Boat

Have Boat Questions? Ask a Boat Repair Expert.

Connect one-on-one with {0} who will answer your question

Related Boat Questions
I have a 1996 Mercury 200 hp. Efi outboard. I replaced the
I have a 1996 Mercury 200 hp. Efi outboard. I replaced the power trim motor because it was frozen and did not turn freely. The new power trim now makes noise but is not raising or lowering the engine.… read more
Charles
Charles
Certified Mercury Tech
5,378 satisfied customers
I have a 2000 Hewes Bonefisher 18 powered by a 1999 Yamaha
I have a 2000 Hewes Bonefisher 18 powered by a 1999 Yamaha 130. WOT is 4700 rpm and hole shot is poor. Thinking it is the prop which is a 3 blade SS 13.25x19. The prop is probably ten years old, decen… read more
Ted G.
Ted G.
Rigger, Diagnostician
Vocational, Technical or Trade Scho
747 satisfied customers
2013 90 hp 4 stroke Yamaha will tilt up and down except if
2013 90 hp 4 stroke Yamaha will tilt up and down except if raised all the way to its limit. It then has to be lowered by opening the screw to release the pressure and lowered manually. If engine isn't… read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade School
19,343 satisfied customers
I have a 2000 90 HP honda. The tilt & trim will not raise up.
I have a 2000 90 HP honda. The tilt & trim will not raise up. Sounds like it is working but motor does not raise. If I tap to go down it seems to work.I checked oil level and looks good and not milky.… read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,399 satisfied customers
I have a 1987 cobalt with a rebuildt engine I had a new lower
I have a 1987 cobalt with a rebuildt engine I had a new lower unit installed on it last year the problem is even with the battery pulled out the trim with raise up in a month or so now the trim will n… read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,399 satisfied customers
I have a 1985 90 hp merc. The t/t motor runs but motor will
I have a 1985 90 hp merc. The t/t motor runs but motor will not raise or lower. I filled reservoir with t/t oil but no luck. Any suggestions?… read more
K. Kergan
K. Kergan
Inboard/Outboard Mechanic
Vocational, Technical or Trade Scho
1,031 satisfied customers
have 94 90 hp merc outboard. Trim will lift eng only slowly
have 94 90 hp merc outboard. Trim will lift eng only slowly or not at all. Engine falls if it is at max tilt. Have replaced trim/tilt pilot valve components (kit#811226-A1)and cleaned manifold/pump co… read more
James
James
Certified Marine Mechanic
Vocational, Technical or Trade Scho
4,094 satisfied customers
2002 HONDA 130 Four Stroke Power Trim not tiilting engine.
2002 HONDA 130 Four Stroke Power Trim not tiilting engine. Tilt motor runs but is not lifting the engine. Also the manual tilt screw is almost impossible to budge so I can not manually tilt the motor … read more
Jeff G.
Jeff G.
Marine Mechanic
Vocational, Technical or Trade Scho
4,730 satisfied customers
I have a 2002 Evinrude (90hp) outboard engine. The electronic
I have a 2002 Evinrude (90hp) outboard engine. The electronic tilt failed last night and I cannot get the engine into the water. This is a recurring problem. It seeme to work once the hydraulic fluid … read more
Jeff G.
Jeff G.
Marine Mechanic
Vocational, Technical or Trade Scho
4,730 satisfied customers
replaced my trim and tilt motor but having trouble bleeding
replaced my trim and tilt motor but having trouble "bleeding" the system. I let the motor settle with relief valve closed, then ran it rest of the way down, opened valve, I hear gurgling like air esca… read more
James
James
Certified Marine Mechanic
Vocational, Technical or Trade Scho
4,094 satisfied customers
I have a problem with the power trim on my 1995 Honda four-s
I have a problem with the power trim on my 1995 Honda four-stroke 90 hp. It barely works at all. The motor runs, the reservoir has fluid, but doesn't raise the engine, it does however lower the engine… read more
Whitecap36
Whitecap36
Service Manager/Technician
Vocational, Technical or Trade Scho
1,556 satisfied customers
Jeremy, you helped me with my 1998 Honda 4 Stroke 90 HP motor
Jeremy, you helped me with my 1998 Honda 4 Stroke 90 HP motor yesterday. I have another question. I did what you suggested - cleaned both pressure relief valves. Looked relatively clean. Some debris, … read more
shane j forrest
shane j forrest
Vocational, Technical or Trade Scho
270 satisfied customers
i have a skeeter 200zx with a yamaha 200 hdpi v-max. it runs
i have a skeeter 200zx with a yamaha 200 hdpi v-max. it runs 65.1mph at 5800rpm with the prop shaft 3 7/8 inches below the hull. the prop is a 25 v-max. what do you suggest i do to increase top end?… read more
Captain Dave
Captain Dave
Marine Mechanic
Master's Degree
2,672 satisfied customers
Need to know the max motor size I can put on this boat. The
Need to know the max motor size I can put on this boat. The boat is a 1983 Lowe 17' jon The spec plate is all smotthed out from people sanding and repainting it is not legable. I have picture if there… read more
Scott
Scott
Marine technician
Vocational, Technical or Trade Scho
543 satisfied customers
I bought a new trim motor for my 1989 johnson 40 hp. The trim
I bought a new trim motor for my 1989 johnson 40 hp. The trim motor works but the engine wont raise or lower. Do I need to bleed the hydraulic to get it working.… read more
orcamarine
orcamarine
Proprietor
Vocational, Technical or Trade Scho
7 satisfied customers
I have just purchased a bass boat with a 1989 Evinrude model
I have just purchased a bass boat with a 1989 Evinrude model E50TLCEC 50 HP outboard. The problem is that the tilt/trim does not work properly. The t/t motor makes noise up and down from either pair o… read more
The Man on the Dock
The Man on the Dock
Marina Owner, Operator
Vocational, Technical or Trade Scho
74 satisfied customers
I have an old (1986) Mercury Mariner boat motor. The power
I have an old (1986) Mercury Mariner boat motor. The power tilt works, but the engine falls when under acceleration. Why might that be happening? Also, since I can't trim the motor up, would that caus… read more
orcamarine
orcamarine
Proprietor
Vocational, Technical or Trade Scho
7 satisfied customers
i have a 1996 honda 90 hp boat motor that will run for ...
i have a 1996 honda 90 hp boat motor that will run for a while at max throttle,but will not idle at all. i know that it has set up for about a year,and have run it in with seafoam.what could be my pro… read more
Larry B.
Larry B.
Marine Service Tech
High School or GED
574 satisfied customers
Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

JustAnswer in the News:

Ask-a-doc Web sites: If you've got a quick question, you can try to get an answer from sites that say they have various specialists on hand to give quick answers... Justanswer.com.
JustAnswer.com...has seen a spike since October in legal questions from readers about layoffs, unemployment and severance.
Web sites like justanswer.com/legal
...leave nothing to chance.
Traffic on JustAnswer rose 14 percent...and had nearly 400,000 page views in 30 days...inquiries related to stress, high blood pressure, drinking and heart pain jumped 33 percent.
Tory Johnson, GMA Workplace Contributor, discusses work-from-home jobs, such as JustAnswer in which verified Experts answer people’s questions.
I will tell you that...the things you have to go through to be an Expert are quite rigorous.

What Customers are Saying:

Wonderful service, prompt, efficient, and accurate. Couldn't have asked for more. I cannot thank you enough for your help.

Mary C.Freshfield, Liverpool, UK

This expert is wonderful. They truly know what they are talking about, and they actually care about you. They really helped put my nerves at ease. Thank you so much!!!!

AlexLos Angeles, CA

Thank you for all your help. It is nice to know that this service is here for people like myself, who need answers fast and are not sure who to consult.

GPHesperia, CA

I couldn't be more satisfied! This is the site I will always come to when I need a second opinion.

JustinKernersville, NC

Just let me say that this encounter has been entirely professional and most helpful. I liked that I could ask additional questions and get answered in a very short turn around.

EstherWoodstock, NY

Thank you so much for taking your time and knowledge to support my concerns. Not only did you answer my questions, you even took it a step further with replying with more pertinent information I needed to know.

RobinElkton, Maryland

He answered my question promptly and gave me accurate, detailed information. If all of your experts are half as good, you have a great thing going here.

DianeDallas, TX

< Previous | Next >

Meet the Experts:

Dominick

Dominick

Marine Mechanic

1,009 satisfied customers

25 Years Experience as Mechanic, 20 Yrs Boat Yard Owner/Mechanic, Factory Certified

Ted G.

Ted G.

Rigger, Diagnostician

747 satisfied customers

40 years boating, Safe boating instruct., Offshore Race promoter, Failure Analysis, Expert Witness

John White

John White

Marine Mechanic

306 satisfied customers

11 years experience working on outboards, inboards, sterndrives & pwcs

Jason

Jason

Marine Mechanic

19,343 satisfied customers

Degree in Marine Technology. Gas and diesel marine mechanic.

Tan

Tan

MerCruiser Certified Technician

11,399 satisfied customers

40 yrs. experience with complete engine repairs both inboard/outboard and MerCruiser Certified Technician.

Jeff G.

Jeff G.

Marine Mechanic

4,730 satisfied customers

42 years experience, Certified Master Technician, All Major Outboards, Sterndrives, Hi-Performance

Captain Dave

Captain Dave

Marine Mechanic

2,672 satisfied customers

USCG Licensed Captain, 20+ Years Boating, Fishing, Maintenance and Repair Experience

< Previous | Next >

Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

Show MoreShow Less

Ask Your Question

x