. I believe it is a late 90s
I have a 9.9 HP Evinrude 4 stroke. I believe it is a late 90's or early 2000's model. I am not positive because it came with a used pontoon I bought three years ago. The first year I had no trouble an… read more
K. Kergan
K. Kergan
Inboard/Outboard Mechanic
Vocational, Technical or Trade Scho
1,031 satisfied customers
I am looking for a pair of outboard engines for my boat. How
I am looking for a pair of outboard engines for my boat. How is new Yamaha V6 4.2l 300hp (2011) Reliability? Running cost when comparing to evinrude 300hp (2011)? Which one have more power. Tanawat… read more
Jeff G.
Jeff G.
Marine Mechanic
Vocational, Technical or Trade Scho
4,730 satisfied customers
1991 Evenrude 60 HP. 1. Trolled for 2 1/2 hours at 1300
1991 Evenrude 60 HP. 1. Trolled for 2 1/2 hours at 1300 RMP with trolling plate. When I raised the motor to lift the trolling plate, motor died. Fuel bulb was empty. Pumped bulb and engine took right … read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,504 satisfied customers
I have a 115hp Johnson outboard motor. Were having difficulties
I have a 115hp Johnson outboard motor. We're having difficulties starting it. However, when we get it running it will run well for an hour plus but when we troll the motor and try to change the speed,… read more
Jeff G.
Jeff G.
Marine Mechanic
Vocational, Technical or Trade Scho
4,730 satisfied customers
WE HAVE AYAMAHA 4 CYCLE 4 STROKE T60 OUTBOARD ENGIN. IT WILL
WE HAVE AYAMAHA 4 CYCLE 4 STROKE T60 OUTBOARD ENGIN. IT WILL START AND RUN IN IDLE VERY WELL BUT WHEN WE TRY TO ADVANCE THE THROTTLE IT SPUTTERS AND STOPS. IF WE INCREASE THE THROTTLE VERY SLOWELY IT … read more
Jeremy R.
Jeremy R.
5,362 satisfied customers
I have Evinrude 4 stroke. It runs great for maybe 25 minutes,
I have Evinrude 4 stroke. It runs great for maybe 25 minutes, then dies. I can save the dieing by pumping the bulb. Runs great for another 5 or 10 minutes, then dies unless I pump the bulb. Looked all… read more
davesoutboard
davesoutboard
owner
Associate Degree
1,570 satisfied customers
I just had my 97 4 stroke 35 hp given its annual service, replaced
I just had my 97 4 stroke 35 hp given its annual service, replaced fuel and it idles fine and under it works fine until its been under full power for a few minutes, then the motor sputters and gets bo… read more
Jeremy R.
Jeremy R.
5,362 satisfied customers
HI .. I have a boat with 200 hp mariner outboard every time
HI .. I have a boat with 200 hp mariner outboard every time i take it out it runs fine for a while ... then when its in full throttle it cuts back to at least 1/2 throttle but the throttle is still in… read more
Dominick
Dominick
Marine Mechanic
Vocational, Technical or Trade Scho
1,009 satisfied customers
Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

JustAnswer in the News:

Ask-a-doc Web sites: If you've got a quick question, you can try to get an answer from sites that say they have various specialists on hand to give quick answers... Justanswer.com.
JustAnswer.com...has seen a spike since October in legal questions from readers about layoffs, unemployment and severance.
Web sites like justanswer.com/legal
...leave nothing to chance.
Traffic on JustAnswer rose 14 percent...and had nearly 400,000 page views in 30 days...inquiries related to stress, high blood pressure, drinking and heart pain jumped 33 percent.
Tory Johnson, GMA Workplace Contributor, discusses work-from-home jobs, such as JustAnswer in which verified Experts answer people’s questions.
I will tell you that...the things you have to go through to be an Expert are quite rigorous.

What Customers are Saying:

Wonderful service, prompt, efficient, and accurate. Couldn't have asked for more. I cannot thank you enough for your help.

Mary C.Freshfield, Liverpool, UK

This expert is wonderful. They truly know what they are talking about, and they actually care about you. They really helped put my nerves at ease. Thank you so much!!!!

AlexLos Angeles, CA

Thank you for all your help. It is nice to know that this service is here for people like myself, who need answers fast and are not sure who to consult.

GPHesperia, CA

I couldn't be more satisfied! This is the site I will always come to when I need a second opinion.

JustinKernersville, NC

Just let me say that this encounter has been entirely professional and most helpful. I liked that I could ask additional questions and get answered in a very short turn around.

EstherWoodstock, NY

Thank you so much for taking your time and knowledge to support my concerns. Not only did you answer my questions, you even took it a step further with replying with more pertinent information I needed to know.

RobinElkton, Maryland

He answered my question promptly and gave me accurate, detailed information. If all of your experts are half as good, you have a great thing going here.

DianeDallas, TX

< Previous | Next >

Meet the Experts:

Ted G.

Ted G.

Rigger, Diagnostician

1,074 satisfied customers

40 years boating, Safe boating instruct., Offshore Race promoter, Failure Analysis, Expert Witness

Dominick

Dominick

Marine Mechanic

1,009 satisfied customers

25 Years Experience as Mechanic, 20 Yrs Boat Yard Owner/Mechanic, Factory Certified

John White

John White

Marine Mechanic

306 satisfied customers

11 years experience working on outboards, inboards, sterndrives & pwcs

Jason

Jason

Marine Mechanic

18,955 satisfied customers

Degree in Marine Technology. Gas and diesel marine mechanic.

Tan

Tan

MerCruiser Certified Technician

11,504 satisfied customers

40 yrs. experience with complete engine repairs both inboard/outboard and MerCruiser Certified Technician.

Jeff G.

Jeff G.

Marine Mechanic

4,730 satisfied customers

42 years experience, Certified Master Technician, All Major Outboards, Sterndrives, Hi-Performance

Captain Dave

Captain Dave

Marine Mechanic

2,672 satisfied customers

USCG Licensed Captain, 20+ Years Boating, Fishing, Maintenance and Repair Experience

< Previous | Next >

Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

Show MoreShow Less

Ask Your Question

x