Boat

Have Boat Questions? Ask a Boat Repair Expert.

Connect one-on-one with {0} who will answer your question

Related Boat Questions
Omc cobra 2: i have a 24 foot bayliner trophy boat ..it has
i have a 24 foot bayliner trophy boat ..it has a gm goodwrench 350 in it for engine and my outdrive is a omc cobra,, I have a problem with it shifting in and out of forward ,reverse ,neutral... after … read more
Tan
Tan
MerCruiser Certified Technician
11,507 satisfied customers
Jason, I'm Rob. I have a 1988 Yamaha 175 ETXG since new.
Hi Jason, I'm Rob. I have a 1988 Yamaha 175 ETXG since new. It has approx 400 hours on it. I've always done the winterization per factor manual. The compression is between 115 and 120 PSIG in all cyli… read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade School
21,048 satisfied customers
I have been virtually given a Bayliner boat. I am planning
I have been virtually given a Bayliner boat. I am planning a renovation and I need information as to what I am dealing with. The Hull number is ***** I believe it is 25.5 ft. long, has a radar dome, f… read more
Jeff G.
Jeff G.
Marine Mechanic
Vocational, Technical or Trade Scho
4,730 satisfied customers
James, I had my boat repowered last year (OMC Cobra 350).
James, I had my boat repowered last year (OMC Cobra 350). I also had the lower section of the outdrive replaced with a new one. The boat engine runs fine (~3800 RPM at full throttle). The boat only go… read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade School
21,048 satisfied customers
I just purchased a 1988 bayliner Avanti 2950 with twin 5.0
I just purchased a 1988 bayliner Avanti 2950 with twin 5.0 litre omc cobra outdrives. The previous owner messed around and has wrong props so boat is slow out of the hole and takes too long to plane. … read more
Charles
Charles
Certified Mercury Tech
5,638 satisfied customers
i have a 1988 four winns 3.0 omc cobra, problem i am having
i have a 1988 four winns 3.0 omc cobra, problem i am having is, when im by myself, boat gets up to speed and plane like normal. when there is 2 adults one at 190 lbs and other at 130 lbs and 4 kids at… read more
Ted G.
Ted G.
Rigger, Diagnostician
Vocational, Technical or Trade Scho
2,543 satisfied customers
I have a 1987 bayliner 2450 ciera. The outdrive says Cobra
I have a 1987 bayliner 2450 ciera. The outdrive says Cobra OMC and the plate says the motor is a 5.0 liter but not sure if the motor is Mercruiser or OMC because the carb has a Mercruiser spark arrest… read more
Whitecap36
Whitecap36
Service Manager/Technician
Vocational, Technical or Trade Scho
1,557 satisfied customers
I am looking at buying a 1988 Bayliner witha a single Inboard/Outboard
I am looking at buying a 1988 Bayliner witha a single Inboard/Outboard Engine Make: OMC Cobra 5.7 350 260HP - this boat is on the East Coast in PA and I want to bring it to a fresh water lake in Utah.… read more
Tan
Tan
MerCruiser Certified Technician
11,507 satisfied customers
I have an 1984 4 winns 22.5 cuddy with a 5l OMC engine and
I have an 1984 4 winns 22.5 cuddy with a 5l OMC engine and drive.My lower drive waspulled out by a mechanic and he says the upper gears are shot and when you grab onto the prop you can only 1/4 turn i… read more
K. Kergan
K. Kergan
Inboard/Outboard Mechanic
Vocational, Technical or Trade Scho
1,031 satisfied customers
HI, 1992 Johnson 88 SPL on a 16 Marlin runabout. - Starts
HI, 1992 Johnson 88 SPL on a 16' Marlin runabout. - Starts w/Full choke - Takes @ least 5 minutes before it will idle - Won't restart w/out full choke - even when fully warmed up. - Boat runs fine, ge… read more
Tan
Tan
MerCruiser Certified Technician
11,507 satisfied customers
just had a remand 351 ford installed and rebuilt outdrive.
just had a remand 351 ford installed and rebuilt outdrive. the prop seems like its not letting the boat to run rite. the boat wont go over 3500 rpm and takes forever to get up on plane. its an 89 bayl… read more
James
James
Certified Marine Mechanic
Vocational, Technical or Trade Scho
4,094 satisfied customers
what engine is a 5.o liter(4v) need to replace it. cant seam
what engine is a 5.o liter(4v) need to replace it. cant seam to find onewith same # XXXXX engine out of 1988 bayliner with omc cobra stern drive. thanks need help… read more
Tan
Tan
MerCruiser Certified Technician
11,507 satisfied customers
Hi ... i would repower my bayliner 2755 (1989),actually OMC
Hi ... i would repower my bayliner 2755 (1989),actually OMC cobra 5.8,351 ci,carbs, with OMC drive... what upgrade do you recommend, if i keep my existing drive ? MPI ?… read more
shane j forrest
shane j forrest
Vocational, Technical or Trade Scho
270 satisfied customers
I have a boat with a bad outdrive, 1980 800 series with hydraulic
I have a boat with a bad outdrive, 1980 800 series with hydraulic assist. I was told it needed rebuild for $2500. Would it be smarter to upgrade to newer version(1982 or newer), look for used unit or … read more
The Man on the Dock
The Man on the Dock
Marina Owner, Operator
Vocational, Technical or Trade Scho
74 satisfied customers
I have an 89 omc cobra 4.3. motor was ruined, water got into
I have an 89 omc cobra 4.3. motor was ruined, water got into crank case, i think through bad gasket. as I now have to rebuild motor, what performance mods can be reasonably done? thank you!… read more
Master Tech
Master Tech
Service Manager/Technician
Vocational, Technical or Trade Scho
1,167 satisfied customers
I am considering buying a used boat. It is a 1994 Wellcraft
I am considering buying a used boat. It is a 1994 Wellcraft 196S Eclipse Sport with a new Vortec 4.3 engine with a Holly carborator. The engine has less than 60 hours on it. What can you tell me about… read more
Master Tech
Master Tech
Service Manager/Technician
Vocational, Technical or Trade Scho
1,167 satisfied customers
Good Morning, Have a couple boats. One a 1972 IMP with a 302
Good Morning, Have a couple boats. One a 1972 IMP with a 302 ford v-8. What out drive does it have? The stickers are worn off. The other boat is a 1988 wellcraft sportsman 250 with twin inboards 3.8 l… read more
Pappy's Sales and Service
Pappy's Sales and Service
Vocational, Technical or Trade Scho
586 satisfied customers
I have 1988 bayliner with a 5.7 liter mercruiser and an omc
I have 1988 bayliner with a 5.7 liter mercruiser and an omc cobra out board the engine just shut down will we were pulling out of the harbor when we tried to restart it it would not turnover thought i… read more
Larry B.
Larry B.
Marine Service Tech
High School or GED
574 satisfied customers
Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

JustAnswer in the News:

Ask-a-doc Web sites: If you've got a quick question, you can try to get an answer from sites that say they have various specialists on hand to give quick answers... Justanswer.com.
JustAnswer.com...has seen a spike since October in legal questions from readers about layoffs, unemployment and severance.
Web sites like justanswer.com/legal
...leave nothing to chance.
Traffic on JustAnswer rose 14 percent...and had nearly 400,000 page views in 30 days...inquiries related to stress, high blood pressure, drinking and heart pain jumped 33 percent.
Tory Johnson, GMA Workplace Contributor, discusses work-from-home jobs, such as JustAnswer in which verified Experts answer people’s questions.
I will tell you that...the things you have to go through to be an Expert are quite rigorous.

What Customers are Saying:

Wonderful service, prompt, efficient, and accurate. Couldn't have asked for more. I cannot thank you enough for your help.

Mary C.Freshfield, Liverpool, UK

This expert is wonderful. They truly know what they are talking about, and they actually care about you. They really helped put my nerves at ease. Thank you so much!!!!

AlexLos Angeles, CA

Thank you for all your help. It is nice to know that this service is here for people like myself, who need answers fast and are not sure who to consult.

GPHesperia, CA

I couldn't be more satisfied! This is the site I will always come to when I need a second opinion.

JustinKernersville, NC

Just let me say that this encounter has been entirely professional and most helpful. I liked that I could ask additional questions and get answered in a very short turn around.

EstherWoodstock, NY

Thank you so much for taking your time and knowledge to support my concerns. Not only did you answer my questions, you even took it a step further with replying with more pertinent information I needed to know.

RobinElkton, Maryland

He answered my question promptly and gave me accurate, detailed information. If all of your experts are half as good, you have a great thing going here.

DianeDallas, TX

< Previous | Next >

Meet the Experts:

Ted G.

Ted G.

Rigger, Diagnostician

2,543 satisfied customers

40 years boating, Safe boating instruct., Offshore Race promoter, Failure Analysis, Expert Witness

Dominick

Dominick

Marine Mechanic

1,009 satisfied customers

25 Years Experience as Mechanic, 20 Yrs Boat Yard Owner/Mechanic, Factory Certified

John White

John White

Marine Mechanic

306 satisfied customers

11 years experience working on outboards, inboards, sterndrives & pwcs

Jason

Jason

Marine Mechanic

21,048 satisfied customers

Degree in Marine Technology. Gas and diesel marine mechanic.

Tan

Tan

MerCruiser Certified Technician

11,507 satisfied customers

40 yrs. experience with complete engine repairs both inboard/outboard and MerCruiser Certified Technician.

Jeff G.

Jeff G.

Marine Mechanic

4,730 satisfied customers

42 years experience, Certified Master Technician, All Major Outboards, Sterndrives, Hi-Performance

Captain Dave

Captain Dave

Marine Mechanic

2,672 satisfied customers

USCG Licensed Captain, 20+ Years Boating, Fishing, Maintenance and Repair Experience

< Previous | Next >

Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

Show MoreShow Less

Ask Your Question

x