Boat

Have Boat Questions? Ask a Boat Repair Expert.

Connect one-on-one with {0} who will answer your question

Related Boat Questions
Can not turn forward / reverse control shaft to align lower
can not turn forward / reverse control shaft to align lower unit after replacing water pump impeller … read more
Charles
Charles
Certified Mercury Tech
5,526 satisfied customers
I just bought a 1994 craft with a volvo engine and yamaha
Hi I just bought a 1994 chris craft with a volvo engine and yamaha outdrive ... the outdrive is shot and I cannot find parts anywhere what outdrive can I switch for the yamaha easily ?… read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,406 satisfied customers
Kerry! Mercruiser ALPHA 1 had a nice shifting alpha 1 but
Kerry! Mercruiser ALPHA 1 had a nice shifting alpha 1 but noise was coming from between engine and lower unit. Removed out drive to replace gimble bearing,seal,drive shaft bellows, EX bellows,raw wate… read more
K. Kergan
K. Kergan
Inboard/Outboard Mechanic
Vocational, Technical or Trade Scho
1,031 satisfied customers
I am just reviewing this message about the installation of
hi Jason I am just reviewing this message about the installation of the stern drive on mercruiser, I am having the same problem. When I install the lower unit, my shift lever does not line up with the… read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade School
20,027 satisfied customers
Will a 1-1.98 ratio alpha 1 (mercruiser) out drive work or
Will a 1-1.98 ratio alpha 1 (mercruiser) out drive work or handle a 454 330hp engine if throttle in is done progressively. If not what gears and prop should I use for a 23' sea ray weekender. The 1-1.… read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade School
20,027 satisfied customers
I (think) I have a Bravo III outdrive (twin prop) on my 22
I (think) I have a Bravo III outdrive (twin prop) on my 22' Sea Ray with a MX 6.2 engine. The drive seems to be shifting into forward a bit harder than it used to and at low speed (just above idle) it… read more
James
James
Certified Marine Mechanic
Vocational, Technical or Trade Scho
4,094 satisfied customers
1.) Can the mercruiser alpha 1 genXXXXXbe replaced
1.) Can the mercruiser alpha 1 genXXXXXbe replaced with a genXXXXX 2.) If not, can the in and out alpha 1 gen one be replaced with a gen 2 with out modifications to the transom?… read more
James
James
Certified Marine Mechanic
Vocational, Technical or Trade Scho
4,094 satisfied customers
What is best combination for stern drive and d254 turbo ac
What is best combination for stern drive and d254 turbo ac mercruiser 1993.Also what is good ratio will be used.Boat is Wellcraft 26 foot cca 2800 kg. Thanks Mario from Gold Coast Australia.… read more
James
James
Certified Marine Mechanic
Vocational, Technical or Trade Scho
4,094 satisfied customers
I have a 2000 Mariah 202 with a 305 mercruiser. The out drive
I have a 2000 Mariah 202 with a 305 mercruiser. The out drive is a alpha, it shifts good but when put in in gear it seems to have a clunking sound. It has 101 hours on it.… read more
Whitecap36
Whitecap36
Service Manager/Technician
Vocational, Technical or Trade Scho
1,556 satisfied customers
Hi, I have a 1988 Renken 21 Cuddy. It has a 3.0 4cyl with
Hi, I have a 1988 Renken 21' Cuddy. It has a 3.0 4cyl with the Alpha One stern drive. Is it possible to install one of the 5.7 V-8 engines in this boat. Besides engine mounting and alignment issues, i… read more
James
James
Certified Marine Mechanic
Vocational, Technical or Trade Scho
4,094 satisfied customers
I installed an alpha 1 outdrive. replacing the one I had on
I installed an alpha 1 outdrive. replacing the one I had on the boat. Now it won't shift forward or reverse. When I put it in gear it stalls the engine. I think I have not put the linkage back in the … read more
James
James
Certified Marine Mechanic
Vocational, Technical or Trade Scho
4,094 satisfied customers
Have a 1992 Bayliner Trophy with 3 liter and alpha leg. Raw
Have a 1992 Bayliner Trophy with 3 liter and alpha leg. Raw water used in salt water and motor is done. Was badly underpowered and am considering repowering with 4.3 (carbed or MPI ?) Boat plate indic… read more
K. Kergan
K. Kergan
Inboard/Outboard Mechanic
Vocational, Technical or Trade Scho
1,031 satisfied customers
I have recently purchased an 85 Chris craft Scorpion 230 with
I have recently purchased an 85' Chris craft Scorpion 230 with mercruiser outdrive removed from it du to rock damage a replacment Alpha drive was given to me with the the boat upon trying to install I… read more
K. Kergan
K. Kergan
Inboard/Outboard Mechanic
Vocational, Technical or Trade Scho
1,031 satisfied customers
I have a 2004 mercruiser 350 mpi. When putting it in drive,
I have a 2004 mercruiser 350 mpi. When putting it in drive, I hear a clunk, but then runs fine. Only clunks in forward drive???… read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,406 satisfied customers
Hi, I have a 4.3L mercruiser w/ alpha 1-gen2 outdrive. I just
Hi, I have a 4.3L mercruiser w/ alpha 1-gen2 outdrive. I just changed the water pump (impeller) and when I tried to put it into gear (forward), the drive shaft would tumble and not engaged. I tried th… read more
James
James
Certified Marine Mechanic
Vocational, Technical or Trade Scho
4,094 satisfied customers
Good Day all, I am looking at buying a 28 foot leeder with
Good Day all, I am looking at buying a 28 foot leeder with twin 4.3 v6 motors with 700 hours on them.. one of the motors when started and revved pumps water out the back I thought it was the exhurst m… read more
capt ron 1959
capt ron 1959
Owner/Marine Mechanic
Vocational, Technical or Trade Scho
348 satisfied customers
i have an 87 mercruiser 305 inbord se106 out last weekend my
i have an 87 mercruiser 305 inbord se106 out last weekend my son was skiiing me driving the boat just seemed to loose forward momentum i just shut it down looked at it and seemed ok putted back to the… read more
mercmastertech
mercmastertech
Service Manager, Master technician
Technical School
249 satisfied customers
Can a penta 270 sterndrive be installed to a mercruiser 2.5
Can a penta 270 sterndrive be installed to a mercruiser 2.5 L (alpha one) engine. Problem is the alpha one stern drive including the gimble were destroyed in a accident. Can get a complete used 270 st… read more
mercmastertech
mercmastertech
Service Manager, Master technician
Technical School
249 satisfied customers
Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

JustAnswer in the News:

Ask-a-doc Web sites: If you've got a quick question, you can try to get an answer from sites that say they have various specialists on hand to give quick answers... Justanswer.com.
JustAnswer.com...has seen a spike since October in legal questions from readers about layoffs, unemployment and severance.
Web sites like justanswer.com/legal
...leave nothing to chance.
Traffic on JustAnswer rose 14 percent...and had nearly 400,000 page views in 30 days...inquiries related to stress, high blood pressure, drinking and heart pain jumped 33 percent.
Tory Johnson, GMA Workplace Contributor, discusses work-from-home jobs, such as JustAnswer in which verified Experts answer people’s questions.
I will tell you that...the things you have to go through to be an Expert are quite rigorous.

What Customers are Saying:

Wonderful service, prompt, efficient, and accurate. Couldn't have asked for more. I cannot thank you enough for your help.

Mary C.Freshfield, Liverpool, UK

This expert is wonderful. They truly know what they are talking about, and they actually care about you. They really helped put my nerves at ease. Thank you so much!!!!

AlexLos Angeles, CA

Thank you for all your help. It is nice to know that this service is here for people like myself, who need answers fast and are not sure who to consult.

GPHesperia, CA

I couldn't be more satisfied! This is the site I will always come to when I need a second opinion.

JustinKernersville, NC

Just let me say that this encounter has been entirely professional and most helpful. I liked that I could ask additional questions and get answered in a very short turn around.

EstherWoodstock, NY

Thank you so much for taking your time and knowledge to support my concerns. Not only did you answer my questions, you even took it a step further with replying with more pertinent information I needed to know.

RobinElkton, Maryland

He answered my question promptly and gave me accurate, detailed information. If all of your experts are half as good, you have a great thing going here.

DianeDallas, TX

< Previous | Next >

Meet the Experts:

Ted G.

Ted G.

Rigger, Diagnostician

1,074 satisfied customers

40 years boating, Safe boating instruct., Offshore Race promoter, Failure Analysis, Expert Witness

Dominick

Dominick

Marine Mechanic

1,009 satisfied customers

25 Years Experience as Mechanic, 20 Yrs Boat Yard Owner/Mechanic, Factory Certified

John White

John White

Marine Mechanic

306 satisfied customers

11 years experience working on outboards, inboards, sterndrives & pwcs

Jason

Jason

Marine Mechanic

20,027 satisfied customers

Degree in Marine Technology. Gas and diesel marine mechanic.

Tan

Tan

MerCruiser Certified Technician

11,406 satisfied customers

40 yrs. experience with complete engine repairs both inboard/outboard and MerCruiser Certified Technician.

Jeff G.

Jeff G.

Marine Mechanic

4,730 satisfied customers

42 years experience, Certified Master Technician, All Major Outboards, Sterndrives, Hi-Performance

Captain Dave

Captain Dave

Marine Mechanic

2,672 satisfied customers

USCG Licensed Captain, 20+ Years Boating, Fishing, Maintenance and Repair Experience

< Previous | Next >

Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

Show MoreShow Less

Ask Your Question

x