Boat

Have Boat Questions? Ask a Boat Repair Expert.

Connect one-on-one with {0} who will answer your question

Related Boat Questions
My trim will not go down it goes up fine you can hear the trim
my trim will not go down it goes up fine you can hear the trim motor run when you push the trim down but the leg will not go down I filled the oil it was low. my boat is a 1977 crestliner 305 chev inb… read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,409 satisfied customers
I have a 97 Johnson 50 hp 2 stroke with power tilt trim. Took
I have a 97 Johnson 50 hp 2 stroke with power tilt trim. Took motor off tilt trim to replace o rings in the cylinder. When I got the motor off I turned the unit upside down to drain hydraulic. A small… read more
Jeff G.
Jeff G.
Marine Mechanic
Vocational, Technical or Trade Scho
4,730 satisfied customers
, Tan I wish know now about the Mercruiser trim and
hello, Tan I wish know now about the Mercruiser trim and tilt system. As I was raising the out drive to move the boat to a more favorable location to remove the engine, one of the steel webbed hoses t… read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,409 satisfied customers
I have a 1983 Chris Craft Scorpion 182 with a 1981 305 v8.
I have a 1983 Chris Craft Scorpion 182 with a 1981 305 v8. The exhaust pipe within the stern drive seems to have burned out to some degree. Where can I get a schematic of the backend and/or guidance o… read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade School
23,211 satisfied customers
I have a 1983 16 Glassmaster with a 120 hp Mercruiser
I have a 1983 16' Glassmaster with a 120 hp Mercruiser stern drive. It has a Pull Neutral Hi Lex remote control box. I would like a manual on the Hi Lex and on the boat including wiring diagrams. IF t… read more
Expert
Expert
I took my boat out and my tilt didnt work. Looked in the tilt
I took my boat out and my tilt didn't work. Looked in the tilt fluid and it was pink, guessed it was water contamination. Just wondering if the water jacket ran through the plate located on the stern … read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,409 satisfied customers
I have a 1978 MerCruiser trim motor that I had repaired. It
I have a 1978 MerCruiser trim motor that I had repaired. It runs but now I cannot get it to move the prop up or down. I took the pump apart and am having trouble figuring out where the ball bearings g… read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,409 satisfied customers
I have a 1973 140 hp Mercruiser. It has new trim cylinders. A
I have a 1973 140 hp Mercruiser. It has new trim cylinders. A few days ago first use this year - the pump would lift and lower the stern drive Next day - it would lower - but groan in to lift the ster… read more
Jeff G.
Jeff G.
Marine Mechanic
Vocational, Technical or Trade Scho
4,730 satisfied customers
I have a Mercruiser 898R from 1983. The Trim up switch stopped
I have a Mercruiser 898R from 1983. The Trim up switch stopped working a couple of years ago. The Trim up Trailer switch still worked. I took the Power Trim Control apart and determined there was no p… read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,409 satisfied customers
I own 1994 Mercruiser Alpha one. I seem to be low on hydraulic
I own 1994 Mercruiser Alpha one. I seem to be low on hydraulic fluid (based on level in plastic vessel on top of manifold). I don't know what previous owner used (motor oil, atf, or hydraulic fluid). … read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,409 satisfied customers
Need some assistance to deal with mercruiser stern drive, Water
Need some assistance to deal with mercruiser stern drive, Water and exhaust coming out from around the bell(?) housing (seaward side of transom)… read more
Jeremy R.
Jeremy R.
5,362 satisfied customers
i have a 1988 bayliner boat an i need to know where i can get
i have a 1988 bayliner boat an i need to know where i can get a key ignition for my boat please help me.… read more
K. Kergan
K. Kergan
Inboard/Outboard Mechanic
Vocational, Technical or Trade Scho
1,031 satisfied customers
I have a 1985 Mercruiser 140 MR stern drive with a Prestolite
I have a 1985 Mercruiser 140 MR stern drive with a Prestolite power trim pump. When I opened the pump to clean the sludge that had collected from sitting idle for a few years some of the ball valves/s… read more
K. Kergan
K. Kergan
Inboard/Outboard Mechanic
Vocational, Technical or Trade Scho
1,031 satisfied customers
how do I know if the mercruiser stern drive on my 1966 starcraft
how do I know if the mercruiser stern drive on my 1966 starcraft holiday 110hp is a type1? boat sat for 13 years in storage, engine runs fine but won't go into gear and stern tilt is inoperative. just… read more
Dominick
Dominick
Marine Mechanic
Vocational, Technical or Trade Scho
1,009 satisfied customers
I have a 2002 Mercury 200EFI I just took out of winter storage
I have a 2002 Mercury 200EFI I just took out of winter storage and power trim seems like it may be locked or have air in it. stern of boat was lifted off trailer with sling under motor and may have ti… read more
Dominick
Dominick
Marine Mechanic
Vocational, Technical or Trade Scho
1,009 satisfied customers
I have an older Reinell with a merc cruiser . The power trm
I have an older Reinell with a merc cruiser . The power trm will go up and will not come down . I pulled the pump out and took apart. it was full of sludge. I cleaned it up . when I put it back togeth… read more
TOM
TOM
Vocational, Technical or Trade Scho
196 satisfied customers
i am having trouble with thepower trim &tilt system on my 1997
i am having trouble with thepower trim &tilt system on my 1997 maxum 1900. the solenoids (in, out) both click but the pump does not pump.… read more
TOM
TOM
Vocational, Technical or Trade Scho
196 satisfied customers
1979 mercruiser on 228 hp on trim/tilt goes slow on going down
1979 mercruiser on 228 hp on trim/tilt goes slow on going down and creeps down, can this repaired… read more
ROCKET
ROCKET
MASTER CERTIFIED TECH
Vocational, Technical or Trade Scho
426 satisfied customers
Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

JustAnswer in the News:

Ask-a-doc Web sites: If you've got a quick question, you can try to get an answer from sites that say they have various specialists on hand to give quick answers... Justanswer.com.
JustAnswer.com...has seen a spike since October in legal questions from readers about layoffs, unemployment and severance.
Web sites like justanswer.com/legal
...leave nothing to chance.
Traffic on JustAnswer rose 14 percent...and had nearly 400,000 page views in 30 days...inquiries related to stress, high blood pressure, drinking and heart pain jumped 33 percent.
Tory Johnson, GMA Workplace Contributor, discusses work-from-home jobs, such as JustAnswer in which verified Experts answer people’s questions.
I will tell you that...the things you have to go through to be an Expert are quite rigorous.

What Customers are Saying:

Wonderful service, prompt, efficient, and accurate. Couldn't have asked for more. I cannot thank you enough for your help.

Mary C.Freshfield, Liverpool, UK

This expert is wonderful. They truly know what they are talking about, and they actually care about you. They really helped put my nerves at ease. Thank you so much!!!!

AlexLos Angeles, CA

Thank you for all your help. It is nice to know that this service is here for people like myself, who need answers fast and are not sure who to consult.

GPHesperia, CA

I couldn't be more satisfied! This is the site I will always come to when I need a second opinion.

JustinKernersville, NC

Just let me say that this encounter has been entirely professional and most helpful. I liked that I could ask additional questions and get answered in a very short turn around.

EstherWoodstock, NY

Thank you so much for taking your time and knowledge to support my concerns. Not only did you answer my questions, you even took it a step further with replying with more pertinent information I needed to know.

RobinElkton, Maryland

He answered my question promptly and gave me accurate, detailed information. If all of your experts are half as good, you have a great thing going here.

DianeDallas, TX

< Previous | Next >

Meet the Experts:

Ted G.

Ted G.

Rigger, Diagnostician

2,678 satisfied customers

40 years boating, Safe boating instruct., Offshore Race promoter, Failure Analysis, Expert Witness

Dominick

Dominick

Marine Mechanic

1,009 satisfied customers

25 Years Experience as Mechanic, 20 Yrs Boat Yard Owner/Mechanic, Factory Certified

John White

John White

Marine Mechanic

306 satisfied customers

11 years experience working on outboards, inboards, sterndrives & pwcs

Jason

Jason

Marine Mechanic

23,211 satisfied customers

Degree in Marine Technology. Gas and diesel marine mechanic.

Tan

Tan

MerCruiser Certified Technician

11,409 satisfied customers

40 yrs. experience with complete engine repairs both inboard/outboard and MerCruiser Certified Technician.

Jeff G.

Jeff G.

Marine Mechanic

4,730 satisfied customers

42 years experience, Certified Master Technician, All Major Outboards, Sterndrives, Hi-Performance

Captain Dave

Captain Dave

Marine Mechanic

2,672 satisfied customers

USCG Licensed Captain, 20+ Years Boating, Fishing, Maintenance and Repair Experience

< Previous | Next >

Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

Show MoreShow Less

Ask Your Question

x