Boat

Have Boat Questions? Ask a Boat Repair Expert.

Connect one-on-one with {0} who will answer your question

Related Boat Questions
2011 Mercury 115 4 stroke, went out several days ago, boat
2011 Mercury 115 4 stroke, went out several days ago, boat planes good, after 10-15 minutes at 3800 rpms 28 mph, boat starts to bog down, won't go more than 8 mph decreased rpms motor idled ok tried t… read more
Charles
Charles
Certified Mercury Tech
5,752 satisfied customers
Have 96 Basscat with 200HP Merc EFI 2 Stroke where the oil
Have 96 Basscat with 200HP Merc EFI 2 Stroke where the oil pump was taken out to mix Quicksilver Premium Plus precisely straight into ethanol free gas using 50:1 ratio. Got a rebuild with new Boyesen … read more
Charles
Charles
Certified Mercury Tech
5,752 satisfied customers
I have a 1989 120 HP outboard on a 16-ft bass boat. It will
I have a 1989 120 HP Johnson outboard on a 16-ft bass boat. It will start, idles bit fast (around 1000 RPM, and goes in gear w/o any difficulty. Using the throttle advance lever while in Neutral, the … read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,409 satisfied customers
I just purchased a 1989 Grumman with a 40 Horse Merc
hi Jeff. I just purchased a 1989 Grumman with a 40 Horse Merc Classic. The first time I took it out I had difficulties getting the engine to start. Once the engine started and warmed up it ran seeming… read more
Jeff G.
Jeff G.
Marine Mechanic
Vocational, Technical or Trade Scho
4,730 satisfied customers
Have a 150 verado that generally runs excellent. But recently
Have a 150 verado that generally runs excellent. But recently it goes into limp mode after the long 6 sec beep. It will never happen at idle speed but once rpm is up it happens. Not consistently thoug… read more
Charles
Charles
Certified Mercury Tech
5,752 satisfied customers
75hp Merc 1985 4cy,2st. Motor Bog issue. Bought this used with
75hp Merc 1985 4cy,2st. Motor Bog issue. Bought this used with bad starter. Replaced it, cleaned carbs, new fuel tank and lines, new fuel pump kit, new plugs, 110 comp. check on all 4cyl. Got it out o… read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade School
22,043 satisfied customers
My 2009 225 Suzuki starts and runs perfect. When I throtle
My 2009 225 Suzuki starts and runs perfect. When I throtle up to 3000 rpm or higher the motor runs for 30-40 seconds then bogs down and stalls. Changed the exterior gas water seperator the internal on… read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,409 satisfied customers
I own a 2009 Merc 50 ELPTO 2-stroke on a Triton VT18 aluminum
I own a 2009 Merc 50 ELPTO 2-stroke on a Triton VT18 aluminum shallow V bass boat. More frequently in warm weather, and sometimes unpredictably, when I start up to take off and make a run at high spee… read more
orcamarine
orcamarine
Proprietor
Vocational, Technical or Trade Scho
7 satisfied customers
Im having a problem with low idle and a primer pump bulb not
I'm having a problem with low idle and a primer pump bulb not staying firm on a Johnson 115 motor (1995). I just had the boat in for tune up/repairs and first time I took it out it started and ran fin… read more
James
James
Certified Marine Mechanic
Vocational, Technical or Trade Scho
4,094 satisfied customers
Hello. I have an 1978 70 hp Evinrude 815cc. It starts fine.
Hello. I have an 1978 70 hp Evinrude 815cc. It starts fine. the idel lever works great when i increase the rpm's (out of gear) it works great. I put it in gear and idle away from the dock, no problem.… read more
Jeremy R.
Jeremy R.
5,362 satisfied customers
I have a 2002 Crusiers 3075 boat with two 5.0 Volvo Penta EFI
I have a 2002 Crusiers 3075 boat with two 5.0 Volvo Penta EFI stern drive engines. The boat was summerized and runs fine at wake speed. When power is applied the port drive bogs down and backfires and… read more
James
James
Certified Marine Mechanic
Vocational, Technical or Trade Scho
4,094 satisfied customers
i have a 2006 johnson v6 150hp, this engine was serviced early
i have a 2006 johnson v6 150hp, this engine was serviced early in november of last year and the engine was not performing as it should, the owner brought the boat to my workshop and i adjusted the flo… read more
Master Tech
Master Tech
Service Manager/Technician
Vocational, Technical or Trade Scho
1,167 satisfied customers
I have a 2001 225 VMAX. It had been unused for a couple of
I have a 2001 225 VMAX. It had been unused for a couple of months. I ran the boat and it ran well at less than 2200 to 2400 RPM. Around 2300 to 2400 is when the engine is max loaded to push oven on to… read more
Jeremy R.
Jeremy R.
5,362 satisfied customers
my 2006 f90 runs fine up to 4000rpms. no issues at idle 1000,2000,3000
my 2006 f90 runs fine up to 4000rpms. no issues at idle 1000,2000,3000 rpms. When i get it above 4000 rpms in the water it starts to hesitate and the rpms will drop back to 1500-2000 rpms and them sur… read more
Jason
Jason
Associate Degree
210 satisfied customers
have a johnson 155hp mod# XXXXX got boat and motor for
have a johnson 155hp mod# XXXXX got boat and motor for ferr been working on it in spare time got motor running out of water replaced normal needed items plugs, pump ect . put in water yesterday motor … read more
Master Tech
Master Tech
Service Manager/Technician
Vocational, Technical or Trade Scho
1,167 satisfied customers
I have a 1999 Yamaha 200 hp outboard. Starts and idles fine,
I have a 1999 Yamaha 200 hp outboard. Starts and idles fine, but will only run on a plane for a couple of minutes before it dies. When it dies, it just dies, no hesitation no miss nothing. It will res… read more
ROCKET
ROCKET
MASTER CERTIFIED TECH
Vocational, Technical or Trade Scho
426 satisfied customers
I have a 2000 Bayliner Capri 2052LX. 5.0 merc i/o 220hp.
I have a 2000 Bayliner Capri 2052LX. 5.0 merc i/o 220hp. The boat sat in storage for about 1-1/2 years. At first use it started great but only idled and shut off. It seems to have water in the fuel. I… read more
Larry B.
Larry B.
Marine Service Tech
High School or GED
574 satisfied customers
1986 Yamaha ProV 150, starts and runs good but has no top ...
1986 Yamaha ProV 150, starts and runs good but has no top end rpm, rpms top at 4600 then surges towards wot. What are some things to try to recover full performance? Motor also idles fine.… read more
Pappy's Sales and Service
Pappy's Sales and Service
Vocational, Technical or Trade Scho
586 satisfied customers
Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

JustAnswer in the News:

Ask-a-doc Web sites: If you've got a quick question, you can try to get an answer from sites that say they have various specialists on hand to give quick answers... Justanswer.com.
JustAnswer.com...has seen a spike since October in legal questions from readers about layoffs, unemployment and severance.
Web sites like justanswer.com/legal
...leave nothing to chance.
Traffic on JustAnswer rose 14 percent...and had nearly 400,000 page views in 30 days...inquiries related to stress, high blood pressure, drinking and heart pain jumped 33 percent.
Tory Johnson, GMA Workplace Contributor, discusses work-from-home jobs, such as JustAnswer in which verified Experts answer people’s questions.
I will tell you that...the things you have to go through to be an Expert are quite rigorous.

What Customers are Saying:

Wonderful service, prompt, efficient, and accurate. Couldn't have asked for more. I cannot thank you enough for your help.

Mary C.Freshfield, Liverpool, UK

This expert is wonderful. They truly know what they are talking about, and they actually care about you. They really helped put my nerves at ease. Thank you so much!!!!

AlexLos Angeles, CA

Thank you for all your help. It is nice to know that this service is here for people like myself, who need answers fast and are not sure who to consult.

GPHesperia, CA

I couldn't be more satisfied! This is the site I will always come to when I need a second opinion.

JustinKernersville, NC

Just let me say that this encounter has been entirely professional and most helpful. I liked that I could ask additional questions and get answered in a very short turn around.

EstherWoodstock, NY

Thank you so much for taking your time and knowledge to support my concerns. Not only did you answer my questions, you even took it a step further with replying with more pertinent information I needed to know.

RobinElkton, Maryland

He answered my question promptly and gave me accurate, detailed information. If all of your experts are half as good, you have a great thing going here.

DianeDallas, TX

< Previous | Next >

Meet the Experts:

Ted G.

Ted G.

Rigger, Diagnostician

2,678 satisfied customers

40 years boating, Safe boating instruct., Offshore Race promoter, Failure Analysis, Expert Witness

Dominick

Dominick

Marine Mechanic

1,009 satisfied customers

25 Years Experience as Mechanic, 20 Yrs Boat Yard Owner/Mechanic, Factory Certified

John White

John White

Marine Mechanic

306 satisfied customers

11 years experience working on outboards, inboards, sterndrives & pwcs

Jason

Jason

Marine Mechanic

22,043 satisfied customers

Degree in Marine Technology. Gas and diesel marine mechanic.

Tan

Tan

MerCruiser Certified Technician

11,409 satisfied customers

40 yrs. experience with complete engine repairs both inboard/outboard and MerCruiser Certified Technician.

Jeff G.

Jeff G.

Marine Mechanic

4,730 satisfied customers

42 years experience, Certified Master Technician, All Major Outboards, Sterndrives, Hi-Performance

Captain Dave

Captain Dave

Marine Mechanic

2,672 satisfied customers

USCG Licensed Captain, 20+ Years Boating, Fishing, Maintenance and Repair Experience

< Previous | Next >

Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

Show MoreShow Less

Ask Your Question

x