Boat

Have Boat Questions? Ask a Boat Repair Expert.

Connect one-on-one with {0} who will answer your question

Related Boat Questions
I have 2004 Mercury xr6 150 hp outboard, when I shift
I have 2004 Mercury xr6 150 hp outboard, when I shift forward everything sounds works good, but in reverse it spins but grinds when in the lake, in my driveway with water muffs it spins fine … read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade School
22,043 satisfied customers
I have an old but strong 1984 60 hp model J60elcre.
I have an old but strong 1984 Johnson 60 hp model J60elcre. Yesterday having just got up on plane the motor revved way up and boat came to a halt. I didn't hit anything nor did I hear any odd noise as… read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade School
22,043 satisfied customers
I have a 1990 40 hp Evinrude. It fires right up and idles
I have a 1990 40 hp Evinrude. It fires right up and idles fine. But when you throttle it up in gear, it backfires here and there. Can unburned oil that is there from previous trips cause this? I just … read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,507 satisfied customers
I purchased a home which included a pontoon boat and a mid
I purchased a home which included a pontoon boat and a mid 90s 15 hp Johnson Outboard motor. I can start the engine but cannot rev the engine. 2 controls in addition to the forward reverse control are… read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,507 satisfied customers
I have a 1968 Evinrude Sportsman. This year I hade a KIT,Carb
I have a 1968 Evinrude Sportsman. This year I hade a KIT,Carb (802401*18-7016) installed along with points,plugs,etc. When i put the boat back in the water, she would not start until the choke lever w… read more
K. Kergan
K. Kergan
Inboard/Outboard Mechanic
Vocational, Technical or Trade Scho
1,031 satisfied customers
I have a 05 Johnson 90 hp 2 cycle outboard. Its not sucking
I have a 05 Johnson 90 hp 2 cycle outboard. It's not sucking air thru gas or oil hoses. It's been doing it for 2 yrs. Last yr took it back to the dealer and they put a new gas pump on it. It's doing t… read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,507 satisfied customers
After extensive certified service and a fresh tank of gas my
After extensive certified service and a fresh tank of gas my 1989 Johnson 150 HP Outboard ran better than ever for 40 minutes at all speeds until after I stopped and shut her down for 20 minutes. She … read more
K. Kergan
K. Kergan
Inboard/Outboard Mechanic
Vocational, Technical or Trade Scho
1,031 satisfied customers
Century Resorter- 72CBW: My question regards XXXXX XXXXX 72C Velvet
My question regards XXXXX XXXXX 72C Velvet Drive Transmission (1:1). It is in a 1963 Century boat. I had it rebuilt about 20 years ago. The boat has not been used (because of the trans issue) for 10 y… read more
James
James
Certified Marine Mechanic
Vocational, Technical or Trade Scho
4,094 satisfied customers
I have a Johnson Aj25rcos 25 hp outboard, that has not been
I have a Johnson Aj25rcos 25 hp outboard, that has not been used for sometime. I have changed plugs and tried new fuel, but unable to get started can you advise of some tips that might help me to get … read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,507 satisfied customers
I have a 88 bayliner with a 5.0 omc outdrive. We went out to
I have a 88 bayliner with a 5.0 omc outdrive. We went out to the lake the other day and all was good. She ran like a champ with no problems. We went back the next day and she was lock in forward. We t… read more
K. Kergan
K. Kergan
Inboard/Outboard Mechanic
Vocational, Technical or Trade Scho
1,031 satisfied customers
What is making my 25 hp johnson backfire through the exhau
What is making my 25 hp johnson backfire through the exhaust. The motor starts easily and will run but it pops throuhg the exhaust. I cleaned the carb and set the timing. But it still pops, even when … read more
Jeff G.
Jeff G.
Marine Mechanic
Vocational, Technical or Trade Scho
4,730 satisfied customers
I just purchased a 1981 35 HP johnson with a jet drive. (Almost
I just purchased a 1981 35 HP johnson with a jet drive. (Almost like new) Started it... ran good but it was stuck in forward. Tooling along and pop... it jumped into neutral and the shift lever won't … read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,507 satisfied customers
1988 Johnson 200 hp outboard, at half throddle the motor jerks
1988 Johnson 200 hp outboard, at half throddle the motor jerks (sounds like it is back-firing) and does not get to full speed as the motor starts to 'bug'. What can be the cause what needs to be done … read more
Shane Creekmore
Shane Creekmore
Certified Mercury Marine technician
High School or GED
537 satisfied customers
I have a 2000 Evinrude 70 hp 4 stroke. Ive ordered a prop
I have a 2000 Evinrude 70 hp 4 stroke. I've ordered a prop from Evinrude twice now and it doesn't fit. But Evinrude keeps telling me it is the right one. Whats up? Has anybody had any expierence with … read more
Jeff G.
Jeff G.
Marine Mechanic
Vocational, Technical or Trade Scho
4,730 satisfied customers
just inherited a small boat with an 1973 25hp evinrude (Elec.
just inherited a small boat with an 1973 25hp evinrude (Elec. Start).I'm clueless as to proper lean/rich settings in regard to proper starting and operation. Motor seems to run ok, sure don't want to … read more
Whitecap36
Whitecap36
Service Manager/Technician
Vocational, Technical or Trade Scho
1,557 satisfied customers
Hi, thanks for taking my question. I have a 25hp 1974 Johnson
Hi, thanks for taking my question. I have a 25hp 1974 Johnson outboard. Yesterday as I was running the motor on the lake at full throttle, I heard pop or smack (can not describe it) and all of a sudde… read more
briggs archer
briggs archer
master marine mechanic
Associate Degree
403 satisfied customers
Hi, I have a Johnson Big Twin outboard motor model No 407022
Hi, I have a Johnson Big Twin outboard motor model No: 407022 & serial No: c542672, I think that it is a 40hp,1970, 22" shaft from the model No, but all the ref. No do not seem to use these numbers. C… read more
orcamarine
orcamarine
Proprietor
Vocational, Technical or Trade Scho
7 satisfied customers
I have a 50 hp tohatsu outboard 1990s model. She will ...
I have a 50 hp tohatsu outboard 1990''s model. She will run but can''t get more thaen 2500 rpm out of her if I idle it up in nuetral it will run up but as soon as I put it in gear she won''t perform, … read more
BC Boat Guy
BC Boat Guy
Lecturer/Instructor
Vocational, Technical or Trade Scho
56 satisfied customers
Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

JustAnswer in the News:

Ask-a-doc Web sites: If you've got a quick question, you can try to get an answer from sites that say they have various specialists on hand to give quick answers... Justanswer.com.
JustAnswer.com...has seen a spike since October in legal questions from readers about layoffs, unemployment and severance.
Web sites like justanswer.com/legal
...leave nothing to chance.
Traffic on JustAnswer rose 14 percent...and had nearly 400,000 page views in 30 days...inquiries related to stress, high blood pressure, drinking and heart pain jumped 33 percent.
Tory Johnson, GMA Workplace Contributor, discusses work-from-home jobs, such as JustAnswer in which verified Experts answer people’s questions.
I will tell you that...the things you have to go through to be an Expert are quite rigorous.

What Customers are Saying:

Wonderful service, prompt, efficient, and accurate. Couldn't have asked for more. I cannot thank you enough for your help.

Mary C.Freshfield, Liverpool, UK

This expert is wonderful. They truly know what they are talking about, and they actually care about you. They really helped put my nerves at ease. Thank you so much!!!!

AlexLos Angeles, CA

Thank you for all your help. It is nice to know that this service is here for people like myself, who need answers fast and are not sure who to consult.

GPHesperia, CA

I couldn't be more satisfied! This is the site I will always come to when I need a second opinion.

JustinKernersville, NC

Just let me say that this encounter has been entirely professional and most helpful. I liked that I could ask additional questions and get answered in a very short turn around.

EstherWoodstock, NY

Thank you so much for taking your time and knowledge to support my concerns. Not only did you answer my questions, you even took it a step further with replying with more pertinent information I needed to know.

RobinElkton, Maryland

He answered my question promptly and gave me accurate, detailed information. If all of your experts are half as good, you have a great thing going here.

DianeDallas, TX

< Previous | Next >

Meet the Experts:

Ted G.

Ted G.

Rigger, Diagnostician

2,678 satisfied customers

40 years boating, Safe boating instruct., Offshore Race promoter, Failure Analysis, Expert Witness

Dominick

Dominick

Marine Mechanic

1,009 satisfied customers

25 Years Experience as Mechanic, 20 Yrs Boat Yard Owner/Mechanic, Factory Certified

John White

John White

Marine Mechanic

306 satisfied customers

11 years experience working on outboards, inboards, sterndrives & pwcs

Jason

Jason

Marine Mechanic

22,043 satisfied customers

Degree in Marine Technology. Gas and diesel marine mechanic.

Tan

Tan

MerCruiser Certified Technician

11,507 satisfied customers

40 yrs. experience with complete engine repairs both inboard/outboard and MerCruiser Certified Technician.

Jeff G.

Jeff G.

Marine Mechanic

4,730 satisfied customers

42 years experience, Certified Master Technician, All Major Outboards, Sterndrives, Hi-Performance

Captain Dave

Captain Dave

Marine Mechanic

2,672 satisfied customers

USCG Licensed Captain, 20+ Years Boating, Fishing, Maintenance and Repair Experience

< Previous | Next >

Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

Show MoreShow Less

Ask Your Question

x