Boat

Have Boat Questions? Ask a Boat Repair Expert.

Connect one-on-one with {0} who will answer your question

Related Boat Questions
2004 Carver Voyager Grand Salon with twin Volvo Penta Tamd
2004 Carver Voyager Grand Salon with twin Volvo Penta Tamd 75EDC. From the helm (fly bridge) I have key ignitions one for port and one for starboard. EDC module have to be pushed for the n … read more
Yachtwork
Yachtwork
Owner Team Yachtwork
Technical or Trade School
2,574 satisfied customers
I have a 1990 Silverton 41 aft cabin with twin Crusader 502
I have a 1990 Silverton 41 aft cabin with twin Crusader 502 engines. 609 hours each. The starboard engine started to rev up at about 3000 rpm. Would drop down again, after a short time it would do it … read more
Jason
Jason
Marine Mechanic
24,851 satisfied customers
I have a 1992 carver 36, with two 454, 7.4 Crusader engines.
Second opinion] I have a 1992 carver 36, with two 454, 7.4 Crusader engines. I needed engine repair since starboard engine will not start. Went to boat yard, they partially tore down the engine and co… read more
Ted G.
Ted G.
Rigger, Diagnostician
Vocational, Technical or Trade Scho
4,044 satisfied customers
Friends boat, on the water now, and starboard engine will
Friends boat, on the water now, and starboard engine will not restart said it sounds like a dead battery. Does the Carver 360 Sport Sedan have a solenoid parallel start button? … read more
Ted G.
Ted G.
Rigger, Diagnostician
Vocational, Technical or Trade Scho
4,044 satisfied customers
When we bought our 2001 carver there were 5 810 cranking amp
When we bought our 2001 carver there were 5 810 cranking amp batteries....we were told they should be 1000. Cranking amps for the motors?? The port engine battery is low....port engine won't start...s… read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,409 satisfied customers
I have a 33 ft carver w/twin 360 crusaders, the port engine
I have a 33 ft carver w/twin 360 crusaders, the port engine breaks down and quits after running for approx 30 minutes at 2900 rpms. I wait about 5 mins and it will restart but won't run over 2000 rpms… read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,409 satisfied customers
What was the original battery set up on a Sea ray 2004
What was the original battery set up on a Sea ray 2004 Amberjack with three batteries and two switches 2 cranking and 1 house ? Bought the boat used with 3 cranking bateries 2 of them are bad I have 2… read more
Jason
Jason
Marine Mechanic
24,851 satisfied customers
Wellcraft 290 coastal. Has 2 battery's starboard starts Starboard
Wellcraft 290 coastal. Has 2 battery's starboard starts Starboard motor and is also house battery. Port battery is only for starting Port eng. Each battery has a factory on/off switch only. NOT 1/2/bo… read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,409 satisfied customers
Ive recently repowered with crusader 350 power packs and having
I've recently repowered with crusader 350 power packs and having trouble with the ignition coils getting hot and breaking down. The distributor, coils and ballast resistors came with the engines. They… read more
Jason
Jason
Marine Mechanic
24,851 satisfied customers
AD41 Charging problem. The voltmeter on the port engine does
AD41 Charging problem. The voltmeter on the port engine does not go above 12V, the hour meter does not work and the Raymarine display cycles on and off. Interesting is that even when the starboard eng… read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,409 satisfied customers
I have a 454 crusader port engine that starts very hard when
I have a 454 crusader port engine that starts very hard when cold but no problem once it starts even if I leave it off for three or four hours. Overnight and it starts very hard with a lot of cranking… read more
orcamarine
orcamarine
Proprietor
Vocational, Technical or Trade Scho
7 satisfied customers
I repowered my BW V-Drive boat in 2006 with new Crusader 5.7L
I repowered my BW V-Drive boat in 2006 with new Crusader 5.7L 310hp "Classic" carb engines, starboard is normal rotation and port is reverse rotation. After about 2 years (212 hours) I had to replace … read more
Jason
Jason
Marine Mechanic
24,851 satisfied customers
Another question for cummins dr Boat 34 twin Cummins
Another question for "cummins dr": Boat: 34' twin Cummins diesel 250 hp. I am unable to get the port engine to charge the "house" bank of batteries. This has been going on for some time. Over the past… read more
Yachtwork
Yachtwork
Owner Team Yachtwork
Technical or Trade School
2,574 satisfied customers
I have 2 Cummins 370B engines. 8 years old/about 450 hours.
I have 2 Cummins 370B engines. 8 years old/about 450 hours. I was having intermittent starting problems on one engine for a couple of seasons then both last year. Both starter solenoids were bad. It a… read more
Scott
Scott
Marine technician
Vocational, Technical or Trade Scho
543 satisfied customers
83 Carver 28 with twin 305s crusader model 220 running at
83 Carver 28 with twin 305s crusader model 220 running at 3100 rpm WOT and running at 15knts so I cleaned bottom of boat and changed props from 16/15 to 16/14and it picked up from 15 KNTS TO 22KNTS at… read more
Noel Schembri
Noel Schembri
Marine Mechanic
Diploma
2,759 satisfied customers
i have a 26 f cruisers inc with two 470 i know most boaters
i have a 26 f cruisers inc with two 470 i know most boaters dont like ut this two re rely good now i exchange the alternator and i still get 11.9v on my gps this is the kit with a one wire alternator … read more
K. Kergan
K. Kergan
Inboard/Outboard Mechanic
Vocational, Technical or Trade Scho
1,031 satisfied customers
the starboard engine will not start when i am ready togo back
the starboard engine will not start when i am ready togo back to the marina after parking for about 5 hours at party cove with the generator running for 5 hours . it starts and works fine and after 5 … read more
briggs archer
briggs archer
master marine mechanic
Associate Degree
403 satisfied customers
I have a 1978 Carver Voyager with twin PCM 302s. The Starboard
I have a 1978 Carver Voyager with twin PCM 302's. The Starboard engine stopped putting out voltage, so I had the Prestolite Alternator rebuilt. No good, still no output, so I changed the Voltage Regul… read more
Mechman45
Mechman45
Vocational, Technical or Trade School
152 satisfied customers
Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

JustAnswer in the News:

Ask-a-doc Web sites: If you've got a quick question, you can try to get an answer from sites that say they have various specialists on hand to give quick answers... Justanswer.com.
JustAnswer.com...has seen a spike since October in legal questions from readers about layoffs, unemployment and severance.
Web sites like justanswer.com/legal
...leave nothing to chance.
Traffic on JustAnswer rose 14 percent...and had nearly 400,000 page views in 30 days...inquiries related to stress, high blood pressure, drinking and heart pain jumped 33 percent.
Tory Johnson, GMA Workplace Contributor, discusses work-from-home jobs, such as JustAnswer in which verified Experts answer people’s questions.
I will tell you that...the things you have to go through to be an Expert are quite rigorous.

What Customers are Saying:

Wonderful service, prompt, efficient, and accurate. Couldn't have asked for more. I cannot thank you enough for your help.

Mary C.Freshfield, Liverpool, UK

This expert is wonderful. They truly know what they are talking about, and they actually care about you. They really helped put my nerves at ease. Thank you so much!!!!

AlexLos Angeles, CA

Thank you for all your help. It is nice to know that this service is here for people like myself, who need answers fast and are not sure who to consult.

GPHesperia, CA

I couldn't be more satisfied! This is the site I will always come to when I need a second opinion.

JustinKernersville, NC

Just let me say that this encounter has been entirely professional and most helpful. I liked that I could ask additional questions and get answered in a very short turn around.

EstherWoodstock, NY

Thank you so much for taking your time and knowledge to support my concerns. Not only did you answer my questions, you even took it a step further with replying with more pertinent information I needed to know.

RobinElkton, Maryland

He answered my question promptly and gave me accurate, detailed information. If all of your experts are half as good, you have a great thing going here.

DianeDallas, TX

< Previous | Next >

Meet the Experts:

Ted G.

Ted G.

Rigger, Diagnostician

4,044 satisfied customers

40 years boating, Safe boating instruct., Offshore Race promoter, Failure Analysis, Expert Witness

Dominick

Dominick

Marine Mechanic

1,009 satisfied customers

25 Years Experience as Mechanic, 20 Yrs Boat Yard Owner/Mechanic, Factory Certified

John White

John White

Marine Mechanic

306 satisfied customers

11 years experience working on outboards, inboards, sterndrives & pwcs

Jason

Jason

Marine Mechanic

24,851 satisfied customers

Degree in Marine Technology. Gas and diesel marine mechanic.

Tan

Tan

MerCruiser Certified Technician

11,409 satisfied customers

40 yrs. experience with complete engine repairs both inboard/outboard and MerCruiser Certified Technician.

Jeff G.

Jeff G.

Marine Mechanic

4,730 satisfied customers

42 years experience, Certified Master Technician, All Major Outboards, Sterndrives, Hi-Performance

Noel Schembri

Noel Schembri

Marine Mechanic

2,759 satisfied customers

Advanced technical diploma

< Previous | Next >

Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

Show MoreShow Less

Ask Your Question

x