Boat

Have Boat Questions? Ask a Boat Repair Expert.

Connect one-on-one with {0} who will answer your question

Related Boat Questions
I have a 2018 Yamaha 90 HP V Mav SHO outboard and it idles
I have a 2018 Yamaha 90 HP V Mav SHO outboard and it idles fine when it is cold, but after it has been running for about an hour, it will shut off when you are in gear or neutral. If you take it out o… read more
Noel Schembri
Noel Schembri
Marine Mechanic
Diploma
2,759 satisfied customers
After a run Kill motor. Start motor and go to get up will
After a long run Kill motor. Start motor and go to get up will not run. Not even enough power to load on trailer. As long as motor cold runs fine … read more
Yachtwork
Yachtwork
Owner Team Yachtwork
Technical or Trade School
2,578 satisfied customers
CHANGE PLUGS RUNS GREAT LET IDLE FOR A WHILE STARTS RUNNING
CHANGE PLUGS RUNS GREAT LET IDLE FOR A WHILE STARTS RUNNING BAD PULL PLUGS THERE REALLY WET … read more
Charles
Charles
Certified Mercury Tech
5,752 satisfied customers
2000 Yamaha F-80 wont start. New fuel pumps. electric choke
2000 Yamaha F-80 wont start. New fuel pumps. electric choke cold start not working. been in storage for five years. new water pump, plugs, fuel and filters. … read more
Charles
Charles
Certified Mercury Tech
5,752 satisfied customers
I have a yamaha 2010 F90 TLR. When it warms up, it idles
I have a yamaha 2010 F90 TLR. When it warms up, it idles very fast ( over 2500 rpm). Any ideas? … read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade School
22,804 satisfied customers
I have a 2008 Yamaha 90hp four stroke outboard that stalls
I have a 2008 Yamaha 90hp four stroke outboard that stalls at very low speed. It also has difficulty re-starting after I have taken it out fishing. A mechanic replaced the IAC (idle air control valve)… read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade School
22,804 satisfied customers
I have a pair of suzuki 150's 2013 with under 20 hours....
I have a pair of suzuki 150's 2013 with under 20 hours.... port side motor will fire up and run until i back off the throttle and then it will stall and wont re start unless i bypass neutral on the co… read more
Greg Robinson
Greg Robinson
Senior service manager
Vocational, Technical or Trade Scho
199 satisfied customers
i have a 225 hp johnson outboard that was just rebuilt the
i have a 225 hp johnson outboard that was just rebuilt the stator is new the powerpack is new the plugs are new and it wont come off fast idle when it starts right up thus timing is very far advanced … read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,409 satisfied customers
i have a 2008 yamaha v150tlr 4 stroke carb out board ...when
i have a 2008 yamaha v150tlr 4 stroke carb out board ...when the engine is cold ( after it sets for several days ) the engine starts but will not stay running..it takes several starts before it stays … read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade School
22,804 satisfied customers
Having trouble with my Yamaha outboard 90 HP 4-stroke 2004.
Having trouble with my Yamaha outboard 90 HP 4-stroke 2004. engine produces cavitation. I disconnected the temperature sender and the engine runs normal. I replaced the sender but continues with same … read more
Jeremy R.
Jeremy R.
5,362 satisfied customers
The engine idles fine after it is warmed up (about 700RPM).
The engine idles fine after it is warmed up (about 700RPM). When the engine is cold it idles lower (400 RPM) or sometimes quits. Is there a cold idle setting?… read more
James
James
Certified Marine Mechanic
Vocational, Technical or Trade Scho
4,094 satisfied customers
I have a 1988 90HP Mariner outboard, 3 cylinder. Cranks from
I have a 1988 90HP Mariner outboard, 3 cylinder. Cranks from cold quickly and seem to run smoothly while on fast idle. When warm enough to reduce fast idle to normal(NNN) NNN-NNNNRPM idle range, it id… read more
Noel Schembri
Noel Schembri
Marine Mechanic
Diploma
2,759 satisfied customers
2006 250hp v-max hdpi, have cranking issues when cold, first
2006 250hp v-max hdpi, have cranking issues when cold, first time you hit the start it fires and dies, after that it takes 4-6 times turning it over then it will fire up and run. after it cranks it ru… read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade School
22,804 satisfied customers
trouble shotting GM 350, TB, Pleasure Craft Marine, Starting
trouble shotting GM 350, TB, Pleasure Craft Marine, Starting and Idling problems. I have done various suggestions and it is still not right. I fell I would not want to pay unless we can fix the prob. … read more
Joe
Joe
Owner Kingsland Auto & Marine Services
Vocational, Technical or Trade Scho
1,396 satisfied customers
Hi i own a 2006 yamaha 25hp 4 stroke outboard it is a base
Hi i own a 2006 yamaha 25hp 4 stroke outboard it is a base model with no electric start or tilt trim. i bought it second hand with the prior owner stating it had about 180hours use. I have just comple… read more
Whitecap36
Whitecap36
Service Manager/Technician
Vocational, Technical or Trade Scho
1,557 satisfied customers
I have a 2003 yamaha 115 4 cycle outboard I had a problem that
I have a 2003 yamaha 115 4 cycle outboard I had a problem that after running for a long time the motor would not start it would crank but would not fire if I let it set for about20 minutes it would fi… read more
ROCKET
ROCKET
MASTER CERTIFIED TECH
Vocational, Technical or Trade Scho
426 satisfied customers
i have a 90hp yamaha outolube outboard engine.engine starts
i have a 90hp yamaha outolube outboard engine.engine starts fine and runs well untill i give it full trottle then all power is lost,engine doesnt cut out and stays running but with little power. new b… read more
ROCKET
ROCKET
MASTER CERTIFIED TECH
Vocational, Technical or Trade Scho
426 satisfied customers
I have a 1995 Yamaha pro 50 outboard. It was running when last
I have a 1995 Yamaha pro 50 outboard. It was running when last used. All three plugs are fireing and there is fuel pumping from the fuel pump though I am not sure of the pressure. The motor will not s… read more
ROCKET
ROCKET
MASTER CERTIFIED TECH
Vocational, Technical or Trade Scho
426 satisfied customers
Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

JustAnswer in the News:

Ask-a-doc Web sites: If you've got a quick question, you can try to get an answer from sites that say they have various specialists on hand to give quick answers... Justanswer.com.
JustAnswer.com...has seen a spike since October in legal questions from readers about layoffs, unemployment and severance.
Web sites like justanswer.com/legal
...leave nothing to chance.
Traffic on JustAnswer rose 14 percent...and had nearly 400,000 page views in 30 days...inquiries related to stress, high blood pressure, drinking and heart pain jumped 33 percent.
Tory Johnson, GMA Workplace Contributor, discusses work-from-home jobs, such as JustAnswer in which verified Experts answer people’s questions.
I will tell you that...the things you have to go through to be an Expert are quite rigorous.

What Customers are Saying:

Wonderful service, prompt, efficient, and accurate. Couldn't have asked for more. I cannot thank you enough for your help.

Mary C.Freshfield, Liverpool, UK

This expert is wonderful. They truly know what they are talking about, and they actually care about you. They really helped put my nerves at ease. Thank you so much!!!!

AlexLos Angeles, CA

Thank you for all your help. It is nice to know that this service is here for people like myself, who need answers fast and are not sure who to consult.

GPHesperia, CA

I couldn't be more satisfied! This is the site I will always come to when I need a second opinion.

JustinKernersville, NC

Just let me say that this encounter has been entirely professional and most helpful. I liked that I could ask additional questions and get answered in a very short turn around.

EstherWoodstock, NY

Thank you so much for taking your time and knowledge to support my concerns. Not only did you answer my questions, you even took it a step further with replying with more pertinent information I needed to know.

RobinElkton, Maryland

He answered my question promptly and gave me accurate, detailed information. If all of your experts are half as good, you have a great thing going here.

DianeDallas, TX

< Previous | Next >

Meet the Experts:

Ted G.

Ted G.

Rigger, Diagnostician

3,332 satisfied customers

40 years boating, Safe boating instruct., Offshore Race promoter, Failure Analysis, Expert Witness

Dominick

Dominick

Marine Mechanic

1,009 satisfied customers

25 Years Experience as Mechanic, 20 Yrs Boat Yard Owner/Mechanic, Factory Certified

John White

John White

Marine Mechanic

306 satisfied customers

11 years experience working on outboards, inboards, sterndrives & pwcs

Jason

Jason

Marine Mechanic

22,804 satisfied customers

Degree in Marine Technology. Gas and diesel marine mechanic.

Tan

Tan

MerCruiser Certified Technician

11,409 satisfied customers

40 yrs. experience with complete engine repairs both inboard/outboard and MerCruiser Certified Technician.

Jeff G.

Jeff G.

Marine Mechanic

4,730 satisfied customers

42 years experience, Certified Master Technician, All Major Outboards, Sterndrives, Hi-Performance

Noel Schembri

Noel Schembri

Marine Mechanic

2,759 satisfied customers

Advanced technical diploma

< Previous | Next >

Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

Show MoreShow Less

Ask Your Question

x